• Geophysics and Geophysical Exploration
• /
• v.10 no.1
• /
• pp.29-36
• /
• 2007

Recent seismic surveys have shown that the presence of methane hydrate (MH) in sediments has significant influence on seismic attenuation. I have used vertical seismic profile (VSP) data from a Nankai Trough exploratory well, offshore Tokai in central Japan, to estimate compressional attenuation in MH-bearing sediments at seismic frequencies of 30-110 Hz. The use of two different measurement methods (spectral ratio and centroid frequency shift methods) provides an opportunity to validate the attenuation measurements. The sensitivity of attenuation analyses to different depth intervals, borehole irregularities, and different frequency ranges was also examined to validate the stability of attenuation estimation. I found no significant compressional attenuation in MH-bearing sediments at seismic frequencies. Macroscopically, the peaks of highest attenuation in the seismic frequency range correspond to low-saturation gas zones. In contrast, high compressional attenuation zones in the sonic frequency range (10-20 kHz) are associated with the presence of methane hydrates at the same well locations. Thus, this study demonstrated the frequency-dependence of attenuation in MH-bearing sediments; MH-bearing sediments cause attenuation in the sonic frequency range rather than the seismic frequency range As a possible reason why seismic frequencies in the 30-110 Hz range were not affected in MH-bearing sediments, I point out the effect of thin layering of MH-bearing zones.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.11
• /
• pp.95-101
• /
• 2008

We have used diversely the multilayer ceramic oscillator of the SMD(Surface Mounted Device) package technology that connects the crystal with the chip package. Such an oscillator occurs a stray inductance and a parasitic capacitance by the length and inner pattern. And it has been happened an amplitude attenuation and signal loss due to the reflection of power source and noise component. So we don't evaluate the precise performance of the oscillator for these factors. In this paper we have developed the Jig system to evaluate the performance of the oscillator. Through this system, we will expect an advanced performance of the oscillator and redesign an oscillator of the low jitter characteristics and low phase noise.

• Journal of the Institute of Convergence Signal Processing
• /
• v.5 no.1
• /
• pp.1-5
• /
• 2004

A new method for the estimation of pitch-frequency contour of voiced speech is presented. The method is based on the double application of Kaiser's energy operator［1］, which has the capabilities of extracting amplitude and frequency of a sinusoidal waveform. According to the modulation model, a vowel can be represented by a combination of damped sinusoids representing formants, modulated by pitch pulses. Therefore, the amplitude envelope of each of the components will give a pitch-like waveform and the pitch can be obtained by averaging the frequencies of this waveform. The first part is the same as Gopalan's approach［9］, but by substituting the LPC based spectral analysis with the second application of energy operator, the algorithm becomes very simple and can be processed on-line. Although the estimation is rather coarse, the suggested algorithm can be useful for getting a general sketch of pitch contour on-line.

• Plant Journal
• /
• v.11 no.2
• /
• pp.39-44
• /
• 2015

According to a research that is based on a previous study, But in a different way, This study shows fault diagnosis of Induction motor bearing which runs in coal-fired power plant industries on Desulfurization absorber agitator using Spectrum analysis of Stator Current and visual inspection. As a result of harmonic content analysis of stator current spectrum, It was possible to detect ball and outer race fault frequency. The comparison in the context of this experiment proves that the amplitude of faulty frequency is increased in three times at a fault in ball and in outer race. Spectrum analysis of stator current can be used to detect the presence of a fault condition as well as experiment in faulty bearings, besides early fault detection in bearings can prevent unexpected power generation loss and emergency maintenance cost.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.30 no.3B
• /
• pp.315-324
• /
• 2010

We developed a design chart for very large floating structures through intensive hydroelastic analysis. Using this chart, one can predict the hydroelastic response of very large floating structures preliminarily at design stage without the cost-demanding hydroelastic analysis. This paper presents two new design charts based on the theory of VLFS. The purpose of the first design chart is to determine RAOs of the maximum longitudinal stress of VLFS considering properties of waves and structures. The design chart I can be applied to any sizes of VLFS in same aspect ratios and dimensionless stiffness parameters. The second design chart is developed to take into account the actual wave condition by using the Bretschneider spectrum with Beaufort sea state.

• The Journal of the Acoustical Society of Korea
• /
• v.29 no.1
• /
• pp.69-75
• /
• 2010

In this paper, the pitch is detected after the elimination of formant ingredients by flattening the spectrum in frequency domain. In order to remove impact of formant and transition frequency in the signal spectrum, formant envelop is made by linear interpolation with any points each sub-band and the spectrum of speech signal is compensated by the reverse of the envelop interpolated linearly after we divide frequency band into several segment based on LSP and detect the points. The experimental result showed the proposed method appeared an outstanding performance in compared with LPC, Cepstrum, Lifter methods. The method reduced the gross error rate 1.30% than the LPC method which appeared a good performance except the proposed method. Also, the proposed method showed low error rate in noise environment.

• Korean Journal of Optics and Photonics
• /
• v.19 no.1
• /
• pp.54-59
• /
• 2008

We report on the measurements of absorption spectra from acetylene ($^{12}C_2H_2$) and hydrogen cyanide ($H^{13}C^{14}N$) for wavelength reference in the C-band (conventional band) region using a supercontinuum optical source generated from a mode-locked $Cr^{4+}$:YAG laser. The center wavelength of the mode-locked $Cr^{4+}$:YAG laser was 1510 nm and the pulse duration was 75 fs at 100 MHz repetition rate. The supercontinuum source achieved a flatness of ${\pm}5dB$ over a wavelength range of more than 400 nm, using a 20 m long photonic crystal fiber. The measured absorption spectra from acetylene ($^{12}C_2H_2$) and hydrogen cyanide ($H^{13}C^{14}N$) had more than 50 lines and were analyzed for wavelength standardization.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.33 no.2
• /
• pp.585-594
• /
• 2013

In this study, laboratory experiments and numerical simulations were conducted to test the performance of resonance power buoy system proposed by Kweon et al.(2010). The system is composed of a linear generator and a mooring buoy. The mover of the linear generator mainly has heave motion driven by vertical oscillation of the buoy. In this system, the velocity discrepancy between the mover and the buoy makes electricity. However, ocean wave energy as a natural resource around Korean peninsula is comparatively small and the driving force for producing electricity is not enough for commercialization. Therefore, it is necessary that the buoy motion be amplified by using resonance characteristics. In order to verify the resonance effects on the test power buoy, the experimental investigations were conducted in the large wave flume (length of 110 m, width of 8 m, maximum depth of 6 m) equipped with regular and random plunger wave generator. The resonance draft of test power buoy is designed for the corresponding period of incident wave, 1.96 sec. Regular wave test results show that the heave response amplitude operator(RAO) by a test buoy has the amplification of 5.66 times higher compared to the wave amplitude at the resonance period. Test results of random waves show that the buoy has the largest spectrum area of 20.73 times higher at the point of not the resonance period but the shorter one of 1.85 sec. Therefore this study suggests the resonance power buoy for wave power generation for commercial application in the case of the coastal and oceanic area with smaller wave energy.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.21 no.4
• /
• pp.317-322
• /
• 2003

This paper have calculated a relative heights of an each station using the data which were observed by GPS permanent stations(Chejudo, Homigoj, Jumunjin, Marado, Palmido, Ulengdo, Youndo) established in Korea. We performed spectrum analysis with a calculated relative heights by CLEAN algorithm. Through these process, we estimated vertical displacement of earth surface by semi-dinural ocean tidal loading components, and compared them with the results which were calculated by improving ocean tide model(NA099jb) for adjacent seas around Japan and Korea. As the result of this study, we determined the ocean tidal loading components with loading effects of $M_2$ and $N_2$, and we noted that the amplitude and the phase lags of ocean tidal loading components from observed GPS data were almost equal to values calculated from ocean tide models. However, the loading components about semi-diurnal tide $S_2$, $K_2$ couldn't estimate because of periods. Also, the diurnal ocean tide loading components were not considered, because the noise level have increased during the diurnal frequency.

• 한국해양학회지
• /
• v.27 no.3
• /
• pp.228-236
• /
• 1992

Internal temperature oscillations of tidal periods were studied using data observed by a thermistor chain in summer of 1980 off Jukbyun on the mid-east coast of korea. The vertical stratification was well established during the observation period. The spectral energy was found to be predominant in the semidiurnal tidal band and its energy increased with depth with maximum near the bottom. The coherence in the semidiurnal band between different depths is high with a small phase difference. The results suggest the existence of the internal tide of semidiurnal period. The amplitude of internal tide was of the order of 10 m and the largest just before the disappearance of the internal tide signal.