• Korean Journal of Optics and Photonics
• /
• v.8 no.4
• /
• pp.315-319
• /
• 1997

In photorefractive crystals, light deflection is achieved by dynamic photorefractive volume grating, which is induced by the interference of two writing beams. In this paper, we implemented and analyzed the light deflector using Ce-SBN:60 crystals, which is doped with CeO$_2$ and photorefractive effect is induced by low intensity. And we measured maximum coupling coefficient, effective charge density, diffraction efficiency as the intensity ratio and response time.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.13 no.3
• /
• pp.617-622
• /
• 2018

Simultaneous control of blowers and heat exchangers affecting the air sealing and flow conditions inside the green house is essential to the management of $CO_2$ concentration. Currently, the demand for automation systems and integrated control is steadily increasing according to increasing of farm areas per person due to the reduction of agricultural population. This paper proposes the integrated control system that can control simultaneously the existing devices such as measurement switching devices which are important variables in the supply of $CO_2$, $CO_2$ generator fuel and combustion air mixture ratio(air-to-fuel ratio), and $CO_2$ supply control under internal and external conditions.

• Conservation Science in Museum
• /
• v.10
• /
• pp.21-27
• /
• 2009

This bamboo brush stand was made by attaching two bamboo tubes together, each 80mm in diameter. On the bottom is a "∞-shaped"wood board made of Ailanthus altissima. The surfaces are decorated with exquisite and dynamic designs of a dragon and clouds, and a deer and pine trees. Part of this bamboo brush stand was damaged, lost, or worn down, prior to conservation treatment. After conservation and recovery treatment, its original form was restored. Earth powder, chalk, and gluten mixture were used as materials to fill in the missing parts. After the original form was restored, thin silk fabric was attached to the inner surface of the glued part to prevent cracking. Traditional materials and repair techniques were used to allow for reversal of treatment, if necessary, as seen in the surface of the restored part being made antiquated with lacquer varnish.

• Proceedings of the KIEE Conference
• /
• 2006.10d
• /
• pp.71-73
• /
• 2006

AC loss on variation of external magnetic field is a very important factor in development of power applications. In this paper, we measured and compared AC loss of hybrid-multi stacked wire made of the combination of 1G wires and 2G wires and uniform-multi-stacked wire made of one type of wires, 1G wires or 2G wires. Measurement was performed using by the linked-picked coil method. As results, as the number of wires increase, AC loss per unit volume of both stacked wires in low external magnetic field is reduced. Also AC loss of 2G slacked wire is higher than that of 1G wire. AC loss per unit length of 2G stacked wire is less than that of 1G stacked wire. And AC loss of hybrid-multi stacked wire made of the combination of 1G wires and 2G wires was between uniform-multi-stacked wire made of 1G wires and 2G wires.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2005.11a
• /
• pp.335-340
• /
• 2005

A study on the variation of combustion characteristics by injector geometries was conducted. Coaxial swirl injectors were used. Existence of swirl chamber and variation of a nozzle length become key parameters. Injectors were identified as open, closed and mixed type by existence of swirl chamber. Variation of nozzle length was made extruding the both nozzle along the axis while other design parameters remain the same. A uni-element combustor with ablative material liner and a water cooled nozzle made by oxygen free copper with outer stainless steel casing were used.

• The Journal of the Acoustical Society of Korea
• /
• v.18 no.5
• /
• pp.52-57
• /
• 1999

It is very important to design of QAM modulator of high spectral efficiency for high speed data transmission. In this paper, typical 16-QAM modulator is designed by modification design of DDFS(direct digital frequency synthesizer). DDFS generates sinusoidal waveform digitally to the frequency setting word. Phase modulation is accuratly made by control of a generated phase increment value and amplitude modulation is accomplished in the D/A converter output by control of amplitude level. For the suppression of harmonics and glitch, dual-structured DDFS is studied to improve the spurious characteristics. P-Spice is used for design and simulation in mixed mode. Also we can get the satisfactory results of designed 16-QAM modulator from the constellation output.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.06a
• /
• pp.739-742
• /
• 2007

In the step processing multimedia information signals transmitted by a variety of mediums, noises are generated by the internal or exterior causes of systems and these noises degrade the perception about information signals. Therefore, in order to remove noises and restore signals a great number of researches have been progressed and recently, many noise removal methods using time-frequency localization of wavelet have been applied in wide applications. Moreover, when two wavelet bases are designed to accomplish the Hilbert transform pair, wavelet can be efficiently applied to detect characteristics of signals. Therefore, in this paper, in order to restore the corrupted signal by noises, a noise removal algorithm using the Hilbert transform pair of wavelet was proposed.

• Journal of the Microelectronics and Packaging Society
• /
• v.8 no.2
• /
• pp.1-7
• /
• 2001

In order to form a uniform oxidation layer of spinel phase on Kovar which helps the strong bonding in Kovar-to-glass sealing, the humidified $N_2/H_2$ was used as an oxidation atmosphere. The oxidation of Kovar was controlled by diffusion mechanism and the activation energy was 31.61 kacl/mol at 500~$800^{\circ}C$. After oxidation at $600^{\circ}C$, the external oxidation layer was below 0.5 $\mu \textrm{m}$ thick. According to TEM analysis, oxidized Kovar was spinel its lattice parameter of 7.9 $\AA$. Oxidation of under $600^{\circ}C$ and in a humidified $N_2/H_2$ atmosphere, Kovar was found to be appropriate for the Kovar-to-glass sealing.

• Journal of Korea Game Society
• /
• v.19 no.6
• /
• pp.99-106
• /
• 2019

This paper addresses a method to compute the closest approach distance between two ellipsoids in their inter-center direction. This is the key technique for collision detection and response between ellipsoids. We formulate a set of conditions with the inter-center distance, the contact point and the contact normal vector of the two externally-contacting ellipsoids. The equations are solved robustly and efficiently using a hybrid of Newton's method and the bisection method with root bracketing. We demonstrate the robustness and efficiency of the proposed method in various experiments.

• Proceedings of the KIEE Conference
• /
• 2000.11a
• /
• pp.262-264
• /
• 2000

원자로 내에서 연소 중인 핵연료나 저장 또는 재처리 중인 사용후핵연료의 성분으로서 시설의 공정설계, 안전성분석 및 차폐설계에 중요한 입력자료가 되는 핵분열생성물질, 방사화생성물 및 악티나이드의 핵종 농도와 이에 대응하는 방사능 강도의 기기 별 시간변 화율을 해석할 수 있는 코드 개발할 목적으로 MULTISAMS 정상 평형상태 모델을 구현하였다. MULTISAMS 코드의 반응공정 모델은 서로 연결되어 있으며 내부에 방사성물질의 혼합유체가 순환하는 세 종류의 반응기(원자로, 열교환기 및 화학반응기) 계통에서 자연적 또는 설계에 의해 일어나는 현상으로서; 반응기 간의 물질 흐름; 각 반응기 내에서 방사성 붕괴, 변환, 이동과 중성자 흡수 및 핵분열; 외부로부터 특정 핵종의 유입혹은 유출을 고려한 시간종속 핵종농도보존방정식 이론에 근거한다. 코드의 유용성 및 신뢰성을 검증하기 위해 현재 개념설계가 진행 중인 AMBIDEXTER원자력 에너지시스템을 대상으로 ORIGEN2 계산과 비교하였다. 두 코드 간의 입력조건과 배경이론차이점 때문에 절대적 비교가 불가능하므로 단순이론의 중간매개코드로서 SAMS를 이용한 2단계 비교방법을 따랐다. 결론은 MULTISAMS는 ORIGEN2 계산의 수렴치와 근사하게 일치하면서 ORIGEN2 가 다룰 수 없는 핵주기 연속후처리공정의 정상가동 시 핵종 평형농도를 기기 별로 계산할 수 있다는 장점을 확인하였다.