• The KIPS Transactions:PartC
• /
• v.16C no.5
• /
• pp.637-644
• /
• 2009

A study about performance analysis of synchronization clock using measured clock noises is required. Therefore this paper executed the study for performance analysis of synchronization clock and acquirement of maximum number of network node with various clock states using measured clock noises in NG-SDH networks. Also this paper generated a suitable clock model using measured clock noises, and carried out simulations with various clock states. Through the simulation results, maximum numbers were 80 or more network nodes in normal state, and were below 37 nodes in short-term phase transient(SPT) state, and were 50 or more in long-term phase transient(LPT) state. Accordingly this study showed that maximum numbers to meet ITU-T specification were below 37 network nodes in three clock states. Also this study showed that when SPT or LPT states occur from NE network before DOTS system, synchronization source must change with other stable synchronization source of normal state.

• The KIPS Transactions:PartC
• /
• v.13C no.3 s.106
• /
• pp.303-310
• /
• 2006

This paper is to execute a study for characteristic analysis of synchronization clock and maximum network node number with various clock states, normal, SPT, LPT, in NG-SDH networks. Through the simulations, maximum network node numbers showed from 42 to 38 nodes in normal state. In SPT state, maximum network node numbers, when the last NE network applied to only SPT state, presented from 19 to 4 nodes, much less than normal state. Node numbers to meet specification in case of occurrence of SPT state in all NE networks decreased greatly. In LPT state, all maximum node numbers, when the last NE network applied to only LPT state, presented more than 50 nodes, and the results in case of occurrence of LPT state in all NE networks were also identified. However, node numbers to meet specification in case of LPT state in all DOTS networks were few large with difference between LPT and normal or SPT state.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.6
• /
• pp.1242-1249
• /
• 2012

This paper proposes a metastability-free synchronization method and a mesochronous synchronizer for NoC. It uses the clock transmitted from TX as a strobe and solves the metastability problem by selecting one of rising or falling clock edge depending on the sampling value in RX when the phase difference between clocks is under a metastability window. The logic simulation results show that it works without metastability under $0^{\circ}{\sim}360^{\circ}$ phase difference in the synchronizer that a fault is inserted. The mesochronous synchronizer has a simple control logic and is suitable for NoC.

• The KIPS Transactions:PartC
• /
• v.8C no.3
• /
• pp.299-310
• /
• 2001

동기망과 동기식 전송망을 설계할 때에는 동기클럭의 단기안정 클럭특성과 이에 따른 망구성 노드수가 중요하게 고려되어야 할 사항이다. 또한 동기망과 전송망을 동시에 고려하여야 한다. 만일 전송망 만을 고려한다면 동기망에서의 발생할 수 있는 클럭성능 저하를 반영시킬 수 없기 때문이다. 지금까지의 연구는 주로 동기식 전송망만을 적용하여 연구되었다. 본 논문에서는 동기망과 동기식 전송망을 통합 고려하고, 최악의 원더생성을 적용하였을 때의 세가지 클럭상태에 따른 망동기클럭의 MTIE와 TDEV 특성을 얻었다. 또한 현 ITU-T 규격을 적용하여 세 가지 클럭상태에 따른 최대 망 구성 노드수를 구하였다.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2003.11b
• /
• pp.1085-1088
• /
• 2003

동기식 전송망에서는 다양한 동기클럭 성능과 상태가 나타날 수 있고, 이는 전송성능에 영향을 줄 수 있기 때문에 전송망 설계에 필요한 최대노드수의 변화가 생길 수 있다. 이에 따라 전송망에서 다양한 클럭성능과 상태를 적용할 수 있는 시뮬레이터가 요구된다. 따라서 본 논문에서는 전송망 동기클럭 시뮬레이터를 살펴보고, 또한 이를 이용하여 NE 노드에 따른 동기클럭 특성과 최대 노드수 결과를 얻었다. 본 연구 결과를 통해 볼 때 NE 노드의 성능보다 동기원의 성능이 최대 노드수에 미치는 영향이 크다는 것은 알 수 있었다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.9
• /
• pp.2062-2073
• /
• 1997

The important articles we must consider in SDH network and system design are the number of maximum nodes and clock characteristics of each node. In order to get these, the study of characteristics about some clock states, such as normal state and phase transient state, on the standard specifications is required. In this paper, we presented MTIE and TDEV characteristics with ITU-T & ANSI standard specifications in some clock states of the SDH linear networks, and proposed the number of maximum nodes satisfying above two standards. Also our resulsts are compared with AT&T's.

• The KIPS Transactions:PartC
• /
• v.11C no.1
• /
• pp.123-134
• /
• 2004

The synchronized clock performance in the synchronization network and SDH transmission network design is an important element in aspect of guaranteeing network stability and data transmission. Consequently the simulator which can applicable various parameters and several input levels from the best state to the worst state for performance analysis of the synchronized clock is required in case of network design. Therefore, in this paper, 1 developed the SNCA and TNCA for analysis of the synchronized clock in the synchronization network and transmission network. And utilizing these simulators with various wander generation, node number and clock state, 1 obtained the synchronized clock characteristics and maximum network nodes In NE1, NE2 and NE3 transmission network and DOTS1, DOTS2 synchronization network.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.10 no.10
• /
• pp.1123-1130
• /
• 2015

Network on a chip(NoC) is a communication subsystem between intellectual property(IP) cores in a SoC and improves high performance in the scalability and the power efficiency compared with conventional buses and crossbar switches. NoC needs a synchronizer to overcome the metastability problem between data links. This paper presents a new mesochronous synchronizer(MS) which is composed of selection window generator, selection signal generator, and data buffer. A delay line circuit is used to build selection window in selection window generator based on the delayed clock cycle of transmitted clock and the transmitted clock is compared with local clock to generate a selection signal in the SW(selection window). This MS gets rid of the restriction of metastability by choosing a rising edge or a falling edge of local clock according to the value of selection signal. The simulation results show that the proposed MS operates correctly for all phase differences between a transmitted clock and a local clock.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.6B
• /
• pp.305-315
• /
• 2007

In this paper, We generated a wander generation model from really measured clock noise data on the transmission node and DOTS in NG-SDH network. and then, We presented the performance of Synch. clock and maximum node level capable network configuration through the clock characteristics simulation on network having the steady-state clock.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.9 no.12
• /
• pp.1345-1352
• /
• 2014

Bus architecture of SoC has been replaced by NoC in recent years. Noc uses the multi-clock domains to transmit and receive data between neighbor network interfaces and they have same frequency, but a phase difference because of clock skew. So a synchronizer is used for a mesochronous frequency in interconnection between network interfaces. In this paper the metastability is defined and analyzed in a D latch and a D flip-flop to search the possibilities that data can be lost in the process of sending and receiving data between interconnects when a local frequency and a transmitted frequency have a phase difference. 180nm CMOS model parameter and 1GHz are used to simulate them in HSpice. The simulation results show that the metastability happens in a latch and a flip-flop when input data change near the clock edges and there are intermediate states for a longer time as input data change closer at the clock edge. And the next stage can lose input data depending on environmental conditions such as temperature, processing variations, power supply, etc. The simulation results are very useful to design a mescochronous synchronizer for NoC.