• Korean Journal of Soil Science and Fertilizer
• /
• v.33 no.2
• /
• pp.71-78
• /
• 2000

Preferential flow has recently been the subject of increasing interest because these phenomena contribute to solute transport in soils. Commonly, preferential flow paths are associated with macropores or highly structured soils. We presented an analysis of the measured breakthrough curves (BTCs) of $Cl^-$ and $Cu^{2+}$ ions to test the occurrence of preferential flow in soils using miscible displacement technique under steady flow conditions. We also analyzed soil water retention curves and from this curves induced cumulative pore size distribution of undisturbed soils, which sampled from Ap1, B1, and C horizons of Songjeong series soils (the fine loamy, mesic family of Typic Hapludults). In this study, miscible displacement experiment on C horizon was excluded, because it is structureless sandy loam with saturated hydraulic conductivity of $5.2cmhr^{-1}$. The saturated hydraulic conductivity of Ap1 horizon was $2.0cmhr^{-1}$, which was about 7 times higher than that of B1 horizon ($0.27cm hr^{-1}$). Cumulative pore size distribution predicted that Ap1 horizon had more macropores (pore diameter larger than $49{\mu}m$, equivalent to -6 kpa of soil matric potential) than B1 horizon. The hydrodynamic dispersion coefficient from chloride BTCs was estimated as $1.3cm^2hr^{-1}$ for B1 and $34cm^2hr^{-1}$ for Ap1 horizon. However the retardation factors of B1 and Ap1 horizon were significantly different, i.e. 1 and 0.6, respectively, which means that there was distinct partition between mobile water and immobile phase in Ap1 horizon. The copper retardation effect of Ap1 horizon was less than that of B1 horizon, even though cation exchange capacity of Ap1 horizon was higher than that of B1 horizon. Thus, breakthrough curves of $Cl^-$ and $Cu^{2+}$ obviously showed the probability that preferential flow would occur in Ap1 horizon.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.1
• /
• pp.39-44
• /
• 2009

The advance of communication and networking technology enables high bandwidth multimedia data transmission. The development of high performance compression technology such as H.264 also encourages high quality video and audio data transmission. The trend requires efficient protection system for digital media rights. We propose an efficient digital media protection system using elliptic curve cryptography. Only key parameters are encrypted to reduce the burden of complex encryption and decryption in the proposed system, and the digital media are not played back or the quality is degraded if the encrypted information is missing. We need a playback system with an ECC processor to implement the proposed system. We implement an H.264 decoding system with a configurable ECC processor to verify the proposed protection system We verify that the H.264 movie is not decoded without the decrypted information.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.2 no.2
• /
• pp.104-111
• /
• 1990

The water level variation due to the Typhoon around the coast of Pusan in the southern sea of Korea is investigated from the observed tidal record. Water level variations at six stations along the coast are discussed in association with the meteorological data. The characteristics of storm surge at Pusan during Typhoon Thelma in 1987 is analysed using the observed data, and it is performed the numerical simulation of storm surge which includes a inverse barometric effect due to the horizontal distribution of sea sur-face pressure. From the calculation results, the peak value of storm surge in the coast of Pusan was occur-red around the 01：00 July 16th, which is well coincident with the observed water level variation at the Kadukdo. However, the calculated value at the Pusan TBM is inconsistent with the observed one, which is regarded due to a reason that the Tidal Bench Mark (TBM) locates in the channel. In the computation results, the maximum surge occurs at the coast of Nakdong estuary, which is considered primarily due to a topographic effect, and water level variation exceeded 2.5 meter in these areas while only about 60 cm in another coasts.

• Korean Journal of Environment and Ecology
• /
• v.6 no.2
• /
• pp.162-167
• /
• 1993

A mixed deciduous forest community in Mt. Sobaek was studied to determine the adequate number of plots of tree stratum for investigating forest community structure. Twenty l0m $\times$ l0m plots were set up iii the studied forest community, and species area curve. performance curve and statistical method were carried out. According to species-area curve, the minimal number of plots where a given percentage increase in number of plots produced less than the same percentage increase in number of species was eight. The minimal number of plots where a given percentage increase in number of plots produced less than the half of the percentage increase in number of plots was eleven. According to performance curve by importance value of the major species, the minimal number of plots where the dominant species was distinguished from the subdominant species was five. The minimal number of plots where the subdominant species was distinguished from each other was ten. Therefore, ten l0m $\times$ l0m plots seems to give an adequate sample for investigating structure of the studied forest community. Similarity index between the ten plots and total twenty plots was above 90%, and 95% confidence interval of species diversity of the ten plots was $\pm$ 0.073.

• Ecology and Resilient Infrastructure
• /
• v.7 no.1
• /
• pp.53-62
• /
• 2020

The present study aimed to investigate the impact of the restoration of the restoration technique on fish habitat using a physical habitat simulation in the Wonju-cheon Stream, Korea. The target species were Pungtungia herzi, Zacco platypus, and Zacco Koreanus, a dominant and sub-dominant species in the Wonju-cheon Stream. The River2D model was used for the computation of the flow and the habitat suitability index model was used to estimate the quality and quantity of habitat using habitat suitability curve. To assess the impact of pool-riffle sequence on change of fish habitat, this present study conducted using the each representative distance, namely, 50 m, 100 m, 200 m, and 300 m. Simulation results indicated that the pool-reffle sequence significantly increased the habitats for the target species than the result without considering pool-riffle sequence. On average, 53% of the Weighted Usable Area (WUA) increased due to pool-riffle sequence in the study area.

• Korean Journal of Environment and Ecology
• /
• v.16 no.3
• /
• pp.239-248
• /
• 2002

This study was conducted to investigate the hydrological characteristics of groundwater level change and rainfall-runoff processes at the Moojechi Bog located in Mt. Jeungjok, Ulsan. The average runoff rate of bog was 0.58 which is similar to that of general mountainous watershed. In the short term hydrograph, runoff was increased slowly and It took a long time to arrive peak flow. After that time, the decreasing pattern of runoff was slower than that of general mountainous watershed. In case of the long term water budget, the Moojechi Bog had a abundant base flow and runoff was continued in spite of non rainfall period. The groundwater level was arrived peak flow immediately after rain stop but was decreased very slowly until the next rain. The change pattern of long term groundwater level was very similar to that of the amount of rain and discharge. The higher rainfall intensity was, the lower slope of recession curve on the groundwater level was and the longer rainfall duration was, the longer peak flow was. Judging from these results, Moojechi bog could be evaluated to have a constant groundwater level.

• Korean Journal of Environment and Ecology
• /
• v.9 no.2
• /
• pp.197-201
• /
• 1996

A mixed forest community of Abies holophylla and broad-leaved trees in Odaesan National Park was studied to determine the adequate number of plots of shrub stratum for investigating forest community structure. Thirty 5m*5m plots were set up in the shrub stratum, and species-area curve and performance curve were made out. The minimum number of plots where a given percentage increase in number of plots produce in number of plots produced less than the same percentage increase in number of species was six. The minimum number of plots where a given percentage increase in number of plots produced less than the half of the percentage increase in number of plots was eleven. The minimum number of plots where the dominant species was distinguished from the subdominant species was five. The minimum numver of plots where the first subdominant species was distinguished from other subdominant species was ten. The diffrence of species diversity(H') between five or more plots and total thirty plots was less than 0.05. Similarity index was more than 70% between five or more plots and total thirty plots, and more than 80% between ten or more plots and total thirty plots. The conclusion is that the adequate number of 5m*5m plots for the shrub stratum was about 5 in general case and about 10 in case of requiring more accuracy.

• Korean Journal of Environment and Ecology
• /
• v.8 no.2
• /
• pp.150-153
• /
• 1995

A Pinus densiflora forest in Chuwangsan was studied to determine the adequate plot area of shrub stratum for investigating forest community structure. Nineteen nested plots were set up in the studied forest, and species-area curve and performance curve were established. According to species-area curve, the minimum plot area where a given percentage increase in plot area produced less than the same percentage increase in number of species was 900$m^2$. The minimum plot area where a given percentage increase in plot area produced less than the half of the percent-age increase in number of species was 1,500$m^2$. According to performance curve of the importance values of the major species, the minimum plot area where the importance value of the major species was distinguished from each other was 1,400$m^2$. According to performance curve of species diversity, the minimum plot area was 750-1,500$m^2$. Similarity indices between plot area above 900$m^2$ and total plot area were more than 90% and similarity indices between plot area above 625$m^2$ and total plot area were more than 85%. It may be given as a conclusion that minimum plot area was about 1,500$m^2$ in case of requiring more accuracy.

• Korean Journal of Environment and Ecology
• /
• v.7 no.2
• /
• pp.187-191
• /
• 1994

A mixed forest community in Tokyusan was studied to determine the adequate plot area of tree stratum for investigating forest community structure. Nineteen nested plots were set up in the studied forest community, and species-area curve and performance curve were established. According to species-area curve, the minimum plot area where a given percentage increase in plot area produced less than the same percentage increase in number of species was 500$m^2$. The minimum plot area where a given percentage increase in plot area produced less than the half of the percentage increase in number of species was 1,000$m^2$. According to performance curve of the importance values of the major species, the minimum plot area where the importance value of the major species was distinguished from each other was 900$m^2$, and the minimum plot area was 500$m^2$ except for a big tree of Pinus densiflora distributed unexpectedly. According to performance curve of species diversity, the minimum plot area was 400$m^2$. Similarity indices between plot area above 900$m^2$ and total plot area were more than 90% and similarity indices between plot area above 400$m^2$ and total plot area were more than 85%. It may be as a conclusion that minimum plot area was generally about 500$m^2$ and in case of requiring more accuracy, minimum plot area was about 1,000$m^2$.

• Korean Chemical Engineering Research
• /
• v.47 no.4
• /
• pp.395-402
• /
• 2009

The atomic force microscopy(AFM) has been used, as a powerful tool, to investigate physical properties of supported-lipid layers. Prior to the advent of the AFM, no observation was performed for the physical phenomena at the nanometer-scale. This microscope provides nanometer-scale morphology by scanning surfaces with the cantilever and presents force curve by monitoring the behavior of the cantilever that approaches to surface and retracts from the surface. From the morphology, the structures of the supported lipid layer and the effect of other molecules on the structures have been investigated. From the force curve, the surface properties-electrostatic and mechanical properties-of the supported lipid layers have been studied. In this article, characterization of the structure and surface properties of the supported lipid layer is explained. Future perspectives and direction are also discussed.