• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.8
• /
• pp.129-135
• /
• 2007

It is necessary to study on the prevention and the management of electrical facilities because the electrical fault took place at the dust occurrence area due to environmental pollution. In particular, the dust accumulates easily on insulation material which is exposed an external long time. Therefore, we measured surface leakage current and surface variation of insulation material due to the dust and salt-water. From the results, the surface of bakelite is bad effect for salt-water than other material. The surface leakage current increases by repeated salt-water pollution and the surface of material is carbonized with arc occurrence. Also, it is need to variation of surface coating and shape of material to repress a leakage current on electrical material.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.9 no.1
• /
• pp.53-62
• /
• 1989

In order to determine the form and the length of saline wedge, it is necessary to evaluate interfacial friction factor. Hetherto one dimensional two-layer flow model which assumed pressure as the hydrostatic pressure distribution has been well used to the calculation of saline wedge form, it just then stands in need of relevant interfacial friction factor. For example, in the case where we calculate back to interfacial friction factor out of saline wedge form obtained at a laboratory open channel with comparatively narrow width, it is needed to correct the side-wall effect of a channel, if generally negligible in the river. In this study, we confirmed the influence of a side-wall upon the lateral velocity distributions at laboratory channel and then examined in detail the value of interfacial friction factor in the case where it was corrected by the side-wall effect and not corrected. And then we make clear the influence of a side-wall upon the arrested saline wedge and interfacial faction factor from these results.

• Korean Journal of Environmental Biology
• /
• v.17 no.2
• /
• pp.175-182
• /
• 1999

An unprecedented mass mortality of commercially important macrobenthic animals, including Haliotis discus discus, H. diversicolor, Batilus cornutus, Sticopus japonious and Hemicentrotus puzoherrimus, occurred off the west coast of Cheju Island in summer of 1996. Phytoplankton blooms were absent along the coast. The appearances of the surface low-salinity water (SLSW) off the coast of Cheju Island preceded the mass mortality, leading to speculation that the low-salinity stress may have a crucial role in the mass mortality. Since there was no heavy rain for the same period, the precipitation was not a possible explanation for the decrease of salinity. Physical oceanographic data taken by NFRDI (1997) clearly indicated that the SLSW was present in the area between China and Cheju Island in August 1996. This is most likely due to a freshwater supply resulting from the existence of large river runoff. Evidence of the current and the distance between the Yangtz River and Cheju Island also supports the hypothesis that source of the SLSW was the freshwater originated from the Yangtz River runoff.[macrobenthic animals, mass mortality, surface low-salinity water].

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.43 no.12
• /
• pp.1913-1919
• /
• 2014

Baechu (Brassica campestris var. pekinensis) was salted in 29.6% brine at $30^{\circ}C$ for 4 hours on mobile automatic salting equipment (MASE) with brine circulation four times, and the quality of MASE salted kimchi was compared with that of general factory salted kimchi (control, 12% brine, $10^{\circ}C$, 16 hr) for 5 weeks. Salinity, acidity and number of lactic acid bacteria of MASE kimchi were higher than those of control at 2.5%, 1.17%, and 8.38 log CFU/g, compared to 1.5%, 1.00%, and 2.68 log CFU/g, respectively, whereas reducing sugar content and texture were not significantly different. Overall quality of sensory evaluation was higher than 4.0 in MASE kimchi compared to lower than 4.0 in the control, and taste was significantly higher (P<0.01). The quality of kimchi salted at high salt concentration and high temperature for a short time was higher than those salted at low salt concentration and low temperature for a long time. Higher productivity in the Baechu salting process can be achieved by shortening salting time with MASE.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.23 no.6
• /
• pp.684-689
• /
• 2017

We examined the possibility of developing an early monitoring system using the shell valve movement activity of Pacific oyster (Crassostrea gigas) for early detection of low salinity water in coastal areas. At salinity levels of 30 psu and 20 psu, SVMs were detected $7.32{\pm}3.21times/hr$ and $7.11{\pm}3.90times/hr$, respectively, The patterns and times of SVMs were not significantly different between the two experiment phases. However, at 10 psu and 5 psu, shell valves were observed to be permanently closed in all experiments. Under combined condition (Group 1: temperature $15^{\circ}C$ ${\times}$ salinity 15 psu), SVMs were observed from 20 psu to 30 psu over a 2 - 3 hr period, and then remained closed. In Group 2 (temperature $30^{\circ}C$ ${\times}$ salinity 15 psu), SVMs were observed, which indicated that the physiological condition of the oysters reached a critical point. Thus, it may be possible to utilize SVMs as an early warning signal for low salinity water.

• Journal of the Korean GEO-environmental Society
• /
• v.12 no.8
• /
• pp.51-57
• /
• 2011

Surface water at the lower part of the Seom-jin river has a high salinity because the erosion at river bottom has made sea water move upstream continuously since 1978. The effect of underground dam on the prevention of sea water intrusion was modelled in this study. Present chloride concentration in surface water decreases exponentially along a river and in groundwater is about one-tenth of surface water's. The finite element method model, FEFLOW, was conducted on the assumption that the underground dam with a height of 25m over a bedrock is located under a water surface at the site of 4.6km from an estuary. The result shows that the position with chloride concentration of 0.25psu moves downstream from the sites of 25km to 22km, if an enough sedimentation with 5m thickness happens in the upper reservoir of underground dam. On the other side, the underground dam is little effective for the prevention of sea water intrusion in case of non-sedimentation.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.10 no.3
• /
• pp.307-313
• /
• 2022

In this study, the correlation between Half Cell Potential(HCP) and the corrosion influencing factors was analyzed with considering three levels of water-cement ratio, the concentration of chloride solution, and cover depth. As a result of long-term corrosion monitoring, HCP behavior was close to the critical corrosion potential(-350 mV) in all water-cement ratios in the case of 3.5 % and 7.0 % chloride concentration. Regarding the passed charge test in 548 curing days, the passed charge results were improved to 'Moderate' grade. Multiple regression analysis was performed to evaluate the correlation between corrosion influencing factors and HCP, and it was evaluated that the effects of influencing factors to HCP were in the order of chloride concentration, water-cement ratio, and cover depth. In the case of the relationship between HCP and the passed charge, the coefficient of determination showed a high level of 0.9, which yielded a close correlation between the passed charge and HCP.

• Journal of the Korean Institute of Gas
• /
• v.22 no.5
• /
• pp.53-61
• /
• 2018

Low-salinity water based polymerflooding (LSPF) is one of promising enhanced oil recovery (EOR) method that has the synergetic effect of combining polymer injection method and low-salinity water injection method. In order to maximize EOR efficiency, it is essential to design low-salinity water appropriately considering the properties of polymer. In this aspect, the main purpose of this study is to investigate the effect of pH and $SO_4{^{2-}}$ ion which one of PDI (Potential Determining Ion) on oil production when applying LSPF to carbonate oil reservoir. First, the stability and adsorption of polymer molecule were analyzed in different pH of injection water and $SO_4{^{2-}}$ concentration in injection water. As a result, regardless of pH and $SO_4{^{2-}}$ concentration, when $SO_4{^{2-}}$ ion was contained in injection water, the stability of polymer solution was obtained. However, from the result of polymer retention analysis, in neutral state of injection water, since $SO_4{^{2-}}$ interfered the adsorption of polymer, the adsorption thickness of polymer was thinner as $SO_4{^{2-}}$ concentration was higher. On the other hand, when injection water was acidic as pH 4, the amount of polymer adsorption increased with the injection of polymer solution, so the mobility of polymer solution was greatly lowered. From the results of wettability alteration due to low-salinity water effect, in the case of neutral injection water injected, as $SO_4{^{2-}}$ concentration was increased, more oil which attached on rock surface was detached, altering wettability from oil-wet to water-wet. On the other hand, in acidic condition, due to complex effect of rock dissolution and polymer adsorption, wettability of the entire core system was less altered relatively to neutral condition. Therefore, it was evaluated that better EOR efficiency was obtained when injecting low-salinity water based polymer solution containing high concentration of $SO_4{^{2-}}$ with neutral condition, enhancing the oil production up to 12.3% compared to low-salinity water injection method.

• The Journal of Engineering Geology
• /
• v.25 no.2
• /
• pp.215-225
• /
• 2015

We performed injection tests in a deep-seated confined aquifer to assess the potential of artificial recharge as a means of preventing saltwater contamination, thereby securing groundwater resources for the Nakdong Delta area of Busan City, Korea. The study area comprises a confined aquifer, in which a 10-21-m-thick clay layer overlies 31.5-36.5 m of sand and a 2.8-11-m-thick layer of gravel. EC logging of five monitoring wells yielded a value of 7-44 mS/cm, with the transition between saline and fresh water occurring at a depth of 15-38 m. Above 5 m depth, water temperature is 10-15.5℃, whereas between 5 and 50 m depth the temperature is 15.5-17℃. Approximately 950 m³ of fresh water was injected into the OW-5 injection well at a rate of 370 m³/day for 62 hours, after which the fresh water zone was detected by a CTD Diver installed at a depth of 40 m. The persistence of the fresh water zone was determined via EC and temperature logging at 24 hours after injection, and again 21 days after injection. We observed a second fresh water zone in the OW-2 well, where the first injection test was performed more than 20 days before the second injection test. The contact between fresh and saline water in the injection well is represented by a sharp boundary rather than a transitional boundary. We conclude that the injected fresh water occupied a specific space and served to maintain the original water quality throughout the observation period. Moreover, we suggest that artificial recharge via long-term injection could help secure a new alternative water resource in this saline coastal aquifer.

• Food Science and Preservation
• /
• v.19 no.2
• /
• pp.193-200
• /
• 2012

The quality characteristics of $kalopanax$ $pictus$ and Aralica elata shoots during their preservation were investigated according to the salt conditions and storage temperatures to improve the use of the shoots. The results were as follows: the pH of $kalopanax$ $pictus$ shoots duing their storage did not changes with 10% and 12% brine at $4^{\circ}C$ and with 12% brine at $10^{\circ}C$. The pH of $Aralica$ $elata$ shoots is at $4^{\circ}C$ tended to be similar to the $kalopanax$ $pictus$ shoot and decreased at the storage temperature of $10^{\circ}C$. The salinity of the $kalopanax$ $pictus$ and $Aralica$ $elata$ shoots tended to increase during their storage and did not change significantly as their storage temperature changed. The L values of $kalopanax$ $pictus$ and $Aralica$ $elata$ shoots tended to decrease gradually during their storage, and the salt concentrations appeared high. The b value of the $kalopanax$ $pictus$ shoot tended to increase and that of the $Aralica$ $elata$ shoots, to decrease gradually. The a value tended to increase gradually but did not differ with variations in the storage temperatures and salt concentrations. The strength and the hardness of the $kalopanax$ $pictus$ and $Aralica$ $elata$ shoots tended to decreased gradually during their storage and highest in 10% brine at $4^{\circ}C$, and those of $Aralica$ $elata$ shoots were highest in 8-10% brine at $4^{\circ}C$. The Chlorophyll contents of the $kalopanax$ $pictus$ and $Aralica$ $elata$ shoots tended to decrease during their salt storage and did not change significantly as the temperatures and salt concentrations changed. Therefore, it can be concluded that the quality of $kalopanax$ $pictus$ and $Aralica$ $elata$ shoots can be maintained when the are stored in 10% brine at $4^{\circ}C$.