• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.7
• /
• pp.310-316
• /
• 2019

In automotive application, customers are demanding high efficiency and various functions for convenience. The demand for these automotive applications is steadily increasing. In this study, it has been studied the analysis of heat flow to improve the PCB(printed circuit board) heating performance of WPC (wireless power charger) recently developed for convenience. The charging performance of the wireless charger has been reduced due to power dissipation and thermal resistance of PCB. Therefore, it has been proposed optimal PCB design, layout and position of electronic parts through the simulation of heat flow analysis and PCB design was analyzed and decided at each design stage. Then, the experimental test is performed to verify the consistency of the analysis results under actual environmental conditions. In this paper, The PCB modeling and heat flow simulation in transient response were performed using HyperLynx Thermal and FloTHERM. In addition, the measurement was performed using infrared thermal imaging camera and used to verify the analysis results. In the final comparison, the error between analysis and experiment was found to be less than 10 % and the heating performance of PCB was also improved.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.47 no.4
• /
• pp.309-318
• /
• 2019

The thermal design of the Lunar Terrain Imager (LUTI) on the Korean Pathfinder Lunar Orbiter (KPLO) was performed and the soundness of the thermal design was verified by thermal analysis. The thermal environment of the lunar mission orbit should be reflected in the thermal design because the IR radiation of the lunar surface is important, unlike the earth orbit. The components or modules exposed to the outside of the satellite are insulated with MLI as much as possible, but the camera tube and the radiator are functionally exposed, so the thermal shield using the concept of radiation shape factor is mounted on the front to mitigate IR radiation. The IR emissivity is important in the front side of the radiator that receives little solar radiation, and components that are susceptible to thermal deformation such as the tube use a radiation heater to minimize the temperature gradient. Through the investigation of computational results, it was confirmed that the thermal design of LUTI is stable in various situations.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.40 no.6
• /
• pp.173-179
• /
• 2012

The experiments, which analyze the injury symptoms and diagnose growth conditions utilizing IRVT and analyzing each parts of H. helix L., had been held under a low temperature. Greenhouse and outdoor growing Genus hedera had been prepared and compared with each Genus hedera's peak and bottom leaves' surface temperature under the experimental categories $-6^{\circ}C$ and $-12^{\circ}C$. As results, analyzing the surface thermal property of peak part leaves' of outdoor growing Genus hedera, at experimental categories $-6^{\circ}C$, $-12^{\circ}C$ were ranged from $-2^{\circ}C{\sim}-7^{\circ}C$ and $-2^{\circ}C{\sim}-15^{\circ}C$. On the other hand, the surface thermal property of bottom part leaves at experimental categories $-6^{\circ}C$, $-12^{\circ}C$ were ranged $-2^{\circ}C{\sim}-11^{\circ}C$ and $-1^{\circ}C{\sim}-12^{\circ}C$. It appears that the thermal properties of leaves' surface on $-6^{\circ}C$ peaks and $-12^{\circ}C$ bottoms were more broadband than bottoms and peaks. It means that the peaks were more sensitive than bottoms, as like $-2^{\circ}C{\sim}-15^{\circ}C$, $-1{\sim}-12^{\circ}C$. Moreover, as similar results had seen to leaves surface temperature added to cold wind conditions. How the cold wind damaged the outdoor growing Genus hedera, analyzed the surface thermal property by IRVT data under $0^{\circ}C$, $-2^{\circ}C$, $-4^{\circ}C$ condition, it resulted to $-6.2^{\circ}C$, $-6.8^{\circ}C$, $-7.5^{\circ}C$. It appeared more $3.5{\sim}6.2^{\circ}C$ low temperature than experimental setting point. In addition, each parts thurmal property of peaks and bottoms was not similar, it referred to each parts' sensitivities of low temperature were different on the peak and bottom leaves surface temperature.

• Journal of the Korean Chemical Society
• /
• v.39 no.7
• /
• pp.501-507
• /
• 1995

The electronic structure of cis-$[Cr(cyclam)Cl_2]Cl$ has been investigated by the emission and excitation spectroscopy at 77K, and infrared and visible spectroscopy at room temperature. The ten electronic transitions due to spin-allowed and spin-forbidden are assigned. The zero-phonon line in the excitation spectrum splits into two components by $139\;cm^{-1}$, and it can be reproduced by modern ligand field theory. According to the results of ligand field analysis, we can confirm that nitrogen atoms of the cyclam ligand have a strong ${\sigma}$-donor character, but chloride ligand has weak ${\sigma}-$ and ${\pi}-$donor properties toward chromium(III) ion.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.18 no.8
• /
• pp.678-685
• /
• 2006

Analysis of drying characteristics has been carried out with one-dimensional model in the dryer using the principle of the refraction of radiation. The dryer is composed of hot water tank, plastic film conveyer belt, drying material, etc. The model considers the con-duction and radiation within the plastic film and drying material. The film is semitransparent to radiation and the drying material is assumed to be semitransparent or opaque to radiation. The results show that the effect of radiative transfer on the drying rate is relatively large when the thickness of drying material is small and the water temperature is high. When the material is thin, the drying rate due to conduction is also enhanced and the drying time can considerably be reduced.

• Journal of Sensor Science and Technology
• /
• v.27 no.5
• /
• pp.294-299
• /
• 2018

This article describes the output properties of non-dispersive infrared carbon dioxide($CO_2$) sensors resulting from the changes in ambient temperatures. After the developed sensor module was installed inside the gas chamber, the temperature was set to 267 K, 277 K, 300 K, and 314 K, and the concentrations of $CO_2$ gas were increased from 0 to 5,000 ppm. Then, the output voltage at each concentration was obtained. Through these experimental results, two observations were made. First, both the $CO_2$ sensor and the reference sensor showed an increase in the output voltages as the temperature rose from 0 ppm, Second, the full scale outputs of the $CO_2$ sensor grew as the temperature increased. The output characteristics were analyzed based on two factors: change in the radiant energy of the infrared light source and change in the absorptivity of $CO_2$ gas according to the ambient temperature. Additionally, temperature compensation methods were discussed.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.1 no.2
• /
• pp.27-31
• /
• 2000

Thermal imaging system is implemented for the measurement and the analysis of the thermal distribution of the target objects. The main Part of the system is thermal camera in which a focal plane array typed sensor is introduced The sensor detects mid-range infrared spectrum or target objects and then it output generic video signal which should be processed to form a thermal image frame. A digital signal processor(DSP) in the system inputs analog to digital converted data. performs algorithms to improve the thermal images and then outputs the corrected frame data to frame buffers for NTSC encoding and for digital outputs.. To enhance the quality of the thermal images, two point correction method is applied. Figures indicate that the corrected thermal images are much improved.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.9
• /
• pp.2065-2070
• /
• 2010

The diluted PMMA treated $SiO_2$ films as an passivation materials for semiconductor devices was researched by using the FTIR spectra. The diluted PMMA solution with various ratios changed the surface of $SiO_2$ film as the hydrophilic, hydrophobic or hybrid type properties. The sample 7 with little carbon content showed dramatically the chemical variation by the FTIR spectra analysis. Beacuse the little carbon with electrons decreased the polarity and surface energy on the $SiO_2$ film, and then became a stable bonding structure and decreased the leakage current. The FTIR spectra can define the detail variation due to the chemical reaction on the organic thin film, and help to research the characteristic of the organic materials.

• Journal of Radiation Protection and Research
• /
• v.8 no.2
• /
• pp.1-7
• /
• 1983

S-2-($\omega-aminoalkylamino) ethyl dihydrogen phosphorothioates and S-2-($\omega$-aminoalkylamino) ethyl isothiuronium bromides were prepared from easily available starting compounds via convenient synthetic processes. The isothiuronium derivatives showed extreme drug toxicities as compared to that of AET, which seemed to be due to an intramolecular rearrangement of these compounds. The propyl derivative of the phosphorothioate could show better radioprotective effect than those of AET and WR-638, whereas the ethyl derivative of the equivalent drug dose revealed far less protective effect. The correlation between radioprotective effects, drug toxicities, and chemical structures were discussed through infrared spectroscopy.

• Journal of the Korean Chemical Society
• /
• v.50 no.3
• /
• pp.183-189
• /
• 2006

A series of substituted styryl 4-methoxy-1-naphthyl ketones [(2E)-1-(4-methoxy-1-naphthyl)-3-phenyl-2-propen-1-ones] were synthesized using facile method of microwave assisted condensation reaction. The yield of chalcones is more than 90%. They are characterized by their physical constants, micro analysis, infrared (KBr, 4000-400 cm？1) and NMR both 1H and 13C spectral data. From infrared spectra, the s-cis and s-trans stretching vibrations of carbonyl group, from NMR spectra the ethylenic proton and carbon chemical shifts (ppm) are assigned. These spectral data are correlated with various Hammett substituent constants. From the results of statistical analysis the effect of substituents on CO, ？ and ？ proton and carbons are explained.