• 한국지구물리탐사학회:학술대회논문집
• /
• 2006.06a
• /
• pp.291-296
• /
• 2006

The aspect of wave propagation around cavity was investigated for the exact inversion of crosshole tomography data in order to understand the possibility of the existence of underground cavity. We found that the adequate frequency range for the tunnel investigation was about 2kHz to 5kHz, and the grid space was set up to 1/10 length of wavelength. The propagation of the seismic wave near the cavity may go through or detour the cavity according to the seismic velocity of inside of cavity. The detouring wave propagates with the seismic velocity of mother rock in spite of the velocity of inside of cavity. The smaller the velocity difference between the mother rock and cavity, the more frequent penetration of the seismic wave through the cavity was appeared.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.10 no.4 s.50
• /
• pp.1-13
• /
• 2006

Soil and rock dynamic properties such as shear wave velocity $(V_s)$, compressional wave velocity $(V_p)$ and corresponding Poisson's ratio (v) are very important geotechnical parameters in predicting deformational behavior of structures as well as practicing seismic design and performance evaluation. In an effort to measure the parameter efficiently and accurately, various bore-hole seismic testing techniques have been, thus, developed and used during past several decades. In this study, cross-hole seismic testing technique which is known as the most reliable seismic method was adopted for obtaining geotechnical dynamic properties. To perform successfully the cross-hole test for rock as well as soil layers regardless of the ground water level, spring-loaded source which impact laterally a subsurface ground in vertical bore-hole was developed and applied at three study areas, which contain four sites composed of two existing port sites and two new LNG storage facility sites. The geotechnical dynamic properties such as $V_s,\;V_p$ and v with depth from the soil surface to the engineering and seismic bedrock were efficiently determined from the laterally impacted cross-hole seismic tests at study sites, and were provided as the fundamental parameters for the seismic performance evaluation of the existing ports and the seismic design of the LNG storage facilities.

• Tunnel and Underground Space
• /
• v.21 no.2
• /
• pp.145-150
• /
• 2011

Variations of physical properties such as weight loss rate, wave velocity and uniaxial compressive strength after performing freeze-thaw cyclic test were measured in order to define weathering characteristics of sandstone and andesite. Weight change in specimens of the two rocks decreased with increasing the repetition number of freeze-thaw cyclic test. In particular, weight loss of andesite specimens was very irregular. P-wave velocity of sandstone specimens decreased more than 5%. On the other hand, P-wave velocity of andesite specimens do not vary up to 500 cycles and decreased more than 5% after 1000 cycles. This implies that the sandstone are easily weakened and loosened by weathering processes, while the andesite are relatively strong. In addition, the wave velocity changes of the andesite specimens coincident with the weight change. Uniaxial compressive strengths of the sandstone specimens slightly decreased at the early stage of the freezing-thawing cyclic test, then tended to be irregular after 64 cycles. In conclusion, the rock specimens showed smaller weight loss, less had lower strength reduction rate.

• Tunnel and Underground Space
• /
• v.21 no.6
• /
• pp.460-470
• /
• 2011

Wave velocity was measured to define the weathering characteristics of rock and the strength evaluation of weathered rock on a target of the Aso gravestones with various sizes under the natural environment. As a result, the size correction method which was changed sample of the different size to one of the same size for evaluating wave velocity was proposed, and also suggested the NET (Normalized Elapsed Time) as a new weathering index of rock. In addition, the strength of the weathered rock was estimated from the weathering classification of rock using the NET. Wave velocity of welded tuff was high and didn't show velocity degradation, on the other hand, one of andesite was low and showed velocity degradation. The degree of weathering between rocks of the different size is considered to be comparable, applying the NET based on the on the $V_p/V_o$-NET curve. Furthermore, the classification of rock weathering stages using the NET based on the $S_c/S_o$-NET curve was available, and the estimation of strength for the weathered rock was also possible.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.17 no.6
• /
• pp.1518-1528
• /
• 1993

The wake-induced vibration and proximity-induced vibration of two interfering circular cylinders in tandem are investigated experimentally, using an elastically supported cylinder and a fixed cylinder in uniform crossflow. Dynamic responses and flow periodicity in wake are measured to investigate the effect of system parameters on aerodynamic instability. The parameters include the free stream wind velocity and the position of two interfering circular cylinders. The oscillating behavior of the amplitude of the elastically supported cylinder is changed by varying the position, the relative gap spacing between two interfering circular cylinders and the reduced velocities. In small gap spacing between the elastically supported cylinder located to upstream and the circular cylinder fixed to downstream, the fluidelastic instability is founded. The vibration amplitude decreases notably as gap spacing between two interfering circular cylinders becomes large. The dynamic behavior at g/D-4.0 is similar to that of the single circular cylinder.

• The Korean Journal of Rheology
• /
• v.10 no.3
• /
• pp.173-183
• /
• 1998

본 연구에서는 Advanced Rheometric Expansion System(ARES)를 사용하여 대진폭 진동 전단 변형하에서 발생하는 폴리이소부틸렌(PIB) 농후 용액의 비선형 점탄성 거동을 저 장탄성율과 동적점도의 변형량 의존성 및 응력파형의 fast Fourier transform(FFT) 해석을 통해 고찰하였다. 스트레인 진촉을 단계적으로 증가시키면서 측정한 동적 점탄성으로 부터 저장탄성율 및 동적점도의 선형응답한계를 결정하고 이들에 미치는 각주파수의 영향을 조사 하였다. 그리고 응력파형의 Fourier 전개로부터 유도되는 비선형 점탄성함수를 사용하여 비 선형 거동을 설명하였다. 끝으로 비선형 점탄성 거동의 정도를 나타내는 비선형 거동 지수 를 정의하고 이들에 미치는 각주파수의 영향에 대해 검토하였다. 이상의 연구를 통해 얻어 진 결과를 요약하면 다음과 같다.(1) 선형 응답한계는 고분자 용액의 특성시간의 역수보다 높은 각주파수 범위에서는 일정한 값을 유지하지만 특성시간의 역수보다 낮은 각주파수 영 역에서는 각주파수가 감소할수록 증가한다. (2)선형응답한계 이상의 대변형하에서는 3차비선 형 점탄성 함수 이상의 고차항의 영향이 크게 작용하며 이로인해 비선형 거동이 발생된다. (3) 스트레인 진폭을 단계적으로 증가시키면서 측정한 저장탄성율 및 동적점도의 변형량 의 존성은 응력파형의 Fourier transform으로부터 유도된 1차 비선형 점탄성 함수의 변형량 의 존성을 나타낸다 (4) 저장탄성율 및 동적점도의 변형량 의존성으로부터 유도된 비선형 거동 지수는 탄성적 서질과 점성적 성질에 대한 비선형 특성을 평가하기 위한 유요한 방법으로 인정된다. (5) 비선형 점탄성 거동의 정도를 나탄는 비선형 거동지수는 특정한 각주파수에서 최대치를 가지며 또한 탄성적 거동이 점성적 거동에 비해 더욱 큰 각주파수 의존성을 나타낸다.

• International Journal of Highway Engineering
• /
• v.12 no.2
• /
• pp.115-121
• /
• 2010

To evaluate the engineering characteristics of aggregate base materials, cyclic triaxial, CBR and permeability tests were performed for 15 samples. The CBR values of aggregate base materials have wide range from 32 to 110(average 81) and the amount of swelling in submerged conditions has below 0.04mm. The Modulus of aggregate base materials were significantly affected by volumetric stress, linear volumetric model was best for fitting. The modulus of aggregate base materials were determined within range of 100MPa~600MPa, 80~270 and 0.1~0.6 for model coefficient $k_1$ and $k_2$ respectively. The empirical correlation model was suggested that prediction the modulus from the basic properties obtained from particle size distribution test and compaction test. The coefficient of determination of the proposed correlation model was 0.423 for model coefficient $k_1$, 0.920 for model coefficient $k_2$ and 0.872 for modulus with stress level.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.20 no.5
• /
• pp.232-236
• /
• 2010

Silicon carbide (SiC) ceramics are widely used in the application of high-temperature structural devices due to their light weight as well as superior hardness, fracture toughness, and temperature stability. In this paper, we employed classical molecular dynamics simulations using Tersoff's potential to investigate the elastic constants of the SiC crystal at high temperature. The stress-strain characteristics of the SiC crystal were calculated with the LAMMPS software and the elastic constants of the SiC crystal were analyzed. Based on the stress-strain analysis, the SiC crystal has shown the elastic deformation characteristics at the low temperature region. But the slight plastic deformation behavior was shown as applied the high strain over $1,000^{\circ}C$. Also the elastic constants of the SiC crystal were changed from about 475 GPa to 425 GPa as increased the temperature to $1,250^{\circ}C$.

• The Journal of the Acoustical Society of Korea
• /
• v.24 no.5
• /
• pp.282-293
• /
• 2005

Sonoelastography is an ultrasound-based technique that visualizes the elastic properties of soft tissues by measuring the tissue motion generated by an externally applied vibration. In this paper. the characteristics of wave generation in soft tissues due to an acoustic vibrator are studied. The effects of modal patterns on the detectability of lesions such as tumors in senoelastography are also investigated These are accomplished by analyzing the vibration patterns calculated using theoretical equations and finite element methods in halt space, infinite plate. and finite-sized tissue. A finite-width source generates shear waves with large amplitude Propagating in specific directions. and the generation characteristics depend both on the width and frequency of the vibrator. as well as the distance from it. It is shown in a finite-sized tissue that the lesion detection in displacement images is quit dependent on the modal patterns inside tissue. In contrast it Is also found that the lesion detectability in strain images is less dependent on the modal Patterns and is much better than that in displacement images.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.25 no.6
• /
• pp.95-102
• /
• 2021

Elastometic bearings using flexible rubber materials have recently been widely applied for seismic retrofit of bridges. However, due to various factors, the aging of the rubber material progresses, which causes the shear stiffness change of the bearing, which affects the seismic performance of the bridge. For natural rubber, accelerated heat aging test was performed with variables of heating temperatures and exposure time to analyze shear characteristics. As aging progresses (i.e. increase of temperature and exposure time), the maximum shear stress and shear strain decrease. Also, the shear stiffness is greatly increased at the same shear strain. This means that the rubber material is hardened, implying that the seismic performance of the elastomeric bearing becomes poor.