• Journal of the Korean Geotechnical Society
• /
• v.33 no.12
• /
• pp.35-44
• /
• 2017

A large amount of recycled aggregates was produced and crushed from old buildings and pavements. In this study, when these aggregates are re-used in subbase or subgrade materials in near construction sites, their engineering characteristics caused by crushing are investigated in terms of permeability and shear strength. Three different sizes of aggregates (31.5-45.0 mm, 19.0-31.5 mm, 9.5-19.0 mm) and their mixtures, a total of 7 types of aggregates were used in compaction tests (modified D and B methods). After compaction tests, aggregates were sieved and analyzed with four different breakage factors ($B_{15}$, $C_c$, $B_{10}$, $B_r$). The D compaction method gave 2.0-8.0 times more crushable than B compaction method. The breakage factors for the largest size aggregate was 1.4-3.0 times higher than those of the smallest size aggregate. For aggregates with 5.6-9.5 mm sizes, the samples were prepared with $B_{15}$ of 1, 3, 10, 20, 30, 50, 60, and 70 for permeability and direct shear tests. As $B_{15}$ increased, the hydraulic conductivity decreased up to 1/22 for $B_{15}=50$. As $B_{15}$ increased from 1 to 50, the peak friction angle increased from $46.1^{\circ}$ to $54.5^{\circ}$. On the other hand, the friction angle decreased after $B_{15}=60$.

• Solar Energy
• /
• v.13 no.1
• /
• pp.49-58
• /
• 1993

[ $CdS_{0.46}Se_{0.54}$ ] single crystal was grown by a sublimation method. The crystal structure and the temperature dependence of carrier density and mobility of $CdS_{0.46}Se_{0.54}$ single crystal were studied. Heterojunction solar cells of $n-CdS_{0.46}Se_{0.54}/p-Cu_{2-X}S_{0.46}Se_{0.54}$ were fabricated by the substitution reaction. The spectral response, the J-V characteristics and the conversion efficiency of the $n-CdS_{0.46}Se_{0.54}/p-Cu_{2-X}S_{0.46}Se_{0.54}$ heterojunction solar cells were studied. The open-circuit voltage, short-circuit density, fill factor and conversion efficiency of $n-CdS_{0.46}Se_{0.54}/p-Cu_{2-X}S_{0.46}Se_{0.54}$ heterojunction solar cells under $80mW/cm^2$ illumination were found to be 0.48V, $21mA/cm^2$, 0.75 and 9.5%, respectively.

• Korean Journal of Food Science and Technology
• /
• v.28 no.3
• /
• pp.545-551
• /
• 1996

Water-vapor transmission rate and water-vapor permeability of carrageenan-based edible film with three different thicknesses of 0.05, 0.08 and 0.11 mm were measured to investigate the potential applicability of the films to powder foods at five different temperatures (20, 25, 30. 35 and $4^{\circ}C$) and three different relative humidities (50. 70 and 90% RH). Water-vapor transmission rate of the carrageenan-based film was gound to be 2.3 times higher than that of polyethylene (PE) film and water-vapor permeability of the film was 45-230 times higher than that of PE film. Water-ydpor permeability of the film seemed to increase linearly with the film thicknees like other hydrophilic edible films. Water-vapor transmission rate were found to be dependent on the temperature. Activation energies of the water-vapor transmission rate of the film were found to be between 7.898 and 12.8702 kj/mol depending on the film thickness. The water-vapor transmission rate of the film showed the typical kinetic compensation effect between activation energies and preexponential factors. which was proved by the linear increase in the value of logarithms of preecponential factor.

• Journal of the Korean Vacuum Society
• /
• v.10 no.1
• /
• pp.16-21
• /
• 2001

Optical properties of $Ag_2CdSnSe_4$ and $Ag_2CdSnSe_4:Co^{+2}$ quaternary semiconductor single crystals grown by the chemical transport reaction method were investigated. The analysis of the X - ray powder diffraction measurements showed that these crystals have a wurtzite structure with lattice constants a = 4.357 $\AA$, c = 7.380 $\AA$, for $Ag_2CdSnSe_4$ and a = 4.885 $\AA$, c = 7.374 $\AA$, for $Ag_2CdSnSe_4:CO^{2+}$. The direct band gap at 298K, obtained from the optical absorption measurement, is found to be 1.21 eV for $Ag_2CdSnSe_4$ and 1.02 eV for $Ag_2CdSnSe_4:CO^{2+}$. The shrinkage of the band gap due to Co-doping is observed and is about 190 meV, We observed four absorption bands of $Co^{2+}$ ions in two near infrared regions of optical absorption spectra of $Ag_2CdSnSe_4$:$Co^{+2}$. These absorption bands were assigned as due to electronic transitions between the split energy levels of $Co^{2+}$ ions in $T_d$ crystal field under spin-orbit interactions.

• Journal of the Korean Solar Energy Society
• /
• v.23 no.2
• /
• pp.59-70
• /
• 2003

A stoichiometric mixture of evaporating materials for $CuGaSe_2$ single crystal thin films was prepared from horizontal electric furnace. Using extrapolation method of X-ray diffraction patterns for the polycrystal $CuGaSe_2$, it was found tetragonal structure whose lattice constant $a_0$ and $c_0$ were $5.615{\AA}$ and $11.025{\AA}$, respectively. To obtain the single crystal thin films, $CuGaSe_2$ mixed crystal was deposited on thoroughly etched semi-insulating GaAs(100) substrate by the hot wall epitaxy (HWE) system. The source and substrate temperatures were $610^{\circ}C$ and $450^{\circ}C$, respectively. The crystalline structure of the single crystal thin films was investigated by the photoluminescence and double crystal X-ray diffraction (DCXD). The carrier density and mobility of $CuGaSe_2$ single crystal thin films measured with Hall effect by van der Pauw method are $5.01\times10^{17}cm^{-3}$ and $245cm^2/V{\cdot}s$ at 293K. respectively. The temperature dependence of the energy band gap of the $CuGaSe_2$ obtained from the absorption spectra was well described by the Varshni's relation, $E_g$(T)=1.7998 eV-($8.7489\times10^{-4}$ eV/K)$T^2$/(T+335K). After the as-grown $CuGaSe_2$ single crystal thin films was annealed in Cu-, Se-, and Ga-atmospheres, the origin of point defects of $CuGaSe_2$ single crystal thin films has been investigated by the photoluminescence(PL) at 10 K. The native defects of $V_{CU},\;V_{Se},\;Cu_{int}$ and $Se_{int}$ obtained by PL measurements were classified as a donors or acceptors type. And we concluded that the heat-treatment in the Cu-atmosphere converted $CuGaSe_2$ single crystal thin films to an optical n-type. Also, we confirmed that Ga in $CuGaSe_2$/GaAs did not form the native defects because Ga in $CuGaSe_2$ single crystal thin films existed in the form of stable bonds.

• KSBB Journal
• /
• v.15 no.5
• /
• pp.482-488
• /
• 2000

The Fab fraction of PDC-E2 specific human monoclonal antibody was produced using recombinant E. coli, and the effects of glucose and acetate were investigated to develop an optimal strategy for recombinant human antibody production. Higher glucose concentration in the culture media resulted inn higher cell growth and glucose consumption rate, which in turn resulted in an increased acetate production rate. When glucose was depleted, cells began to consume acetate as an energy source, and this consumption rate depended on the glucose concentration. When the residual glucose concentration was high, the accumulation of acetate was accelerated due to an increase in the acetate production rate and a decrease in the acetate consumption rate. Futhermore, it was found that a high accumulation of acetate, accompanied by a high glucose concentration, inhibited human antibody formation; the critical acetate concentration was $0.6g/\ell$. During production, a high glucose concentration enhanced cell growth, but inhibited antibody formation due to catabolic repression. Therefore, it is important to keep the concentration of both glucose and acetate as low as possible to increase antibody production after induction. Accordingly, it is important to accurately control the concentration of glucose and acetate in the culture media to obtain high cell densities and high productivity levels of recombinant human antibody.

• 대한공업교육학회지
• /
• v.44 no.2
• /
• pp.86-103
• /
• 2019

The purpose of this study is to provide basic data on the development of education and training programs for training 'mechanical facilities maintenance manager'. To this end, the DACUM technique was used for job analysis and education and training programs were developed through expert consultation meetings. The job analysis was based on the 10-member DACUM Committee to derive the job definition, job model, job description, and task description of the 'mechanical facilities maintenance manager'. The main findings are as follows. First, the 'mechanical facilities maintenance manager' was defined as those who operate, inspect, diagnose, and repair mechanical facilities to provide the best performance and efficient operation management, provide a safe and pleasant environment, and perform energy saving and facility life extension tasks. Second, the duties of the 'mechanical facilities maintenance manager' analyzed in the job model consist of the comprehensive plan for operation of mechanical facilities, energy management of mechanical facilities, operation management of mechanical facilities, maintenance of mechanical facilities, safety environment management of mechanical facilities, and customer support management of mechanical facilities. Considering the nature and content of the duties, 4 to 11 tasks per duty were derived and a total of 33 tasks were presented as job model. Third, the curriculum for the 'mechanical facilities maintenance manager' was set up in two courses: Practice I for Mechanical Facilities Maintenance and Practice II for Mechanical Facilities Maintenance. Considerations and policy suggestions were presented when applying and implementing education and training programs based on the results of the research.

• Journal of Climate Change Research
• /
• v.3 no.2
• /
• pp.129-142
• /
• 2012

This study was carried out to evaluate carbon footprint during unhulled rice production and to compare mitigation technologies of methane, main carbon source during rice production, Carbon footprint of unhulled rice was a sum of $CO_2$ emission of agri-materials manufacture, rice cultivation and waste treatment. It was emitted 1.40 kg $CO_2$ during unhulled rice production, its distribution was 71.1% by $CH_4$ emission of rice cultivation, 11.8% of $N_2O$ emission by nitrogen application and 7.6% of complex fertilizer manufacture. $CH_4$ emission could be mitigated by some technologies; cultivation of the early maturing rice variety emitted lower by 44.4% than the mid maturing variety, intermittent drainage of submerged water by 43.8% than the continuous flooding condition, direct seeding by 32.0% than transplanting cultivation, no-ploughing by 20.9% than ploughing cultivation. It means that LCA on Global Warming Potential and the statistical data on innovated technical practice are key tools to systemize Measurable-Reportable-Verifiable (MRV) system for carbon footprint and carbon emission trade in the farm base.

• Tunnel and Underground Space
• /
• v.32 no.1
• /
• pp.78-92
• /
• 2022

In this study, we proposed a diagnostics and assessment model for mining sites that can evaluate the smart mining technology level in a systematic and structured way. For this, the maturity of the smart mining was defined, and detailed assessment items of the diagnostics and assessment model for smart mining were derived by considering the smart factory diagnostics and assessment model (KS X 9001-3) used in the manufacturing industry. While maintaining the existing system, the existing 46 detailed assessment items were modified to be suitable for mining. As a result, a total of 29 detailed assessment items were derived in the areas of promotion strategy, process, information system and automation, and performance. Based on this, a questionnaire was designed to diagnose the level of smart mining technology, and assessment was performed by applying it to domestic iron mines. The level of smart mining technology in the study area was found to be level 2, and it could be inferred that it was about 40% lower than the average smart level of the general manufacturing industry. In addition, by using the developed model, it was possible to recognize the weak points of the mine at each stage of the introduction, operation, and advancement of smart mining, and to suggest investment and improvement directions.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.42 no.3
• /
• pp.351-357
• /
• 2022

A conventional seawater reverse osmosis (SWRO) and a forward osmosis (FO) and reverse osmosis (RO) hybrid process to produce 1,000 m³/d of fresh water, were designed and compared in terms of carbon emission. When FO was adapted for the osmotic dilution, the required pressure for RO decreases, and thus energy consumption decreases. The decrease in carbon emission by decreased energy consumption (up to -0.73 kgCO₂/m³ using coal as the energy source) was compared with the increase in carbon emission by the FO system (+0.16 kgCO₂/m³), which is a function of various factors such as the number of FO modules and energy consumption. The comparison revealed that the FO-RO process causes less carbon emission compared with the SWRO process when the energy sources are coal and oil. However, if energy sources with low carbon emission such as solar, wind, and nuclear energy are selected, the carbon emission of the FO-RO process becomes higher than that of the SWRO process. This implies that the type of energy source is a key factor to determine the necessity of the FO-RO process from the aspect of carbon emission.