• JOURNAL OF ELECTRICAL WORLD
• /
• s.307
• /
• pp.68-73
• /
• 2002

감전보호$\cdot$누전화재보호로서 누전차단기가 일반적으로 사용되고 있는데 이 누전차단기가 누전으로 트립되었을 경우 (1) 누전트립이 재현되지 않는다. (2) 누설전류치가 고조파의 영향 때문에 측정이 곤란하다는 등의 이유로 원인조사가 어려운 경우가 많다. 그래서 누전차단기의 동작원인조사를 지원하는 기기로서 WS시리즈의 노퓨즈차단기 및 누전차단기에 각종 누설전류치의 액정표시유닛을 탑재한 $''$누설전류표시부 노퓨즈차단기$\cdot$누전차단기$''$를 제품화하였다. 이에 의하여 전로에 영상변류기(ZCT)와 계측기 등을 설치하지 않고 전로의 절연열화상태나 누전사고 상황을 간단하게 파악할 수가 있다. 또 액정표시유닛의 제어전원은 차단기 내부에 포함하고 있기 때문에 특별배선작업은 불필요하다. 이 제어전원은 차단기가 오프상태 또는 트립상태에서는 끊어지나 내부에 전기이중충 콘덴서를 내장하고 있기 때문에 각종 누설전류 정보를 표시할 수가 있다(정전보상시간 100시간). 주요특징은 다음과 같다. (1)각종 누설전류의 계측과 표시(현재치, 최대치, 이동평균치, 이동평균의 최대치, 각 최대치의 발생경과시간) (2) 누전경보의 설정 감도를 세분화하여 설정가능 또한 접점경보출력 표준탑재 (3) 누전트립 발생시의 누전사고전류치 및 누전사고 발생으로부터의 경과시간 표시(누전차단기만) (4) 미쓰비시전기 누전차단기의 액티브필터와 같은 특성의 필터를 내장하고 있으며 누전차단기의 동작특성에 맞는 누설전류치 표시가능 (5) 누전경보만으로 누전트립 동작을 하지 않는 누설전류표시부 노퓨즈차단기 라인업

• 유체기계공업학회:학술대회논문집
• /
• 2006.08a
• /
• pp.187-190
• /
• 2006

In the present study, effects of tree-stream turbulence and surface trip wire on the flow past a sphere at $Re\;=\;0.4\;{\times}\;10^5\;{\sim}\;2.8\;{\times}\;10^5$ are investigated through wind tunnel experiments. Various types of grids are installed upstream of the sphere in order to change the tree-stream turbulence intensity. In the case of surface trip wire, 0.5mm and 2mm trip wires are attached from $20^{\circ}\;{\sim}\;90^{\circ}$ at $10^{\circ}$ interval along the streamwise direction. To investigate the flow around a sphere, drag measurement using a load cell, surface-pressure measurement, surface visualization using oil-flow pattern and near-wall velocity measurement using an I-type hot-wire probe are conducted. In the variation of free-stream turbulence, the critical Reynolds number decreases and drag crisis occurs earlier with increasing turbulence intensity. With increasing Reynolds number, the laminar separation point moves downstream, but the reattachment point after laminar separation and the main separation point are fixed, resulting in constant drag coefficient at each free-stream turbulence intensity. At the supercritical regime, as Reynolds number is further increased, the separation bubble is regressed but the reattachment and the main separation points are fixed. In the case of surface trip wire directly disturbing the boundary layer flow, the critical Reynolds number decreases further with trip wire located more downstream. However, the drag coefficient after drag crisis remains constant irrespective of the trip location.

• Journal of the Korean Chemical Society
• /
• v.31 no.5
• /
• pp.400-405
• /
• 1987

The two dissociation constants of three amino acid, glycine, alanine, and tryptophan were measured by the conductometric method in the temperature from 15 to 35$^{\circ}$C and pressure up to 2,500bar in aqueous solution. The both dissociation constants were increased as the temperature increased but the pressure effect were not same as the temperature effect. The first constants were increased as the pressure increased but second constants were decreased except tryptophan. The characteristic properties of these amino acids were discussed from the thermodynamic properties of the dissociation reaction. The substituted effects of the reaction were deduced from Hammett reaction and substituted constants which were calculated from the dissociation constants.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.22 no.5
• /
• pp.13-20
• /
• 2008

Power quality problems such as momentary interruptions and voltage sags do not great influence on loads at past. However, the interests in power quality problems increase as the use of sensitive loads with microprocessor like computers increases recently. Accordingly, power system reliability research focusing to sustained interruption and momentary interruption partially needs more accurate evaluation methods including momentary and instantaneous problems. That is, many sensitive loads being tripped by voltage sags result in interruption costs. In this paper, new reliability worth evaluation method is presented considering voltage sags. We calculated the magnitude of voltage sags using fault studies and the duration of voltage sags using the trip time of protective relays for each fault. Moreover, we includes the customer interruption cost resulted from sensitive load trip by voltage sags. Through case studies, we evaluate the effects of voltage sags for permanent faults.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.2 no.1
• /
• pp.46-54
• /
• 1991

A noble phased-array antenna of the circular form with microstrip slots was designed for steering the radiation beam and increasing the directivity and gain. The directivity and gain could be controlled, varying the number of slots and the radius of a circle, but here, the 40 .deg. beam scanning antenna system was achieved by tangentially arranging 4 mi- crostrip slots on a circumference and the analog phase shifter was used to adjust phase difference in the adjacent elements. And such a system has a microstrip configuration taking the effects of the line dispersion and discontinuities into account at 10 Ghz. The experimental results were fairly agreed with theoretical values, and this circular phased array had an improved performance over the rectangular phased array with 64-microstrip patches in a view of the number of array elements.

• The Journal of Natural Sciences
• /
• v.8 no.1
• /
• pp.33-39
• /
• 1995

Klebsiella sp. L-10 was treated with physical and chemical mutagens, and one of the NTG mutant which increased hyaluronic acid complex yield 2.5 folds was selected. The yield of hyaluronic acid complex from Klebsiella sp. L-10 NTG 50 mutant reached maximum level I the YPD medium containing 0.1% yeast extract, 3% Bacto-tryptone, 3% dextrose, each 30mM of $K_2HPO_4$ and $KH_2PO_4$ (pH 6.0-6.5) with shaking culture at $37^{\circ}C$ for 24 hrs, and 2900mg of hyaluronic acid complex per litre of culture was produced under the above condition.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.5
• /
• pp.668-677
• /
• 1998

This paper is to verify the availability of the finite difference time domain (FDTD) method for the analysis of millimeter wave microstrip patch antenna. Using this method, the size of the microstrip patch antenna resonating at 32.153 GHz is optimized and the input impedance, the voltage standing wave ratio and the radiation pattern are calculated. The resonance frequencies of the microstrip patch antenna are calculated by MOM and FDTD method and then compared with the measured results, showing the difference of 12.27% and 1.27% respectively. Also, the bandwidth of this Ka-band patch antenna is about 8% which is similar to the case of X-band.

• Fire Science and Engineering
• /
• v.28 no.4
• /
• pp.21-28
• /
• 2014

This study obtained the following results by analyzing the standards related to a $1{\phi}$ 2W MCCB and evaluating its heat resistance characteristics. Since KS C 8321 corresponds to IEC 60947-2 standards, most of the related regulations are similar. The NFPA, which presents the user oriented safety regulations, contains no details about tests or inspections, etc., but it does specify in detail the regulations directly related to safety. It can be seen that KS C 8321 classifies in detail the items about tests and inspections. However, IEC 60947-2 and IEEE C37.51 simplified the test and inspection items or omitted some of them. When applying thermal stress to an MCCB for 6 hours at $180^{\circ}C$ using a heat resistant experimental device, it was found that the actuator lever was transformed and moved in the tripped state. In addition, most of the fixing hanger was melted down, losing their function. When applying thermal stress to the MCCB at $90^{\circ}C$, it showed nothing peculiar, but the fixing hanger was partly deformed at $105^{\circ}C$ and $120^{\circ}C$. It was found that the fixing hanger was deformed and the name plate was discolored at $150^{\circ}C$. It can be seen from the analysis of the internals of the MCCB that the trip bar has been melted away and that the up and down operator has moved up. The experiment performed by applying a withstanding voltage of 6 kV for 60 s showed that all items remained intact. In addition, the evaluation of the insulation performance performed by applying DC 500 V using an insulation-resistance tester showed good insulation performance.

• Journal of Korean Society of Transportation
• /
• v.26 no.2
• /
• pp.177-186
• /
• 2008

Video Image Detection System can be used for various traffic managements including traffic operation and traffic safety. Video Image Detection Technique can be divide by Tripwire System and Tracking System. Autoscope, which is widely used in the market, utilizes the Tripwire System. In this study, we developed an individual vehicle tracking system that can collect microscopic traffic information and also developed another image detection technology under the Tripwire System. To prove the accuracy and reliability of the newly developed systems, we compared the traffic data of the systems with those generated by Autoscope. The results showed that 0.35% of errors compared with the real traffic counts and 1.78% of errors with Autoscope. Performance comparisons on speed from the two systems showed the maximum errors of 1.77% with Autoscope, which confirms the usefulness of the newly developed systems.

• KSBB Journal
• /
• v.11 no.4
• /
• pp.462-469
• /
• 1996

Biosolubilization of an Australian lignite was investigated by using Streptomyces viridosporus and Poria cocos. In order to solubilize coals effectively they were pretreated by nitric acid both in surface and liquid cultures. The optimum growth pH was 7.5 for S. viridosporus and 4.5 for P. cocos. The effects of various carbon, nitrogen and metal sources on overall solubilization were also studied. Solubility increased with the addition of urea for S. viridosporus, and peptone and tryptone for P. cocos. However carbon and metal sources had little or negative effects on solubilization. Maximum amount of coal solubilized was 85%(w/w) in a batch fermentation culture. Extracellular materials produced by micro-organism were found to be responsible for the coal solubilization. Approximately 70 to 80% of coal solubilization was determined to be the result of non-enzymatic reactions, and the rest to be the result of enzymatic reactions. Characteristics of the solubilized coal were compared with those of original coal and pretreated coal by the approximate and ultimate composition analysis, and IR-spectrum analysis. The spectroscopic results showed that the mechanism of coal solubilization was caused by continuous oxidation.