• International Journal of Highway Engineering
• /
• v.10 no.2
• /
• pp.135-143
• /
• 2008

According to the present highway design criteria, there are minimum standards which re ade from special design speeds. If some highways are satisfied the standards, it regards he highway as safety. In reality, however, most drivers drive a car at different speed compared with design speed. It is very dangerous for drivers especially at transition sections between curve and horizontal curve sections. Hence, this study calculated the rate of changing and horizontal acceleration at each section. Moreover, this study evaluated thesafety of design at curve transition sections and then calculated lateral acceleration and curve radii. This study found the minimum standards which are using as basic safety standards are not appropriate for measuring driver's safety.

• Proceedings of the KOR-KST Conference
• /
• 1999.10a
• /
• pp.141-146
• /
• 1999

본 연구는 평면곡선부의 차량속도변화와 교통사고에 대한 영향을 분석하기 위해 수행되었으며, 이를 위해 곡선반경별로 진입부 직선도로 - 곡선부 - 이탈부 직선도로로 구분하여 각 주행속도를 산정하였다. 본 연구에서는 선행차량에 의해 영향을 받지 않는 속도를 이용하여 평면곡선부 기하구조의 영향을 분석하였다. 이러한 곡선부의 주행 속도를 분석한 결과, 곡선반경별 최저속도와 그 속도가 나타나는 위치를 분석하였고, 해당 도로구간의 교통사고자료를 분석하여 평면곡선부의 차량주행속도변화와 교통사고 발생간의 관계를 규명하였다. 연구 결과는 다음과 같다. 첫째, 운전자들은 곡선시작지점에 도착하기 전에 충분히 속도를 줄이고, 곡선부에서 가장 낮은 속도가 나타나는 위치는 곡선시점의 후방에서 나타나고 이는 운전자의 시거에 의한 영향이다. 둘째, 곡선부에서의 속도변화폭이 클수록 사고위험성은 크고 실제 교통사고의 발생건수는 높다. 본 연구의 결과에 의해 도로 주행의 안전성을 고려한 평가지표를 개발할 수 있으며, 이에 의한 일관성 있는 도로설계를 유도할 수 있다.

• Journal of Korean Society of Transportation
• /
• v.20 no.7
• /
• pp.95-105
• /
• 2002

Under a specific roadway alignment condition by design-speed standards, safety of the roadway is determined by an actual operating speed of a driver. This research takes first lanes of four-lane(hi-direction) rural highways as target facility. It also takes the straight and curved lanes of the selected highways for in-depth study. This study used NC-97 to detect speeds of passenger cars whose speeds are not affected by front vehicles. This research analyzed properties of 85th percentile operating speed at upstream of horizontal and through curves under various alignment conditions. The results show that 53∼65 Percent of drivers drive faster than the posted speed-limit (80KPH) by 14∼20 KPH on average. It also shows that the 85th-percentile operating speeds are the lowest at the middle point of curve length when curve radius is smaller. However, they are lowest at 1/4 point of curve length when curve radius is greater. Along roadways where curve radius is small, difference between upstream speed and the speed along the curve is considerably large. On the other hand. the speed difference is setting smaller as the curve radius is increasing. According to the results, significant variables affecting the 85th percentile operating speeds are curve radius and the 85th-Percentile operating speeds of upstream curves.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.16 no.4
• /
• pp.107-121
• /
• 2017

This study conducted a 3-stage survey and simulation experiment to identify the impact of vehicle platoons on car-following behavior of manually-driven vehicles. Vehicle maneuvering data obtained from driving simulations was statistically analyzed based on three measures including average speed, acceleration noise, and offset to represent the deviation of lateral movements. Results indicate that MV drivers tended to have psychological burden while driving in automated vehicle platooning environments, which resulted in different vehicle maneuvers. It is expected that the outcome of this study would be useful fundamentals in developing various traffic operations strategies for managing mixed traffic stream consisting of MVs and autonomous vehicles.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.38 no.1
• /
• pp.37-44
• /
• 2014

For testing a two-wheeled vehicle's per-charge range, this study conducted road and chassis dynamometer driving tests. Three typical road routes within Daejeon Metropolitan City were selected for the road-driving test. In the case of CVS-40 mode driving tests using a chassis dynamometer, various road-loading conditions were set. In this study, two-wheeled electric vehicles' per charge range on the road was confirmed through testing, and the range and energy consumption efficiency depending on various chassis dynamometer road load settings were measured. Then, the results of the actual road driving tests were compared with those of the chassis dynamometer driving tests, and road load settings that yielded per-charge range testing results similar to those under actual road driving conditions in the chassis dynamometer experiments were studied.

• Journal of Korean Society of Transportation
• /
• v.35 no.6
• /
• pp.545-556
• /
• 2017

Various assessment indexes have been developed and utilized to evaluate the driver workload. However, existing workload assessment indexes do not fully reflect driving habits and driving patterns of individual drivers. In addition, there exists significant differences in the amount of workload experienced by a driver and the ability to overcome the driver's workload. To overcome these limitations associated with existing indexes, this study has developed a novel workload assessment index to reflect an individual driver's driving pattern. An average of the absolute values of the steering velocity for each driver are set as a threshold value in order to reflect the driving patterns of individual drivers. Further, the sum of the areas of the steering velocities exceeding the threshold value, which is defined as erratic steering area (ESA) in this study, was quantified. The developed ESA index is applied in evaluating the driver workload of manually driven vehicles in automated vehicle platooning environments. Driving simulation experiments are conducted to collect drivers' responsive behavior data which are used for exploring the relationship between the NASA-TLX score and the ESA by the correlation analysis. As a result, ESA is found to have the greatest correlation with the NASA-TLX score among the various driver workload evaluation indexes in the lane change scenario, confirming the usefulness of ESA.

• Journal of Korean Society of Transportation
• /
• v.28 no.5
• /
• pp.141-153
• /
• 2010

The study is about the development of operating speed prediction models aimed for an evaluation of design consistency of four lane rural roads. The main differences of this study relative to previous research are the method of data collection and classification of road alignments. The previous studies collected speed data at several points in the horizontal curve and approaching tangent. This method of collection is based on the assumption that acceleration and deceleration only occurs at horizontal tangents and the speed is kept constant at horizontal curves. However, this assumption leads to an unreliable speed estimation, so drivers' behavior is not well represented. Contrary to the previous approach, speed data were collected with one and data analysis using a speed profile is made for data selection before building final models. A total of six speed prediction models were made according to the combination of horizontal and vertical alignments. The study predicts that the speed data analysis and selection for model building employed in this study can improve the prediction accuracy of models and be useful to analyze drivers' speed behavior in a more detailed way. Furthermore, it is expected that the operating speed prediction models can help complement the current design-speed-based guidelines, so more benefits to drivers as real road users, rather than engineers or decision makers, can be achieved.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2023.11a
• /
• pp.1171-1172
• /
• 2023

자율주행 기술에서 스테레오 비전과 End-to-End Driving은 많이 사용되는 기술이며 본 연구에서는 이를 신호등 인식과 주행에 적용하였다. 신호등 인식은 좌우 카메라로부터 적색 원을 인식한 후 스테레오 비전을 통해 신호등과의 거리를 추정한다. 주행 시스템은 End-to-End Learning 기반으로 이루어지며, 출력값인 가변저항을 조향각으로 변환하여 제어할 수 있다. 또한 감마 보정을 통한 데이터 증강을 통해 빛에 대해 민감하지 않게 모델을 학습하였다. 추후 신호등 인식 시 HSV 필터가 빛에 민감한 점과 주행 시 가변저항 값이 일정하지 않은 점이 해결된다면 더욱 안정적인 시스템을 구축할 수 있을 것으로 기대된다.

• Journal of Korean Society of Transportation
• /
• v.23 no.7 s.85
• /
• pp.35-42
• /
• 2005

Few studies have been carried out to find out the interaction of design speeds, operating speeds, and posted speeds though they have a complementary relationships. As an attempt to find the relationships, this study measured the speeds of the free flowing vehicles at four lane rural highways. In comparison of 95th percentile speeds and inferred design speeds determined from the road design manual with the geometric features of each sites, operating speeds were constantly higher than the inferred design speeds at the sites where the inferred design speed is under 110km/h. and the reverse situation was observed at the sites where the inferred design speed is over 130km/h. In the comparison of operating speeds and posted speeds. the range of the 85th percentile speeds at the sites where posted speeds is 80km/h was distributed from 95km/h to 110km/h. and the range was distributed from the 105km/h to the 120km/h at the sites where posted speeds is 90km/h. Multiple regression analysis was used to develop prediction equations for mean. 85th. and 95th percentile speeds at approach and curve midpoint locations. At the midpoint, only posted speeds influenced the mean, 85th. At the approach locations, the mean, 85th, 95th percentile speeds were influenced by posted speeds and length of the approach tangent.

• Journal of the Korean Society for Railway
• /
• v.12 no.6
• /
• pp.983-988
• /
• 2009

When the railway vehicle passing through curves & transitions, the running speed must improve by proposing the practical standard about maximum running possibility speed of each section on existing line considering running safety. In this paper, when the railway vehicle passing through curves of actual track conditions (Namsunghyun-Chungdo up & down lines), the effect that has influence on running safety is examined to devise the high speed of vehicle which passing through curves which risk of derailment is high. The running safety analysis is performed that running speed by curve radius improves 5-20% compared with existing speed under actual track conditions. In result of the running safety analysis, in case the speed condition is fewer than 15% compared with existing speed, the derailment coefficient and unloading ratio are within acceptable level. so we could confirm possibility of speed improvement on the whole Namsunghyun-Chungdo up & down lines.