• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.1
• /
• pp.52-60
• /
• 2001

In this paper proposes a multi-carrier MFSK-DPSK/DS-CDMA combined modulation techniques in Nakagami fading environment. Also, multi-carrier DS-CDMA combined system is a promising technique for mobile communications systems, since it has a strong immunity to multipath fading and increasing bandwidth efficiency. The modulations under consideration are noncoherent M-ary frequency shift keying (MFSK)and an MFSK based joint frequency phase modulation utilizing differential phase shift keying (DPSK). With the result, performance improvement of power efficiency and bandwidth efficiency combined system in multi-carrier MFSK-DPSK/DS-CDMA are better then conventional communication system.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.26 no.6
• /
• pp.102-107
• /
• 1989

This paper describes a new circuit modeling technique for the directly frequency modulated semiconductor laser. Especially this model accounts for not only the accounts for not only the carrier density effect but also the temperature effect. The simulation results with this model are compared with published experimental results of sinusoidal frequency modulation in the range from DC to 3 GHz, and show good agreements.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.11a
• /
• pp.557-561
• /
• 2002

본 논문에서는 전자식 형광등의 직류구동과 AM 변조시 빛의 주파수 특성에 관하여 다루고 있다. 전자식 형광등을 구동하는 안정기 회로는 상용전원을 직류로 정류시켜 고주파로 변환하여 형광등을 구동시킨다. 형광동의 구동에 사용되는 안정기 회로의 내부 평활 컨덴서의 유.무와 각각 공급되는 전원을 상용전원인 경우, 상용전원을 정류한 경우, 상용전원을 정류하고 정현파를 AM 변조한 경우에 대해서 측정하였으며, 변조하여 입력되어진 정현파가 빛을 통해서 송신되는 것을 확인할 수가 있었다.

• Journal of Advanced Navigation Technology
• /
• v.14 no.3
• /
• pp.367-374
• /
• 2010

In this paper, the frequencies sharing possibility between TA(TalkAround) Radios and RFID system in 900MHz frequency band have been studied. The modulation technic for FHSS(Frequency Hopping Spread Spectrum) of TA is digital FSK and RFID system adapts digital ASK modulation technic. The communication mode of the tested RFID system for frequencies sharing possibility was FHSS. The field test was performed by five scenarios. The RFID field testing system for the frequencies sharing possibility was composed of four tags and two main devices made in USA. Four TA and Egilant spectrum analyzer was used for testing. The frequencies sharing possibility by differentiated modulation was theoretically analyzed. As result of simulation, it was proved that the frequencies sharing between each other modulation system is possible. And also as result of field testing it was confirmed that the signal of TA Radios have no effect on the signal of RFID system.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2010.05a
• /
• pp.665-667
• /
• 2010

In this paper, the method to detect the IM(Inter Modulation) components of power amplifier is proposed by using frequency down-convertor. Output signals of power amplifier which is coupled by 20dB coupler and divided by power divider are applied to RF and LO of the frequency converter. It could be found the magnitude of IM components of power amplifier as a converted DC voltage which is come from the difference between 3th and 5th IM component. The detected DC voltage values are changed from 0.72V to 0.9V when 3rd IM component level changed from -26.4dBm to +2.15dBm and 5th IM component level changed from -34.2dBm to -12.89dBm as the Vgs of 3W power amplifier is changed.

• The Journal of the Korea Contents Association
• /
• v.9 no.2
• /
• pp.10-17
• /
• 2009

This paper analyze the effect of frequency offset for the IEEE 802.15.4b LR-WPAN(Low-Rate Wireless Personal Area Network) with 915MHz bandwidth noncoherent DSSS O-QPSK based receiver system, and presents a compensation method with addition of differential filter to the system for compensation of frequency offset problem. DSSS PSSS-ASK and DSSS O-QPSK modulation techniques are accepted within the regularization of IEEE 802.15.4b. These new method can obtain 250kbps transmission rate. The DSSS O-QPSK modulation method that is used in this paper has no BER variation below 40ppm(frequency offset 36.6kHz), but if the offset frequency become high above 40ppm, then the system cannot have stable receiving condition due to worse BER. To solve this problem, we present a more stabilized receiver system at maximum frequency offset ${\pm}80ppm$ using MDDF unti a correlator of DSSS O-QPSK modulator. Moreover computer simulation results will be presented to evaluate the performance of the proposed algorithm unde various AWGN and frequency offset environment.

• Korean Journal of Optics and Photonics
• /
• v.10 no.2
• /
• pp.146-151
• /
• 1999

We demonstrated a harmonic mode locking scheme that used regeneratie phase modulation to get a high and stable repetition rate in a figure-of-eight fiber soliton laser. From the detected beat spectra of the laser output, a sinusoidal clock freguency tone of 400 MHz, the 96th harmonics of the fundamental mode locking frequency, was extracted with a high Q filter and was used to drive the phase modulator, resulting in stable output of soliton pulse train synchronized with the modulation signal. Generated soliton pulses had FWHM pulsewidth of 930 fs and 3.1 nm linewidth, yielding pulsewidth-bandwidth product of 0.359 that was close to the transform limit. As the modulation frequency always followed the beat frequency of laser modes, stable harmonic mode locking was achieved without the adjustment of the cavity length, which has been commonly required in actively mode-locked lasers.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.9
• /
• pp.2009-2019
• /
• 2013

In this paper, we propose an automatic modulation recognition algorithm based on cyclic moment and new modified cumulant for analog and digital modulation signals. It is noteworthy that each modulated signal has different cycle frequency characteristics according to its order of cyclic moment. By means of this characteristics as classification features, various modulated signals can be efficiently classified. Also, to identify modulated signals having the same cycle frequency characteristics, we take advantage of the additional classification factors such as variations of envelope and phase as well as modified cumulant. The proposed algorithm was evaluated by considering the number of symbols, SNR, and frequency offset. In the simulation condition where the number of gathered symbols was about 819, and SNR and frequency offset were above 10dB and below 25%, respectively, the average accuracy of the proposed algorithm was more than 95%.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2000.11a
• /
• pp.206-210
• /
• 2000

본 논문에서는 PLL 주파수 합성기를 이용한 900 MHz 대역의 무선 마이크용 송신기를 설계 및 제작하였다. 위상잡음을 고려한 주파수 합성기는 VCO, Loop Filter 및 RF 중폭부로 구성한 후 HP EEsof ADS ver. 1.3을 이용하여 설계하였다. VCO는 구조가 간단하며 변조가 용이한 직접변조방식을 사용하였으며 Loop Filter는 주파수 합성기의 기준 고조파 성분을 낮추기 위해 수동 3차 필터를 사용하였다. 주파수 대역 928.125 MHz～929.875 MHz 내에서 채널간격 125 kHz를 갖으며 15개의 채널이 되도록 분주비를 설정한 주파수 합성기는 제작 결과, 송신기 출력 9.3 dBm과 위상잡음이 100 kHz에서 -113 dBc/Hz 이하의 위상잡음 특성을 나타내었고 불요주파수 특성은 -80 dBc 이하의 특성을 나타내었다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.6
• /
• pp.661-670
• /
• 2013

In this paper, we propose the measurement techniques of mixed waveform. Mixed waveform has phase-continuous periodic waveform with fixed frequency signal and Linear Frequency Modulation(LFM) signal. This waveform is generated from a compact radar transmitter with frequency synthesizer and high power amplifier. Frequency synthesizer generates various signal waveform with continuos phase and high power amplifier amplify transmitting signal. First, we describe a compact radar transmitter with the phase-continuos signal and then verify the distortion characteristic of pulse compression by the mismatch of LFM waveform. Second, we describe three kinds of measurement techniques for measuring LFM waveform. These techniques include methods using signal analyzer, signal source analyzer and new methods using RF mixer and phase shifter. Finally, we verify the accuracy of the measurement technique from the pulse compression result of receiving signal.