• Proceedings of the Korean Geotechical Society Conference
• /
• 1996.10a
• /
• pp.237-248
• /
• 1996

• Geotechnical Engineering
• /
• v.12 no.4
• /
• pp.101-114
• /
• 1996

In this study, the characteristics of bearing capacity and deformation of intermediate soils are investigated through centrifuge tests. The experimental parameters are footing width, initial stress condition of soils and relative loading rate defined relationship of loading rate and permeability of soils. It is examined that loading rate influences on the bearing capacities and deformations. Based on the test results, some problem of existing specification are introduced in the view of related loading rates and load intensities. Especially it is showed that load intensities magnitude rlre reversed in the same settlement ratio(s/B(%)), due to partial drained effect as well as loading rates in undrained con dition based on the excess pore pressure and deformations measured under loading.

• Journal of the Korean Geotechnical Society
• /
• v.17 no.4
• /
• pp.161-171
• /
• 2001

점성토의 압밀거동은 투수성뿐만 아니라 변형 특성에 따라 크게 영향을 받으며, 변형 특성은 재하 방법에 따른 변형조건과 흙의 특성, 특히 이방성에 따라 다르게 나타난다. 이 논문에서는 점성토의 이방적 변형 특성이 압밀거동에 미치는 영향을 분석하기 위하여 다양한 변형 조건에 대한 압밀방정식과 압밀계수를 직교 이방성 탄성이론을 이용하여 유도하였다. 다양한 변형 조건에서 등방과 이방적 변형 특성하의 압밀계수를 평가하였으며, 그 결과 탄성계수의 이방성이 압밀계수에 미치는 영향이 매우 크고, 특히 수평방향의 변위가 허용되고, 수직방향의 변위가 구속될수록 크게 나타났다. 따라서 점성토 지반에 대한 하중 재하시 압밀소요시간의 정확한 예측을 위해서는 발생 가능한 변형 조건과 이방적 변형 특성에 대한 적절한 고려가 매우 중요함을 알 수 있었다.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.39 no.6
• /
• pp.779-788
• /
• 2019

The compaction grouting method is one of the conventional ground improvement methods, which consolidates and compacts the surrounding ground through the injection of grout materials with low mobility. Injecting the grout into the ground can improve the soil properties, as well as form a composite of soil-grout columns. However, the conventional grout pumping is not applicable to handle multiple injection holes at the same time, which may diminish its constructability when the construction time is not enough. This paper proposes a simultaneous multiple compaction-grouting method using a new pump system developed to cover up simultaneously three injection holes at a time. Field injection tests with a single injection hole and with triangular arrangement of injection holes were conducted to evaluate the applicability of the proposed method to soft clay ground. In addition, a series of standard penetration tests (SPTs) were performed to assess the efficiency of each arrangement in improving the soft ground. It is noted from the in-situ test results that the interval distances between injection holes and the elapse time for ground stabilization are the crucial factors governing the applicability of the simultaneous multiple compaction-grouting method to improve the soft clay ground.

• Journal of the Korean GEO-environmental Society
• /
• v.12 no.5
• /
• pp.29-36
• /
• 2011

In this study, settling experiment was performed about cohesive and sandy soils among representative sample expected to dredge and dump for analysis of settling and consolidation characteristic. The analysis showed the definite difference between cohesive soils and sandy soils of relationships with settling and consolidation coefficient, a water content, interfacial heights. But directly after a dredged reclamation, prediction results about a initial volume change showed that cohesive soil of a water content change was decreased rapidly as time goes by, but sandy soils made no difference in a water content change. Results were compared and analyzed with the settling and consolidation coefficient and a initial settling velocity by real soil amounts for a feasibility check about test conditions applied to these experiment: we judge that test conditions are appropriate, each material by such these analyses suggests the scope of settling and consolidation coefficient, average and the representative relational formula.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.03b
• /
• pp.559-566
• /
• 2000

본 연구에서는 비등방성 응력조건 하에서 콘 관입속도가 콘 관입시험 결과에 미치는 영향을 연구하기 위하여 유한요소해석 및 Calibration Chamber를 이용한 Miniature Piezocone의 관입시험이 수행되었으며 그 결과를 비교 분석하였다. 비등방성을 고려하기 위하여 Anisotropic Soil Model이 유한요소해석에 이용되었으며 LSU/CALCHAS(Louisiana State University Calibration Chamber System)가 Miniature Piezocone의 관입시험에 이용되었다. 콘 관입속도의 영향이외에도 OCR 및 필터위치의 영향을 고찰하였다.

• Journal of the Korean Geotechnical Society
• /
• v.16 no.3
• /
• pp.67-75
• /
• 2000

본 연구에서는 지반의 비등방성을 고려한 점탄소성 bounding surface 모델의 정확성을 검증하고 모델정수의 영향을 고찰하였다. 이를 위하여 모델을 컴퓨터 프로그래밍 하였으며 실내시험을 실시하였다. 실내시험으로는 표준압밀시험, 등방/비등방 압밀 삼축압축시험, 크리프 시험 등이 실시되었다. 연구결과, 컴퓨터 프로그램을 이용한 해석결과와 실내시험 결과는 잘 부합되었으며, 탄소성 모델정수의 영향은 크지 않았으나 점소성 모델정수의 영향은 해석결과에 큰 영향을 미치는 것으로 고찰되었다.

• Journal of the Korean Geotechnical Society
• /
• v.18 no.4
• /
• pp.55-64
• /
• 2002

In the present study, in order to apply a cyclic viscoelastic-viscoplastic constitutive model to multi-layered ground conditions during large earthquake, the numerical simulations of the 1995 Hyogoken Nanbu Earthquake at Port Island, Kobe, Japan, were performed by the seismic response analysis. From the seismic response analysis, it was found that the acceleration calculated from the cyclic elasto-viscoplastic model and cyclic viscoelastic-viscoplastic models for clay was in close agreement with the recorded accelerations at the Port Island down-hole array, and the cyclic elastic-viscoplastic and viscoelastic-viscoplastic constitutive models showed little different behavior characteristics near clay layer. Thus, the propriety of viscoplastic model for clay was convinced. Therefore, it can be concluded that a cyclic viscoelastic-viscoplastic constitutive model can give a good description of the amplification and also it showed accurate damping characteristics of clay during large event which induces plastic deformation in large strain range.

• Journal of the Korean Geotechnical Society
• /
• v.26 no.8
• /
• pp.67-75
• /
• 2010

In this study, a series of 1 g shaking table tests were carried out for a single pile in soft clay with various input acceleration amplitudes and frequencies. Based on the results, dynamic p-y curves were drawn and, in turn, the dynamic p-y backbone curve was formed by connecting the peak points, corresponding to the maximum soil resistance, of the dynamic p-y curves. In order to represent the p-y backbone curve numerically, Matlock's p-y formulations for clay was used to find the initial stiffness ($k_{ini}$) and the ultimate capacity ($p_u$) of the clay, both of which are required to formulate the p-y backbone curve as a hyperbolic function. The suggested p-y backbone curve was verified through comparisons with currently available p-y curves as well as other researchers' centrifuge test results and numerical analysis results.

• Geotechnical Engineering
• /
• v.13 no.6
• /
• pp.107-122
• /
• 1997

This paper presents a ground surface settlement prediction method for shield tunneling in cohesive soils. In order to develop the method, a parametric study on shield tunneling was performed by using a threetimensional elasto-plastic finite element analysis, which can simulate the construction procedure. By using the results of the finite element analysis, the ground movement mechanism was investigated and a base which relates the ground surface settlement and iuluencing factors was formed. The data base was then used to formulate semi -empirical equations for both surface settlement ratio above tunnel face and imflection point by means of a regression analysis. Furthermore, a prediction method for transverse and longitudinal surface settlement profiles was suggested by using the leveloped equations in conjunction with the normal probability curve. Effectiveness of the developed method was illustrated by comparing settlement profiles obtained by using the developed method with the results of finite element analysis and measured data. Based on the comparison, it was concluded that the developed method can be effectively rosed for practical applications at least within the conditions investigated.