• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.33 no.2
• /
• pp.585-594
• /
• 2013

In this study, laboratory experiments and numerical simulations were conducted to test the performance of resonance power buoy system proposed by Kweon et al.(2010). The system is composed of a linear generator and a mooring buoy. The mover of the linear generator mainly has heave motion driven by vertical oscillation of the buoy. In this system, the velocity discrepancy between the mover and the buoy makes electricity. However, ocean wave energy as a natural resource around Korean peninsula is comparatively small and the driving force for producing electricity is not enough for commercialization. Therefore, it is necessary that the buoy motion be amplified by using resonance characteristics. In order to verify the resonance effects on the test power buoy, the experimental investigations were conducted in the large wave flume (length of 110 m, width of 8 m, maximum depth of 6 m) equipped with regular and random plunger wave generator. The resonance draft of test power buoy is designed for the corresponding period of incident wave, 1.96 sec. Regular wave test results show that the heave response amplitude operator(RAO) by a test buoy has the amplification of 5.66 times higher compared to the wave amplitude at the resonance period. Test results of random waves show that the buoy has the largest spectrum area of 20.73 times higher at the point of not the resonance period but the shorter one of 1.85 sec. Therefore this study suggests the resonance power buoy for wave power generation for commercial application in the case of the coastal and oceanic area with smaller wave energy.

• Journal of Satellite, Information and Communications
• /
• v.11 no.3
• /
• pp.1-5
• /
• 2016

The continuous variable quantum key distribution has been considered to have practical solution to provide high key rate. This paper explains the difference between DV-QKD and CV-QKD schemes. It describes CV-QKD as a theory that satisfies the uncertainty principle using continuous variable and homodyne detector. We shows varying length of secret key in QKD systems and amount of the exposed information to amplify privacy.

• Korean Journal of Optics and Photonics
• /
• v.17 no.6
• /
• pp.556-563
• /
• 2006

We present a comprehensive study of a chirped pulse Ti:sapphire regenerative amplifier system operating at 1 kHz. Main constituents of the system are described in detail. The amplifier stage was first converted to a repetition rate-tunable kHz gain-switched nanosecond Ti:sapphire laser. Operation characteristics at different repetition rates such as build-up times of laser pulses, pump power-dependent output powers and pulse durations, damage thresholds, and tunability ranges were studied. Based on the results achieved, the switching time of the Pocket's cell used and the round trip numbers in the regenerative amplifier were optimized at 1 kHz. The output pulses with a pulse width of 50fs from a home-made Ken lens mode-locked Ti:sapphire oscillator were used as seed pulses. The pulses were expanded to 120ps in a grating stretcher prior to coupling into the 3-mirror amplifier cavity. After amplification and recompression, a stable 1kHz Ti:sapphire regenerative amplifier system, which delivers 85-fs, $320-{\mu}J$ pulses, was fully constructed.

• Journal of Advanced Navigation Technology
• /
• v.3 no.1
• /
• pp.52-59
• /
• 1999

Digital microwave wideband receiver including linear amplifier, analog-to-digital converter(ADC) and digital signal processor is able to analyze its performance using sensitivity and dynamic range of system. Determination of gain, third-order intermodulation products and ADC characteristics and design criteria for the linear amplifier chain is essential problem for sensitive and dynamic range. Also, if there are two signals with frequencies very close, digital signal processor must be able to separate the two signals. In this paper, we measured dynamic range as gain was changed and determined gain value for the proper sensitivity and dynamic range and high resolution spectrum estimation was used to separate two close signals.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2010.05a
• /
• pp.137-138
• /
• 2010

This paper presents new seismic control system that utilize toggle brace to amplify the displacement of damper. A full scale steel moment frame was constructed for the purpose of testing the energy dissipation system with double toggle brace.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2009.10a
• /
• pp.931-934
• /
• 2009

본 논문은 $24{\mu}m$ 이하의 미세 폭 및 $30{\mu}m$ 이하의 피치와 같이 미세 패턴을 가진 칩 온 필름(chip-on-film, COF)에 발생한 결함들을 자동으로 검출할 수 있는 시스템을 제안한다. 개발된 검출시스템은 미세 패턴의 COF에서 발생한 개방 (open), 단락 (hard short), mouse bite 및 near short (soft short)과 같은 다양한 결함들을 자동으로 빠르게 검출할 수 있는 기술이 적용되어 있다. 본 논문에서 제안하는 결함 검사 기술의 기본 원리는 미세 패턴내의 결함으로 인해 발생한 저항의 미세 변화를 고주파 공진기 (resonator)를 이용하여 측정 주파수에서 증폭시키고 증폭된 결함 신호와 결함이 없는 경우의 신호와의 전압차를 읽어서 0이 아니면 결함이 있음을 판단한다. 제안된 시스템은 미세 패턴 COF 검사 과정에서 결함들을 신속히 측정할 수 있으므로 불필요한 COF 복사를 위해 소요되는 경비를 줄일 수 있으리라 기대한다.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.35 no.1
• /
• pp.23-28
• /
• 2022

Natural frequency variations in a vehicle-bridge interaction system is examined. The interaction system is designed for a simple beam subject to a moving vehicle. The equation of motion for the system is derived under the quarter-car condition, and numerical simulation is performed. Frequency amplification ratio (FAR) is defined as a ratio between the initial and the varying natural frequency of the system; a discontinuity in the FAR implies a resonance condition. Analysis is mainly focused on patterns, frequency variation characteristics, and discontinuity points of the FAR under the vehicle mass and tire stiffness variations. The result reveals that the interactions between the system affects the natural frequency of both the vehicle and the bridge in similar frequency regions that can be visually identified at the middle of the span using the FAR.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.1A
• /
• pp.12-17
• /
• 2009

We consider an OFDM based multiple AF relaying systems. Since the channel between first hop (source station-relay station) and second hop (relay station -destination station) varies independently, the subcarrier in the first hop can be paired to another subcarrier in the second hop for the increase of the system capacity. The conventional pairing which uses the brute force searching requires large complexity while giving optimal pairing for maximum system capacity. In this paper, we present sub-optimal subcarrier pairing scheme with low complexity. Every RS firstly pairs the subcarrier with the highest channel gain in the first hop to the subcarrier with highest channel gain in the second hop. The pair with the highest SNR among all the pairs is determined as final selected pair and the corresponding subcarriers are not selected at other RSs in the next paring iteration. This process is repeated until all the subcarriers are paired. Simulation results show the proposed pairing scheme achieves near optimal performance with low complexity.

• KIPS Transactions on Computer and Communication Systems
• /
• v.7 no.1
• /
• pp.19-26
• /
• 2018

Recently, DDoS amplification attacks using servers that provide Microsoft Active Directory information using CLDAP protocol are increasing. Because CLDAP is an open standard application that allows a wide range of directory information to be accessed and maintained in a network, the server is characterized by its openness to the Internet. This can be exploited by the Reflector server to perform an amplification attack by an attacker. In addition, this attack can be attacked with a packet that is amplified 70 times more than the conventional UDP-based flooding attack, and it can block service to small and medium sized server. Therefore, in this paper, we propose an algorithm that can reduce the DDoS amplification attack using CLDAP server and implement the corresponding CLDAP server environment virtually, and implement and demonstrate the corresponding algorithm. This provides a way to ensure the availability of the server.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.12
• /
• pp.2317-2323
• /
• 2015

In this paper, we analyze the performance of dual-hop amplify-and-forward (AF) relaying in cooperative networks with partial relay selection. An AF relay gain considered in this paper includes channel-noise-assisted relay gain. Leveraging a received signal-to-noise ratio (SNR) model, we derive exact closed-form expressions for the probability density function (pdf) and cumulative distribution function (cdf) of the end-to-end SNR. Moreover, an exact closed-form expression of the ergodic capacity for dual-hop AF relaying with channel-noise-assisted relay gain and partial relay selection is investigated. The analytical results shown in this paper are confirmed by Monte-Carlo simulations.