• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.11
• /
• pp.4563-4567
• /
• 2010

In this paper, the adaptive MPSAM is suggested in order to analyze and improve problems caused by the case of the impact of delay waves on Pilot Symbol Assisted Modulation (PSAM), a singular Pilot method. PSAM predicts and compensates amplitude and phases caused on fading channels, using the Pilot Symbol. In addition, the Basic method is not only analyzed but also grafted onto the suggested method properly; therefore, the performance could be improved. Comparing to the Basic method, the BER performance can be distinguished in case that the level of delay on delay waves with the suggested method goes below 0.7. On the other hand, the BER performance can be inferior due to a considerable effect of the adjacent symbol in the event that the level of delay on delay waves is worse. However, the BER performance is rather improved on the point where the level of delay on delay waves is serious because the Basic method uses reciprocal compensation. Hence, stable improvement can be expected in all areas which receive the influence of delay waves within one symbol once grafted onto the suggested method.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.27 no.4
• /
• pp.538-549
• /
• 2021

In this study, a trim tab on the stern hull of a small high-speed vessel of approximately 10 m length sailing at a Froude number of 1.0 was designed for energy efficiency. The running attitude and resistance performance of the bare hull and trim tab hull at several angles to the base line were analyzed for model and full scale ships using computational fluid dynamics, and compared to investigate the scale effect. The analysis results for the bare hull were quite similar, but a difference in the attitude control under same conditions of the trim tab was observed, resulting in the total resistance error. However, there was no significant difference in tendency of the variation in the resistance with the attitude. Thus, the optimum running attitude could be determined from the tendency despite the scale effect, but a full scale analysis is required to analyze the control of the attitude by the trim tab and flow characteristics near the full scale ship.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.37 no.8
• /
• pp.1007-1013
• /
• 2013

This study aims to analyze the aerodynamics when the geometry of the turbine rotor is modified. The turbine used in this study is a small engine used in the APU of a helicopter. It is difficult to improve the performance of small engines owing to the structural weakness of the blade tip. Therefore, the improvement of the hub geometry is investigated in many ways. The working fluid of a turbine is a high-temperature and high-pressure gas. The heat transfer rate of the turbine surface should be considered to avoid the destruction of blade owing to the heat load. The SST turbulence model gives an excellent prediction of the aerodynamic behavior and heat transfer characteristics when the numerical simulations are compared with the experimental results. In conclusion, the aerodynamic efficiency is improved when a bulbous design is applied to the leading edge near the hub. The endwall loss is reduced by 15%.

• 월간 기계설비
• /
• s.46
• /
• pp.74-89
• /
• 1994

현재 범국가적 차원에서 지속적인 국가 경제 발전과 국제수지 개선을 위하여 추진되고 있는 정부의 에너지 절약사업에서 건물부문이 차지하는 에너지절약 효과는 막중하다. 특히 전체주택에서 공동주택이 차지하는 비율은 1990년에 32.1$\%$, 서울시의 경우 51.3$\%$로 전체 주택의 과반수를 넘어섰으며, 수도권의 대단위 아파트단지의 개발과 함께 공동주택의 증가추세는 당분간 지속될 전망이다. 본 연구는 공동주택의 최적난방 운전기법 개발을 위한 1차년도의 연구로서 현행 공동주택의 난방운전 실태를 조사, 분석하고 각 난방법에 따른 문제점 및 최적제어 알고리즘의 개발을 위한 자료 도출을 주 목적으로 진행되었다. 1차년도에 수행된 연구의 주요 내용을 살펴보면 다음과 같다. 공동주택의 난방에너지 소비현상은 단지에 따라 최대 3배이상의 열사용량에 차이가 있는 것으로 나타났다. 열사용량의 차이는 건축의 기본 열성능, 설비시설의 수준 및 노후화정도에 영향을 받으나 동일 연대의 단지들에서도 최대 80$\%$이상의 열사용량이 차이를 보이고 있었으며 이는 기계실 및 각 세대의 난방운전방법 및 제어수준에 따른 것으로 평가되었다. 세대의 층별, 위치별 열사용량 분석에 의하면 층별 열사용량차이가 큰 것으로 분석되었으며, 특히 최상층부와 최하층부의 열사용량이 뚜렷이 많이 나타나 단열성능의 강화가 요구되는 것으로 나타났다. 한편 샘플단지에 대한 측정 데이터를 통해 적정 열량공급시간대의 설정과 외기온의 변화에 따른 적정 온수공급온도의 설정조건 및 유량제어 효과등에 대한 분석 및 검토를 하였으며, 이를 통해 2차년도의 개발목표인 최적운전제어 방안의 제시를 위한 자료를 구축하였다. 또한 각 세대의 기밀성능이 공동주택의 열성능에 미치는 영향을 도출하기 위하여 샘플단지에 대해 트레스가스 측정법과 Blower Door법에 의하여 환기 및 기밀상태를 평가 하였으며 측정주호에 대한 환기를 예측할 수 있는 환기예측평가식을 제시하였다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.7
• /
• pp.1355-1363
• /
• 2017

Recently, distributed compressed video sensing (DCVS) has been actively studied in order to achieve a low complexity video encoder by integrating both compressed sensing and distributed video coding characteristics. Conventionally, a motion compensated block compressed sensing with smoothed projected Landweber (MC-BCS-SPL) has been considered as an effective scheme of DCVS with all compressed sensing frames pursuing the simplest sampling. In this scheme, video frames are separately classified into key frames and WZ frames. However, when reconstructing WZ frame with conventional MC-BCS-SPL scheme at the decoder side, the visual qualities are poor for temporally active video sequences. In this paper, to overcome the drawbacks of the conventional scheme, an enhanced MC-BCS-SPL algorithm is proposed, which corrects the initial image with reference to the key frame using a high correlation between adjacent key frames. The proposed scheme is analyzed with respect to GOP (Group of Pictures) structuring method. Experimental results show that the proposed method performs better than conventional MC-BCS-SPL in rate-distortion.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.12
• /
• pp.142-149
• /
• 2015

Most of the mono-camera based lane detection systems are fragile on poor illumination conditions. In order to compensate limitations of single sensor utilization, lane information fusion system using multiple lane sensors is an alternative to stabilize performance and guarantee high precision. However, conventional fusion schemes, which only concerns object detection, are inappropriate to apply to the lane information fusion. Even few studies considering lane information fusion have dealt with limited aids on back-up sensor or omitted cases of asynchronous multi-rate and coverage. In this paper, we propose a lane information fusion scheme utilizing multiple lane sensors with different coverage and cycle. The precise lane information fusion is achieved by the proposed fusion framework which considers individual ranging capability and processing time of diverse types of lane sensors. In addition, a novel lane estimation model is proposed to synchronize multi-rate sensors precisely by up-sampling spare lane information signals. Through quantitative vehicle-level experiments with around view monitoring system and frontal camera system, we demonstrate the robustness of the proposed lane fusion scheme.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.41 no.4
• /
• pp.341-345
• /
• 2021

Known to improve resistance to chloride ingress, blast furnace slag is a widely used supplementary cementitious material. However, a detailed characterization of cements blended with slag exposed to seawater remains unavailable. This study employs thermodynamic modeling as a toolkit for assessing the long-term phase evolution of slag cement in seawater. The modeling result shows that slag incorporation leads to the formation of phases that are less prone to structural alteration in seawater. Formation of more ettringite is expected to induce expansion in both plain and blended cements, while brucite is unstable in the blended systems. Despite this, the porosity is expected to increase in the blended cements, and aluminate hydrates with a higher chloride binding capacity are more abundant in the blended cements. The results suggest that the use of slag in concrete improves the durability performance of concrete in marine environments.

• Journal of Korea Society of Industrial Information Systems
• /
• v.23 no.6
• /
• pp.47-58
• /
• 2018

Recently, remote sensing video applications have become increasingly important in many wireless networks. Distributed compressive video sensing (DCVS) framework in these applications has been studied to reduce encoding complexity and to simultaneously capture and compress video data. Specially, a motion compensated block compressed sensing with smoothed projected Landweber (MC-BCS-SPL) has been actively researched for one useful algorithm of DCVS schemes, However, conventional MC-BCS-SPL schemes do not provide good visual qualities in reconstructed Wyner-Ziv (WZ) frames. In this paper, the conventional schemes of MC-BCS-SPL are described and then upgraded to provide better visual qualities in WZ frames by introducing reliability estimate between adjacent key frames and by constructing efficiently motion-compensated interpolated frames. Through experimental results, it is shown that the proposed algorithm is effective in providing better visual qualities than conventional algorithm.

• Journal of the Korea Society of Computer and Information
• /
• v.28 no.12
• /
• pp.259-266
• /
• 2023

In this paper, we propose an algorithm that can improve the accuracy performance of collaborative filtering using attribute-based opinion mining (ABOM). For the experiment, a total of 1,227 online consumer review data about smartphone apps from domestic smartphone users were used for analysis. After morpheme analysis using the KKMA (Kkokkoma) analyzer and emotional word analysis using KOSAC, attribute extraction is performed using LDA topic modeling, and the topic modeling results for each weighted review are used to add up the ratings of collaborative filtering and the sentiment score. MAE, MAPE, and RMSE, which are statistical model performance evaluations that calculate the average accuracy error, were used. Through experiments, we predicted the accuracy of online customers' app ratings (APP_Score) by combining traditional collaborative filtering among the recommendation algorithms and the attribute-based opinion mining (ABOM) technique, which combines LDA attribute extraction and sentiment analysis. As a result of the analysis, it was found that the prediction accuracy of ratings using attribute-based opinion mining CF was better than that of ratings implementing traditional collaborative filtering.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.23 no.5
• /
• pp.47-53
• /
• 2023

With the advent of the 4th Industrial Revolution, diverse and a large amount of data has been accumulated now. The agricultural community has also collected environmental data that affects the growth of crops in smart farms or open fields with sensors. Environmental data has different features depending on where and when they are measured. Studies have been conducted using collected agricultural data to predict growth and yield with statistics and artificial intelligence. The results of these studies vary greatly depending on the data on which they are based. So, studies to enhance data quality have also been continuously conducted for performance improvement. A lot of data is required for high performance, but if there are outlier or missing values in the data, it can greatly affect the results even if the amount is sufficient. So, adjustment of outlier and missing values is essential in the data preprocessing. Therefore, this paper integrates data collected from actual farms and proposes a adjustment system for outlier and missing values based on it.