• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.1
• /
• pp.68-75
• /
• 2007

A single chip NFC transceiver supporting not only NFC active and passive mode but also 13.56MHz RFID reader and tag mode was designed and fabricated. The proposed NFC transceiver can operate as a RFID tag even without external power supply which has dual antenna structure for initiator and target. The area increment due to additional target antenna is negligible because the target antenna is constructed by using a shielding layer of initiator antenna. The analog front end circuit of the proposed NFC transceiver consists of a transmitter and receiver of reader/writer block supporting NFC initiator or RFID reader mode, and a tag circuit for target of passive NFC mode or RFID tag mode. The maximum baud rate of the proposed NFC device is 212kbps by using UART serial interface. The chip has been designed and fabricated using a Magnachip's $0.35{\mu}m$ double poly 4-metal CMOS process, and the effective area of the chip is 2200um by 3600um.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.6
• /
• pp.52-57
• /
• 2009

This paper presents a low-noise low-dropout linear regulator that is suitable for on-chip integration with RF transceiver ICs. In the bandgap reference, a stacked diode structure is adopted for saving silicon area as well as maintaining low output noise characteristic. Theoretical analysis for supporting the approach is also described. The linear regulator is fabricated in $0.18{\mu}m$ CMOS process. It operates with an input voltage range of 2.2 V - 5 V and provide the output voltage of 1.8 V and the output current up to 90 mA. The measured line and load regulation is 0.04%/V and 0.46%, respectively. The output noise voltage is measured to be 479 nV/$^\surd{Hz}$ and 186 nV/$^\surd{Hz}$ from 100 Hz and 1 kHz offset, respectively.

• Journal of Korea Soil Environment Society
• /
• v.4 no.3
• /
• pp.95-104
• /
• 1999

Comparative biodegradation studies of liquid and solid alkanes and of two different solid alkanes were conducted by an isolated Acinetobacter sp., which degraded crude oil alkanes simultaneously. for the determination of degradation mechanism of hydrophobic crude oil constituents. Also a model oil experimental system composed of a solid alkane. heneicosane, as a substrate and a non-degradable non-aqueous phase liquid. pristane, as an oil matrix was established and studied. It was proposed that the Acinefobacter sp. utilized hydrophobic substrates directly on the surface of them with no difference in the degradation rates between the liquid and solid alkanes. On the basis of the results from the heneicosane/pristane system which imitates crude oil matrix containing solid constituents. the crude oil matrix was considered to reduce the bioavailability of contained substrates by reducing the specific surface area of substrates to contact with microorganisms.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.14 no.2
• /
• pp.141-157
• /
• 2012

For the application TBM tunneling method, Both tunnel design standard and case study designed & constructed in domestic and foreign have been conducted. According to the study, the number of lane and inner shape (single or duplex) vary depending on the volume of traffic. Also extra space located in the top and bottom of tunnel is used for a multipurpose such as ventilation, disaster prevention, maintenance and administration. To find area ratio according to the components of road TBM tunnel, a standard section was considered as a two-lane road. Then, the analysis of area ratio of this section which consists of components for clearance, extra space in upper and lower tunnel was carried on two widths of shoulder. In addition, after a structural analysis, a thickness requirement of lower slab which is essential for road tunnel was derived on a few supporting types. Through correlation analysis, the ranges of available cross-sectional area between slab thickness and lower extra space of the tunnel was presented.

• Korean Journal of Soil Science and Fertilizer
• /
• v.31 no.3
• /
• pp.246-252
• /
• 1998

A survey was conducted to investigate the status of soils involving pH, electrical conductivity, total organic matter content, available phosphate and major exchangeable cations in the paddy soils sampled from 1,168 sites throughout the country. The content of soil chemical properties was lower on the average than the optimum levels for cropping. An average value showed pH 5.6, organic matter $25g\;kg^{-1}$, available phosphate $128mg\;kg^{-1}$, available silicate $72mg\;kg^{-1}$, and exchangeable potassium and the calcium and magnesium were 0.32, 4.0, $1.2cmol^+\;kg^{-1}$, respectively. Soil chemical properties was related with topography except soil pH. A soil pH and organic matter, available phosphate, exchangeable potassium increased with time while exchangeable calcium, magnesium available silicate decreased with time.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.8
• /
• pp.47-55
• /
• 2010

In this paper, a timing register architecture using demultiplexer and counter is proposed to reduce the area of the high resolution SAR type analog to digital converter. The area and digital power consumption of the conventional timing register based on the shift register is drastically increased, as the resolution is increased. On the other hand, the proposed architecture results in reduction of the area and the power consumption of the error correction logic of the SAR ADC. This chip is implemented with 0.18 um CMOS process. The area is reduced by 5.4 times and the digital power consumption is minimized compared with the conventional one. The 12 bits SAR ADC shows ENOB of 11 bits, power consumption of 2 mW, and conversion speed of 1 MSPS. The die area is $1 mm{\times}1mm$.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.20 no.4
• /
• pp.435-442
• /
• 2014

In this paper, radar cross section (RCS) analysis program, RACSAN has been developed to predict RCS of complex structures. RACSAN is based on the high frequency range analysis method of Kirchhoff approximation in physical optics (PO). This program can present RCS including multi-bounce effect in complex structures by combination of geometric optics (GO) and PO method. GO method has a concern in the evaluation of the effective area, and PO method is involved in the calculation of RCS for the final effective area that is evaluated by GO method. Comparisons of the predicted results and analytical solutions showed that the developed program could be an effective tool for predicting RCS in complex structures.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.2
• /
• pp.433-442
• /
• 2017

This study consists of five case studies of the catering facilities of newly-built elementary schools' in Sejong City, regarding the spatial configuration and allocation. The analysis indicated that the space allocated in the cooking area in the five schools compared to the standard was as follows: School A; 99.2%, B; 91.1%, C; 81.4%, D; 110.8%, E; 88.1%. Accordingly, the cooking area was close to, or slightly above the standard; nevertheless, other areas in the facilities were not allocated sufficient space and were not appropriately planned. Among the other findings, the receiving areas of three schools were not even planned, and the receiving works were carried out in the pre-preparation area. Considering the flow of the dish-washing process, the width of the room should be at least 3.6 meters with a passage width of 1.6 meters, and easy access to the cooking and dining areas must be equipped. An interview with all five supervisors showed that most complaints focused on the cooking and dishwashing areas, whereas there were none in the storage and workers' area. The result highlights the importance of the cooking and dishwashing areas as the main functions in catering facilities, and future planning strategies should consider this aspect.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2007.05a
• /
• pp.825-830
• /
• 2007

사면에서 발생되는 강우유출과정에 기여하는 대공극의 영향은 그 중요성에도 불구하고 잘 알려져 있지 않다. 특히 대공극의 공간적분포특상에 대한 현장측정은 이뤄지지 않았다. 본 연구의 실험지역은 경기도 포천시 광릉수목원에 있는 작은 소유역이다. 이 지역의 정밀한 측량을 하여 수치고도모형(DEM)을 얻었다. 이 수치고도모형을 바탕으로 수치지형분석을 통해 흐름선을 파악하여 총 20지점을 선정하였다. 각 지점에서의 대공극을 통한 수직적인 유동들은 장력침투계를 사용하여 지표면아래 깊이 10cm에서 측정하였다. 공간적 토양의 특성분포를 파악하기 위해 각 지점에서의 체적밀도와 점토함량을 조사하였다. 토양수분의 공간적 분포 특성은 TDR(Time Domain Reflectometry)방식인 TRASE를 이용하여 토양수분 값을 얻었다. 이러한 다양한 공간적 특성들은 대공극발달의 공간적 분포특성을 파악하는 중요자료가 된다. 소유역을 크게 기여사면 면적을 기준으로 상부, 중부, 하부로 나누어 대공극의 유효 공극율과 대공극흐름율을 계산하였다. 상부에서의 유효 대공극율의 평균값과 변동계수는 각각 4.3%, 42.1%이고, 대공극흐름율의 평균값과 변동계수는 각각 45.0%, 26.6%이다. 중부에서는 유효 대공극율의 평균값과 변동계수는 6.8%, 37.3%이고, 대공극흐름율의 평균값과 변동계수는 56.2%, 14.4% 이다. 그리고 하부에서의 유효공극율의 평균값과 변동계수는 12.5%, 58.3% 이고 대공극흐름율의 평균값과 변동계수는 64.5%, 24%이다. 이는 유효 대공극율과 대공극흐름율의 비율은 기여사면 면적이 증가할수록 증가하였다. 이는 대공극을 통한 물 이송 능력이 원두부로 갈수록 증가한다는 것을 보여주고 있다.e, taurine, methionine, phenylalanine은 함량(含量)이 적었다. 5. 일건(日乾)중 총유리아미노산의 변화(變化)는 생시료(生試料)의 경우 2,041.2 mg%였으나 1일(日) 건조(乾燥) 후는 1,784.0 mg%로 감소(減少)하다가 그 이후 계속 증가(增加)하여 20일(日) 건조(乾燥) 후는 5,277.0 mg%였다. 6. 일건(日乾)중 leucine, isoleucine, valine은 대체로 증가(增加)하는 경향(傾向)을 나타내었으나 aspartic acid, proline, taurine은 대체로 감소(減少)하는 경향(傾向)을 나타내었다. 436.59mg%로 가장 많았고 군유산(軍有山) 차엽(茶葉)이 146.94mg%로 가장 적었으며 일반차엽(一般茶葉)의 평균치(平均値)는 264.59mg%, 용장(龍欌) 차엽(茶葉)이 223.10mg%, Yabukita 차엽(茶葉)이 256.49mg%였다. 7) 이상(以上)의 결과(結果)를 종합(綜合)할 때 용장(龍欌) 차엽(茶葉)은 일반차엽(一般茶葉)과 형질(形質) 뿐만 아니라, 성분(成分)도 다르므로 품종(品種)이 다른 수종(樹種)으로 추정(推定)되며 와운(臥雲) 차엽(茶葉)은 일반차엽(一般茶葉)과 형질(形質)은 다르나 성분상(成分上)의 비슷한 점으로 보아 동일계통(同一系統)의 변이(變異)된 대엽종(大葉種)으로 추정(推定)된다.5(${\pm}0.77$0.77) % 의 오차로 크게 감소하였다. 결론: 방사선이 통과하는 경로에 불균질조직인 폐가 존재할 경우에도 불균질조직에 대하여 조직의 밀도를 이용하여 보정하는 방법을 사용하여 투과선량으로부터 종양선량을 계산할 수 있음을 알 수 있었다.X>로 평균$43.26{\m

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.33 no.4
• /
• pp.310-320
• /
• 2009

In this paper, we estimate area-averaged solution of peening residual stress using a 3-D multi-impact symmetry-cell FE model. The symmetry-cell model includes factors reflecting peening phenomena and plastic shot. Area-averaged solution is much closer to XRD experimental solution than 4-node-averaged solution in plastic shot FE model. We then obtain FE Almen saturation curve corresponding to experimental Almen curve based on area-averaged solution. Using the curve, we obtain FE area-averaged solution in major peening materials, and compare the FE solution with experimental solution. In peening materials, surface, maximum compressive residual stress and deformation depth reach experimental solutions. Thus, FE Almen curve is useful for estimation of residual stress solution and could improve the efficiency of peening process. Consequently, it is confirmed that concept of area-averaged solution is the realistic analytical method for evaluation of peening residual stress.