• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.12
• /
• pp.63-72
• /
• 2007

This paper addresses the system development that can transfer data and TDM signals simultaneously by adding TDM pseudowires functions to E-PON system. E-PON technology is one of many technologies which can realize FTTH, has raised as next generation access network solution having both low-cost Ethernet technology and optical infrastructure. TDM pseudowires service is the new voice/data conversion technology which can transfer the existing TDM circuit switched voice and data over packet switching network. In this paper, this system can provide both data and TDM service without deteriorating QoS by adding TDM pseudowires service module to E-PON, and then implementing QoS control function. Therefore, the competitive system which can transfer both data and TDM signal, can be installed.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.12
• /
• pp.120-127
• /
• 2008

HMIPv6 draws lots of attentions in recent years for providing an efficient handover and reducing the signaling overhead. HMIPv6 employs MAP(Mobility Anchor Point) in order to minimize a signaling overhead and a local mobility management. MAP completes an efficient mobility management in HMIPv6 network environment with frequent handover. However, HMIPv6 causes load concentration at a paricular MAP and may have unnecessary latency between HN(Mobile Node) and CN(Correspondent Node) within the same network. A MAP may also disturb the route optimization in HMIPv6 network because all packets must be transmitted through a MAP. In this paper, we propose a scheme to optimize the route in HMIPv6 networks according to MAP load. We configure a threshold in order to support the better service into MAP domain. The packets do not pass through MAP and are directly transmitted to AR(Access Router) if the number of current MNs attached to the MAP exceed the desired threshold. We simulate the performance of the proposed scheme and compare with HMIPv6. Resultly, the proposed scheme reduces signaling costs and mitigates concentration of a paticular MAP as well.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.7
• /
• pp.9-19
• /
• 2004

WLAN (Wireless Local Area Networks) needs error recovery and flow control schemes to support reliable multicast protocol. Limited wireless bandwidth, as well as queuing losses caused by the asymmetric wired/wireless interactions, demands more effective approaches for reducing packet losses. Moreover, since the wireless channel is a shared broadcast medium, if sender receives feedback information simultaneously from several receivers, the feedback delays data frame transmission of forward direction by introducing channel congestion and burden at the sender. Therefore, it is important to minimize the amount of feedback information from receivers. In this paper, we propose an ARS(Adaptive Redundancy Scheme) that combines FEC(Forward Error Correction) using channel state estimation and ARQ(Automatic Repeat Request) both to reduce the amount of feedback information and the number of retransmissions and to guarantee high data reliability in a WLAN multicast environment. Performance of the proposed scheme is evaluated by means of analysis and simulations in AWGN and Rayleigh fading channels. The results show that the proposed scheme reduces the amount of feedback information and the number of retransmissions and guarantees high data reliability, while keeping throughput efficiency similarly with the conventional FEC and ARQ scheme.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.2B
• /
• pp.146-153
• /
• 2006

It is required to have researches on efficient resource allocation schemes in an integrated voice and data CDMA system with the spreading of high-speed wireless internets. In this paper, we proposed a efficient resouce allocation scheme for providing a high speed data service in an integrated CDMA system. In an integrated voice/data CDMA system, resources for voice users are allocated with high priority and residual resources are allocated to the data service. In this case, it is necessary to use a resource allocation scheme for minimizing interference. In this paper, we first explain about a interference minimizing method and define QoS requirements. Based on the method, we proposed a efficient resource allocation scheme which satisfy the QoS requirements. The proposed scheme controls the transmission rate and delay of data users with a priority information such as the number of packets in a queue. From the simulation results, we show that the proposed scheme reduce the blocking probability and delay and improve the performance.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.2A
• /
• pp.90-97
• /
• 2005

Generally, DAB systems are divided into two categories, a stand-alone type and a PC/PDA-based type. The PC/PDA-based type has less mobility comparing to the stand-alone type, nevertheless, it has the advantage of using memory, audio/video decoder, or other resources of PC/PDA. The DAB receiver implemented in this paper is a PC-based receiver system employing USB interface. The USB interface bridge is designed using FPGA and EZ-USB development kit and the implemented DAB receiver adopts the bridge and makes use of the stand-alone typed DRK-026 receiver for experiments. The USB interface bridge transforms serial data into USB packets and all of related signals are controlled by hardware logics. The operation of the implemented DAB receiver is verified by sending audio data into the PC for decoding through USB interface bridge.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.4B
• /
• pp.371-377
• /
• 2011

Users of the Information Age, IT usage patterns of the wired broadband information services and various forms of the same quality wireless multimedia services are required. Changes of these times the next-generation mobile communications (IMT-Advanced) has emerged as the necessity of developing its current voice and packet data communications on the move in the high-speed 100Mbps, 1Gbps in stationary and slow data transmission rates up to fixed-mobile convergence based on needed to provide ubiquitous service platform for the realization of IMT-Advanced is the time for preparation. In particular, 3-5GHz band, focused on mobile communications can be used to secure the necessary frequency band relocated and the existing crosstalk analysis methodology developed for the services rendered, and the frequency of such results to obtain new spectrum for IMT-Advanced for the country to secure the frequency characteristics and IMT-Advanced 3-5GHz band for the radio frequency of the characterization techniques necessary to develop a national wireless communication interference and frequency-based technology acquisition and management skills were identified.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.12B
• /
• pp.1058-1065
• /
• 2008

In the Internet, as computer resource is developed, multimedia data request being increase more and more. It is effective way that process both high capacity-data and real-time data. Overlay Multicast is an effective method for efficient utilization of system resources and network bandwidth without using hardware customization. Overlay Multicast is an effective method for multimedia data service to multi-users. Multicast tree reconstruction is required when a non-leaf host leaves or fails. In this paper, relay-frame interval is selected as revealed network-state with jitter. In our proposal, multi-user service control algorithm gives a delay effect in multimedia request time. The simulation results show that our proposal takes shorter period of time than the other algorithms to reconstruct a similar tree and that it is a more effective way to deal with a lot of nodes that have lost their multi-user nodes.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.5A
• /
• pp.479-486
• /
• 2008

In this paper, an efficient training symbol design with m-sequence is proposed for the MIMO-OFDM based next generation wireless transmission system which supports gigabits per second data rate. In the traditional blute force method, the preamble design is based on the case by case comparison with the system requirements. This paper discusses a training symbol design methodology for the MIMO-OFDM system based on the m-sequence which has been widely used in the spread spectrum communication areas due to its good correlation characteristics. Also the step-by-step design and performance verification method within the limited search space is discussed. The proposed method targets the design of the training symbol which satisfies system requirements for the packet based MIMO-OFDM wireless communication system including automatic gain control(AGC), timing synchronization, frequency and sampling offset estimation, and MIMO channel estimation.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.11 no.2
• /
• pp.129-136
• /
• 2018

The IEC 61850 communication standard is used worldwide, and within the country the new substation is built as a digital substation based on IEC 61850 from 2013, after field tests and R&D from 2007. Research on the development of digital substation operating system has been conducted mainly in large domestic companies, so the IED power application equipment for LCP are developed. However, there is still a lack of research in the field of systems that can accommodate all the field devices used for legacy substation and new digital substation. In this paper, we developed the 48VDC input modules and the 125VDC output modules which can construct proposed field information processing modules to IEC 61850 based type, and verified the field applicability from the state monitoring and control operation tests by using IEC 61850 client authentication program and Wireshark.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.8B
• /
• pp.1426-1437
• /
• 1999

The introduction of fast packet switching networks such as the ATM leads to the possibility of video services with constant quality. However, the fixed traffic descriptor(TD), which is defined by ATM Forum and ITU-T, can not simultaneously satisfy network efficiency and video quality. This paper presents fast resource reallocation protocol (FRRP) which can provide an effective compromise between network efficiency and video quality. This protocol reallocates the network resources and then adapts the traffic to the reallocated resources. In the proposed method, a video session is divided into several time-intervals according to its generated traffic and TD is calculated which well characterizes the traffic during the specific subdivided interval. In addition, a system model, where MPEG coding algorithm and network control are unified, is proposal and the performance of the FRRP in terms of cell loss rate(CLR) is evaluated though the simulation using real video traffic(Star Wars). Simulation results show that the FRRP has only 5 ~35% CLR of the fixed TD.