• Geophysics and Geophysical Exploration
• /
• v.2 no.1
• /
• pp.33-42
• /
• 1999

AVO and complex trace analyses mainly used to characterize natural gas reservoir were tested in this paper for a possible application to detection of major geological discontinuities such as fracture zones. The test data used in this study were calculated by utilizing a viscoelastic numerical program which was based on the generalized Maxwell body for a horizontal fracture model. In AVO analysis of a horizontal fracture zone, p-wave reflection appears to be variant depending upon the acoustic-impedence contrast and the offset distance. The fracture zone is also effectively clarified both in gradient stack and range-limited stack in which fracture zone reflection is attenuated with the increasing offset distance. In complex attribute plots (instantaneous amplitude, frequency, and phase), the top and bottom of the fracture Tone are characterized by a zone of strong amplitudes and an event of the same phase. Low frequency characteristics appear at the fracture zone and the underneath. Amplitude attenuation and waveform dispersion are dependent on Q-contrast between the fracture zone and the surrounding media. They were properly compensated by optimum inverse Q-filtering.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.8
• /
• pp.55-63
• /
• 2018

In this paper, we measured the propagation path loss by a ground to air flight communication test at UHF band and analyzed the results. The ground receiving terminal was located at 1,100m above sea level in Cheju Island and the airborne transmit terminal flew at an altitude of 3.5km from 150 to 220km from the ground terminal. In this case, the ground terminal and the airborne terminal are on the Line of Sight. Therefore loss in this communications environment can be predicted based on Free Space Loss. However, in this test, the sea level exists between two terminals, and due to the very small angle of incidence on the reflecting surface due to the long-range communication environment, it is not possible to accurately predict the loss of free space only. Therefore, considering that there are no surrounding obstacles and that a line of sight is secured between the end of two terminals, we applied a plane earth reflection model and a spherical earth reflection model to estimate the propagation path loss and compared with the actual test results. As a result of the comparison, the predicted propagation path loss by a spherical earth reflection model were quite similar to the actual test values.

• Journal of Korean Society of Environmental Engineers
• /
• v.39 no.7
• /
• pp.426-439
• /
• 2017

This review summarizes advantage and limitation in infrared spectroscopy and computational chemistry to understand rhizospheric interaction among organic acids, oxyanions and metal oxides. Since organic acids and metal oxides determine dynamics of oxyanions in the soil environment, knowledge of fundamental mechanisms is a prerequisite for understanding the interactions at soil-water interface. Attenuated total reflectance-fourier transform infrared spectroscopy (ATR-FTIR) is a powerful tool to measure the interfacial reactions. However, the ATR-FTIR measurements are abstruse, because the optical characteristics for measurements are variable depending on the experimental setup. In addition, spectral overlapping is a primary obstacle to the analysis of the interfacial reaction; thus, it is essential to detect and to deconvolute bands for signal interpretation. In this review, we expained the fundamental principle for spectrum processing, and four band identification methods, such as derivative spectroscopy, two-dimension correlation spectroscopy, multivariate curve resolution, and computational chemistry with example of aqueous phosphate speciation. As a result, spectrum processing and computational chemistry improved interpretation and spectral deconvolution of overlapped spectra in relatively simple systems, but it was still unsatisfactory for the problems in more complexed system like nature. Nevertheless, we believed that our challenge would contribute practically to develop adequate analytical procedure, signal processing and protocols that could help to improve interpretation and to understand the interfacial interactions of oxyanions in natural systems.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.16 no.1
• /
• pp.27-38
• /
• 2004

In this study, the reliability design method developed by Shimosako and Takahashi in 1999 for calculation of the expected sliding distance of the caisson of a vertical breakwater is extended to take into account the variability in wave direction such as directional spreading of waves, obliquity of the deep-water design principal wave direction from the shore-normal direction, and its variation about the design value. To calculate the transformation of random directional waves, the model developed by Kweon et al. in 1997 is used instead of Goda's model, which was developed in 1975 for unidirectional random waves normally incident to a straight coast with parallel depth contours and has been used by Shimosako and Takahashi. The effects of directional spreading and the variation of deep-water principal wave directions were minor compared with those of the obliquity of the deep-water design principal wave direction from the shore-normal direction, which tends to reduce the expected sliding distance as it increases. Especially when we used the field data in a part of east coast of Korea, considering the variability in wave directions reduced the expected sliding distance to about one third of that not considering the directional variability. Reducing the significant wave height calculated at the design site by 6％ to correct the effect of wave refraction neglected in using Goda's model was found to be proper when the deep-water design principal wave direction is about 20 degrees. When it is smaller than 20 degrees, a value smaller than 6％ should be used, or vice versa. When we designed the caisson with the expected sliding distance to be 30㎝, in the area of water depth of 25 m or smaller, we could reduce the caisson width by about 30％ at the maximum compared with the deterministic design, even if we did not consider the variability in wave directions. When we used the field data in a part of east coast of Korea, considering the variability in wave directions reduced the necessary caisson width by about 10% at the maximum compared with that not considering the directional variability, and is needed a caisson width smaller than that of the deterministic design in the whole range of water depth considered (10∼30 m).

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.4
• /
• pp.442-450
• /
• 2014

This paper is a study of the propagation characteristic of matching liquids in the skin-covered breast model. In order to evaluate the matching liquids, we investigated six kinds of matching liquids applied to proposed 1-D breast model from frequency range of 3~6 GHz. A uniform plane wave is projected / transmitted inside the multi-layered breast model. Then the propagation characteristics inside the model and the transmission loss of each matching liquids were analyzed. The studying method presented in the paper can be used in the breast cancer detection system, the field of cancer detection using human tissue and the field of other medical devices. This paper was applied to the breast cancer detection system. Consequently, these studies could be used to determine the suitable type of matching liquids for breast cancer detection system and to apply useful for performance analysis.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.22 no.2
• /
• pp.193-197
• /
• 2002

The frequency dependency of the Rayleigh surface wave was investigated indirectly by measuring the angular dependency of the backward radiation of the incident ultrasonic wave in the abrasion specimens, which was explained in view of the residual stress distribution. The peak intensity of the backward radiation profile decreased and the right half width of the profile increased with an increase of the variational rate of residual stress for the scuffing specimen. The peak intensity was also affected by the surface wave scattering during the propagation around the micro-damages. The peak angle might depend on not only the amount of residual stress but also the micro-structure. The result observed in this study demonstrates the high potential of the backward radiated ultrasound as a tool for the nondestructive evaluation of the subsurface gradients of materials.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.8 no.2
• /
• pp.137-150
• /
• 1997

The problem of electromagnetic coupling into a thin conducting wire through a slot in an infinite conducting is analyzed by use of MPIE(mixed potential integral equation) and two- dimensional moment method using subsectional(rooftop) basis functions. The equivalent circuit is derived using a center-repesentation method which is valid in a narrow slot case. The equi- valent magnetic currents on the slot and the induced currents on the wire are caculated respec- tively, for the TM wave is incident upon the slot with arbitrary angle of incidence. The theoretical transmission coefficients of transmission line which is composed of thin-wire and infinite conducting plate with a narrow slot are compared and found to be in good agreement with experimental results.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.19 no.5
• /
• pp.399-407
• /
• 2007

Two reliability models, AFDA(Approximate Full Distribution Approach) and Monte-Carlo simulation method, are directly developed to study on both hydraulic failure mode of berm recession and structural failure mode of armour breakage of berm breakwaters. By comparing the present results with the results of other researcher, it may be confirmed that two reliability models can be straightforwardly applicable to berm breakwaters. Relative influence of each random variable on hydraulic and structural failure probabilities could be properly analyzed. The upper bound and the lower bound of failure probability can be evaluated by using bi-modal bounds of the multiple failure mode analysis, from which it may be possible to investigate some kinds of dependence into between two failure modes. Finally, it may also be found that the structural failure mode of armour breakage could become a main failure mode of berm breakwaters in the condition of more than any allowable berm recession.

• Geophysics and Geophysical Exploration
• /
• v.20 no.2
• /
• pp.88-95
• /
• 2017

Chogye basin, which is surrounded by country rock, has a closed-basin form. In such a basin, incident seismic energy can form multiply reflected waves, thus causing energy concentration to occur at this closed-basin area. Microtremor measurement survey was performed at the Chogye basin, which is located in Chogye-myeon and Jeokjungmyeon, Hapcheon-gun, Gyeongsangnam-do, Republic of Korea. Microtremor data were transformed into the frequency domain, and then the horizontal-to-vertical spectral ratios (HVSR) were calculated. Fundamental resonance frequencies were estimated from the HVSR results for every observation point. Using the empirical relationship between site period and thickness for sediment sites in Korea known from the previous study, the distribution of sediment thickness of the Chogye basin was estimated from the fundamental resonance frequencies. Being compared with the mountainous rim with steep slope, the measurement points inside the basin have low values of the fundamental resonance frequency with the minimum of 1.03 Hz, which corresponds to the thickness of sedimentary layer with the maximum depth of about 100 m. A three-dimensional basin model was constructed for bedrock topography of the Chogye basin by an interpolation of basin depths estimated at each measurement site.