• The Korean Journal of Applied Statistics
• /
• v.8 no.2
• /
• pp.77-86
• /
• 1995

For the problem of testing the parallelism of two regression lines, a robust procedure is proposed and examined. The proposed test statistic is based on the one-step GM-estimators of slope parameters proposed by Song et al. (1994b). These GM-estimators used the Least Trimmed Squares estimates as an initial values so as to obtain high breakdown point. Through a small-sample Monte Carlo simulation the empirical levels and powers of the proposed test are compared with other tests under various error distributions.

• Journal of the Korean Society for Precision Engineering
• /
• v.16 no.2 s.95
• /
• pp.50-59
• /
• 1999

The effect of a variant drain orifice damping on the characteristics of a servovalve flapper-nozzle stage is analyzed. Steady-state characteristics of flapper-nozzle stage and the linearized dynamics of flapper-nozzle assembly with a spool valve show that the variant drain orifice damping could improve such null performance characteristics as null pressure sensitivity and linearity of gain function. Generalized design criterion and a sufficient condition for servovalve stability are also established.

• Proceedings of the Korean Society for Applied Microbiology Conference
• /
• 1986.12a
• /
• pp.526.2-526
• /
• 1986

P. mirabilis 로부터 정제한 cysteinylglycine 분해효소의 성질 및 세포내 국재성을 검토하였다. 본 효소의 일반적 성질은 pH가 7.3 온도 37$^{\circ}C$에서 최대 활성을 냐타내었으며 pH 8.0에서 안정하였고, 열안정성은 $50^{\circ}C$, 30분처리에 30%의 활성 손실을 보였다. 또한 $Mn^{+2}$이온과 $Mg^{+2}$ 이온에 의해 활성이 촉진되었으며 본 효소를 반응전 30분 Preincubation 하므로서 최대 활성을 보였다. 본 효소는 glutathione 일단계 분해효소인 ${\gamma}$-glutamyl transpeptidase와 마찬가지로 세포내의 periplasmic space에 존재하였다.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.49 no.6
• /
• pp.441-449
• /
• 2000

Analysis, design and practical implementation of a single-stage electronic ballast for compact fluorecent lamps are presented in this paper. The proposed topology is based on a single-stage ballast which combines a boost converter and a half-bridge series resonant inverter. High power factor is achieved by using the boost semi-stage operating in discontinuous conduction mode, and inverter semi-stage operated above resonant frequency to provide zero voltage switching is employed to ballast the fluorescent lamp. Analytical and experimental results from the ballast system with 36W fluorescent lamps have demonstrated the feasibility of the proposed single-stage electronic ballast.

• Journal of Chest Surgery
• /
• v.28 no.6
• /
• pp.610-618
• /
• 1995

Three neonates with interrupted aortic arch with VSD underwent one stage repair using revised technique of cardiopulmonary bypass with short period of circulatory arrest. A left posterolateral thoracotomy was made to permit mobilization of the descending aorta and placement of polytetrafluoroethylene[PTFE graft for distal aortic perfusion. Then the patient was placed in the supine position and a median sternotomy was performed to permit the proximal dissection, VSD repair, and direct anastomosis between the ascending aorta and descending aorta. This technique has advantages to facilitate direct anastomosis between the ascending aorta and the descending aorta, to lessen circulatory arrest time, and to prevent dangerous laceration and post-operative narrowing of the thin small ascending aorta at cannulation site. There was no operative mortality but postoperative stenosis developed in one case which was relieved with balloon aortoplasty.

• Proceedings of the KIEE Conference
• /
• 1999.07f
• /
• pp.2792-2794
• /
• 1999

본 논문에서는 컴팩트 형광램프용 조도제어형 전자식 안정기의 각 동작 모드별 해석과 설계 및 실험적 고찰을 제시한다. 부스트 컨버터와 해프브리지형 고주파 공진형 인버터를 결합한 일단계 인버터 안정기를 제안하고 그 기본동작 및 특성에 관해 검토한다. 역률을 높이기 위한 방법으로 부스트단에서는 전류불연속 모드로 동작하도록 하였다. 전력 손실을 줄이기 위해 직렬 공진형 인버터는 영전압 영전류 스위칭 방식을 적용하였다. 출력 전압을 조정할 수 있도록 설계하여 조도제어를 구현하였으며 다단계의 조도제어가 가능해진다. 전자식 안정기 시스템을 구성하기 위한 이론적인 근거를 마련하기 위하여 공진형 인버터를 동작 모드별로 해석하고 그 결과를 토대로 동작주파수 및 회로정수를 결정하며, 실제 전자식 안정기를 제작하여 시동특성과 조광특성을 비교 분석하였다. 36W 형광램프에 대한 실험 결과와 등가회로 모델에 의한 Pspice 시뮬레이션 결과를 토대로 제안한 전자식 안정기의 적용가능성을 입증하였다.

• Journal of Chest Surgery
• /
• v.39 no.4 s.261
• /
• pp.269-274
• /
• 2006

Background: Tetralogy of Fallot (TOF) with pulmonary atresia and major aortopulmonary collateral arteries (MAPCAS) is complex lesion with marked heterogeneity of pulmonary blood supply and arborization anomalies. Patients with TOF with PA and MAPCAS have traditionally required multiple staged unifocalization of pulmonary blood supply before undergoing complete repair. In this report, we describe recent change of strategy and the results in our institution. Material and Method: We established surgical stratagies: early correction, central mediastinal approach, initial RV-PA conduit interposition, and aggressive intervention. Between July 1998 and August 2004, 23 patients were surgically treated at our institution. We divided them into 3 groups by initial operation method; group I: one stage total correction, group II: RV-PA conduit and unifocalization, group III: RV-PA conduit interposition only. Result: Mean ages at initial operation in each group were $13.9{\pm}16.0$ months (group 1), $10.4{\pm}15.6$ months (group II), and $7.9{\pm}7.7$ months (group III). True pulmonary arteries were not present in f patient and the pulmonary arteries were confluent in 22 patients. The balloon angioplasty was done in average 1.3 times (range: $1{\sim}6$). There were 4 early deaths relating initial operation, and 1 late death due to incracranial hemorrhage after definitive repair. The operative mortalities of initial procedures in each group were 25.0% (1/4: group I), 20.0% (2/10: group II), and 12.2% (1/9: group III). The causes of operative mortality were hypoxia (2), low cardiac output (1) and sudden cardiac arrest (1). Definitive repair rates in each group were 75% (3/4) in group I, 20% (2/10, fenestration: 2) in group II, and 55.0% (5/9, fenestration: 1) in group III. Conclusion: In patients of TOF with PA and MAPCAS, RV-PA connection as a initial procedure could be performed with relatively low risk, and high rate of definitive repair can be obtained in the help of balloon pulmonary angioplasty. One stage RV-PA connection and unifocalization appeared to be successful in selected patients.

• Korean Journal of Animal Reproduction
• /
• v.22 no.4
• /
• pp.319-329
• /
• 1998

These experiments were conducted to investigate the optimal maturation stage for cryopreservation of porcine oocyte when the oocytes were frozen-thawed and/or exposed in cryoprotect ant at immature, maturing and mature stages. The results of this research are as follows ; 1. When the oocytes matured for 0, 24 and 44h were exposed in media containing cryoprotectants or without in vitro, the rates of cultured oocytes developed to metaphase II were 44.0, 45.0, 50.3 or 55.0%, respectively. 2. When the oocytes matured for 0, 24 and 44h were exposed in media containing cryoprotectants or without in vitro, the cleavage rates of cultured oocytes were 18.6, 19.7, 47.6 or 50.9%, respectively. 3. When the oocytes matured for 0, 24 and 44h were frozen and thawed using vitrification or not in vitro, the rates of cultured oocytes developed to metaphase II were 4.3, 7.1, 46.7 or 62.4%, respectively. 4. When the oocytes matured for 0, 24 and 44h were frozen and thawed using vitrification or not in vitro, the cleavage rates of cultured oocytes were 2.5, 2.4, 10.2 or 49.6%, respectively.

• Polymer(Korea)
• /
• v.37 no.2
• /
• pp.204-210
• /
• 2013

Effects of additives (lubricant and antioxidant) and melt-blending condition (temperature, time and rotor speed) on the mechanical properties of polypropylene-based wood polymer composites (WPCs) were investigated. WPCs were prepared by melt-blending followed by compression molding. To understand melt-blending procedure, torque change of the WPC melt-blend was monitored. Maleic anhydride modified PP and nanoclay were used as a compatibilizer and a reinforcing filler, respectively. UTM and izod impact tester were used to measure the mechanical properties of the WPCs and a color-difference meter was used to measure the discoloration of the WPCs according to melt-blending condition. The mechanical properties showed that the optimized melt-blending condition was $170^{\circ}C$, 15 min, and 60 rpm. The mechanical properties of the WPCs decreased with increasing lubricant and antioxidant content. The two step method, adding wood flour later separately during melt-blending, was more effective than the typical one step method for improving the mechanical properties of the WPCs.

• Textile Coloration and Finishing
• /
• v.19 no.3
• /
• pp.18-25
• /
• 2007

The fixing behaviors of anthraquinone disperse dyes containing dimethylamino substituent, such as C. I. Disperse Violet 26(D.V.26) and C. I. Disperse Blue 14(D.V.14), or containing diamino substituent, such as C. I. Disperse Blue 73(D.B.73), and monochlorotriazinyl azo reactive dyes, such as C. I. Reactive Orange 13(R.O.13), C. I. Reactive Red 3(R.R.3). C. I. Reactive Yellow 2(R.Y.2) on polyester/cotton blend(P/C) fabrics were examined for the one-step printing of P/C fabrics. The high temperature steaming of $175^{\circ}C$ is the most satisfactory fixing method for P/C one-step printing with above disperse and reactive dyes among the four different fixing methods: $175^{\circ}C$ steaming, $102^{\circ}C$ steaming${\rightarrow}175^{\circ}C$ steaming, $190^{\circ}C$ thermosol, $102^{\circ}C$ steaming${\rightarrow}190^{\circ}C$ thermosol. $190^{\circ}C$ thermosol is unfit to fix R.R.3 and R.Y.2 whose heat stability is poor. It was found that D.V.26 and D.B.14 containing dimethylamino substituent are unstable for heat and alkali, but D.B.73 is stable for them to print P/C blend fabrics with R.O.13 which is also stable for heat. Therefore we found that D.B.73, R.O.13 and a pair of D.B.73 and R.O.13 were very suitable for one-step printing of P/C blend fabrics.