• 한국정밀공학회지
• /
• 제16권7호
• /
• pp.58-65
• /
• 1999

Hard turning offers many possible benefits over grinding such as lower equipment costs, shorter setup time, reduced process steps and better surface integrity. Despite the amount of research in this area, there exists no data in the intermittent hard turning. The objective of this paper is to investigate the effect of CBN tool materials and machinability to an intermittent hard turning. To this end, different CBN materials were tested to evaluate the tool wear and surface roughness in an intermittent hard turning. It is found that low-CBN-content tool is better than high-CBN-content tool. Then, we discussed a cutting force, vibration, and CBN tool wear mechanism from the hard turning.

• 한국공작기계학회논문집
• /
• 제16권4호
• /
• pp.119-126
• /
• 2007

Generally, the machinability of materials that have a good mechanical properties is poor. The material having a high strength, high toughness in high temperature and wear resistance, it is difficult to remove a chip from workpiece. STD11 and NAK80 are kinds of these materials and these materials can be used in many industrial fields. But it is limited in use because of high cost and poor machinability. In this experimental study, the cutting of STD11 and NAK80 were used to decide the machinability and the tool shape of CBN ball end mill. From the results, the CBN ball end mill is verified that the estimated cutting edge shape of rake angle 30 degree has consistent effect on the tool wear and cutting force.

• 한국세라믹학회지
• /
• 제34권3호
• /
• pp.249-256
• /
• 1997

100-500KHz범위의 주파수전원을 인가하여 발생한 플라즈마를 이용하여 질화붕소(boron nitride)막의 합성시 육방정상(hexagonal phase)과 입방정상(cubic phase)의 생성거동을 관찰하였다. BCl3와 NH3를 붕소와 질소의 공급기체로 선택하였고 Ar과 수소를 carrier기체로 사용하였다. 합성변수로는 플라즈마전원의 전압, 기판의 bias, 합성압력, 기체의 조성, 기판의 온도이었는데, 합성된 박막은 FT-IR결과로부터 육방정과 입방정의 혼합상으로 나타났고, 각 상의 분률은 변수의 크기에 의존하였다. TEM분석결과 육방정으로만 구성된 박막은 비정질상으로 이루어졌으며, 입방정과 육방정의 혼합상의 경우는 비정질기지상에 수십 nanometer크기의 입방정입자가 분산된 구조를 하고 있었다.