• 월간산업보건
• /
• s.38
• /
• pp.39-39
• /
• 1991

• Journal of the Korean Wood Science and Technology
• /
• v.33 no.6 s.134
• /
• pp.63-70
• /
• 2005

The purpose of this study was to investigate how to modify the physical properties of cellulose after thermal treatment. Cellulose was treated between $225^{\circ}C$ and $325^{\circ}C$ for 3 hrs under air flow, and then the thermally treated cellulose was measured to specific surface area, constitute elements, consumption ofacid and base, as well as the adsorption capacity of ethylamine vapor. The higher was the treating temperature from $225^{\circ}C$ to $325^{\circ}C$, the lower was the total yield of cellulose. Elemental analysis revealed that carbon content in thermally treated cellulose was gradually increased in proportion to temperature increment. The amount of acidic functional groups tended to increase up to $300^{\circ}C$, after then to be lowered slightly. In principle, no alkaline functional groups were found in thermally treated cellulose. In case of treatment with $325^{\circ}C$, only a few amount of alkaline functional groups were detectable. Specific surface area of thermally treated cellulose are determined to $1.9m^2/g$, which value can become higher when the treated temperature rises. The thermally treated cellulose at $275^{\circ}C$ shows the highest adsorption capacity of ethylamine at $40^{\circ}C$ for 4 hrs. Solubility of those two celluloses with WPG (Weight Percent Gain) value of 113% and 108%, respectively, was determined to almost 100%. X-ray diffractogram of thermally treated cellulose suggested that the crystalline structure of cellulose began to be destroyed at the temperature of $275^{\circ}C$. As a conclusion, changes of such a physical properties make it possible to weaken inter and/or intra hydrogen bond in crystal region of cellulose macromolecules. When thermally treated cellulose adsorbs ethylamine, it turns to be well soluble to water.

• Proceedings of the Korean Environmental Sciences Society Conference
• /
• 2000.05a
• /
• pp.147-148
• /
• 2000

• Proceedings of the Petrological Society of Korea Conference
• /
• 2009.05a
• /
• pp.120-123
• /
• 2009

• Journal of the Mineralogical Society of Korea
• /
• v.20 no.3
• /
• pp.155-163
• /
• 2007

A novel route to the synthesis of tetramethoxysilane and other silicon alkoxides is described using siliceous mudstone as the raw material. The reaction of amorphous silica with triethanol-amine is enhanced by using an alkali metal hydroxide catalyst to form a range of triethanol-amnine-substituted silatrane species. These can undergo alkoxide exchange in acidic alcohols to form alkoxysilatranes, tetraalkoxysilanes, hexaalkoxydisiloxanes and higher siloxanes. Products were identified by FT-IR spectroscopy, XRD, SEM, 1H and 13C NMR spectroscopy, or gas chromatography.

• Journal of Korean Society of Environmental Engineers
• /
• v.27 no.4
• /
• pp.445-449
• /
• 2005

Present study was designed to evaluate the practical application of triethyl amine(TEA) injection for improving the collection efficiency of electrostatic precipitator(ESP) connected to a real operating plant. The major fuels used at the domestic power stations were bituminous coals imported from Australia, China, South Africa, and USA. Although the values of the electric resistance would be more or less different according to the type of the coals used, the unique electric resistance values of fly ash from the coals were mostly higher than $1{\times}10^{12}\;{\Omega}-cm$ and therefore, back corona problems were always expected to occur in the electrostatic precipitator. The particulates concentrations, smoke concentrations and their electric resistivity measured at the outlet of ESP, and the inspection of collection indicated that the injection of TEA improved the collection efficiency of particulate at collection plates of ESP. The electric resistance for, fly ash with the injection concentration of TEA 15 ppm(Purity 99.7%) was lowered to $2.1{\times}10^{11}\;{\Omega}-cm$ after injection from $1.9{\times}10^{12}\;{\Omega}-cm$ before injection. Under this condition, the dust emission content at the stack was reduced to approximately 80%, lowering the average outlet concentrations of particulates from $70\;mg/Sm^3$ to $14\;mg/Sm^3$.

• Journal of the Korean Chemical Society
• /
• v.37 no.2
• /
• pp.249-254
• /
• 1993

N-p-nitrophenyl poly(m-phenylene isophthalamide) was obtained from treatment of poly(m-phenylene isophthalamide) with sodium hydride in dimethyl sulfoxide followed by the addition of 1-fluoro-4-nitrobenzene in 43 wt% yield. Its inherent viscosity was 0.606 g/cm${\cdot}$sec determined from a solution of 0.125 g of the above polymer dissolved in 25 ml of 98% sulfuric acid at $30^{\circ}C.$ In order to synthesize poly(m-phenylene isophthalamide), 1,3-phenylenediamine is allowed to react with isophthaloyl chloride in chloroform in the presence of triethylamine and added triethylamine hydrochloride. The value of inherent viscosity is 0.560 g/cm${\cdot}$sec measured at the same condition. The substitution ratio of N-p-nitrophenyl poly(m-phenylene isophthalamide) was to be 16.7∼47.0% by using the $^1H-NMR$ integration. When the higher inherent viscosity of poly(m-phenylene isophthalamide) was used, lower substitution ratio would be calculated.

• Clean Technology
• /
• v.14 no.2
• /
• pp.87-94
• /
• 2008

The catalytic properties of large pore zeolite (mordenite, beta, and Y) with 12-membered rings were comparatively evaluated in the synthesis of diethylamines from ethanol amination. The number of strong acid sites, which obviously promoted the formation of mono- and diethylamines, was decreased with the increase of Si/Al ratio of the zeolites that were used. H-beta and H-Y zeolites with multidimensional pore channels favorably formed diethylether by the dimerization of ethanol, due to their large cage volumes and low acid strength. On the other hand, H-mordenite which has one dimensional straight channel was shown to be suitable for the formation of mono- and diethylamine which are well known as the useful intermediates of fine chemicals.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.23 no.1
• /
• pp.14-19
• /
• 2013

We have successfully synthesized $Bi_{4-x}La_xTi_3O_{12}$ (x~2) having Aurivillius-type layered perovskite structure from exfoliated layered perovskite oxide of $K_2La_2Ti_3O_{10}$ with Ruddlesden-Popper structure. The reaction between the exfoliated lanthanum titanate nanosheets and BiOCl nanocrystal resulted in the formation of polycrystalline $Bi_{4-x}La_xTi_3O_{12}$ (x~2) after heating above $700^{\circ}C$. Colloidal suspension of the nanosheets could be obtained by intercalating ethylamine (EA) into the protonated lanthanum titanate, $H_2La_2Ti_3O_{10}$, derived from $K_2La_2Ti_3O_{10}$. Transmission electron microscopic (TEM) analysis show that the exfoliated lanthanium titanate nanosheets have a thickness of a few nano meters. According to X-ray diffraction (XRD) analysis, the exfoliated lanthanium titanate was found to be transformed into $Bi_{4-x}La_xTi_3O_{12}$ (x~2) after restacking with BiOCl and subsequent thermal treatment at > $700^{\circ}C$.

• Korean Chemical Engineering Research
• /
• v.57 no.5
• /
• pp.714-722
• /
• 2019

Catalysts were prepared by using incipient wetness impregnation method with 17 wt% Ni on a support ($SiO_2-Y_2O_3$, $Al_2O_3$, $SiO_2-ZrO_2$, $SiO_2$, $TiO_2$, MgO) and the catalytic activity in the reductive amination of ethanol with ammonia in the presence of hydrogen was compared and evaluated. The catalysts used before and after the reaction were characterized using X-ray diffraction, nitrogen adsorption, ethanol-temperature programmed desorption (EtOH-TPD), isopropanol-temperature programmed desorption (IPA-TPD), and hydrogen chemisorption etc. In the case of preparing $ZrO_2$ and $Y_2O_3$ supports, the small amount of Si dissolution from the Pyrex reactor surface provoked the formation of mixed oxides $SiO_2-ZrO_2$ and $SiO_2-Y_2O_3$. Among the catalysts used, $Ni/SiO_2-Y_2O_3$ catalyst showed the best activity, and this good activity was closely related to the highest nickel dispersion, and low desorption temperature in EtOH-TPD and IPA-TPD. The low catalytic activity on Ni/MgO catalysts showed low activity due to the formation of NiO-MgO solid-solutions. In the case of $Ni/TiO_2$, the reactivity was low due to the low nickel metal phase due to strong metal-support interaction. In the case of using a support as $SiO_2-Y_2O_3$, $Al_2O_3$, $SiO_2-ZrO_2$, and $SiO_2$, the selectivities of ethylamines and acetonitrile were not significantly different at similar ethanol conversion.