• Journal of the Korean Geotechnical Society
• /
• v.37 no.12
• /
• pp.107-116
• /
• 2021

In this study, a set of laboratory liquefaction test has been conducted using undisturbed samples collected from Songlim-park, Pohang where liquefaction phenomenon had been observed in 2017. Soil samples were frozen right after tube sampling to minimize the disturbances during transport, storage, and test preparation. Cyclic triaxial test has been carried out to evaluate the liquefaction resistance ratio of undisturbed soil samples. As a result, the liquefaction resistance ratio of samples collected from 8.0~8.8 m and 11.0~11.8 m were almost similar, and these values were approximately 0.04~0.07 larger than values estimated by simplified assessment method using field test results. It is expected that the application of undisturbed sample for the evaluation of liquefaction resistance could contribute to the economical design of geotechnical structures.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2021.06a
• /
• pp.68-68
• /
• 2021

Sesan강과 Srepok강은 베트남, 캄보디아, 라오스가 공유하는 3S강 유역 (Sesan강, Srepok강, Sekong강)의 일부로 연구 및 관리된다. 3S강 유역은 Mekong강의 중요한 지류이며 Mekong강 유역의 상당 부분을 구성한다(Mekong강 유역 면적의 10%, 연간 총 유출량의 20%). 베트남 측 Sesan강 유역의 면적은 11,255km²이고 Srepok강 유역 면적은 18,162km²이다. Sesan강과 Srepok 강의 상류는 베트남 중부 고원의 긴 산맥에 위치하고 있다. Sesan강과 Srepok강 유역은 기후변화에 따른 홍수, 가뭄, 어업 지속 가능성 감소, 퇴적 등 많은 문제와 도전에 직면 할 것으로 예측되고 있다. 본 연구에서는 World Bank의 "Viet Nam Mekong Integrated Water Resources Management (M-IWRM) Project의 일환으로 베트남 정부 차원에서 처음으로 구축한 수자원관리 의사결정지원 시스템인 "DSS-2S"를 활용하여, Sesan-Srepok강 유역의 강둑 침식 위험성을 분석하였다. DSS-2S는 MIKE Hydro Basin을 기반으로 SWAT모델, 수리모델, 하상변동 모델, 및 수질모델 등과 연계 하여 구축되었다. 2030 년을 목표 연도로 설정하고, 기후 변화 시나리오와 사회 경제적 발전을 기반으로 DSS-2S에 포함되어 있는 유사 이송 및 수리학적 모델을 활용하여 주요 하천 단면에서의 평균 유속과 하상 침식 양을 예측하였다. 유속 및 심부 침식 기준에 근거하여 강둑 침식 위험성을 분석하였다. 모델의 시뮬레이션 결과를 기반으로 강둑 침식 위험이 있는 강 구간은 고(高)유속과 높은 침식의 조합에 의해 결정되었다. 고위험 침식 예상지는 Sesan강 유역의 Dak Bla, Po Ko, 및 Se San강에 총 길이 73.5km에 걸쳐 발생 할 것으로 분석되었으며, 침식 위험이 매우 높은 지역은 Dak Bla 강에 총 길이 2,286m, Po Ko 강에 총 길이 5,096m 정도가 발생 하는 것으로 분석되었다. 강둑 세국을 유발할 수 있는 다양한 인자들을 고찰하였으며, 본 성과는 베트남 중앙 정부의 장기수 자원 종합계획 수립의 기본 자료로 활용 될 예정이다.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.30 no.1A
• /
• pp.27-33
• /
• 2010

This study addresses a methodology to use small wind turbines for dual purposes, improving aerodynamic performance of flexible bridges and wind energy harvesting. A way to proper placement of small wind turbines on flexible bridges were proposed according on the analogy of conventional aerodynamic appendages. From the wind tunnel tests, it was found that the wind turbine attached like fairing was effective to reduce the vortex-induced vibration of bridge and the optimal spanwise interval of the wind turbine was 3-4.5 time of turbine diameter. Moreover the aerodynamic coefficients of the bridge were improved after installation of the wind turbines. Present results showed the general availability of wind turbine for improvement of aerodynamic performance and energy supply of flexible bridges although the capacity of wind power generation was strongly dependent on wind characteristics of the bridge site.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.11 no.1
• /
• pp.97-105
• /
• 2009

This paper studied the cause of the deterioration of the four 3-Arch tunnels built in mid-1990. The common deteriorations of the four 3-Arch tunnels were longitudinal cracks, leakage and efflorescence at the same parts of lining concrete. Three fourths of 3-Arch tunnels, there was high percentage longitudinal cracks and a quarter was low frequency about longitudinal cracks. So the material reviewed to find out the differences between two groups in construction process and analysis was conducted such as non-destructive testing, precise visual survey and safety evaluation of one tunnel which had bad ground condition As the result, the tunnels were safety condition and the primary deterioration occurred during the construction process, namely, problems arrangement of rebar and the effects of the blast at middle tunnel.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.11 no.5
• /
• pp.135-143
• /
• 2007

This paper presents results of an experimental study designed to investigate the effect of sustained load on the flexural performance of reinforced recycled aggregate concrete beams. In this experimental program, three beams with recycled aggregate replacement percentages(natural 100%, recycled coarse aggregate 100%, recycled fine aggregate 50%) were tested up to failure after sustained loading($0.5M_n$) for one year. The experimental results showed that reinforced concrete beams using recycled aggregate(water absorption : 1.86~3.64%) concrete showed the same flexural performance as that of natural aggregate concrete beam. Current the ACI code underestimated experimental obtained ultimate flexural strength of beams irrespective of usage of recycled aggregates.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.39 no.6
• /
• pp.623-629
• /
• 2002

In transmitting compressed video bit-stream over Internet, packet losses cause error propagations in both spatial and temporal domains, which in turn leads to severe degradation I image quality. In this paper, a new error concealment algorithm, called EBMA(Edge Detection based Boundary Matching Algorithm), is proposed to repair damaged portions of the video frames in the receiver. Conventional BMA(Boundary Matching Algorithm) assumes that the pixels on the boundary of the missing block and its neighboring blocks are very similar, but has no consideration of edges across the boundary. In our approach, the edges are detected across the boundary of the lost or erroneous block. Once the orientation of each edge is found, only the pixel difference along the expected edges across the boundary is measured instead of the calculation of difference along the expected edges across the boundary is measured instead of the calculation of differences between all adjacent pixels on the boundary Therefore, the proposed approach needs very few computations and the experiment shows and improvement of the performance over the conventional BMA in terms of both subjective and objective quality of video sequences.

• Journal of Bio-Environment Control
• /
• v.17 no.3
• /
• pp.197-203
• /
• 2008

This study was performed to check the structural safety of modified 1-2W Greenhouses to be utilized fur growing Paprika. This type of greenhouse was derived from being remodeled by enhancing the column height of conventional 1-2W type greenhouses. According to the results of structural analysis performed by SAP-2000, there was not significant change in critical snow depth in spite of increasing the column height of 1.2 m by welding. But the critical wind velocities were shown to be $26.0\sim4l.0m/s$, which were $3\sim18%$ lower wind velocities compared with those critical velocities estimated for typical type of 1-2W greenhouse. Under the wind loads, those maximum section forces such as shear force, axial force, and bending moment, together with the deformed frame shape of strained greenhouse, were almost similar in both typical type and modified type. Maximum bending moment of column was found at eave's height of column on windward side. Under the snow loads, those maximum section forces such as shear farce, axial force, and bending moment, together with the deformed frame shape of strained greenhouse, were almost similar in both typical type and modified type. Maximum section forces except axial force was found at eave's height of column. Maximum axial force was found at inner column. Soil bearing capacity together with the total foundation resistance against wind upheaval was found to be consistently safe enough to resist to both wind load and snow load.

• Journal of Korean Society of Steel Construction
• /
• v.19 no.6
• /
• pp.671-680
• /
• 2007

In this study, we performed a loading test to evaluate the effect of load distribution on continuous two-span plate-girder bridges with or without bottom lateral bracing using one-fifth-scale bridge specimens. From the test results, when specimens with lateral bracing were loaded eccentrically, the load distribution capacity of the concrete deck and cross beam improved and greater loading was distributed to the other side of the girder subjected to loading. The load distribution rate of the specimens with and without lateral bracing system was evaluated from the analytical model that was verified by the test results. From the result of the quantitative evaluation, when specimen without lateral bracing was loaded eccentrically, mostly 21% of loading according to the concrete deck was distributed to the other side of the girder subjected to loading. However, when specimen with lateral bracing was loaded eccentrically, the load distribution rate increased by 1.7 times as all cross beams, bracing and concrete deck participated in load distribution. The reason is that the torsional rigidity increased as the model with lateral bracing behaved like a pseudo-closed box section.

• KDI Journal of Economic Policy
• /
• v.34 no.4
• /
• pp.117-156
• /
• 2012

This paper decomposes and estimates trend/cyclical components of some key macro variables-GDP, inflation, and interest rate, using a simple DSGE model along with flexible trend specification. The extracted cyclical components of output and interest rate are similar to HP-filtered counterparts, despite some differences in persistence and volatility, while inflation resembles that from BK filtering. This implies that the usual practice of applying a single filtering method to the data of interest may be problematic. When the baseline model is extended to incorporate consumption habit and price indexation, habit turns out to be important in explaining the persistence of business cycles. Comparison of several alternative models shows that the usual practice of estimation of DSGE model using filtered data leads to biased results. Finally, various sensitivity analyses illustrate that (1) allowing for correlation between structural cyclical shocks and trend shocks and (2) including irregular components (in inflation rate) may deliver interesting/important implication for gap estimates.

• Journal of the Korea Computer Graphics Society
• /
• v.24 no.4
• /
• pp.29-38
• /
• 2018

In this paper, we propose an automatic segmentation method of meniscus in knee MR images by automatic meniscus localization, multi-atlas-based locally-weighted voting, and patch-based edge feature classification. First, after segmenting the bone and knee articular cartilage, the volume of interest of the meniscus is automatically localized. Second, the meniscus is segmented by multi-atlas-based locally-weighted voting taking into account the weights of shape and intensity distribution in the volume of interest of the meniscus. Finally, to remove leakage to the collateral ligaments with similar intensity, meniscus is refined using patch-based edge feature classification considering shape and distance weights. Dice similarity coefficient between proposed method and manual segmentation were 80.13% of medial meniscus and 80.81 % for lateral meniscus, and showed better results of 7.25% for medial meniscus and 1.31% for lateral meniscus compared to the multi-atlas-based locally-weighted voting.