• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.7
• /
• pp.68-74
• /
• 2007

For carnation productivity improvement, compact-low cost discharge lamp type ozonizer using pulse power source is designed and manufactured. This paper describes the discharge characteristics and the ozone generation characteristics with variation of the output voltage of pulse power source, the quantity of flowing air and the operating number of ozonizer. The important conclusions are as follows. The discharge voltage and current values are proportional to the output voltage of pulse power source. The ozone concentration and generation are proportional to the output voltage of pulse power source and the number of ozonizer. The maximum value of the ozone concentration and generation of the discharge lamp type ozonizer can be obtained 890[ppm] and 59.7[mg/h] respectively. In the carnation productivity house, when the discharge lamp type ozonizer is used the carnation is good quality in the uniformity of the carnation stalk thickness and increased the productivity through improvement of the air and the soil.

• The Journal of the Acoustical Society of Korea
• /
• v.42 no.1
• /
• pp.25-31
• /
• 2023

In order to estimate the radial speed of an underwater object so-called target with active sonar, Continuous Wave (CW) pulse is generally used, but if a target is slow and at near distance, it is not easy to estimate the radial velocity of the target due to acoustic reverberation in the ocean. In 2017, Wang et al. utilized broadband signal of two Hyperbolic Frequency Modulation (HFM) pulses, which is known as a doppler-invariant pulse, with equal frequency band and in opposite sweep directions to overcome this problem and successfully estimate the radial speed of slow-moving nearby target. They demonstrated the estimation of the radial velocity with computer simulation using the parameters of two HFM starting time differences and receiving times. However, for it uses two HFM pulses with equal frequency, cross-correlation between the two pulses negatively affect the detection performance. To mitigate this cross-correlation effect, we suggest using two different band HFM with the opposite sweep directions. In this paper, a method of radial velocity estimation is derived and simulated using two HFM pulses with the pulse length of 1 second and bandwidth of 400 Hz. Applying the suggested method, the radial velocity was estimated with approximately 6 % of relative error in the simulation.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.18 no.1
• /
• pp.42-49
• /
• 2014

Performance evaluation was carried out for the 70 N-class hydrazine thruster whose design performance had been already verified. The pulse-mode firing test was conducted for the development model thrusters with various thrust chamber diameters. Evaluation was made by the performance parameters such as specific impulse, impulse bit, and characteristic velocity, etc: specific impulse and characteristic velocity were deteriorated as the thrust chamber diameter deviates from a standard model. Consequently, it is revealed that the performance characteristics of standard model is most superior among the test models.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.08a
• /
• pp.296-296
• /
• 2010

ICRF 시스템을 이용한 방전세정인 ICWC(Ion Cyclotron Wall Cleaning)는 ITER와 DEMO 같은 초전도 자석을 이용하는 토카막에서 토카막 shot 중간에 자장을 낮추지 않고 바로 방전 세정을 할 수 있는 방법이다. 토카막에서 방전세정은 탄소나 산소 화합물과 같은 불순물을 제거하여 방사에 의한 플라즈마 냉각을 막고 토카막 초기 start-up시 진공 챔버 벽면으로부터 의도하지 않은 연료주입을 제거하는 역할을 한다. 본 연구에서는 ICWC 방전 세정 최적화를 위해 플라즈마의 불순물 제거 특성을 수소 유량의 크기와 ICRF 펄스의 duty ratio를 바꿔가면서 관찰하였다. ICRF 전력은 44.2 MHz에서 20-50 kW 가 입사되었으며 자장은 3 T에서 고정되었다. 운전압력은 $10^{-4}$ mbar 정도이다. 헬륨의 유량을 400 sccm으로 고정한 후 수소의 유량을 40 sccm에서 160 sccm까지 증가시켜가면서 제거율을 관측하였다. 그 결과 수소 유량의 증가에 따라 제거율이 증가하는 불순물과 오히려 감소하는 불순물이 있음이 관측되었다. 제거율이 증가되는 불순물 group은 charge-to-mass ratio가 26, 28, 40, 44이고 감소하는 불순물 group은 18, 20, 32 이다. 펄스의 duty ratio를 1/9(on/off) 초에서 5/5(on/off) 초로 증가시킴에 따라 제거율이 증가하는 불순물과 감소하는 불순물이 또한 나타났는데 수소 유량 실험과 그 group에 차이가 없었다. 이러한 실험결과는 수소 유량의 증가나 펄스 길이의 증가에 따라 가스의 종류에 관계없이 모두 증가하거나 감소할 것이라는 예측과는 다른 결과로서 이것에 대한 명료한 해석이 필요하다. 왜냐하면 위와 같은 운전조건에서 효율적인 불순물 제거를 위해서는 불순물 제거 운전 방법이 불순물의 종류에 따라 모두 달라져야 하기 때문이다. 본 연구에서는 이러한 특성을 불순물의 dissociation 에너지 관점에서 해석을 시도하였다.

• Korean Journal of Optics and Photonics
• /
• v.13 no.5
• /
• pp.430-434
• /
• 2002

We present the magnitude of terahertz electromagnetic pulses when femtosecond laser pulses are moving along to a dipole antenna. The dipole antenna chip has maximum 4.7 nA THz current, generated at 11 DC volt. This current is 3.4 times bigger than the current of a $300{\mu}{\textrm}{m}$ separated transmission line structure chip that has 70 DC volt. We also apply an AC square wave voltage to the dipole antenna from 0.1 volt to 10 volt for binary signals using the terahertz electromagnetic pulses.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.19 no.4
• /
• pp.294-299
• /
• 1999

In this paper, the calibration system for contact transducer has been developed to improve the reliability of the inspection result of ultrasonic testing on rotors. This system consists of signal processing parts: (oscilloscope, spectrum analyzer, pulser/receiver), standard block, and user interface program. Signal processing for the calibration system was performed quickly with high accuracy. The developed system has been applied to a practical calibration of probe using the non-destructive testing on rotors, and demonstrated high sensitivity and precision.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.1 no.2
• /
• pp.63-68
• /
• 2000

A passively mode-locked ring type fiber laser had been installed in order to get the short pulses The single and the double mode-locking were appeared, and the shortest pulse length of 65 fs was obtained with a 110 m long dispersion shifted fiber(DSF) in a local cavity of 139.8 m. Also high order harmonic modelocking of 17th and Q-switched high order harmonic modelocking were obtained.

• The Journal of the Acoustical Society of Korea
• /
• v.17 no.1
• /
• pp.9-16
• /
• 1998

본 논문에서는 낮은 비트율 CELP 음성 부호화기의 장구간 예측기의 성능 향상 방 법을 제안한다. 비트율을 낮추기 위해서는 분석 구간의 길이가 길어져야하며 이에 따라 장 구간 예측기의 성능이 저하되어 장구간 예측 후에도 준 주기성 성분이 상당량 존재하므로 백색 잡음으로 구성된 통계 코드북만으로는 이를 모델링하기 어려워진다. 제안 방법에서는 다중 대역 필터와 다중 펄스열을 이용하여 한 번 더 필터링(이차 장구간 예측)함으로써 장 구간 예측 후의 신호가 통계 코드북에 적합한 백색 잡음 형태로 되도록 모델링한다. 제안된 방법의 성능을 평가하기 위해 4.8kbps 비트율로 양자화한 후, 기존에 제안된 같은 전송률의 MBCELP와 DoD-CELP와 비교하였다. 실험 결과 제안된 방법이 기존 부호화기들에 비해 주/객관적인 음질에서 우수한 성능을 보여준다.

• Korean Journal of Optics and Photonics
• /
• v.4 no.4
• /
• pp.457-463
• /
• 1993

We investigated that the CARS signals generated from resonant or nonresonant contributions can be selectively suppressed by phase-controlled nonlinear interferometry. To control the phase of the CARS signal over a broad spectral range, a home-made phase shifting unit was used, whose thickness was automatically controlled as the wavelength of Stokes beam scaned. Using this technique, we recovered the Q-branch resonance lines of carbon monoxide and HC1 which had been distorted and buried by the nonresonant and resonant signal of propane respectively. All the spectrum measured have been normalized by reference signal which had no resonance lines over the spectral range of interest.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.51 no.4
• /
• pp.158-163
• /
• 2002

The pulsed Power system has been widely used to many applications, such as E/P(Electrostatic Precipitator), DeNOx/DeSOx power system, often generator, etc. In this paper, we study EMTP analysis and characteristics of critical voltage and load in impedance on various electrode length of pulse corona. To obtain a stable pulse voltage, we designed a compact pulse generator switched MOSFET and tested their characteristics by adjusting electrode length and pulse repetition. As a re sult, critical voltage of pulse corona and load impedance on increasing electrode length were decreased. These results indicate we can control critical voltage of pulse corona and suppress arc discharging between two electrodes.