• 한국추진공학회지
• /
• 제19권2호
• /
• pp.81-87
• /
• 2015

디젤 엔진에서 저압 배기재순환 시스템의 적용을 통한 질소산화물 저감과 연비 향상에 관한 효과를 확인하였다. 엔진의 정상 상태 및 과도 상태에서 시험이 진행되었으며, 차량상사를 통한 NEDC 모드 테스트를 위하여 별도의 제어로직도 개발되었다. 정상 상태의 시험결과에서 저압 배기재순환 시스템은 고압 배기재순환 시스템에 비하여 질소산화물 저감 및 연비 향상에 유리함을 확인하였고, NEDC 모드 테스트 결과로부터 배출가스의 증가없이 연비를 향상시킬 수 있는 것으로 나타났다.

• 대한기계학회논문집B
• /
• 제35권5호
• /
• pp.525-531
• /
• 2011

디젤엔진에서 배기가스 재순환(EGR; Exhaust Gas Recirculation)은 선택적 환원 촉매나 $NO_x$ 흡장 촉 매에 비해 $NO_x$ 배출 저감을 위한 가장 효과적인 기술이다. 점점 더 강화되어 가는 $NO_x$ 배출 규제를 만족시키기 위해서는 많은 양의 EGR 가스 공급이 필요하다. 저압 EGR은 일정한 과급 압력에서 가변형상 터보차져의 제어와 거의 독립적이기 때문에 EGR 공급 측면에서 보면 저압 EGR이 기존의 고압 EGR에 비해서 더 많은 장점을 갖는다. 본 연구에서는 저압 EGR이 연소 특성에 미치는 영향을 고압 EGR을 적용했을 때와 비교하였다. 각 EGR 루프에 대해 혼합기의 희석 정도에 따른 영향을 분석하기 위해 독립변수로써 희석비를 사용하였다. 저압 EGR을 적용하였을 때, 고압 EGR을 적용했을 때와 동등한 $NO_x$ 배출량을 유지하면서 연료 소비율과 매연 배출은 고압 EGR의 경우보다 좀 더 낮은 결과를 보였다.

• Journal of Advanced Marine Engineering and Technology
• /
• 제35권4호
• /
• pp.379-387
• /
• 2011

최근 디젤엔진에서 엔진성능향상 및 배출가스저감을 위해 저압 EGR시스템에 대하여 연구개발이 활발히 진행되고 있다. 저압 EGR시스템은 EGR율에 따라 과급압력이 영향을 받지 않기 때문에 PM을 최소 화하면서 $NO_x$를 저감할 수 있는 장점을 갖고 있다. 본 연구에서는 2.0L급 고속직분사방식의 엔진에서 출력 및 연비저하로 EGR적용이 어려운 엔진회전수 2000 rpm, BMEP 1.0 MPa, 과급압력 181.3 kPa인 중부하 운전영역에서 서로 다른 EGR시스템에 따른 엔진성능 및 배출가스 특성을 실험적으로 연구하였다. 그 결과로서 기존의 고압 EGR시스템 또는 배압조절밸브를 사용하는 저압 EGR시스템에 비하여 ETC를 적용한 저압 EGR시스템이 $NO_x$ 배출특성은 큰 차이가 없는 반면에, 연비 및 열효율이 향상되고 PM 저감에 연소효과를 나타내고 있음을 확인하였다.

• 한국자동차공학회논문집
• /
• 제22권6호
• /
• pp.120-127
• /
• 2014

Robustness and controllability are the key factors in internal combustion engine commercialization. This study focuses on the combustion strategy to commercialize the low temperature diesel combustion technology. Various LTC combustion methods such as PPCI, MK and highly diluted mixing controlled LTC were conducted on 6.0L heavy duty diesel engine. To find the best feasible LTC strategy, emission level, fuel consumption and combustion safety during the combustion mode change were considered. Experiments were carried out under various engine operating conditions; engine speed & load, EGR level, injection timing. Finally, this study suggests realizable LTC combustion strategy; moderate EGR level and slight early injection are possible to considerably lower PM, NOx emission and expand LTC operating range up to 50% load without CO and HC emission.

• 한국자동차공학회논문집
• /
• 제22권6호
• /
• pp.83-88
• /
• 2014

LTC(Low Temperature Combustion) technology has been studied to see feasibility of the combustion technology applied to heavy-duty engines on the laboratory scale. This study succeeded to develop a demo engine including realized low temperature combustion under partial load conditions. To find the best feasible LTC strategy, various LTC combustion methods such as PPCI, MK and highly diluted mixing controlled LTC were conducted on 6.0L heavy duty diesel engine. Air management system was re-designed to make these combustion scheme stable and the re-designed air system helped expand LTC operating range. This study finally revealed plausible LTC concept to maximize benefit of the alternative combustion technology while overcoming handicaps of the LTC strategy.

• 한국자동차공학회논문집
• /
• 제10권6호
• /
• pp.59-64
• /
• 2002

The effects of EGR on emissions were investigated by using a six-cylinder, 8 litre, turbo-charged, heavy-duty diesel engine with a low pressure route EGR system. The experiments were performed at various engine loads while the EGR rates were set from 0% to 30%. Hot and cooled EGR are achieved without cooling and with cooling respectively. To verify the possibility of EGR technology for the applications, test were performed with steady state test cycle. It was found that the exhaust emissions with the EGR system resulted in a very large reduction in oxides of nitrogen at the expense of higher smoke and PM emissions. Increasing the EGR rate leads to deteriorating specific fuel consumption and power at lower speed and higher load. Also, the reduction rates of NOx emissions for hot and cooled EGR are similar.

• 한국공작기계학회논문집
• /
• 제15권1호
• /
• pp.76-81
• /
• 2006

Modem after-treatment technology has been developed variously in order to decrease exhausted emission in diesel engine. However, it seems very difficult to comply with updated stringent emission standards. Specially, it has been many years that exhaust gas from gasoline automobile rather than from diesel is the major object concerned by Korea and other countries, and it is strongly required on the reduction techniques on harmful NOx and PM among those compositions. Thus, this research focused on the electronic control EGR and the target for this research is heavy-duty turbo-diesel engine with EGR technology(High pressure route and low pressure route system).

• 한국산학기술학회논문지
• /
• 제3권1호
• /
• pp.58-62
• /
• 2002

본 연구는 기관의 성능과 배출가스의 ECR 효과을 대한 것으로 기관은 6실린더 11리터의 대형터보디젤기관이며 ECR 방식은 저압루트시스템을 적용하였다. EGR 작동방식은 기계시이며 터빈 출구로부터 압축기 입구로 재순환시키는 방식이다. 또한 실험은 기관회전수와 부하별로 변경시켰으며 ECR율은 4%와 8%로 고정하여 실험하였고 그 결과를 기존 기관의 성능 및 배출가스결과와 비교 분석하였다. 따라서 본 연구의 목적은 대형터보디젤기관에 폭넓은 작동범위에서 ECR에 의한 기관 및 배출가스 성능에 미치는 영향을 고찰하고자 한다.

• 한국자동차공학회논문집
• /
• 제14권1호
• /
• pp.115-122
• /
• 2006

EGR system has been widely used to reduce NOx emission in light duty diesel engines, but its application to heavy duty diesel engine is not common yet. In this study, simulation model for EURO-3 engine was developed using commercial code WAVE and then verified by comparison with experimental results in performance and emission. Possibility to meet EURO-4 regulation using modified EURO-3 engine with LPL EGR system was studied. Each components of the engine was modeled using CATIA and WaveMesher. The engine test mode was ESC 13 and injection timing and quantity were changed to compensate engine performances, because applying EGR causes power reduction. As a results of the simulation, it was found that EURO-4 NOx regulation could be achieved by applying LPL EGR system to current EURO-3 engine even with some BSFC deterioration.

• 한국자동차공학회논문집
• /
• 제20권6호
• /
• pp.140-145
• /
• 2012

Recently, various after-treatment systems, such as LP-EGR(Low Pressure-Exhaust Gas Recirculation), SCR(Selective Catalytic Reduction) and LNT(Lean NOx Trap), were developed to obey the stringent emission regulations of diesel engine. There are many researches on LP-EGR system because it has advantages of NOx reduction and low fuel consumption. But, condensation water is generated in internal of intercooler tube and it contains various types of anion that cause the corrosion of aluminium tube. In this study, it is examined that the condensation water effects on corrosion of aluminium tube. And method for improvement of corrosion characteristics is investigated using the dipping and electrochemical test.