• Journal of the Korean Geotechnical Society
• /
• v.18 no.5
• /
• pp.27-35
• /
• 2002

To construct pipe lines, culverts, or other utility lines, temporary slopes formed by excavating the compacted embankment are frequently met with in the field. Ignoring stability analyses for such slopes and applying inappropriate slope inclinations often result in safety problems. In this study, stability of such slopes were investigated considering the influence of anisotropic shear strength of the layered compacted ground. A series of stability analyses were conducted for slopes varying the slope angle and the height, and assuming isotropic and anisotropic shear strength conditions, respectively. The anisotropic shear strength of the compacted soil was determined from the direct shear test for layered soil blocks varying the inclination angle between the horizontal shear surface and the direction of the soil layer. As a result of the analyses, it has been concluded that the appropriate slope inclination f3r a temporary slope could vary in accordance with the consideration of anisotropy. However, the factor of safety as well as the location of the failure surface did not show significant variation.

• Journal of the Korean GEO-environmental Society
• /
• v.6 no.1
• /
• pp.63-72
• /
• 2005

From the geological and engineering point of view, the limestone is so rigid that it is able to act as a bedrock but if there are some unstable elements which are solubility cavity and cracking zone in the ground, the settlement and bearing capacity of a structure will be required to long-term stability investigations and countermeasures about those problems. When comparing the allowable bearing capacity, the results of Bell's method and the Bowles' method are similar but the results of Hoek-Brown's method are very larger than the others. For weathered limestone, stability is changed by size and depth of the cavity of limestone, but soft and hard rock are stable regardless of size and depth of the cavity.

• Geotechnical Engineering
• /
• v.7 no.2
• /
• pp.67-82
• /
• 1991

When bridge abutments are constructed on pile foundations in unstable slope, horizontal deflections may be developed in the piles and the abutments due to lateral soil movements arisen from backfills. In most of the above mentioned cases, the piles are situated in a soft layer where lateral earth pressures are developed between the piles and the soils. The undesirable lateral earth pressures decreases the stability of the piles. However, the piles may have a preventive effect against lateral soil movements and improve the stability of the slope. For the stability problem of such slope containing piles in a row, two kinds of analyses for the slope-stability and the pile-stability have to be performed. The whole stability of bridge abutments on pile foundation can be obtained only by the stabilization for both the slope and the piles. A reasonable analytical method for the bridge abutments on pile foundation was established in this study By use of the analytical method for an example, several factors which influence affect the stability of bridge abutment were investigated. Finally, for the bridge abutment subjected to lateral deflections damage, the fixity condition of pile head was investigated.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.6
• /
• pp.189-206
• /
• 2003

During tunnel excavation in urban area a systematic monitoring is important for the purpose of determination of support type and quantity, as well as for the control of stability of both surface structures and the tunnel itself due to the frequently, and in many cases, abruptly changing ground condition. In Austria absolute displacement monitoring methods have replaced relative displacement measurements by geodetic methods to a large extent. Prompt detection of weak ground ahead of the tunnel face as well as better adjustment of excavation and support to the geotechnical conditions is possible with the help of the improved methods of data evaluation on sites. Deformation response of the ground to excavation starts ahead of the tunnel face, therefore, the deformation and state of the tunnel advance core is the key factor of the whole deformation process after excavation. In other words, the rigidity and state of the advance core play a determining role in the stability of both surface structures and the tunnel itself. This paper presents the results from detailed three-dimensional numerical studies, exploring vertical displacements, vector orientations and extrusions on tunnel face during the progressive advancement for the shallow tunnel in various geotechnical conditions.

• Journal of the Korean Geosynthetics Society
• /
• v.16 no.2
• /
• pp.183-194
• /
• 2017

When a borehole is drilled, the load distributed by the removal is taken to re-establish equilibrium. As a result, the stresses around the borehole is redistributed. If there is no hydrostatic support pressure by drilling fluid (mud) introduced into the borehole, failure in the formation may take place. The mud pressure boundary that keeps the borehole stable is defined as a mud window. To predict the potential for failures around the borehole, a series of numerical analysis were performed and compared with a mud window. The effect of failure criterion and the intial stress ratio adopted on the mud window was also studied.

• Journal of the Korean Geotechnical Society
• /
• v.17 no.4
• /
• pp.199-208
• /
• 2001

본 연구의 목적은 교대가 설치된 지반의 사면안전율과 교대측방변위의 관계를 분석하여 교대의 측방이동 판정기준을 마련하고자 함에 있다. 이를 위하여 국내의 연약지반에 설치된 30개 교대의 측방이동사례를 조사하고, SLOPILE (Ver 2.0)프로그램을 이용하여 교대의 측방변위와 교대기초말뚝의 사면안정효과를 고려한 사면안정해석을 실시한다. 해석결과 교대기초말뚝의 실측측방변위를 고려할 경우 1.8이상 되어야 한다. 또한, 교대기초말뚝의 허용측방변위량에 따른 사면안정 해석결과, 교대의 허용측방변위가 작게 규정될수록 사면안정성에 기여하는 말뚝의 효과는 감소하고 있음을 알 수 있다.

• Journal of the Korean Geotechnical Society
• /
• v.18 no.5
• /
• pp.271-280
• /
• 2002

A probabilistic approach to identify the effects of uncertainties of soil strength parameters on searching a critical slip surface with the lowest reliability is introduced. In general construction field, it is impossible for the engineer to always gather a variety of statistical information of soil strength parameters for which lots of laboratory and in-situ soil testing are required and to use it with enough statistical knowledge. Thus, in order that the engineer may easily understand the probabilistic concept for the slope stability analysis, this study proposes a combined procedure to incorporate the engineering probabilistic tools into the existing deterministic slope stability analysis methods. Using UTEXAS 3, a slope stability analysis computer program developed by U.S. Army Corps of Engineers (U.S. COE), this study provides the results of this probabilistic slope stability analysis in terms of probability of failure or reliability index. This probabilistic method f3r slope stability analysis appears to yield more comprehensive results of slope reliability than does existing deterministic methods with safety factors alone.

• Tunnel and Underground Space
• /
• v.25 no.4
• /
• pp.332-340
• /
• 2015

Ground subsidence occurring in mine area can cause an enormous damage of loss of lives and properties, and a systematic survey should be conducted a series of field investigation and ground stability analysis in subsidence area. This study describes the results from field investigation and ground stability analysis in a limestone mine located in Cheongwon-gun, Chungcheongbuk-do, Korea. Rock mechanical measurements and electrical resistivity surveys are applied to obtain the characteristics of in-situ rock masses and the distribution patterns of subsurface weak zone, and their results are extrapolated in numerical analysis. From the field investigation and stability analysis, it is concluded that the subsidence occurrence in this limestone mine is caused mainly by subsurface limestone cavities.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.03b
• /
• pp.365-372
• /
• 2000

현장상황에 대한 불충분한 자료와 파괴 메커니즘에 대한 불완전한 이해로 인해 발생하는 가변성(variability)과 불확실성(uncertainty)은 암반사면공학뿐만 아니라 지반공학에서 흔히 접하게 되는 문제점이다. 특히 암반사면공학에서는 이러한 가변성과 불확실성이 불연속면의 방향 및 기하학적 특성, 그리고 실내실험 결과의 분산으로 나타난다. 그러나 안전율(factor of safety)의 개념을 기초로 하는 전통적인 결정론적 해석방법(deterministic analysis)은 이러한 분산을 고려하지 않은 채 단일 대표 값만을 이용하여 구조물의 안정성을 판단하여 왔다. 확률론적 해석방법(probabilistic analysis)은 이러한 가변성과 불확실성을 효과적으로 정량화하여 해석에 이용할 수 있는 방법 중의 하나로 제안되었다. 이러한 해석방법은 불연속면의 기하학적 특성과 강도 특성을 확률변수(random variable)로 취급하여 신뢰성이론(reliability theory)과 확률이론(probability theory)을 근거로 분석하였으며 이를 기초로 하여 Monte Carlo Simulation과 같은 해석법을 이용, 구조물의 붕괴가능성을 확률로 표현하였다. 확률론적 해석 방법은 기존의 안전율을 대체하여 구조물의 안정성을 붕괴확률(probability of failure)로 제안하였으며 이 붕괴확률은 안전율의 확률분포함수 (probability density function)에서 안전율이 1보다 작을 가능성을 확률로 나타낸 수치이다. 본 논문에서는 확률론적 해석방법을 이용하여 불연속면 특성들의 확률특성을 고찰하였으며 이를 기초로 하여 암반사면의 안정성 해석에 응용했다.

• Journal of the Korean GEO-environmental Society
• /
• v.17 no.11
• /
• pp.23-33
• /
• 2016

This study evaluated the stability and deformation subsea foundation after implementation of the contaminant isolation method by covering the contaminated materials using Zeolite and sands under subsea condition. The appropriate contaminant adsorption materials used in this study was selected as Zeolite based on the existing research results due to its efficiency. Safety (or stability) was evaluated by calculation and to analyze deformation after completing the contaminant isolation method. The minimum safety factors from slope stability analyses results were 30.1 and 11.2 depending on subsea submerged conditions and the amount of the maximum primary consolidation settlement from consolidation analysis results was 209.2 mm. In addition, change of consolidation amount with increasing consolidation time was evaluated based on consolidation degree.