• Journal of Satellite, Information and Communications
• /
• v.12 no.1
• /
• pp.132-136
• /
• 2017

In this paper, expanded lowest operating frequency by adopting circular slot on ground of balun and balance improved balance performances by stacking dielectric layer balun is proposed. Bandwidth of proposed balun is 1~7 GHz, and electrical length is $0.05{\lambda}$ at 1 GHz. In order to check performances of the proposed balun, simple dipole is integrated with the balun and radiation pattern of dipole is measured.

• Korean Journal of Remote Sensing
• /
• v.37 no.5_1
• /
• pp.1013-1027
• /
• 2021

Images taken with KOMPSAT-3 have additional NIR and PAN bands, as well as RGB regions of the visible ray band, compared to imagestaken with a standard camera. Furthermore, electrical and optical properties must be considered because a wide radius area of approximately 17 km or more is photographed at an altitude of 685 km above the ground. In other words, the camera sensor of KOMPSAT-3 is distorted by each CCD pixel, characteristics of each band,sensitivity and time-dependent change, CCD geometry. In order to solve the distortion, correction of the sensors is essential. In this paper, we propose a method for detecting uniform regions in side-slider-based KOMPSAT-3 images using segment-based noise analysis. After detecting a uniform area with the corresponding algorithm, a correction table was created for each sensor to apply the non-uniformity correction algorithm, and satellite image correction was performed using the created correction table. As a result, the proposed method reduced the distortion of the satellite image,such as vertical noise, compared to the conventional method. The relative radiation accuracy index, which is an index based on mean square error (RA) and an index based on absolute error (RE), wasfound to have a comparative advantage of 0.3 percent and 0.15 percent, respectively, over the conventional method.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.10
• /
• pp.134-140
• /
• 2007

In recent years, power equipment and system standards have been increasing in both number and complexity. The standards that will soon be introduced to KOREA is the transmission system standards for harmonic emission limits assessing in distorting loads. Utility engineers, being under increasing time constraints, are turning more and more to software to quickly solve problems. This paper describes the methodology used to implement the above standards in Microsoft Excel in order to assist utility engineers to readily apply these standards in practical situations.

• Journal of IKEEE
• /
• v.11 no.4
• /
• pp.219-226
• /
• 2007

An efficient block based two-layer JPEG encoding algorithm is proposed to compress high dynamic range (HDR) images in this work. The proposed algorithm separates an input HDR image into a tone-mapped low dynamic range (LDR) image and a ratio image, which represents the quotients of the original HDR pixels divided by the tone-mapped LDR pixels. Then, the tone-mapped LDR image is compressed using the standard JPEG scheme to preserve backward compatibility and the ratio image is encoded to minimize a cost function that models the perception of each block with different quantization parameters in the human visual system (HVS). Simulation results show that the proposed algorithm provides better performance than the conventional method, which encodes the ratio image without any prior information of blocks.

• Journal of IKEEE
• /
• v.4 no.2 s.7
• /
• pp.225-232
• /
• 2000

Dead time which is inserted in PWM signals of VSI distorts the inverter output voltage waveforms and deteriorate the control performance of an induction machine by producing torque ripples. In this paper, dead time compensation method in a vector controlled induction machine is proposed. The method is based on a feedforward approach that compensates dead time effect by adding the compensating voltages to the inverter output voltage references in 2 phase stationary frame. The proposed method is only software intensive and easy to realize without additional hardware. The experimental results show the validity and effectiveness of the proposed method.

• Journal of Broadcast Engineering
• /
• v.25 no.6
• /
• pp.1004-1012
• /
• 2020

We present a novel content-preserving seam estimation algorithm for real-time high-resolution video stitching. Seam estimation is one of the fundamental steps in image/video stitching. It is to minimize visual artifacts in the transition areas between images. Typical seam estimation algorithms are based on optimization methods that demand intensive computations and large memory. The algorithms, however, often fail to avoid objects and results in cropped or duplicated objects. They also lack temporal consistency and induce flickering between frames. Hence, we propose an efficient and temporarily-consistent seam estimation algorithm that utilizes a straight line. The proposed method also uses convolutional neural network-based instance segmentation to locate seam at out-of-objects. Experimental results demonstrate that the proposed method produces visually plausible stitched videos with minimal visual artifacts in real-time.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.14 no.2
• /
• pp.160-167
• /
• 2009

To detect islanding mode when the grid is being tripped is a major safety issue in the Utility Interactive Photo Voltaic (UIPV) system. In this paper, analytical design method is suggested for AFD & RPV method under IEEE 929-2000 recommended islanding test condition. We have discussed that there is a same point. we injected reactive component of the current by AFD & RPV methods, but the current reference generated is other waveform. Possible if amount of reactive components in this methods are same each method, there is happened same rates frequency variation. To verify the validity of the analytical comparison, this paper presents simulation and experimental results from single phase, 3[kW] inverter for the transformerless UIPV system.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.9 s.339
• /
• pp.49-56
• /
• 2005

Memory effect, which influence the performance of Doherty amplifier, become more significant and critical in designing these circuits as the modulation signal bandwidth and operation power level increase. This paper reports on an attempt to investigate, model and quantity the contribution of the electrical nonlinearity effects and the thermal memory effects to a Doherty amplifier's distortion generation. Also this raper reports on the development of an accurate dynamic expression of the instantaneous junction temperature as a function of the instantaneous dissipated power. This expression has been used in the construction of an electrothermal model for the Doherty amplifier. Parameters for the nelv proposed behavior model were determined from the Doherty amplifier measurements obtained under different excitation conditions. This study led us to conclude that the effects of the transistor self-heating phenomenon are important for signals with wideband modulation bandwidth(ex. W-CDMA or UMTS signal). Doherty amplifier with electrothermal memory effect compensator enhanced ACLR performance about 20 dB than without electrothemal memory effect compensator. Experiment results were mesured by 60W LDMOS Doherty amplifier and electrothermal memory effect compensator was simulated by ADS.

• Korean Journal of Optics and Photonics
• /
• v.31 no.6
• /
• pp.247-258
• /
• 2020

In this paper, based on a stochastic parallel gradient descent (SPGD) algorithm we study phase control of a coherent-beam-combining system under turbulent atmospheric conditions. Based on the statistical theory of atmospheric turbulence, we carry out the analysis of the phase and wavefront distortion of a laser beam propagating through a turbulent atmospheric medium. We also conduct numerical simulations of a coherent-beam-combining system with 7- and 19-channel laser beams distorted by atmospheric turbulence. Through numerical simulations, we characterize the phase-control characteristics and efficiency of the coherent-beam-combining system under various degrees of atmospheric turbulence. It is verified that the SPGD algorithm is capable of realizing 7-channel coherent beam combining with a beam-combining efficiency of more than 90%, even under the turbulent atmospheric conditions up to cn2 of 10-13 m-2/3. In the case of 19-channel coherent beam combining, it is shown that the same turbulent atmospheric conditions result in a drastic reduction of the beam-combining efficiency down to 60%, due to the elevated impact of the corresponding refractive-index inhomogeneity. In addition, by putting together the number of iterations of the SPGD algorithm required for phase locking under atmospheric turbulence and the time intervals of atmospheric phenomena, which typically are of the order of ㎲, it is estimated that hundreds of MHz to a few GHz of computing bandwidth of SPGD-based phase control may be required for a coherent-beam-combining system to confront such turbulent atmospheric conditions. We expect the results of this paper to be useful for quantitatively analyzing and predicting the effects of atmospheric turbulence on the SPGD-based phase-control performance of a coherent-beam-combining system.

• Journal of Broadcast Engineering
• /
• v.24 no.2
• /
• pp.306-314
• /
• 2019

Since the resolutions of videos increase rapidly, there are continuing needs for effective video compression methods despite an increase in the transmission bandwidth. In order to satisfy such a demand, a reconstructive video coding (RVC) method by using a super resolution has been proposed. Since RVC reduces the resolution of the input video, when frames are compressed to the same size, the number of bits per pixel increases, thereby reducing coding artifacts caused by video coding. However, RVC method using super resolution is not effective in all target bitrates. Comparing the size of the loss generated while downsizing the resolution and the size of the loss caused by the video compression, only when the size of loss generated in the video compression is larger, RVC method can perform the improved compression performance compared to direct video coding. In particular, since HEVC has considerably higher compression performance than the previous standard video codec, it can be experimentally confirmed that the compression distortions become larger than the distortions of downsizing the resolution only in the very low-bitrate conditions. In this paper, we applied RVC based HEVC in various video types and measured the target bitrates that RVC method can be effectively applied.