• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.1 s.343
• /
• pp.79-88
• /
• 2006

In this paper, we designed and implemented ubiquitous u-Health system using RFE and ZigBee. We made a wireless protocol Kit which combines RFE Tag recognition and ZigBee data communication capability. The software is designed and developed on the TinyOS. Wireless communication technologies which hold multi-protocol stacks with RFID and result in the wireless ubiquitous world could be Bluetooth, ZigBee, 802.11x WLAN and so on. The environments that the suggested u-Health system may be used is un-manned nursing, which would be utilized in dense sensor networks such as a hospital. The the size of devices with RFID and ZigBee will be so smaller and smaller as a bracelet, a wrist watch and a ring. The combined wireless RFID-ZigBee system could be applied to applications which requires some actions corresponding to the collected (or sensed) information in WBAN(Wireless Body Area Network) and/or WPAN(Wireless Person Area Network). The proposed ubiquitous u-Health system displays some text-type alert message on LCD which is attached to the system or gives voice alert message to the adequate node users. RFE will be used as various combinations with other wireless technologies for some application-specific purposes.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.10a
• /
• pp.693-697
• /
• 2007

The SSB modem performs the modulation process which converts the digital voltage level to the audible frequency band signal and the demodulation process which converts reversely the audible frequency signal to the digital voltage level. The modulator and the demodulator are implemented with a single DSP chip. Because of the SSB specific character, the distortion occurs when the frequency is changed. This distortion has no effect on voice communication, but it has an significant effect on data communication. In other words, it is impossible to send data stream with adjacent 2 periods. Therefore, in case of using 2-tone FSK, it is needed to send at least 3 periods to transmit 1 bit. Therefore we implemented the modem using modified phase-delay shift keying to transmit 1 tone signal for high speed transmission. In the 1200[bps] mode, it generates 0, $187{\mu}s$ delay time at 1.3kHz symbol frequency, and in the 2400[bps] mode, 0, $70{\mu}s$, $130{\mu}s$, $200{\mu}s$ delay time at 1.5kHz symbol frequency. Finally, in the maximum 3600[bps] mode, it generates 0, $100{\mu}s$, $160{\mu}s$, $250{\mu}s$ delay time at 2.0kHz symbol frequency. The measured results of the implemented SSB modem shows a good transfer functional characteristic by spectrum analyzer, almost same bandwidth in pass band and 20dB higher SNR comparing the German PACTOR and American CLOVER and in the experimental transmitting test, we verified the transmitted data is received correctly in platform.

• Journal of KIISE:Computing Practices and Letters
• /
• v.9 no.1
• /
• pp.100-108
• /
• 2003

By choosing Multicast for transmission of educational contents in the Remote Educational System, we can reduce the server load and increase network bandwidth utilization. We design and implement Multicast Middleware for the Remote Educational System in this paper. There are three characteristics in this Multicast Middleware: 1) Through Centralized Multicast Group Management for passive members, it allows a host to make multicast group, which is composed of receivers, called Group Member and who are chosen by the host, called group Maker. Because, all groups are created by the Group Maker in Centralized Group Management, Group Member's join action will be passive 2) Maintenance and recovery of multicast group information in order to restore from exception and crash; the maintenance and recovery mechanism of Group Maker is distinct from that of Group Member. 3) The mechanism which enables to transmit large size multimedia data through multicasting and remove additional copy operation through shared buffer. Fragmentation/de-fragmentation for large data delivery results in additional copy operation in user level. But by using user level shared buffer, it can be done without user Bevel copy operation. By applying to Remote Educational environment which consists of 30 PCs and Fast Ethernet, we can examine the efficiency of this middleware, which can transmit 18frames/sec movie which resolution 320 $\times$ 120 pixels, 128Kbps encoded sound data and some text data.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.10
• /
• pp.28-33
• /
• 2009

In this paper, we propose the receiver algorithms suitable for the VHF (Very High Frequency) digital link mode-2(VDL Mode-2) system. Unlike conventional digital communication systems using the root raised cosine filter as a transmit and receive filter, raised cosine filter is used as a transmit filter in the VDL Mode-2 system. Hence, it is crucial to design and implement the optimum lowpass receive filter by considering inter-symbol interference and noise performance. On the other hand, due to the short preamble pattern, it is crucial to develop an efficient packet detection algorithm for reliable communication link for the VDL Mode-2 system. Also, frequency offset due to the carrier frequency difference between transmitter and receiver and doppler frequency shift must be estimated and compensated for reliable communication. In this paper, the optimum receive filter, packet detection and frequency offset compensation algorithms are proposed and the performance of the VDL system employing the proposed algorithms are evaluated.

• The Transactions of the Korea Information Processing Society
• /
• v.5 no.12
• /
• pp.3047-3062
• /
• 1998

This paper deseribes the desihn and the implementation of the Realtime Transport Protocol(RTP)/ Rdaltime Control Protocol(RTCP) (RFC 1889,1890) that is used to transmit the audio/video data to any destination and to feedback the Quality of Service (QoS) information of the received media data to the sender, in the teleconferencing systems proposed by ITU-T. These protocols are implemented with multi thead technique and run on top of UDP/IP-Multicast through the socket interface as the underlying protocol. The upper layer is impelmented such that in can be accessed by the H245 comference control protocol. The RTP packetizes the digitized audio/video data from the encoder info a fixed format, and multieast to the participants. The RTCP monitors RTP packets and extracts the QoS values from it such as round-trip delay, jiter and packet loss to form RTCP packets and non periokically sends them to the sender site. In this Paper, we also descritx the study of measurement and analysis for QoS factors that observed on performing teleconferencing system over Internet. The results from this experiment is indicate that RTT and Jitter value are acceptable even entwork load is high. However, it appears that packet loss rate is high in daytime and most losses periods have length one or two.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.10
• /
• pp.1852-1857
• /
• 2007

The SSB modem performs the modulation process which converts the digital voltage level to the audible frequency band signal and the demodulation process which converts reversely the audible frequency signal to the digital voltage level. The modulator and the demodulator are implemented with a single DSP chip. Because of the SSB specific character, the distortion occurs when the frequency is changed. This distortion has no effect on voice communication but it has an significant effect on data communication. In other words, it is impossible to send data stream with adjacent 2 periods. Therefore, in case of using 2-tone FSK, it is needed to send at least 3 periods to transmit 1 bit. Therefore we implemented the modem using modified phase-delay shift keying to transmit 1 tone signal for high speed transmission. In the 1200[bps] mode, it generates 0, $187{\mu}s$, delay time at 1.3kHz symbol frequency, and in the 2400[bps] mode, 0, $70{\mu}s\;130{\mu}s\;200{\mu}s$, delay time at 1.5kHz symbol frequency. Finally, in the maximum 3600[bps] mode, it generates 0, $100{\mu}s\;160{\mu}s\;250{\mu}s$ 2.0kHz symbol frequency. The measured results of the implemented SSB modem shows a good transfer functional characteristic by spectrum analyzer, almost same bandwidth in pass band and 20dB higher SNR comparing the emu FACTOR and American CLOVER and in the experimental transmitting test, we verified the transmitted data is received correctly in platform.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.23 no.6
• /
• pp.639-645
• /
• 2017

Application Specific Messages (ASM) have been introduced by a number of international bodies, such as the International Maritime Organization (IMO), the International Telecommunication Union (ITU) and the International Association of Lighthouse Authorities (IALA), for the purpose of resolving AIS overloading issues caused by an increasing number of ships using AIS systems. ASM communication will transmit a large amount of safety-related information at sea, including meteorological information, accident reporting, and navigational warnings. Specifically, this message transaction system is expected to be actively used for communication among ships and for ship-to-shore (4S), where VHF communication through voice was standard. In order to design a user-oriented service through standardised AIS-ASM messaging in the future, the need for analysis of this seems to be quite critical. In order to reflect users' AIS-ASM communication needs, therefore, frequently-occurring marine communication messages were analysed through a questionnaire survey conducted on 57 marine officers and 50 VTS operators. Based on the survey results, a list of key standardised messages was suggested as a reference for future AIS message development.

• The Journal of Korean Institute of Next Generation Computing
• /
• v.13 no.2
• /
• pp.18-25
• /
• 2017

In computer science, an encoding is a standardization of converting information to one format for audio, video or text. Therefore, the encoding information of the data should be known to open and read it and there are algorithms detecting encoder of the data. However, some informations of data could be disappeared by packet loss when transmitted on network, especially, if the data is snatched by packet sniffing or eavesdropping from wireless communications. In this paper, we improve the performance of encoding detection algorithm of 'uchardet' program for multi-byte encoded data with errors based on bit-shift algorithm. To simulate the performance, we generated Korean and Japanese text data with errors that is removed some random bits at random positions. Then the detection algorithm are tested using the data and 'uchardet-bitshift' showed better performance than 'uchardet'. When Korean texts are used, 'uchardet' could detect perfectly with ≤0.005% errors but it showed 0% detection rate with ≥1% errors while 'uchardet-bitshift' detected perfectly with ≤0.05% errors and it showed correct detection cases with ≥1% errors. Japanese texts with errors tend to report falsely as Chinese encoding because Japanese texts include lots of Chinese characters. As a results, we improved encoding detection algorithms by applying bit shift operation.