• Journal of radiological science and technology
• /
• v.46 no.4
• /
• pp.295-301
• /
• 2023

In addition to protocol adjustments during CT examinations, the height of the CT table can also affect image quality. Therefore, this study aimed to investigate the change in image quality depending on the height of the table in brain CT, which accounts for a large proportion of CT examinations, by measuring signal to contrast to noise ratio (CNR) and noise power spectrum (NPS) using the head phantom and evaluating them. The head phantom images were acquired using Philips Brilliance iCT 256. When the image was acquired, the table height was adjusted to 815, 865, 915, 965, 1015, and 1030 mm, respectively, and each scan was performed 3 times for each height. The CNR result showed the highest value at 965 mm, which is the height adjacent to the center of the head phantom. NPS showed the lowest NPS at 915 mm, the center of the head phantom in the low frequency region. From these results, it can be seen that the height of the table in CT examination is closely related to the image quality, and it can be seen the characteristics of image quality according to CT table through quantitative evaluation methods such as CNR and NPS.

• Journal of radiological science and technology
• /
• v.41 no.6
• /
• pp.533-538
• /
• 2018

As the use of digital radiographic system has been expanded, there are some concerns an increase about in patient of radiation dose. Therefore, International Electro-technical Commission (IEC) has been proposed a standard foe exposure index (EI). In this study, the EI was measured on human chest model using computed radiography (CR). Radiation quality used RQA5 of IEC62494-1. After acquiring the chest anterior posterior image (Chest AP) by using the phantom, the EI was obtained by applying the system response. In this study, we have analyzed the images with the detector size (Full filed ROI) and the optimized image (Fit filed ROI). The EI increased proportionally with radiation dose increase. Due to the discrete increase in pixel value, the EI showed an exponential increase. The discrete increase in noise equivalent quanta (NEQ) resulted in a discrete increase in the EI. The EI of the two images used in this study increased with increasing NEQ but showed different increments. For the measurement of the EI, IEC standards must be followed. The EI should be used as an index to evaluate the image quality for quality control of X-ray image rather than as an indicator of exposure dose. When calculating the EI, the system response should be applied depending on whether or not the grid is used. The size of the field should be obtained by including only the necessary parts.

• Proceedings of the KSLP Conference
• /
• 1995.11a
• /
• pp.181-184
• /
• 1995

일반적으로 의료상에서 방사선 사진 상으로부터 병소 부위를 찾아내어 질병의 유무 및 진단을 해왔으나 명확하지 못한 방사선 사진 자체의 문제점들과 사진 현상시의 문제점들로 인하여 진단의 혼란을 초월할 수 있다. 또한 오래 전부터 컴퓨터의 발달로 인하여 방사선 사진을 입력, 진단하려는 움직임도 있었으나 많은 노력에도 불구하고 입력시키려는 사진이 잡음이 많고 대비가 상당히 안 좋은 상태이므로, 이로 인한 해상도의 문제점으로 이를 기피하고 현상되어 나온 사진자체로 진단을 하려고 하였다. (중략)

• Journal of Veterinary Clinics
• /
• v.25 no.2
• /
• pp.96-101
• /
• 2008

This study was performed to quantify the pleural effusion in radiography, ultrasonography and computed tomography(CT) and to evaluate and compare the usefulness of these methods. Normal saline of 10 ml/kg was infused into the pleural space until a final loading volume of 60 ml/kg body weight was reached in six Beagle dogs. The radiographic examination was performed for the detection and quantification of pleural effusion. On the ultrasonographic study, the maximum perpendicular distance was measured between the surface of the lung and the thoracic wall to evaluate pleural effusion. On the CT image, pleural effusion was evaluated as the perpendicular distance to the thoracic surface in the maximum pleural effusion volume on any transverse images with soft tissue window. Statistical analysis was performed using linear regression test. The volume of pleural effusion and measurements of radiography and ultrasonography had no statistical relationship. However, a significant correlation was identified between the volume of pleural effusion and the depth at right ($r^2=0.715$), left ($r^2=0.745$), and mean right and left depth ($r^2=0.844$) on the CT images. All of the thoracic radiographs, ultrasonography, and CT are useful in recognition of pleural effusion. In quantification of pleural effusion, the CT measurement method is superior to radiographic and ultrasonographic measurements.

• The Academic Congress of Korean Shoulder and Elbow Society
• /
• 2009.03a
• /
• pp.23-24
• /
• 2009

• Proceedings of the Korean Nuclear Society Conference
• /
• 1997.05b
• /
• pp.365-372
• /
• 1997

이 연구의 목적은 밀도측정 및 수분함량측정용 RI 계기의 개발에 있다. 방사성동위원소를 이용하여 성토시공의 현장다짐 밀도 및 수분함량 측정에 이용되곤 있는 RI 계기는 중성자 검출부분, 감마선 검출부분, 고전압 공급부분, 마이크로 컴퓨터 부분으로 크게 나눌 수 있다. 감마선을 검출하는 G-M 검출기는 그 특징으로 인해 방사선검출 전기회로가 간단하다. 그러나 열중성자를 검출하는 He-3 검출기는 검출기에서 발생하는 신호원이 매우 작아서 검출회로의 상호 간섭으로 인한 전기적 잡음이 발생한다 이 잡음을 제거하는 것이 He-3 중성자 검출기로 열중성자를 검출하는데 중요한 문제이다. 본 연구에서 제작하는 RI 계기는 원자력법에서 제한하는 방사능 이하를 (100$\mu$Ci 의 밀봉선원) 사용하므로 종래의 RI 계기에 비해 방사선의 검출수가 줄어든다. 이에 따라 검출기의 개수를 늘려서 방사선을 검출해야 한다. 또한 본 연구에서는 He-3검출기의 검출 스펙트럼을 분석하여 적정한 방사선 검출 측정영역을 결정하였다.

• Radiation Oncology Journal
• /
• v.8 no.1
• /
• pp.111-114
• /
• 1990

External stereotaxic irradiation of intracranial lesions has recently gained its interest in the fields of not only radiation oncolgy but also neurosurgery. Its main goal is to deliver large doses to a relatively small target volume. Authors present methods of the stereotaxic radiosurgical irradiation using 6 MV linear accelerator (Nelac-6) and isodose distribution by therapeutic computer (Therac 2000). We attempt to demonstrate the dose distribution on verification films.

• Radiation Oncology Journal
• /
• v.13 no.4
• /
• pp.403-409
• /
• 1995

Purpose : Authors tried to enhance the safety and accuracy of radiosurgery by verifying stereotacitc target point in actual treatment position prior to irradiation. Materials and Methods : Before the actual treatment, several sections of anthropomorphic head phantom were used to create a condition of unknown coordinates of the target point. A film was sandwitched between the phantom sections and punctured by sharp needle tip. The tip of the needle represented the target point. The head phantom was fixed to the stereotactic ring and CT scan was done with CT localizer attached to the ring. After the CT scanning, the stereotactic coordinates of the target point were determined. The head phantom was secured to accelerator's treatment couch and the movement of laser isocenter to the stereotactic coordinates determined by CT scanning was performed using target positioner. Accelerator's anteroposterior and lateral portal films were taken using angiographic localizers. The stereotactic coordinates determined by analysis of portal films were compared with the stereotactic coordinates previously determined by CT scanning. Following the correction of discrepancy the head phantom was irradiated using a stereotactic technique of several arcs. After the irradiation, the film which was sandwitched between the phantom sections was developed and the degree of coincidence between the center of the radiation distribution with the target point represented by the hole in the film was measured. In the treatment of the actual patients, the way of determining the stereotactic coordinates with CT localizers and angiograuhic localizers was the same as the phantom study. After the correction of the discrepancy between two sets of coordinates, we proceeded to the irradiation of the actual patient. Results : In the phantom study, the agreement between the center of the radiation distribution and the localized target point was very good. By measuring optical density profiles of the sandwitched film along axes that intersected the target point, authors could confirm the discrepancy was 0.3 mm. In the treatment of an actual patient, the discrepancy between the stereotactic coordinates with CT localizers and angiographic localizers was 0.6 mm. Conclusion : By verifying stereotactic target point in actual treatment position prior to irradiation, the accuracy and safety of streotactic radiosurgery procedure were established.

• Journal of The Korean Radiological Technologist Association
• /
• v.29 no.1
• /
• pp.89-89
• /
• 2003

• Journal of Digital Convergence
• /
• v.11 no.8
• /
• pp.273-279
• /
• 2013

The purpose of the study was to present basic data to evaluation of the spatial resolution for exposure class(EC) in computed radiography(CR) by using the modulation transfer function(MTF). In this study, MTF was measured the edge method by using image plate(IP) of $100{\mu}mm$ pixels. A standard beam quality RQA5 based on an international electro-technical commission(IEC) standard was used to perform the X-ray imaging studies. Digital imaging began to set the sensitivity to EC 50, 100, 200, 300, 400, 600, 800, 1200 in X-ray irradiated to IP. The MTF 50% and 10% in the final images was analysis by using an authorized image analysis program the Origin 8.0 and the image J. As a results, the EC 200 was the best spatial resolution at MTF 50% ($1.979{\pm}0.114lp/mm$) and MTF 10% ($3.932{\pm}0.041$). Therefore, the EC 200 could be useful for the diagnosis of diseases that require high spatial resolution such as fractures.