• Journal of the Earthquake Engineering Society of Korea
• /
• v.10 no.4 s.50
• /
• pp.25-33
• /
• 2006

The purpose of this study is to develop the curve fitted equations for practicality and actual calculation during seismic performance evaluation of buried pipelines. Curve fitting for strain curve according to the wavelength of the seismic wave was produced using the non-linear least square method and the equations with the best results was suggested. In addition, a degree and coefficient of polynomial fitting equation needed to use curve fitted equation were identified. Interpreting process during the test of resistance of earthquake of buried pipelines with various end boundary conditions were provided through example questions. The results of this study were used to conduct a dynamic response analysis and a seismic performance evaluation of concrete, steel, and FRP pipes with various end boundary conditions.

• 전자공학회논문지 IE
• /
• v.44 no.4
• /
• pp.41-47
• /
• 2007

In this paper, the performance of simulation model in mobile to mobile Rayleigh and Rician fading channel is analyzed and simulation results are compared. The auto-correlation and cross-correlation functions of Rayleigh fading channels not only based on received signals of Clarke's fading model and but also based on received signals of phase shifted Clarke's fading model are derived and their simulation results are found. The two models are also applied to mobile to mobile Rician fading channel models and their numerical results of auto-correlation functions of complex envelop received signals shows the statistical properties match the theoretical values very well and rapidly converge with the small number such as N=8.

• Proceedings of the Korea Society for Simulation Conference
• /
• 1999.04a
• /
• pp.65-69
• /
• 1999

Switching System(이하 교환 시스템)이 QoS(Quality of Service)를 유지하면서 처리 가능한 최대 동시 호처리 능력을 검증하기 위하여, 수학적 분석을 이용한 해석적 방법, 실제 호를 사용한 통계적 방법 등이 제안되었다. 해석적 방법을 이용해 산출한 교환 시스템의 최번시 동시 호 처리능력(BHCA, Busy Hour Call Attempt)은 단지 수학적인 예측일 뿐이므로 이를 검증하기 위해서 가상 호 발생기가 제안되었다. 이 가상호 발생기는 가입자의 행동을 시스템 하위 프로세서(가입자 정합 Device 제어 프로세서)에서 Simulation하여 가상의 호를 발생시키고, 이를 통해 교환기 최대 동시 호 처리 용량을 시험하기 위한 SW이다. 이 가상호 발생기는 동일한 형태의 호를 동시에 다량으로 발생시킴으로써 교환 시스템의 주 프로세서(Main Processor, MP)의 동시 호 처리 용량을 시험하기 위한 SW이다. ITU-T 권고에 의하면 시스템부하가 90~95%를 넘어 서는 경우는 예외적인 처리(과부하 제어 등)를 권고하고 있으므로 MP 부하 90~95%에서 BHCA를 계산하면 최대 호 처리 용량이라 할 수 있다. 가상 호 발생기는 시스템 개발 초기에 실제 가입자 정합 Device 와 호 발생기 없이도 MP 과부하 지점까지 호를 발생시킴으로써 개발의 시간 및 비용을 절약할 수 있도록 하고, 계획된 시스템 용량을 만족하기 위해 필요한 조치를 교환 시스템 개발 초기에 취할수 있도록 한다. 또한, 과부하 지점에서 MP가 정상 동작하는지 검증하는 도구로 사용 가능하다. 앞으로 이를 더 발전시키면 가상호 발생기를 이용한 다양한 시스템 검증 및 분석에 이용할 수 있을 것이다. 본 논문은 가상호 발생기의 구조와 최대 용량 시험 방법을 소개하고, 더 나아가 호 Traffic에 대한 최대 용량 시험뿐 아니라 QoS를 향상시키기 위한 교환 시스템의 제반 성능 시험 및 분석에 이를 이용하기 위해 개선이 필요함을 서술하고자 한다.

• Composites Research
• /
• v.22 no.6
• /
• pp.18-22
• /
• 2009

In this paper, we examined impact force and impact behavior through low velocity impact tests of composite laminates. And through c-scan as nondestructive inspection, explored the damaged area being difficult to examine with the visual inspection. Through CAI tests, we also measured the compression strength of composite laminates subjected to low velocity impact. To examine the characteristics of impact behavior measured from low velocity impact test, nondestructive inspection, and CAI test, the simulated data are generated from the test data using Monte-Carlo simulation, then represented it by probability distribution. The testing results using visible stochastic distribution were examined and compared.

• Journal of the Korean Society of Radiology
• /
• v.12 no.7
• /
• pp.801-806
• /
• 2018

Germanium crystals have a dead layer that causes efficiency deterioration because the layer is not useful for detection but strongly weakens the photons. Thus, when the data provided by the manufacturer is used in the detector simulation model, there is a slight difference between the calculated efficiency and the measured efficiency.The shape and dimensions of the high purity germanium (HPGe) detector were determined by CT scans to accurately characterize the shape for the Monte Carlo roll simulation. It is found that the adjustment of the dead layer is a good match with the relative deviation of ${\pm}3%$ between the measurement efficiency and the simulation efficiency at the energy range of 50 - 1500 keV. Simulation data were compared by varying the thickness of the dead layer. The new Monte Carlo simulations were compared with the experimental results to obtain new blank layer thicknesses. The difference in dead layer results for the 1.5 mm thick end cap simulation model in 1.4 and 1.6 mm thick End Cap simulation models was a systematic error due to the accuracy of the end cap dimensions. After considering all errors including statistical errors and systematic errors, the thickness of the detector was calculated as $1.02{\pm}0.14mm$. Therefore, it was confirmed that the increase in the thickness of the dead layer causes the effect to be effected on the efficiency reduction.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.22 no.1
• /
• pp.108-113
• /
• 2012

Routing paths are mightily important for the network security in WSNs. To maintain such routing paths, sustained path re-selection and path management are needed. Region segmentation based path selection method (RSPSM) provides a path selection method that a sensor network is divided into several subregions, so that the regional path selection and path management are available. Therefore, RSPSM can reduce energy consumption when the path re-selection process is executed. However, it is hard to guarantee optimized secure routing path at all times since the information using the path re-selection process is limited in scope. In this paper, we propose partial path selection method in each subregion using preselected partial paths made by RSPSM for routing path optimization in SEF based sensor networks. In the proposed method, the base station collects the information of the all partial paths from every subregion and then, evaluates all the candidates that can be the optimized routing path for each node using a evaluation function. After the evaluation process is done, the result is sent to each super DN using the global routing path information (GPI) message. Thus, each super DN provides the optimized secure routing paths using the GPI. We show the effectiveness of the proposed method via the simulation results. We expect that our method can be useful for the improvement of RSPSM.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.6
• /
• pp.647-656
• /
• 2008

In this paper, we present interference power distribution results when radio frequency identification(RFID) and ubiquitous sensor network(USN) systems share the $908.5{\sim}914MHz$ frequency bands. Average interference powers are obtained by simulation and statistical analysis, respectively. Simulation results are then verified by statistical analysis. According to the number of interferers and the diameter of the protection area, the cumulative density functions(CDFs) of interference power are simulated under the various conditions. From the simulation results, the probability that both USN and RFID systems meet the required maximal interference power levels is 95 % on condition that there are 1 low revered RFID reader and several USN nodes and that the minimum distance between a RFID reader and an USN node is greater than 1 m. Our results can be used as an basic research for coexistence analysis of RFID and USN systems in the $908.5{\sim}914MHz$ frequency bands.

• Korean Journal of Construction Engineering and Management
• /
• v.1 no.4 s.4
• /
• pp.74-81
• /
• 2000

The duration of construction in the construction works contains non-working days as well as working days. The duration is so relevant to climate that it should be calculated after fully considered about the regional climate in which construction processes. In most construction fields, however, there has been a frequent adjustment of duration because the field supervisor's experiences have decided non-working days indiscriminately without any accurate information about weather. Not only has that done great economic damages, but also caused many problems in interests among construction subject. So, in this study, we will analyse the elements of climate which has influences on the duration and implement the hypothetical weather simulation. By connecting the results of simulation with the duration of construction, we will propose the decision-making support model for the efficient calculation of duration when the field supervisor makes the projects schedule.

• Journal of the Korea Society for Simulation
• /
• v.17 no.3
• /
• pp.27-34
• /
• 2008

Wireless sensor networks are comprised of sensor nodes with resource-constrained hardware. Nodes in the sensor network without adequate protection may be compromised by adversaries. Such compromised nodes are vulnerable to the attacks like false reports injection attacks and false data injection attacks on legitimate reports. In false report injection attacks, an adversary injects false report into the network with the goal of deceiving the sink or the depletion of the finite amount of energy in a battery powered network. In false data injection attacks on legitimate reports, the attacker may inject a false data for every legitimate report. To address such attacks, the probabilistic voting-based filtering scheme (PVFS) has been proposed by Li and Wu. However, each cluster head in PVFS needs additional transmission device. Therefore, this paper proposes a fuzzy logic-based false report detection method (FRD) to mitigate the threat of these attacks. FRD employs the statistical en-route filtering scheme as a basis and improves upon it. We demonstrate that FRD is efficient with respect to the security it provides, and allows a tradeoff between security and energy consumption, as shown in the simulation.

• Journal of the Korea Society for Simulation
• /
• v.16 no.1
• /
• pp.1-9
• /
• 2007

The development of efficient Qualify of Service (QoS) routing algorithms in high speed networks is extremely difficult to achieve, because in order to operate, divergent services require various quality conditions. If the parameter of concern is to measure the delay on a specific link, the routing algorithm obtains the Least Delay (LD) path. Meanwhile, if the parameter is to measure the link cost, the Least Cost (LC) path is calculated. The Delay Constrained Least Cost (DCLC) path problem of the mixed issues on the LD and LC has been shown to be NP-hard. The path cost of LD path is relatively more expensive than that of the LC path, and the path delay of the LC path is relatively higher than that of the LD path in the DCLC problem. In this paper, we introduce the new factor for balancing cost and delay. The simulation result shows that our introduced factor is satisfied to solve the DCLC problem.