• Journal of Korean Tunnelling and Underground Space Association
• /
• v.23 no.6
• /
• pp.403-421
• /
• 2021

Most of the urban tunnels in Korea, which are represented by the 1st to 3rd subways, use the drainage tunnel by NATM. Recently, when a construction project that actively utilizes large-scale urban space is promoted, negative effects that do not conform to the existing empirical rules of urban tunnels may occur. In particular, there is a high possibility that groundwater fluctuations and hydrodynamic behavior will occur owing to the practice of tunnel technology in Korea, which has mainly applied the drainage tunnel. In order to solve the problem of the drainage tunnel, attempts are being made to control groundwater fluctuations. For this, the establishment of tunnel groundwater management standard concept and the analysis of the tunnel hydraulic behavior were performed. To prevent the problem of groundwater fluctuations caused by the construction of large-scale tunnels in urban areas, it was suggested that the conceptual transformation of the empirical technical practice, which is applied only in the underground safety impact assessment stage, to the direction of controlling the inflow in the tunnel, is required. And the relationship between the groundwater level and the inflow of the tunnel required for setting the allowable inflow when planning the tunnel was derived. The introduction of a tunnel groundwater management concept is expected to help solve problems such as groundwater fluctuations, ground settlement, depletion of groundwater resources, and decline of maintenance performance in various urban deep tunnel construction projects to be promoted in the future.

• Tunnel and Underground Space
• /
• v.21 no.5
• /
• pp.370-376
• /
• 2011

To design the drainage system of a mine, it is very important to evaluate the groundwater inflow to the mine workings. In this study, continuous steady state flow through rock mass around mine openings developed in Sungok area of Gagok Mine was analyzed. Saturated only model and Saturated/unsaturated model were used as material models of rock mass. Groundwater quantities flowing into Sungok 160 level which is 1216 m long are computed as 1450 $m^3$/day in case of a saturated model and as 1071 $m^3$/day in case of a saturated/unsaturated model. An effect that hydraulic conductivity has on inflow turned out be greater than precipitation and inflow increased linearly with increase of hydraulic conductivity. It was found that change of hydraulic conductivity ratio and orientation have an impact on the variation of inflow and water table.

• Journal of the Korean Society of Groundwater Environment
• /
• v.5 no.3
• /
• pp.141-147
• /
• 1998

This study was initiated to identify the general groundwater quality and the effects of heavy-metal enrichments in the black shales and coal materials in Dukpyung area. Groundwater quality could be divided into three groups based on the major weathering processes in the groundwater system; Group I of carbonate weathering, Group II of silicate weathering with the probable effects of acidic mine drainage, and Group III of silicate weathering with relatively high concentrations of chloride components in anions. Metal contamination of groundwater was not observed. Locally, however, acidic mine drainage appeared to be produced and recharged into the groundwater system. In addition, contamination by NO$_3$-N ranged 2 to 3 times higher than the drinking water standards, probably due to infiltration of domestic sewage and/or fertilizers into the shallow aquifer.

• Tunnel and Underground Space
• /
• v.13 no.6
• /
• pp.465-475
• /
• 2003

Groundwater inflow into the caverns constructed in fractured rock mass was simulated by numerical modeling, NAPSAC (DFN, discrete fracture network model) and NAMMU (CPM, continuous porous media model), a finite-element software package for groundwater flow in 3D fractured media developed by AEA Technology, UK. The input parameters for modeling were determined on surface fracture survey, core logging and single hole hydraulic test data. In order to predict the groundwater inflow more accurately, the anisotropic hydraulic conductivity was considered. The anisotropic hydraulic conductivities were calculated from the fracture network properties. With a minor adjustment during model calibration, the numerical modeling is able to reproduce reasonably groundwater inflows into cavern and the travel length and times to the ground surface along the flow paths in the normal, dry and rainy seasons.

• Tunnel and Underground Space
• /
• v.8 no.4
• /
• pp.275-286
• /
• 1998

The effective permeability and the representative element volume(REV) of fracture network model were evaluated based on the parameters such as permeability tensor, principal permeability and the direction of principal permeability. The effective permeability ranges between the harmonic mean and the arithmetic mean of the local permeabilities of subdivided blocks. From the numerical experiments, which were for investigating the influence of model volume on the variation of flux for the cubic models, it was found that the variation of flux became reduced as the model volume approached REV. The variation of groundwater flux into the tunnel in the fracture network model was mainly dependent on the ratio of the tunnel length to model size rather than REV. And it was found that groundwater flux into the tunnel was not completely consistent between the fracture network model and the equivalent porous media model, especially when the ratio of the tunnel length to model size is small.

• The Journal of Engineering Geology
• /
• v.23 no.3
• /
• pp.227-234
• /
• 2013

The vertical shaft of a selective intake structure, which is constructed in a large reservoir, is required to be impermeable and to employ a grouting technology to prevent water inflow from the reservoir or surrounding ground. In this study, groundwater inflow is estimated using a numerical model for two cases (i.e., grouting or non-grouting cases at the exterior of a vertical shaft) and compared with data measured during an excavation at the construction site of a selective intake structure in the Soyang reservoir, Korea. Groundwater inflow is estimated to range from 444 to 754 $m^3/d$ in the case of non-grouting and from 58 to 95 $m^3/d$ in the case of grouting. The groundwater inflow measured in a vertical shaft, which ranges from 30 to 100 $m^3/d$, is similar to the simulated amount. It is recommended that before the excavation of a shaft, water inflow is estimated using a numerical model and a grouting test to ensure excavation stability and improve excavation efficiency.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2003.09a
• /
• pp.532-535
• /
• 2003

새만금 방조제를 통하여 새만금호로 유입되는 해수 침출수량과 새만금 방조제 내부에서의 해수와 담수 사이의 상호작용 등에 대한 연구를 수행하였다. 본 연구에는, 밀도 차이에 의한 흐름을 고려한 지하수 흐름 지배 방정식과 염류의 분산 및 이송 지배 방정식을 결합시킨 수치해석 모델이 이용되었다. 밀도류를 고려한 경우에는 밀도류를 고려하지 않았을 경우보다 해수 침출량은 다르지 않았으나, 해수 침출면의 길이가 축소되고 유속이 증가하였다. 부정류상태의 해수-담수 경계면은 정류 상태의 결과와 매우 달랐으며, 해수 침출면이 방조제의 하부가 아닌 상부에 존재함을 보였다.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2003.04a
• /
• pp.77-81
• /
• 2003

일반세균, 질산성질소, 탁도로 오염된 지하수 관정의 2개공에 대해 수질개선을 시행하였다. 그 결과 2개공 모두 음용수 기준에 적합한 수질개선 효과를 가질 수 있음으로 하여 수질오염 발생의 주요 요인 중의 하나가 지하수 지표하부 오염방지 시설인 그라우팅이 부실함으로써 기인함을 규명할 수 있었다. 따라서, 본 연구를 통해 수질이 오염된 지하수 관정의 수질개선이 가능하다는 확인은 물론 또한, 지하수 관정내 지표수의 유입을 방지하기 위해서 지하수 상부오염방지 시설의 설치가 적극적으로 추진되어야 할 것이다. 지하수 오염을 예방하기 위해서는 지하수 개발 단계에서부터 지하수 지표하부 오염방지 시설이 연암 암반층까지 견실하게 적용되어져야 한다는 것을 확인할 수 있었다.

• Tunnel and Underground Space
• /
• v.16 no.4 s.63
• /
• pp.281-287
• /
• 2006

Intake of groundwater by tunneling in a mountainous area mostly results from groundwater flow through fractured parts of total rock mass. For reasonable analysis of this phenomenon the representative joint groups 1, 2, and 3 have been selected by previous investigations, geological/geophysical field tests and boring works. Three dimensional fractures were generated by the FracMan and MAFIC which is a three dimensional finite element model has been used to analyse a groundwater flow through fractured media. Monte Carlo simulation was applied to reduce the uncertainty of this study. The numerical results showed that the average and deviation of amounts of groundwater intaked into tunnel per unit length were $5.40{\times}10^{-1}$ and $3.04{\times}10^{-1}m^3/min/km$. It is concluded that tunnel would be stable on impact of groundwater environment by tunneling because of the lower value than $2.00{\sim}3.00m^3/min/km$ as previous and present standard on the application of tunnel construction.

• Economic and Environmental Geology
• /
• v.49 no.5
• /
• pp.361-370
• /
• 2016

It is well known that the inflow of rainwater and the infiltration of groundwater to sewerage (I/I) increase the sewage and burden sewage treatment plants and lower their treatment efficiency. Therefore, it is important to estimate the amount of I/I. In this study, well groundwaters, public water supplies (PWSs), and sewage and rainwater channels were investigated to check whether oxygen and deuterium isotopes could be used as a tool for I/I estimation. This study shows that the isotopic composition of PWS in Jeonju area is very consistent over time and distinctly lighter than the circulating local rainwater (CLR) because it is supplied from Yongdam Dam, which is located about 40 km inland to the east in the mountainous area. Considering the fact that sewage mostly originates from the PWS, we could calculate the amounts of CLR in the sewerage from a monitoring station using unaffected rainwater and tap water as mixing end members. The calculation revealed that the CLR fraction ranged from 50% to 90% depending on observation time. This is well supported by the dilute natures of the sewages at the station. The fraction of PWS in investigated well waters were about 46%, indicating that leaking of PWS is very serious and is an important groundwater source in the study area. Since the infiltration of such groundwater may not alter the isotopic composition of sewage significantly, the actual I/I would be much greater than the calculated ones.