• Journal of the Korean Institute of Intelligent Systems
• /
• v.26 no.4
• /
• pp.273-278
• /
• 2016

In this paper, chaotic circuit of the Lorentz system using multipliers, operational amplifiers, capacitor, fixed resistor and variable resistor for control has been designed in a electronic circuit. Through PSPICE program, electrical characteristics such as time waveforms, frequency spectra and phase attractors analyzed. And in the special area ($10{\sim}100k{\Omega}$) of the $500k{\Omega}$ control variable resistor, the circuit showed chaotic dynamics. Also, we implemented the circuit in a electronic hardware system with discrete elements. Measured results of the circuit coincided with simulated data.

• Journal of the Korean Magnetics Society
• /
• v.9 no.6
• /
• pp.306-311
• /
• 1999

$La_{2/3}Sr_{1/3}MnO_3(LSMO)/YSZ/SiO_2/Si(100)$ polycrystalline thin films were fabricated be chelated sol-gel method The effect of YSZ buffer layer at low field (120 Oe) spin-polarized tunneling magnetotransport (TMR) properties of LSMO thin film was studied at room temperature. Single perovskite LSMO thin films was obtained. The maximum TMR ratio was increased from 0.2 to 0.42 % by the insertion of YSZ buffer. YSZ as diffusion barrier was attributed to the fine microstructure of LSMO thin films and the reduction of dead layer between LSMO and $SiO_2/Si(100)$ interfaces.

• Journal of the Society of Naval Architects of Korea
• /
• v.36 no.4
• /
• pp.56-63
• /
• 1999

The seakeeping and resistance tests of a 47.7m class catamaran are conducted in a towing tank with the 1/21.5 scale model. The effect of the trim tab on the resistance is investigated with the trim tab angle variations and the resistance and trim angle of the catamaran with the trim tab are compared with those without the trim tab. The heave and pitch motions are measured at the three full scale speeds in sea state of 3.4 and 5 and the vertical accelerations at five points on the deck are also measured. The measured accelerations are compared with the criteria of ISO 2631/3 and it is shown that the seakeeping performance of the catamaran is good.

• Journal of the Korean Magnetics Society
• /
• v.14 no.4
• /
• pp.115-119
• /
• 2004

We measured in-plane 2 dimensional magnetization vector using two pick-up coil sets and investigate the relationship between magnetization vector and anisotropic magnetoresistance. We can determine magnetization vector by measuring magnetic moment in x and y direction simultaneously. As the uniaxial magnetic anisotropy of permalloy film increases, magnetoresistance approaches the expectation which is calculated from the angle between current vector and magnetization vector. Magnetoresistance ratio is linearly proportional to the y moment magnitude which is parallel to the current direction.

• The Korean Journal of Pesticide Science
• /
• v.4 no.2
• /
• pp.1-10
• /
• 2000

Fungicide resistance study in Korea is still in its infancy, and most of those resistance studies are largely limited to newness of the detected resistant strains. In future, detection of fungicide-resistant strains has to be based on sensitivity distribution of pathogen populations to certain fungicides, and standard levels of certain fungicides for resistance should be determined under the basis of this data. Most of the early research on fungicide resistance in Korea has overlooked this point, and resulted in inconsistency and confusion for monitoring sensitivity shift of pathogen population among individual researchers. Fungicide resistance detected in vitro tests has to be documented in field trials by examining control efficacy against resistant and wild-type pathogen populations. Resistance detection in wife has to be correlated with lower activity in practice. Using this process, fungicide resistance will have a practical meaning. Fitness evaluation of resistant strains for survival is, in particular, of importance to determine the future stability of the resistance in the pathogen population. In fields, sensitivity change of pathogen populations should be carefully monitored with and without fungicide selection pressures to establish long-term management strategies against fungicide resistance. It is becoming an urgent task to provide information through research for designing and implementing successful counter-measures against fungicide resistance problems in Korea.

• Journal of the Korean GEO-environmental Society
• /
• v.18 no.10
• /
• pp.23-34
• /
• 2017

As the electrical property of fully saturated soils is dependent on the pore water, it has been commonly used for the detection of the contamination into the ground. The objective of this study is to investigate the electrical characteristics according to the salinity and the lead concentration in fully saturated soils. Fresh water and saline water with the salinity of 1%, 2% and 3%, which are mixed with 6 different lead solutions with the range of 0~10 mg/L, are prepared in the cylindrical cell incorporated with sensors for measuring electrical resistance and time domain reflectometry signal. Then, the dried sands are water-pluviated into the cell. The electrical resistance and the time domain reflectometry signal are used to estimate the electrical conductivity. Test results show that electrical conductivity determined from electrical resistance at the frequency of 1 kHz continuously increases with an increase in the lead concentration, thus it may be used for the estimation of the contaminant level. In addition, the electrical conductivity estimated by the time domain reflectometry changes even at very low concentration of lead, the variation rate decreases as the lead concentration increases. Thus, the time domain reflectometry can be used for the investigation of the heavy metal leakage. This study demonstrates that complementary characteristics of electrical resistance and time domain reflectometry may be used for the detection of the leakage and contamination of heavy metal in coastal and marine environments.

• Bulletin of the Society of Naval Architects of Korea
• /
• v.25 no.4
• /
• pp.28-38
• /
• 1988

This paper describes the statistical analysis method of predicting the ship resistance. The equation for the wavemaking resistance coefficient is derived as the principal dimensions and sectional area coefficients by using the wavemaking resistance theory and its regression coefficients are determined from the regression analysis of the resistance test results. The equation for the form factor is derived by purely regression analysis of the principal dimensions, sectional area coefficients and resistance test results. Also, it is shown that the wavemaking resistance can be minimize by varying the sectional area curve without changing the principal dimensions of the ship. This methods were applied to the resistance prediction of a bulk carrier. And the, the modified hull form with minimum wavemaking resistance was obtained and the reduction of effective power was confirmed by the resistance test.

• Proceedings of the KIEE Conference
• /
• 2004.07c
• /
• pp.1848-1850
• /
• 2004

변압기에 사용되는 절연유의 열화정도를 변압기의 운전정지 없이 실시간으로 측정할 수 있는 전기용량을 이용한 센서를 개발하였다. 개발된 전기용량형 센서는 3-전극형의 구조와 변압기에 센서의 외부상자가 접지 될 때 2중의 정전차폐가 되도록 하여 외부로부터의 잡음에 영향을 받지 않도록 하였다. 또한 변압기에서 절연유의 온도변화에 따른 유전율 변화를 보상하기위하여 기준용 센서와 측정용 센서를 한개의 변압기에 장착함으로 온도보상이 되도록 하였다. 제작된 센서는 변압기에서 절연유의 사용기간에 따른 유전율의 변화를 정확히 측정하였으며, 절연유의 체적저항의 변화도 감지 할 수가 있다. 따라서 센서에서 출력되는 신호를 phase sensitive detector를 사용하여 유전율의 변화로 혹은 체적저항의 변화로도 나타내 보일 수가 있다.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.196-196
• /
• 2013

가시광 영역에서의 높은 투과도와 낮은 전기 비저항을 갖는 ITO (Indium Tin Oxide) 박막은 현재 Display, Solar Cell, LED, Smart Phone 등 최첨단 IT산업에서 가장 많이 사용되고 있는 투명전극소재이다. IBD (Ion Beam Deposition)방법은 박막의 증착 방법 중 Plasma에서 독립적으로 이온만을 빔의 형태로 조사하여 박막을 증착하는 방법으로 기존 RF 또는 DC 스퍼터방법에 비해서 상대적으로 높은 진공도(low 10E-04 torr)와 비교적 높은 스퍼터 된 입자의 에너지를 가지는 등의 장점으로 증착 된 박막의 밀도, 거칠기가 향상되고 상대적으로 적은 결함을 가지는 박막의 제작에 사용되고 있는 기술이다. (주)인포비온에서는 IBD 기술과 더불어 표면만을 선택적으로 가열할 수 있는 EBA Technology를 사용하여 박막에 Energy를 전달하고, 이를 바탕으로 ITO 박막의 전기적, 광학적, 구조적인 특성의 변화를 관찰 연구했다 [1]. 본 연구에서는 기존의 Sputter 방법과 IBD 방법으로 증착 된 ITO 박막의 전기적, 광학적, 구조적인 특성 변화를 비교 관찰하였고, EBA 후처리로 ITO 박막을 상온에서 처리하여, 박막의 투과도, 면 저항, 미세구조의 변화를 관찰하였다. 각 특성의 변화는 UV-VIS, 4Point-Probe, TEM을 사용하여 분석하였고, 처리 전, 후의 박막의 결합에너지는 XPS로, 박막의 조성변화는 SIMS를 이용하여 각각 분석하였다.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.02a
• /
• pp.221-221
• /
• 2010

NiO 산화물 타겟을 이용한 RF 마그네트론 스퍼터 방법로 glass 기판 위에 NiO 온도를 R.T(room temperature)~$400^{\circ}C$ 변화시켜 Ar 가스만을 사용하여 박막을 증착시켜, 증착 온도에 따라 NiO 박막 특성에 미치는 영향을 조사하였다. XRD 측정으로부터 증착된 박막의 결정구조는 $200^{\circ}C$이하에서 (111) 면의 우선 배향성으로 보이다가 $300^{\circ}C$ 이상에서 (220)의 우선 배향성으로 보이는 다결정 입방구조임을 확인하였다. NiO 박막의 전기적 특성의 변화는 기판의 온도가 $200^{\circ}C$까지는 $10^5\;{\Omega}cm$대를 보였고 기판의 온도가 $300^{\circ}C$ 이상에서는 $10^{-2}{\sim}10^{-1}{\Omega}cm$대로 감소하는 것을 관측하였다. 이러한 ${\sim}10^7$ 정도의 큰 저항 변화를 관측하였고, 전기적 변화 특성을 결정성, 결정립의 변화 및 NEXAFS를 통한 밴드 구조 변화 등으로 설명하였다.