• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.05a
• /
• pp.487-489
• /
• 2016

In this paper, quad copter provides a method for preventing the possibility of accident in the air during a formation flight. The existing studies had a few studies upon the falls because quad copter formation flight was generally implemented indoors. Therefore, in this paper, we provide a self-diagnosis system to prevent a secondary accident for mismatching the Proportional-Integral-Derivative(PID) and detecting an abnormal communication modules each others in formation flying system. Scheme to be proposed, a system is that when one of the node meets a problem, the header node is sending the information of the current state to the server in the first and making a diagnosis itself in order to avoid the problems caused by dropping from the air. Therefore, if the difference between PID value of header node and slave node is greater than specified values or if it detects a defective sensors and communication modules, the proposed system is set to provide for moving toward a safe place. As a result, we expect that this proposed system is possible to minimize additional incidents by self adjusting the height through a self-diagnosis discovering flawed the acceleration sensor, gyro sensor and various attached sensors.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.05a
• /
• pp.505-508
• /
• 2016

In city, tracing of power transmission lines is difficult due to compound installation of overhead and underground lines, transposition, bad view caused by trees or big buildings. It is hard problem for electrical technician on site to trace power transformers or power lines to serve customers in 3 phase -4 wires power distribution systems. It is necessary that the correct and fast tracing method is required for load balancing among distribution lines. Old technology use to trace lines with high power impulse injection. Our proposed method uses to trace lines with very small power high frequency signal injection. Simulation models for 3-phase power transformers, 3-phase wire lines, and customer loads are described to investigate the transmission characteristics of high frequency power line carrier. Distribution lines have only a limited ability to carry higher frequencies. Typically power transformers in the distribution system prevent propagating the higher frequency carrier signal. The proposed method uses the limited propagation ability to identify the power transformer to serve customers. The system consists of a transmitter and a receiver with power-line communication module. Some experiments are conducted to verify the theoretical concepts in a big commercial building. Also some simulations are done to help and understand the concepts by using MATLAB Simulink simulator.

• The KIPS Transactions:PartC
• /
• v.13C no.3 s.106
• /
• pp.339-344
• /
• 2006

Secure delivery of multicast data can be achieved with the use of a group key for data encryption in mobile ad hoc network (MANET) applications based on the group communication. However, for the support of dynamic group membership, the group key has to be updated for each member joining/leaving and, consequently, a mechanism distributing an updated group key to members is required. The two major categories of the group key distribution mechanisms proposed for wired networks are the naive and the tree-based approaches. The naive approach is based on unicast, so it is not appropriate for large group communication environment. On the other hand, the tree-based approach is scalable in terms of the group size, but requires the reliable multicast mechanism for the group key distribution. In the sense that the reliable multicast mechanism requires a large amount of computing resources from mobile nodes, the tree-based approach is not desirable for the small-sized MANET environment. Therefore, in this paper, we propose a new key distribution protocol, called the proxy-based key management protocol (PROMPT), which is based on the naive approach in the small-sized MANET environment. PROMPT reduces the message overhead of the naive through the first-hop grouping from a source node and the last-hop grouping from proxy nodes using the characteristics of a wireless channel.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.10
• /
• pp.1994-2005
• /
• 2015

Voice over IP (VoIP) is a technology for the delivery of voice communications and multimedia sessions over Internet Protocol (IP) networks. Instead of being transmitted over a circuit-switched network, however, the digital information is packetized, and transmission occurs in the form of IP packets over a packet-switched network which consist of several layers of computers. VoIP Service that used the various techniques has many advantages such as a voice Service, multimedia and additional service with cheap cost and so on. But the various frauds arises using VoIP because VoIP has the existing vulnerabilities at the Internet and based on complex technologies, which in turn, involve different components, protocols, and interfaces. According to research results, during in 2012, 46 % of fraud calls being made in VoIP. The revenue loss is considerable by fraud call. Among we will analyze for Toll Bypass Fraud by the SIM Box that occurs mainly on the international call, and propose the measures that can detect. Typically, proposed solutions to detect Toll Bypass fraud used DPI(Deep Packet Inspection) based on a variety of detection methods that using the Signature or statistical information, but Fraudster has used a number of countermeasures to avoid it as well. Particularly a Fraudster used countermeasure that encrypt VoIP Call Setup/Termination of SIP Signal or voice and both. This paper proposes the solution that is identifying equipment of Toll Bypass fraud using those countermeasures. Through feature of Voice traffic analysis, to detect involved equipment, and those behavior analysis to identifying SIM Box or Service Sever of VoIP Service Providers.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37 no.5B
• /
• pp.385-394
• /
• 2012

The tactical mobile communication network, which comprises a part of the next-generation Tactical Information and Communication Network (TICN), provides means of communication and control for Tactical Multi-Functional Terminals (TMFT) belonging to a Mobile Subscriber Access Point (MSAP). The next-generation of MSAP is capable of constructing a backbone network via LCTR and HCTR directional antennas. At the same time, WMN modules are used to create and manage a wireless mesh backbone. When directional antennas are used in mobile environments, seamless services cannot be efficiently supported as the movement of the node prevents the angle of the antenna to constantly match. Therefore, data communication through the wireless mesh networks is required to provide direct communication between mobile MSAPs. Accordingly, mutual authentication and data encryption mechanisms are required to provide reliable data transmission in this environment. To provide efficient mutual authentication between MSAP devices, the process of verifying a certificate of the other MSAP device through its own authentication server is required. This paper proposes mutual authentication mechanisms where the MSAP requiring authentication and the MSAP that permits it initiates low-cost and efficient authentication in a distributed way. More specifically, we propose a method of applying EAP-ELS (Extensible Authentication Protocol-Transport Layer Security) in the next-generation TICN.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.1A
• /
• pp.33-43
• /
• 2010

Recently, users want to use real-time multimedia services, such as internet, VoIP, etc., using their IEEE 802.11 wireless lan mobile stations. In order to provide such services, a handoff among access points is essential to support the mobility of a node, in such an wide area. However, the legacy handoff methods of IEEE 802.11 technology are easy to lose connections. Also, the recognition of a disconnection and channel re-searching time make the major delay of the next AP to connect. In addition, because IEEE 802.11 decides the selection of an AP depending only on received signal strength, regardless of a node direction, position, etc., it cannot guarantee a stable bandwidth for communication. Therefore, in order to provide a real-time multimedia service, a node must reduce the disconnection time and needs an appropriate algorithm to support a sufficient communication bandwidth. In this paper, we suggest an algorithm which predicts a handoff point of a moving node by using GPS location information, and guarantees a high transmission bandwidth according to the signal strength and the distance. We implemented the suggested algorithm, and confirmed the superiority of our algorithm by reducing around 3.7ms of the layer-2 disconnection time, and guaranteed 24.8% of the communication bandwidth.

• The KIPS Transactions:PartC
• /
• v.16C no.1
• /
• pp.51-56
• /
• 2009

Time synchronization algorithm in wireless sensor networks is essential to various applications such as object tracking, data encryption, duplicate detection, and precise TDMA scheduling. This paper describes CDRS that is a time synchronization algorithm using the Clock Drift rate and Reference Signals between two sensor nodes. CDRS is composed of two steps. At first step, the time correction is calculated using offset and the clock drift rate between the two nodes based on the LTS method. Two nodes become a synchronized state and the time variance can be compensated by the clock drift rate. At second step, the synchronization node transmits reference signals periodically. This reference signals are used to calculate the time difference between nodes. When this value exceeds the maximum error tolerance, the first step is performed again for resynchronization. The simulation results on the performance analysis show that the time accuracy of the proposed algorithm is improved, and the energy consumption is reduced 2.5 times compared to the time synchronization algorithm with only LTS, because CDRS reduces the number of message about 50% compared to LTS and reference signals do not use the data space for timestamp.

• Journal of the Korea Society of Computer and Information
• /
• v.15 no.6
• /
• pp.11-18
• /
• 2010

In this paper, it introduced the device that was fabricated for monitoring sleeping positions of infants with 3-axis accelerometer. Sleep monitoring studies has been usually conducted two ways. To monitor sleeping posture by installing a camera and then recording of sleep in the sleeping room continuously is the first one. The other one is monitoring pressure sensor's results data for sleeping. Those two ways' benefits are that are able to get relatively accurate sleeping posture data but, there are many disadvantages like constraints of spaces and places, the installation of sensors or cameras, and high cost. In addition, it has a lot of problems that difficult to solve. For babies, it's not easy to apply, as well as uncomfortable. The proposed method uses a 3-axis accelerometer's X axis, Y axis, Z axis position output values in order to recognize the bad ground sleeping position that use of the buzzer alarm. This method uses a 3-axis acceleration sensor to measure the data and transmit sleeping posture using Bluetooth wireless in real time monitoring. The data is helpful for prevention safety hazard such as choked themselves when they slept back side on.

• Journal of the Korea Society of Computer and Information
• /
• v.15 no.7
• /
• pp.57-66
• /
• 2010

Due to the advancement of IPTV technologies, open IPTV services are a step closer to becoming reality. In such service environment, users are able to enjoy IPTV services using a variety of devices available at their home domain. However, it is impossible to get such flexible services at their convenience unless each of devices is individually connected to Set-Top-Box (STB) because of Conditional Access System (CAS) or service providers otherwise allow STB to freely distribute decoded contents to every user devices attached to STB. In this paper, we propose a key management scheme for securely distributing contents from STB to multiple user devices at home domain. The proposed scheme also makes the service providers be able to control the access rights to each of user devices without installing individual STBs. It is achieved by computationally dividing a private key of RSA signature scheme into three parts and thus makes possible to distribute the contents scrambled through a underlying CAS mechanism without re-encrypting them that the existing scheme should employ. It improves significantly computation and communication complexities, maintaining it as secure as the existing schemes. Additionally, it prevents misbehaving users from illegally distributing the contents from STB to their devices available at home domain.

• Journal of Digital Convergence
• /
• v.13 no.5
• /
• pp.213-218
• /
• 2015

In parallel with evolving information communication technology, M2M(Machine-to-Machine) industry has implemented multi-functional and high-performance systems, and made great strides with IoT(Internet of Things) and IoE(Internet of Everything). Authentication, confidentiality, anonymity, non-repudiation, data reliability, connectionless and traceability are prerequisites for communication security. Yet, the wireless transmission section in M2M communication is exposed to intruders' attacks. Any security issues attributable to M2M wireless communication protocols may lead to serious concerns including system faults, information leakage and privacy challenges. Therefore, mutual authentication and security are key components of protocol design. Recently, secure communication protocols have been regarded as highly important and explored as such. The present paper draws on hash function, random numbers, secret keys and session keys to design a secure communication protocol. Also, this paper tests the proposed protocol with a formal verification tool, Casper/FDR, to demonstrate its security against a range of intruders' attacks. In brief, the proposed protocol meets the security requirements, addressing the challenges without any problems.