• Journal of the Korean earth science society
• /
• v.31 no.6
• /
• pp.600-607
• /
• 2010

In 2008, multiple episodes of large-scale transport of natural airborne particles and anthropogenically affected particles from different sources in the East Asian continent were identified in the National Oceanic and Atmospheric Administration (NOAA) satellite RGB-composite images and the mass concentrations of ground level particulate matters. To analyze the aerosol size distribution during the large-scale transport of atmospheric aerosols, both aerosol optical depth (AOD; proportional to the aerosol total loading in the vertical column) and fine aerosol weighting (FW; fractional contribution of fine aerosol to the total AOD) of Moderate resolution Imaging Spectroradiometer (MODIS) aerosol products were used over the East Asian region. The six episodes of massive natural airborne particles were observed at Cheongwon, originating from sandstorms in northern China, Mongolia and the loess plateau of China. The $PM_{10}$ and $PM_{2.5}$ stood at 70% and 16% of the total mass concentration of TSP, respectively. However, the mass concentration of $PM_{2.5}$ among TSP increased as high as 23% in the episode in which they were flowing in by way f the industrial area in east China. In the other five episodes of anthropogenically affected particles that flowed into the Korean Peninsula from east China, the mass concentrations of $PM_{10}$ and $PM_{2.5}$ among TSP reached 82% and 65%, respectively. The average AOD for the large-scale transport of anthropogenically affected particle episodes in the East Asian region was measured at $0.42{\pm}0.17$ compared with AOD ($0.36{\pm}0.13$) for the natural airborne particle episodes. Particularly, the regions covering east China, the Yellow Sea, the Korean Peninsula, and the east Korean sea were characterized by high levels of AOD. The average FW values observed during the event of anthropogenically affected aerosols ($0.63{\pm}0.16$) were moderately higher than those of natural airborne particles ($0.52{\pm}0.13$). This observation suggests that anthropogenically affected particles contribute greatly to the atmospheric aerosols in East Asia.

• Atmosphere
• /
• v.21 no.3
• /
• pp.285-300
• /
• 2011

To discriminate and eliminate chaff echoes in radar measurements, a new removal algorithm in two-dimensional reflectivity composite at the height of 1.5 km has been developed by using the brightness temperature($T_B$) obtained from MTSAT-1R. This algorithm utilizes the fact that chaffs are not appeared in infrared satellite data of MTSAT-1R, but detected in radar measurements due to their significant backscattering in the given radar wavelength. The algorithm is evaluated for three different situations: chaff only, chaff mixed with convective storms, and chaff covered with clouds. The algorithm shows excellent performance for the cases of chaff only and chaff mixed with convective storms. However, the performance of the algorithm significantly depends on the presence of clouds. Thus, the statistical analysis of $T_B$ is performed in order to optimize the monthly threshold.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.24 no.5
• /
• pp.475-481
• /
• 2021

The on-board processor of satellite Synthetic Aperture Radar(SAR) digitizes the back-scattered echoes and transmits them to the ground. As satellite SAR image of various operating conditions including broadband and high resolution is required, an enormous amount of SAR data is generated. Decimation filter is used for data compression to improve the transmission efficiency of these data. Decimation filter is implemented with the FIR(Finite Impulse Response) filter and here, the decimation ratio and tap length are constrained by resource requirements of FPGA used for implementation. This paper suggests to use a non-integer ratio decimation filter in order to optimize the data transmission efficiency. Also, it proposes a filter design method that remarkably reduces the resource constraints of the FPGA in-use via applying a polyphase filter structure. The required resources for implementing the proposed filter is analysed in this paper.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.25 no.2
• /
• pp.144-150
• /
• 2022

The on-board processor of satellite synthetic aperture radar(SAR) generates transmission signal by digital signal processing, converts it into an analog signal. At this time, the transmission signal generated from the baseband requires the frequency modulation to convert it to the high-frequency band in order to improve the stability. General frequency modulation method using local oscillator(LO) causes IQ imbalance due to phase error/magnitude error and these error reduce performance of SAR. To generate transmission signal without phase/magnitude error, this paper suggests design method of the frequency modulation method using digital to analog converter(DAC) at on-board SAR. For design, this paper analyzes the characteristic of DAC mode and uses pre-compensation filter. To analyze the proposed method performance, performance index are compared with IQ imbalance signals. This method is suitable for on-board SAR using fast sampling DAC and has the advantage of being able to solve IQ imbalances.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.25 no.4
• /
• pp.347-354
• /
• 2022

The synthetic aperture radar(SAR) is an equipment that can acquire images in all weathers day and night based on radar signals. The on-board processor of satellite SAR generates transmission signal by digital signal processing, converts it into an analog signal and transmits to antenna. Until the transmission signal generated by on-board processor is output, the signal passes the transmission cables and analog devices. At this time, these hardware distort the signal and makes SAR performance worse. To improve the performance, pre-distortion technique is used. But, general pre-distortion using taylor series is not sufficient to compensate for the distortion. This paper suggests transmit signal design method with improved pre-distortion. This paper uses envelop sampling method and interpolation filter for frequency domain compensation. The proposed method accurately compensates the hardware distortion and reduces resource usage of FPGA. To analyze proposed method's performance, IRF characteristics are compared when the proposed method applies to signal with errors.

• Korean Journal of Remote Sensing
• /
• v.33 no.3
• /
• pp.257-266
• /
• 2017

In this study, the dust/smoke detection algorithm was developed with a multi-spectral satellite remote sensing method using Moderate resolution Imaging Spectroradiometer (MODIS) Level 1B (L1B) data and the results were validated as RGB composite images of red(R; band 1), green(G; band 4), blue(B; band 3) channels using MODIS L1B data and Cloud-Aerosol Lidar with Orthogonal Polarization Satellite Observations(CALIPSO) Vertical Feature Mask (VFM) product. In the daytime on March 30, 2007 and April 27, 2012, the consistencies between the dust/smoke detected by this algorithm and verification data were approximately 56.4 %, 72.0 %, respectively. During the nighttime, the similar consistency was 40.5 % on April 27, 2012. Although these results were analyzed for limited cases due to the spatiotemporal matching for the MODIS and CALIPSO satellites, they could be used to utilize the aerosol detection of geostationary satellites for the next generations in Korea through further research.

• Korean Journal of Remote Sensing
• /
• v.34 no.6_4
• /
• pp.1555-1565
• /
• 2018

Detection of subtle ground deformation of volcanoes plays an important role in evaluating the risk and possibility of volcanic eruptions. Ground-fixed observation equipment is difficult to maintain and cost-inefficient. In contrast, satellite remote sensing can regularly monitor at low cost. In this paper, following the study of Chadwick et al. (2006), which applied the interferometric SAR (InSAR) technique to the Sierra Negra volcano, Galapagos. In order to investigate the deformation of the volcano before 2005 eruption, the recent activities of this volcano were analyzed using Sentinel-1, the latest SAR satellite. We obtained the descending mode Sentinel-1A SAR data from January 2017 to January 2018, applied the Persistent Scatter InSAR, and estimated the depth and expansion quantity of magma in recent years through the Mogi model. As a result, it was confirmed that the activity pattern of volcano prior to the eruption in June 2018 was similar to the pattern before the eruption in 2005 and was successful in estimating the depth and expansion amount. The results of this study suggest that satellite SAR can characterize the activity patterns of volcano and can be possibly used for early monitoring of volcanic eruption.

• Korean Journal of Remote Sensing
• /
• v.23 no.6
• /
• pp.501-506
• /
• 2007

Basic research is conducted to identify a target using corner reflectors which are commonly used in calibration of synthetic aperture radar (SAR) systems. At first, an omni-directional reflector is fabricated by combining four 15-cm rectangular trihedral corner reflectors. Then, its radar cross section (RCS) characteristics are measured at C-band (5.3 GHz) for vv-, hh-, hv-, and vh- polarizations at a range of horizontal angle, $-90^{\circ}{\le}{\phi}{\le}90^{\circ}$. The measured RCS angular variation of the omni-directional reflector is much smaller for vv-polarization than other polarizations, and the difference between the maximum and minimum RCSs for vv-polarization is about 8 dB. Peak RCS values are shown at $0^{\circ}$ (normal to plates) and $45^{\circ}$ (direction of bore sight). It is shown that the measurements agree quite well with numerical simulation and theoretical computation results.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.25 no.1
• /
• pp.30-44
• /
• 2022

The advent of deep learning-based algorithms has facilitated researches on target detection from synthetic aperture radar(SAR) imagery. While most of them concentrate on detection tasks for ships with open SAR ship datasets and for aircraft from SAR scenes of airports, there is relatively scarce researches on the detection of SAR ground vehicle targets where several adverse factors such as high false alarm rates, low signal-to-clutter ratios, and multiple targets in close proximity are predicted to degrade the performances. In this paper, a dataset of ground vehicle targets acquired from TerraSAR-X(TSX) satellite SAR images is presented. Then, both detection and instance segmentation are simultaneously carried out on this dataset based on the deep learning-based Mask R-CNN. Finally, this paper shows the future research directions to further improve the performances of detecting the SAR ground vehicle targets.

• Korean Journal of Remote Sensing
• /
• v.10 no.2
• /
• pp.1-15
• /
• 1994

Since Seasat SAR mission in 1978, SAR has become one of the most important surface imaging tools in satellite remote sensing SAR achieves high resolution by signal processing synthesizing a larger aperture. Therefore, SAR signal processing along with antenna technology has been centered upon SAR technologies. Thus interpreters of SAR imagery as well as those who involved in signal processing require the knowledge of the principal SAR processing algorithm. Although the conventional range-Doppler approach has been widely adopted by many SAR processors, azimuth compression including the range migration has been problematic. The recent development of the wavenumber domain approace is able to provide high precision SAR focusing algorithm. Compared with the wavenumber domain algorithm derived by applying Born (first) approximation, the transfer function of the conventional range-Doppler algorithm accounts only for the first order approximation of the exact transfer function. The results of a simulation and an actual test using airborne C-band SAR configuration demonstrate the dxcellent performance of the wavenumber domain algorithm.