• Journal of the Korean Geotechnical Society
• /
• v.17 no.2
• /
• pp.85-93
• /
• 2001

본 논문에서는 연약지반에 시공된 교대말뚝기초에 인접하여 성토하중이 재하될 때 발생하는 측방유동의 발생메커니즘을 규명하기 위해 3차원 유한요소해석을 수행하였다. 본 수치해석에서는 점성토 지반과 점성토-사질토 지반 그리고 사질토-점성토 지반에 선단지지된 강관말뚝에 대하여 성토하중 크기(q=20, 75, 100kPa)와 말뚝두부조건(변위구송, 회전구속) 그리고 말뚝중심간격(s=2.5d, 5.0d, 7.0d, 단독말뚝)에 따라 측방유동압의 분포형태와 크기를 분석하였다. 그 결과 측방유동압의 분포형태는 교대말뚝기초의 수평변위와 유사한 형태로 나타났으며 측방유동압의 크기는 배면 성토하중의 크기에 대한 비로써 결정할 수 있었다. 그리고 점성토 지반과 점성토-사질토 지반의 경우, 측방유동압의 분포형태와 크기는 말뚝두부조건에 가장 큰 영향을 받는 반면 사질토-점성토 지반의 경우에는 말뚝두부조건보다는 토층조건에 가장 큰 영향을 받는 것으로 분석되었다. 본 연구결과를 토대로 연약지반에 시공된 교대말뚝기초의 측방유동에 대한 설계 및 해석시 지침자료로서 측방유동압의 분포형태와 크기를 추천.제안한다.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.1C
• /
• pp.41-51
• /
• 2008

The load distribution and deformation of single piles which is embedded in Jumunjin sand and Kimhae clay are investigated, based on small scale model tests. Special attention is given to the consideration of flexural rigidity in laterally loaded piles. To consider the flexural rigidity of the pile, tests are performed with the aluminium piles of three different length under different relative densities and undrained shear strength. The test results indicate that the initial slope from the results of tests is proportional to the depth and pile-soil rigidity in both soils. But the increasing rate of the initial slope in the clay is less than in the sand. In addition, the soil resistance is more related to the depth and soil condition than the pile rigidity. Base on the test results, an empirical formula is proposed, which is good agreement with previously published small scale model test and field lateral load test.

• Journal of the Korean GEO-environmental Society
• /
• v.22 no.8
• /
• pp.13-19
• /
• 2021

In the case of construction on soft ground - such as national expressways sponsored by Social Overhead Capital (SOC) - many problems occur due to excessive settlement: therefore, an accurate settlement prediction has a major impact on the selection of improvement methods, project budget and construction period. Most of the settlement prediction methods currently used in projects apply Terzaghi's Theory of One-Dimensional Consolidation which assumes the uniformity of the depth of the soft ground. However, the results of soft ground settlement predictions vary when the target layer is divided into multiple horizontal layers. This study analyzed the change in the consolidation settlement behavior according to the horizontal division of soft ground as well as with different loading height.

• Journal of the Korean Geosynthetics Society
• /
• v.12 no.1
• /
• pp.21-28
• /
• 2013

This study proposed optimum lime contents for clayey soils consisting of representative clay minerals, Kaolinite and Na-Bentonite, according to optimum lime content method (ASTM C 977-22) by means of ground improvement method of clayey soils. As geotechnical properties, the variations of atterberg limits and unconfined compressive strength were analyzed and Ca-ion and micro-structure along elapsed time were observed for lime-added clayey specimens. The test results show that optimum lime content method provides an appropriate methodology for ground improvement of clayey soils and the variation of $Ca^{2+}$ might be a good index to predict the rate of ground improvement for clayey soils with lime addition.

• Journal of the Korean Geotechnical Society
• /
• v.21 no.1
• /
• pp.43-50
• /
• 2005

Jet grouting method is widely being used in many geotechnical problems, especially for the purpose of reinforcement of clayey ground and cut-off wall of sandy ground. However, its design depends on highly empirical method, in which many researches have been undertaken. This study investigated the effect of cavitation on jet grouting. Small-scaled model tests were carried out using specially designed and fabricated device to analyze the effect of cavitation on jet grouting with various test conditions including ground condition, injection pressure, and injection time. The test results show that cavitation has a significant effect on jet grouting, and it has a potential for engineering application.

• Journal of Korea Water Resources Association
• /
• v.54 no.12
• /
• pp.1275-1284
• /
• 2021

This paper presents a machine learning technique applied to prediction of time-dependent local scour around bridge piers in both non-cohesive and cohesive beds. The support vector machines (SVM), which is known to be free from overfitting, is used. The time-dependent scour depths are expressed by 7 and 9 variables for the non-cohesive and cohesive beds, respectively. The SVM models are trained and validated with time series data from different sources of experiments. Resulting Mean Absolute Percentage Error (MAPE) indicates that the models are trained and validated properly. Comparisons are made with the results from Choi and Choi's formula and Scour Rate in Cohesive Soils (SRICOS) method by Briaud et al., as well as measured data. This study reveals that the SVM is capable of predicting time-dependent local scour in both non-cohesive and cohesive beds under the condition that sufficient data of good quality are provided.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.55 no.5
• /
• pp.59-69
• /
• 2013

본 연구에서는 동적 점탄-점소성 구성식에 기초한 다층지반의 1차원 액상화 해석을 수행하였다. 일본 고베 포트아일랜드에서 발생한 1995 Hyogoken Nanbu 지진에 대하여 지반 모델링을 하였으며, 사질토 지반에는 탄소성 모델을, 점성토 지반에는 점탄-점소성 모델 및 탄-점소성 모델을 각각 적용하였다. 본 연구 결과, 모델 지반의 경우 지표 10 m 아래를 전후하여 액상화가 발생하였으며 액상화가 발생한 지반을 통과하는 지진파는 감쇠특성을 나타내고 이 때 전단변형률을 크게 증가시켰다. 또한, 대변형률 영역에서의 점성토의 동적거동 해석에서는 점소성 거동특성이 지배적이므로 점소성 모델의 적용이 중요함을 알 수 있었다. 한편 동적 점탄-점소성 구성모델은 대변형률 영역에서 점성토의 소성변형을 유발하는 대형 지진 발생시 점성토의 증폭 및 감쇠특성 분석에 적용 가능한 모델임을 확인하였다.

• Journal of Korean Society of Disaster and Security
• /
• v.12 no.2
• /
• pp.57-63
• /
• 2019

The road sinks in the sewer line or subway section are affected by the ground characteristics. Therefore, it is necessary to accurately identify the relationship between the soil properties and the ground motion in the area where cavities occurred in order to establish a countermeasure against the road sink. In this paper, simulation was performed by using EDEM program, which is one of the Discrete Element Method programs, for sandy soil and clayey soil, which are most common in alluvial deposits, with different locations and sizes of cavities in the underground. As a result, it was found that the sink size occurred more in the sandy soil than in the cohesive soil. Deeper and larger cavity is more likely to occur the road sink In the sand soil model while road sink in the clay model is easy to occur when the cavity is more shallower.

• Journal of the Korean Geotechnical Society
• /
• v.27 no.5
• /
• pp.5-15
• /
• 2011

Recent increase of large scale construction near costal area has also increased the application of soft ground treatment. As a result, solidification with cement and lime which increases stability and durability of soils, is frequently used for surface layer stabilization in soft ground site. While stabilization of very soft clay with high plasticity and compressibility has widely been studied, studies on silty clay with low plasticity and compressibility are relatively rare. In this study, after stabilizing low plasticity silty clay of Songdo area with cement and lime under various water contents, mixing ratio, and curing time, uniaxial compression test and plate load test were performed. Strength properties from both tests were considerably consistent. And trackability of construction equipment on the treated surface layer of dredged land was estimated. Finally, optimum mixing condition for Songdo silty clay was proposed.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.16 no.6
• /
• pp.507-520
• /
• 2014

In this study, the surface displacement was investigated according to the various depth of cover when the tunnel excavation equipment was used in a clay soil. For this the laboratory scaled model test was carried out using the soil sample similar to the in-situ conditions. We carried out four tests according to tunnel depth(1.5D, 2.0D, 2.5D, 3.0D). The distribution of impact due to tunnelling was quantitatively analyzed in the three-dimension by measuring the surface displacement. In addition, the pattern of surface displacements was figured out.