• Proceedings of the KIEE Conference
• /
• 2011.07a
• /
• pp.5-6
• /
• 2011

자계 공진(Magnetic resonance)을 이용한 무선전력전송을 위해 새로운 형태의 동축형 구조를 가지는 자기 공진 코일(Self-Resonant Coil)을 제안한다. 코일은 헬리컬 코일과 동축형 커패시터로 구성된다. 공진 주파수를 조정하기 위해 동축 구조는 병렬로 연결하고, 코일의 Q-factor를 높이기 위해 리츠 코일을 병렬로 연결하였다. 제안된 자기 공진 코일은 소형으로 제작이 가능하며, 우수한 전력전송특성을 가진다.

• Journal of the Korean Magnetics Society
• /
• v.23 no.5
• /
• pp.173-177
• /
• 2013

This work describes the experimental investigations on sloshing characteristics of water and ferrofluid as working fluids in the spherical container with the horizontal oscillation motion and compared the results obtained by two working fluids. In order to Investigate the sloshing characteristics of the sphere container with the horizontal oscillation, experiments are performed with the magnetic intensities from 0 mT to 50 mT and horizontal oscillation motions from 5 mm to 15 mm. As results, Ferrofluid without magnetic field in the sphere container showed a similar liquid surface movement with water. The resonance point of the ferrofluid in the sphere container happened at higher value than that of the theoretical resonance frequency with the rise of the magnetic field. In addition, the sloshing characteristics of the ferrofluid in the sphere container can be controlled with the resonance frequency with the magnetic intensity and the liquid surface displacement could be also controlled.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.19 no.2
• /
• pp.355-360
• /
• 2024

In this paper, in implementing a 4-coil resonant wireless power transmission system, we studied the discharge phenomenon that occurs at the end of the transmitting resonance coil. Resonant wireless power transmission consists of a power supply coil, a transmitting resonance coil, a power receiving resonance coil, and a load coil. The transmitting resonance coil serves to amplify the magnetic field generated from the power supply coil and transmits it to the front receiving resonance coil. When a high current flows through the power supply coil in order to transmit large power, a high voltage is induced at the end of the transmitting resonance coil. It causes line-to-line discharge. Line-to-line discharge phenomenon damages the transmitter case and renders the transmitter unusable. Therefore, in order to eliminate this line-to-line discharge phenomenon, the voltage induced in the transmitting resonance coil that causes line-to-line discharge was analyzed and a solution was proposed.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.35 no.4
• /
• pp.333-341
• /
• 2022

Magnetoelectric (ME) composites are comprised of magnetostrictive and piezoelectric phases. Lots of theoretical and experimental works have been done on ME composites in the last couple of decades. The output performance of ME composites has been enhanced by optimizing the constituent phases, interface layer, dimensions of the ME composites, different operating modes, etc. However, the detailed information about the characterization of ME coupling in ME composites is not provided yet. Therefore, in this tutorial paper, we are giving an insight into the details of measurements of ME voltage coefficient of ME composites both at off-resonance and resonance conditions. A symmetric type Gelfenol/PMN-PZT/Gelfenol ME composites were fabricated by sandwiching (011) 32-mode PMN-PZT single crystal between two Galfenol plates by epoxy bonding are used for the example of ME coupling measurement. The details about the experimental setup used for the measurement of ME voltage coefficient are provided. Furthermore, a step-by-step measurement of ME voltage coefficient using computerized program is demonstrated. We believe the present experimental measurement details can help readers to understand the concept of ME coupling and its analysis.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.4
• /
• pp.466-473
• /
• 2013

In this paper, a compact planar multi-loop self-resonant coil of high quality factor with a coaxial cross section is proposed for effective wireless charging. The proposed coil has high Q-factor and a resonant frequency of a coil can be easily controlled by adjusting distributed capacitance. For designing the coil, a self-inductance and a distributed capacitance are calculated theoretically. The self-inductance is calculated from the sum of the mutual energies between small circular loops that are made by dividing the cross section of the coil. To verify its properties and calculation results, the self-resonant coils are fabricated by using a coaxial cable with characteristic impedance of $50{\Omega}$. The measured frequencies are very consistent with the calculated ones. In addition, the resonant frequency can be adjusted slightly by the tuning parameter ${\gamma}$. The resonant coils are applied to a tablet PC, the Q-factors of the Tx and Rx resonant coils are 282 and 135, respectively. As a result of measurement when height between the two resonant coils is 4.4 cm, the power transfer efficiency is more than 80 % within a radius of 5 cm.

• Journal of the Korean Magnetics Society
• /
• v.25 no.1
• /
• pp.27-30
• /
• 2015

In this study, the LC resonators were fabricated with ferrite cores and external capacitors, and then their characteristics were investigated for the purpose of developing new displacement sensor. The frequency dependence of impedance of single resonator was estimated. There were two resonance peaks on the impedance spectrum; one by self inductance and the other by mutual inductance. The resonance frequency was shifted linearly in direct proportion to displacement of the resonator showing the proposed device, a pair of LC resonators, could be used a precision displacement sensor.

• Proceedings of the KIPE Conference
• /
• 2017.07a
• /
• pp.316-317
• /
• 2017

본 논문에서는 새로운 자기 공진형 무선 전력 전송 시스템을 제안한다. 송신부 2개를 배치하여 기존의 1 대 1 자기 공진보다 더욱 넓은 범위를 확보하여 실용성을 높이고자 한다. 동일한 송신부 2개를 배치하여 자기장의 세기를 높임으로써 수신부에 전송되는 전력의 크기 및 거리를 증대시킬 수 있다. 또한, 송 수신코일의 위치에 따라 서로 다른 출력 전력을 위상 제어를 통하여 다양한 범위의 일정한 전력을 제어할 수 있다. 이때 위상천이를 하지 않을 시에 고정된 입력 전류가 흐르게 된다. 하지만 위상천이, 즉 2개의 송신코일에서 전달하는 전류 조절을 시도함으로써 수신 측으로 전달하여 일정한 전력을 얻을 수 있었다. 실험을 통해, 기존의 방식보다 높은 성능을 가짐을 확인하였다.

• Proceedings of the KIPE Conference
• /
• 2011.07a
• /
• pp.17-18
• /
• 2011

최근 소형화 및 고효율화를 목적으로 한 전력변환기 개발이 활발히 이루어지고 있고 이에 별도의 공진을 위한 리액터를 추가할 필요 없이 효율 및 고정 출력전압을 이룰 수 있는 LLC 공진형 컨버터에 대한 연구가 활발히 이루어지고 있다. 이러한 이유로 본 논문에서는 LLC 공진형 타입의 DC/DC 컨버터를 채택하여, 자기회로 분할 방식의 변합기 구조를 통해 출력측에서의 균등한 부하분담이 가능한 10kW급 자기회로 분할구조를 갖는 LLC 공진형 DC/DC 컨버터를 제안하였고, 실험을 통해 타당성을 입증하였다.

• Proceedings of the Optical Society of Korea Conference
• /
• 2000.08a
• /
• pp.70-71
• /
• 2000

세슘빔 공진기에서 세슘D$_2$ 전이선으로 광펌핑된 원자가 램지공진기에서 마이크로파의 주파수에 따른 초미세준위의 바닥상태간의 원자밀도 전이에 의한 형광 신호의 분포를 펌핑광의 세기에 따라 관측하였다. 펌핑광의 편광방향이 자기장에 나란한 $\pi$편광일 때 각 제만부준위의 마이크로파 전이 신호는 mF=0을 중심으로 $\pm$mF의 신호세기가 대칭적이었으나 펌핑광의 편광 방향이 자기장에 수직인 $\sigma$ $\pm$ 인 경우에는 비대칭적임을 확인하였다. 이것은 펌핑광의 주파수가 세슘빔 공진기에서의 세슘공진주파수에서 detuning이 있는 것에 의한 것으로 예상하였다. 이를 확인하기 위해 원자밀도행렬방정식으로 세슘빔공진기에서 마이크로파 전이신호를 계산하였다. 펌핑광의 세기와 편광방향, detuning에 따른 마이크로파 전이신호의 분포가 실험치와 잘 일치함을 알 수 있었다. 이 연구는 세슘빔 원자공진기에서 펌핑광의 주파수가 세슘공진주파수에 detuning된 정도를 관측할 수 있는 방법을 제시해 준다. (중략)

• Journal of the Korean Magnetics Society
• /
• v.17 no.3
• /
• pp.141-146
• /
• 2007

A new class of LC-resonator for micro magnetic sensor device was invented and fabricated by means of MEMS technique. The micro LC-resonator consists of a solenoidal micro-inductor with a bundle of soft magnetic microwire cores and a capacitor connected in parallel to the micro-inductor. The core magnetic material is a tiny glass coated $Co_{83.2}B_{3.3}Si_{5.9}Mn_{7.6}$ microwire fabricated by a glasscoated melt spinning technique. The core materials were annealed at various temperatures $150^{\circ}C,\;200^{\circ}C\;,250^{\circ}C\;,$ and $300^{\circ}C$ for 1 hour in a vacuum to improve soft magnetic properties. The solenoidal micro-inductors fabricated by MEMS technique were $500{\sim}1,000{\mu}m$ in length with $10{\sim}20$ turns. The changes of inductance as a function of external magnetic field in micro-inductors with properly annealed microwire cores were varied as much as 370%. Since the permeability of ultra soft magnetic microwire is changing rapidly as a function of external magnetic field. The inductance ratio as well as magnetoimpedance ratio (MIR) in a LC-resonator was varied drastically as a function of external magnetic field. The MIR curves can be tuned very precisely to obtain maximum sensitivity. A prototype magnetic sensor device consisting of the developed microinductors with a multivibrator circuit was test successfully.