• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.4 no.3
• /
• pp.139-145
• /
• 1992

In this paper, a technique to separate the incident and reflected waves in the flume tests is investigated. Using a least squares method, the separation technique has been formulated systematically. This method is applicable to the regular and irregular wave conditions. To illustrate its validity and applicability, numerical experiments have been carried out for both regular and irregular wave conditions. It was found that the method gives perfect results for the conditions without signal noises, and yields reasonable results even for the conditions with 30% signal noises of incident wave height. Hydraulic experiments have been also performed to prove its applicability of the method for real situations.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1998.10a
• /
• pp.133-136
• /
• 1998

0.1 내지 $4 \mum$의 입도분포를 가진 kaolin용액을 dead-end형 여과 장치(Amicon Cell, 8050)를 이용하여 공칭세공이 $0.2 \mum$인 PTFE막으로 농도 및 운전압력에 따른 투과실험을 하였다. Kaolin 용액의 투과유속은 케이크 저항이 지배적이었으며 초기에는 분리막 표면에 케이크가 형성되고 그 후에 분리막 세공의 오염이 발생하는 것으로 관찰되었다.

• Resources Recycling
• /
• v.10 no.3
• /
• pp.14-22
• /
• 2001

For the recycle of coal fly ash generated from power stations, we developed an electrocyclone system which can separate unburned carbon form coal fly ash, based on the fact that coarse fly ash particles contain higher amount of unburned carbon and unburned carbon particles are charged positively, and pure ash particles are charged negatively on contacting each other. Additionally, guide vanes were installed in the cyclone to control the cut size. Two types of electrode, stick and grid type, were designed to investigate the effect of electrode type. Results show that by introducing an electric field inside the cyclone, the yield increases by 5 to 15e1o. But the content of unburned carbon in the clean ash does not change significantly.

• Food Science of Animal Resources
• /
• v.30 no.1
• /
• pp.95-101
• /
• 2010

Folate loaded WPI (whey protein isolate) nanoparticles were prepared using the cold-induced gelation process. The aim of this work was to investigate the effects of process parameters, such as the concentration of the WPI solution, pH, temperature, etc, on the properties of nanoparticles. The results show that the smallest nanoparticles were obtained when a WPI concentration of 1% was used at a pH of 8.0 (<330 nm). In the case of the concentration of $CaCO_3$, the smallest particles were obtained at a concentration of 5 mM. Alginate produced the smallest mean size with the narrowest particle size distribution, while the largest particles were prepared with k-carrageenan. As the w:o ratio increased, the mean particle size also increased. When the release profile was analyzed, the particles were shown to be stable for more than 6 h at a pH of 1.2, where almost all of the folic acid was released within 2 h in the dissolution media of PBS at a pH of 7.4. Thus, the process parameters appear to be important factors that affect the properties of nanoparticles.

• Proceedings of the Korea Contents Association Conference
• /
• 2013.05a
• /
• pp.289-290
• /
• 2013

이 논문은 얼굴의 기하학적 특징을 이용한 표정인식 시스템을 제안한다. 먼저 얼굴 인식 시스템으로 Haar-like feature의 특징 마스크를 이용한 방법을 적용하였다 인식된 얼굴은 눈을 포함하고 있는 얼굴 상위 부분과 입을 포함하고 있는 얼굴 하위 부분으로 분리한다. 그래서 얼굴 요소 추출에 용이하게 된다. 얼굴 요소 추출은 PCA를 통한 고유 얼굴의 고유 눈과 고유 입의 템플릿 매칭으로 추출하였다. 얼굴 요소는 눈과 입이 있으며 두 요소의 기하학적 특징을 통하여 표정을 인식한다. 눈과 입의 특징 값은 실험을 통하여 정한 각 표정별 임계 값과 비교하여 표정이 인식된다. 본 논문은 기존의 논문에서 거의 사용하지 않는 눈동자의 비율을 적용하여 기존의 표정인식 알고리즘보다 인식률을 높이는 방향으로 제안되었다. 실험결과 기존의 논문보다 인식률이 개선됨을 확인 할 수 있었다.

• Explosives and Blasting
• /
• v.18 no.4
• /
• pp.43-54
• /
• 2000

본 연구에서는 계단식 발파에서 파쇄입도에 영향을 미치는 변수들로부터 대괴를 줄이는 새로운 발파패턴을 제시하고자 하였다. 광주 제2순환도로 대절토 구간에서 천공경, 1회발파공수, 화약의 종류 등의 영향을 파쇄암의 평균입자의 크기와 상위 5개의 대괴 평균치로 나타내었다. 그 결과 대괴의 크기는 평균 파쇄암의 크기와 선형적인 추이를 나타내었으며 평균파쇄도는 저폭속 폭약인ANFO가 NewMITE 보다 좋은 결과를 보였다. 또 천공경 65 mm와 75 mm로 ANFO즉 사용했을 때 파쇄도는 약포의 직경이 작은 경우에 파쇄도가 양호하게 나타났고 총공수와 파쇄도를 살펴본 결과 평균파쇄도와 대괴의 크기는 대제적으로 총공수의 증가에 비례하여 커지는 경향이었으며 평균파쇄도 보다는 대괴의 크기가 증가의 폭이 컸다. 한편 첫째 열을 2단 분리장약했을 때가 일반 발파나 1열 소단벤치발파 때보다 파쇄도가 좋았다.

• Membrane Journal
• /
• v.18 no.1
• /
• pp.103-107
• /
• 2008

Membrane process has been focused as an alternative separation process because not only it exhibits a high selectivity compared with a traditional distillation process, but also it is known to be an energy saving separation process. Inorganic membrane, especially zeolite membrane, has been studied since it can be operated in severe conditions compared to the organic membranes. Recently, new zeolite materials are tested as an inorganic membrane material to overcome disadvantages of existing zeolite membranes. Kalsilite can be used as an inorganic membrane material for gas separation and selective water separation from water/organic mixtures because it is expected to be hydrophilic resulted from Si/Al ratio of 1 like zeolite 4A and has a narrow pore size of 0.36 nm. In this study, kalsilite was synthesized by a new economical hydrothermal process using Si : Al : K : $H_2O$ mole ratio of 1 : 1 : 8 : 60. The synthesized kalsilite powder was confirmed by XRD and has a mean diameter of $2.73{\mu}m$. The vapor adsorption test showed the synthesized kalsilite is hydrophilic.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.8 no.3
• /
• pp.317-324
• /
• 2020

Plastic wastes generated from domestic waste are separated by mixed discharge with foreign substances, and the cost of the separation and screening process increases, so recycling is relatively low. In this study, as a fundamental study for recycling mixed plastic wastes generated from domestic waste into concrete aggregates, changes in concrete properties according to the plastic waste types and the substitution rate were evaluated experimentally. The mixed plastic waste aggregate(MPWA) was found to have a lower density and a higher absorption rate compared to the coarse aggregate with good particle size distribution. On the other hand, the single plastic waste aggregate(SPWA) was composed of particles of uniform size, and both the density and the absorption rate were lower than that of the fin e aggregate. It was found that the MPWA substitution concrete did not cause a material separation phenomenon due to a relatively good particle size distribution even with the largest amount of plastic waste substitution, and the amount of air flow increased little. The compressive strength and flexural strength of the PWA substitution concrete decreased as the amount of substitution of the PWA increased due to the low strength of the PWA, the suppression of the cement hydration reaction due to hydrophobicity, and the low adhesion between the PWA and the cement paste. It was found that the degree of deterioration in compressive strength and flexural strength of concrete substituted with MPWA having good particle size distribution was relatively small.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.11 no.1
• /
• pp.32-38
• /
• 2023

In this study, as part of the practical development of technology for CLSM using pond ash, the characteristics such as flowability, bleeding rate, and strength of the CLSM according to physical properties such as particle size distribution and particulate content of the pond ash were reviewed. As a result of analyzing the properties of the collected pond ash, it was found that the characteristics of density and particle size distribution were different. As a result of evaluating the characteristics of the CLSM for three types of pond ash, it was found that the blending conditions to satisfy the quality stipulated in ACI 229R were different, and mainly affected the particle size distribution characteristics and particulate content of the pond ash. In case of coarse-grained pond ash (PA-3), mixing conditions that satisfy the performance requirements stipulated in ACI 229R were not derived. But it is considered that further review is necessary according to particle size adjustment.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.7
• /
• pp.714-719
• /
• 2017

The controlled synthesis of inorganic materials with a specific size and morphology is an important factor in the development of new materials in many fields, such as nanoparticles, medicine, electronics, semiconductors, pharmaceutical sand cosmetics. Solution crystallization is one of the most widely used separation processes in the chemical and pharmaceutical industries. Calcium carbonate has attracted a great deal of attention in industry because of its numerous applications. The mean crystal size, crystal size distribution and morphology are important factors in the continuous crystallization process. In this study, the continuous crystallization of calcium carbonate by the calcium chloride process was investigated. The mean crystal size and crystal size distribution data were obtained by a particle size analyzer. The morphological imaging of the crystalswasper formed by SEM. Under steady state operation, the mean crystal size change was small, but increasing the input concentration and mixing rate increased the crystal size. In this operation, some aragonite was found, but the main crystal phase was calcite.