• Applied Chemistry for Engineering
• /
• v.8 no.6
• /
• pp.967-972
• /
• 1997

Recovery of aromatics in extract phase which was obtained by batch equilibrium extraction between light cycle oil(LCO) and dimethylsulfoxide(DMSO) solution as solvent was investigated by re-extraction. To select the most suitable re-extraction solvent for recovery of aromatics in extract phase, distribution equilibrium was measured between extract phase and solvents. The solvents used were benzene(B), toluene(T), m-Xylene(mX), n-hexane(Hx) and n-hexane(Hx) and n-Octane(Ot). From the distribution coefficients and yields of aromatics, Hx seemed to be the most suitable. Furthermore, effects of operation parameters for re-extraction of aromatics in the extract phase were studied by batch equilibrium re-extracion with Hx as solvent. Yields of aromatics were found to increase with increasing solvent/feed (extract phase) mass ratio(S/F), while distribution coefficients of aromatics were fixed irrespective of S/F used. Operating temperature did not affect distribution coefficients and yields of aromatics. Distibution coefficients and yields of naphthalene group(carbon numer : 10~12) increased with increasing cabon number. Mass transfer rates of aromatics were also measured with a batch stirred vessel.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.26 no.5A
• /
• pp.849-859
• /
• 2006

This paper presents an extensive robust analysis of a ${\mu}$-controller in the hybrid system for various uncertainties using the benchmark cable-stayed bridge. The overall system robustness may be deteriorated by introducing active devices and the active controller may cause instability due to small margins. Therefore, a ${\mu}$-synthesis method that simultaneously guarantees the performance and stability of the closed-loop system (robust performance) with uncertainties is used for active devices to enhance the robustness in company with the inherent reliability of passive devices. The robustness of the ${\mu}$-synthesis method is investigated with respect to the additional mass on the deck, structural stiffness matrix perturbation, time delay of actuator, and combinations thereof. Numerical simulation results show that the proposed control system has the good robustness without loss of control performances with respect to various uncertainties under earthquakes considered in this study. Furthermore, the control system robustness is more affected by the perturbation of structural stiffness matrix than others considered in this study. Therefore, the hybrid system controlled by a ${\mu}$-synthesis method could be proposed as an improved control strategy for a seismically excited cable-stayed bridge containing many uncertainties.

• Tuberculosis and Respiratory Diseases
• /
• v.61 no.4
• /
• pp.330-338
• /
• 2006

Background: The main factors associated with weight loss in patients with COPD are not well known. Since chronic inflammation and oxidative stress play a major pathogenic role in COPD, these factors may be responsible for the patients' weight loss. Therefore, this study measured the body mass index (BMI) in COPD patients and evaluated the variables, such as systemic inflammatory marker, oxidative stress and lung function, that correlate with the BMI. Method: The stable COPD patients (M:F=49:4, mean age=$68.25{\pm}6.32$) were divided into the lower (<18.5), normal (18.5-25) and higher (>25) BMI group. The severity of the airway obstruction was evaluated by measuring the $FEV_1$. The serum IL-6 and TNF-$\alpha$ levels were measured to determine the degree of systemic inflammation, and the carbonyl protein and 8-iso-prostaglandin $F_2{\alpha}$ level was measured to determine the level of oxidative stress. Each value in the COPD patients and normal control was compared with the BMI. Results: 1) Serum 8-iso-prostaglandin $F_2{\alpha}$ in COPD patients was significantly higher ($456.08{\pm}574.12pg/ml$) than that in normal control ($264.74{\pm}143.15pg/ml$) (p<0.05). However, there were no significant differences in the serum IL-6, TNF-$\alpha$, carbonyl protein between the COPD patients and normal controls. 2). In the COPD patients, the $FEV_1$ of the lower BMI group was significantly lower ($0.93{\pm}0.25L$) than that of the normal BMI ($1.34{\pm}0.52L$) and higher BMI groups ($1.72{\pm}0.41L$) (p<0.05). The lower $FEV_1$ was significantly associated with a lower BMI in COPD patients (p=0.002, r=0.42). The BMI of very severe COPD patients was significantly lower ($19.8{\pm}2.57$) than that of the patients with moderate COPD ($22.6{\pm}3.14$) (p<0.05). 3). There were no significant differences in the serum IL-6, TNF-$\alpha$, carbonyl protein and 8-iso-prostaglandin $F_2{\alpha}$ according to the BMI in the COPD patients. Conclusion: The severity of the airway obstruction, not the systemic inflammatory markers and oxidative stress, might be associated with the BMI in stable COPD patients. Further study will be needed to determine the factors associated with the decrease in the BMI of COPD patients.

• Journal of the Korea Concrete Institute
• /
• v.20 no.3
• /
• pp.375-381
• /
• 2008

Various problems such as durability degradation may happen when extra water is added to concrete. Because of these reasons, the change of water content is managed by using rapid evaluation method of unit water content such as electric capacity method, heat drying method making use of micro wave, unit capacity mass method among various methods. Especially, in Japan, guidance for the change of water content ($\pm$ 10, 15, 20 kg/$m^3$ etc.) were regulated and used. However, it is the real situation that the guidance which were regulated in South Korea evaluate suitability only considering production and measurement error under the circumstances which are not considering the degree of durability degradation. Therefore, this study tries to investigate the influence of addition of extra water in the concrete on the durability degradation of concrete when it was added by artificial manipulation or by management error. From the test results, a guideline of the contents of extra water for the quality control is suggested with the consideration of the degree of durability degradation and the probable error resulted from the addition of extra water. The contents of extra water for tests are set as 0, 15, 25, 35 kg/$m^3$. To examine the durability degradation of concrete, freezing and thawing, carbonation, chloride penetration and compressive strength are tested.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.36 no.7
• /
• pp.789-796
• /
• 2012

Radiated noise analysis from a ship structure is a challenging topic owing to difficulties in the accurate calculation of the fluid-structure interaction as well as owing to a massive degree of freedom of the problem. To reduce the severity of the problem, a new fluid-structure interaction formulation is proposed in this paper. The complex frequency-dependent added mass and damping matrices are calculated using the high-order Burton-Miller boundary integral equation formulation to obtain accurate values over all frequency bands. The calculated fluid-structure interaction effects are added to the structural matrices calculated by commercial finite element software, MSC/NASTRAN. Then, the impedance and underwater radiation noise due to an excitation of structure are calculated. The present formulation is applied to a ship to calculate the underwater radiated noise.

• Journal of the Society of Naval Architects of Korea
• /
• v.33 no.4
• /
• pp.22-31
• /
• 1996

An efficient calculation method of pressure acting on a bluff body is developed. The method is applied to assess the containment capability of an oil fence, considering skirt deformation in current. The pressure on the frontal side of the oil fence is determined by analyzing the potential flow, substituting the wake region as a rigid body which has its boundary at the closed separation streamlines. The pressure at the downstream side of the fence, the so called base pressure, is obtained from the existing experimental results. To verify the calculation method, pressure drag of some bluff bodies in an infinite-fluid medium is calculated, which shows good agreement with the experimental results. The deformed shape of the oil fence is obtained by solving, iteratively, the coupled equations governing the flow field and the deformation of the oil fence, respectively. The deformed shape and the decrease of draft of oil fences with different ballast mass in various current conditions are investigated.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.31 no.5
• /
• pp.215-226
• /
• 2018

In this paper, to estimate the dynamic behavior of a submerged floating tunnel(SFT) by underwater explosion(UE), the SFT is modeled and analyzed by the explicit structural analysis package LS-DYNA. The section of SFT near to explosion point is modeled to shell and solid elements using elasto-plasticity material model for concrete tubular section and steel lining. And the other parts of the SFT are modeled to elastic beam elements. Also, mooring lines are modeled as tension-only cable elements. Total mass of SFT is including an added mass by hydrodynamic effect. The buoyancy on the SFT is considered in its initial condition using a dynamic relaxation method. The accuracy and the feasibility of the analysis model aree verified by the results of series of free field analysis for UE. And buoyancy ratio(B/W) of SFT, the distance between SFT and an explosion point and the arrangement of mooring line aree considered as main parameters of the explosion analysis. As results of the explosion analysis, the dynamic responses such as the dent deformation by the shock pressure are responded less as more distance between SFT and an explosion point. However, the mooring angle of the diagonal mooring system can not affect the responses such as the horizontal displacement of SFT by the shock pressure.

• Clean Technology
• /
• v.25 no.1
• /
• pp.63-73
• /
• 2019

Numerical analysis was done to evaluate the chemical reaction and the reduction rate inside of selective non-catalytic reduction to denitrification in combustion process. The $NO_X$ reduction in selective non-catalytic reduction is converted to not only nitrogen but also nitrous oxide. Simultaneous $NO_X$ reduction and nitrous oxide generation suppressing is required in selective non-catalytic reduction because nitrous oxide influences the global warming as a greenhouse gas. The current study was performed compare the computational analysis in the same temperature and amount of NaOH, and in comparison with the previous research experiments and confirmed the reliability of the computational fluid dynamics. Additionally, controlling the addition amount of NaOH to predict the $NO_X$ reduction efficiency and nitrous oxide production. Numerical analysis was done to check the mass fraction of each material in the measurement point at the end of selective non-catalytic reduction. Experimental Value and simulation value by numerical analysis showed an error of up to 18.9% was confirmed that a generally well predicted. and it was confirmed that the widened temperature range of more than 70% $NO_X$ removal rate is increased when the addition amount of NaOH. So, large and frequent changes of the reaction temperature waste incineration facilities are expected to be effective.

• The Korean Journal of Pesticide Science
• /
• v.20 no.4
• /
• pp.300-304
• /
• 2016

The aim of this study were to evaluate the exposure level of pyrethroid pesticide according to spraying machine type. The urinary metabolites of pyrethroid pesticide in apple farmers were analyzed to determine the exposure level of pyrethroid pesticide. The result shows that, the spraying volume was greater in SS sprayer group than in power sprayer group. But multi variate analysis which adjust spraying volume and field area, there were no difference of urinary metabolites between two sprayer machine. To make more accurate model of pesticide exposure, the factors influencing pesticide exposure should be determined and further study should be done.

• Journal of Korean Ophthalmic Optics Society
• /
• v.4 no.2
• /
• pp.1-16
• /
• 1999

Differential equations and its numerical solution program using Turbo-C were formulated to describe the radical distribution and average displacement amplitude of vibrating dehydrated contact lens(HEMA) driven by sinusoidal or rectangular pressure. The natural resonant frequency of the lens diaphram(thickness 0.08mm, diameter 14mm, curvature radius 8mm) was measured to be 5730 Hz from the extrapolation of frequency vs addedmass to the diaphram curve. The Young's modulus of the lens was measured to be $4{\times}10^9$ Pa with altering the original shape. The effect of parameters such as thickness, effective radius, damping coeff., amplitude of driving pressure on the vibration characteristics was illustrated by the computer simulation of the derived program. When the frequency of driving pressure coincides with the integral multiple of fundamental resonance frequency of the lens the wave pattern changes from arc to bell-shape along the radial position of the diaphram. If this happens to the contact lens on the cornea in vivo, it might create the feel of pull of the lens due to the increased rise of central part of the lens.