• The Transactions of the Korean Institute of Power Electronics
• /
• v.13 no.6
• /
• pp.469-475
• /
• 2008

In this paper, control of small PEM(Proton Exchange Membrane) fuel cell stack by a microprocessor is introduced. The water management of fuel cell stack inside, a key technique in fuel cell control, can be achieved by adjusting the required air flow for fuel and cooling, and by purging the excessive water from the stack. It is very important to precisely control the BOS(Balance of Stack) since the stable operation of the fuel cell system mainly depends on it. In this study the fuel efficiency of the system is improved by the control of the system based on the measured air flow and purge cycle during the optimal operation and its effectiveness is proved by the experiments. The operating stability of the system is improved by the developed controller using a microprocessor and it is expected to be widely used for the control of small PEM fuel cell stack.

• KSBB Journal
• /
• v.19 no.3
• /
• pp.236-240
• /
• 2004

Korean wastewaters have higher nitrogen concentrations than typical wastewaters of other countries. Most treatment processes such as activated sludge processes will need to supplement extra carbon sources for a complete removal of remaining nitrogen after the initial wastewater treatment, Because of these difficult matters, we have searched wastewater treatment methods that require no additional carbon sources. Wastewater treatment by microalgae in photobioreactors, using a green eukaryotic microalgae, Chlorella kessleri, showed a promising results and thus was selected to study further. This system is not intended to replace the conventional system but is to assist the existing biological treatment systems as a supplemental nitrogen removal process. Thus the secondary treated livestock wastewater was tested. Column type photobioreactors developed in our laboratory were used. When aerated with 5% CO$_2$ balanced with air at 1 vvm and illuminated at 100 ${\mu}$mol/㎡/s under 25$^{\circ}C$ and PH 7-8 by CO$_2$ buffering effect, the maximum nitrogen removal rate was 2.6 mg/L/hr. The results confirmed a possibility of microalgal wastewater treatment system as a secondary system to remove extra nitrogen sources. Based on these experimental results, the size of the optimal microalgal wastewater system was calculated. For the wastewater whose initial nitrogen concentration of 150 mg/L, the optimal batch system was found to be a 2 stage system with a combined retention time of 4.6 day. From the continuous experiments, nitrogen removal rates were examined under different dilution rates and 2 stage system was also found to be the optimal system. The combined retention time for the continuous system was 3.5 days. It is expected that conventional biological wastewater treatment systems followed by microalgal systems would reliably decrease the nitrogen concentration below the government criteria even for the livestock wastewater with low C/N ratio.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.6B
• /
• pp.553-558
• /
• 2009

There have been various research efforts to support the fairness between uplink and downlink of TCP streams in IEEE 802.11 networks. Existing methods, which have been effective for the fairness, however could not provide the solution for the unfairness caused by the situation in which a station which is having multiple TCP uplink streams monopolizes the uplink bandwidth. This paper proposes a method that AP allocates token buckets for each uplink TCP station. The proposed method is also able to support the fairness between the uplink and downlink. To remedy the underutilization which may happen under token bucket-based schemes, it allows the movement of redundant tokens among the token buckets. By controlling the token movements, it can balance the fairness and the utilization. Simulation results show that the proposed method is able to support the fairness of the TCP uplink stations, as well as the fairness between the uplink and downlink.

• Journal of KIISE:Computing Practices and Letters
• /
• v.15 no.6
• /
• pp.425-429
• /
• 2009

Recently, Chen et al.'s proposed mutual authentication scheme based on the quadratic resiidue, finding the squaring root problem, for avoiding exhaustive search on the server. But, if a malicious reader sends same random value, the tag is traced by an adversary. Moreover, there is realization problem because of its limited ability to compute squaring and hash function. In this paper, we analyze Chen et al.'s scheme and its weakness. Furthermore we present an improved mutual authentication scheme based on the quadratic residue which solves the tracing problem by generating random value on the tag and uses only squaring. We also make the scheme satisfy to forward secrecy without updating and synchronizing and avoid exhaustive search.

• Environmental and Resource Economics Review
• /
• v.25 no.2
• /
• pp.255-276
• /
• 2016

This paper is designed to investigate the dynamic structure of optimal tariff imposed by the oil importing country from OPEC when OPEC increases the oil reserves through exploration and development. For this purpose, we used a Stckelberg differential game modeling approach, and tried to analyze two cases such that the one is the extraction cost is dependent on the oil reserves and the other is the extraction cost is independent of it. On the basis of this analysis, we propose that the importing contry has to impose dynamically inconsistent tariffs if the extraction cost is dependent on the oil reserves. Otherwise, she should impose dynamically consistent tariffs announced at initial time. In addition, we found that whether or not the exporting country uses some portion of oil produced for domestic consumption does not affect our policy proposition stated above.

• Survey Research
• /
• v.3 no.2
• /
• pp.47-76
• /
• 2002

Starting point bias arises in the iterative bidding framework when the initial bid influences respondent's final bids. The bidding game has become the most commonly used method of asking the valuation question in contingent valuation studies. A bidding game is typically conducted by either personal or telephone interview. Bidding begins with an interviewer positing an initial bid (starting bid) to a respondent. If the respondent is willing to pay the initial bid, the interviewer revises the bid upward until a negative respondent is obtained. A negative response to the initial bid downward until an acceptable amount is found. The final bid is a measure of the respondent's Hicksian compensating or equivalent surplus for the item being valued. This paper explicity tested for starting point bias in bidding games. That is, it was asked whether final bids are influenced by the magnitude of the starting bids in the process of valuating the WTP when to improve the quality of running water in Seoul and its vicinity. The result shows staring point bias exists in the present data and its magnitude is ${\delta}$=-0.265237.

• Journal of Korea Technology Innovation Society
• /
• v.16 no.2
• /
• pp.391-407
• /
• 2013

The paper tests the embodiment hypothesis by measuring the technological obsolescence of a specific year (1990)'s technology and investigating the relationship between labor productivity and technological obsolescence. This approach is based on Salter (1969) that emphasizes the economic aspect of technology. We use the rate of economic surplus as the proxy of technological obsolescence for 10 main industries, including food processing, textiles, chemicals, non-steel metals, steels, metal products, machinery, electronics, precision machinery, and transportation equipments. The result shows that the embodiment hypothesis is not accepted for the overall manufacturing sector. However, we found the vintage effect - a positive relationship between technological obsolescence and labor productivity over time - in textiles, chemicals, non-steel metals, metal products, electronics, and transportation equipments. Therefore, the government should support R&D investment as well as capital equipments investment for the industries with large vintage effect.

• Tunnel and Underground Space
• /
• v.25 no.2
• /
• pp.115-124
• /
• 2015

Thermal energy storage (TES) is a technology that stores surplus thermal energy at high or low temperatures for later use when the customer needs it, not just when it is available. TES systems can help balance energy demand and supply and thus improve the overall efficiency of energy systems. Furthermore, the conversion and storage of intermittent renewable resources in the form of thermal energy can help increase the share of renewable resources in the energy mix which refers to the distribution of energy consumption from different sources, and to achieve this, it is essential to combine renewable resources with TES systems. Underground TES using rock caverns, known as cavern thermal energy storage (CTES), is a viable option for large-scale, long-term TES utilization although its applications are limited because of the high construction costs. Furthermore, the heat loss in CTES can significantly be reduced due to the heating of the surrounding rock occurred during long-term TES, which is a distinctive advantage over aboveground TES, in which the heat loss to the surroundings is significantly influenced by climate conditions. In this paper, we introduced important factors that should be considered in the shape and multiple layout design of TES caverns, and proposed guidelines for storage space design.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.15 no.1
• /
• pp.299-309
• /
• 1995

A geometrical inverse heat conduction problem is solved for the development of Infrared Computerized-Axial-Tomography (IR CAT) Scan by using a boundary element method in conjunction with regularization procedure. In this problem, an overspecified temperature condition by infrared scanning is provided on the surface, and is used together with other conditions to solve the position of an unknown boundary (cavity). An auxiliary problem is introduced in the solution of this problem. By defining a hypothetical inner boundary for the auxiliary problem domain, the cavity is located interior to the domain and its position is determined by solving a potential problem. Boundary element method with regularization procedure is used to solve this problem, and the effects of regularization on the inverse solution method are investigated by means of numerical analysis.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.49 no.1
• /
• pp.18-28
• /
• 2013

It was compared the estimated parameters by the surplus production from three different models, i.e., three types (Schaefer, Gulland, and Schnute) of the traditional surplus production models, a stock production model incorporating covariates (ASPIC) model and a maximum entropy (ME) model. We also evaluated the performance of models in the estimation of their parameters. The maximum sustainable yield (MSY) of small yellow croaker (Pseudosciaena polyactis) in Korean waters ranged from 35,061 metric tons (mt) by Gulland model to 44,844mt by ME model, and fishing effort at MSY ($f_{MSY}$) ranged from 262,188hauls by Schnute model to 355,200hauls by ME model. The lowest root mean square error (RMSE) for small yellow croaker was obtained from the Gulland surplus production model, while the highest RMSE was from Schnute model. However, the highest coefficient of determination ($R^2$) was from the ME model, but the ASPIC model yielded the lowest coefficient. On the other hand, the MSY of Kapenta (Limnothrissa miodon) ranged from 16,880 mt by ASPIC model to 25,373mt by ME model, and $f_{MSY}$, from 94,580hauls by ASPIC model to 225,490hauls by Schnute model. In this case, both the lowest root mean square error (RMSE) and the highest coefficient of determination ($R^2$) were obtained from the ME model, which showed relatively better fits of data to the model, indicating that the ME model is statistically more stable and robust than other models. Moreover, the ME model could provide additional ecologically useful parameters such as, biomass at MSY ($B_{MSY}$), carrying capacity of the population (K), catchability coefficient (q) and the intrinsic rate of population growth (r).