• Journal of Energy Engineering
• /
• v.4 no.1
• /
• pp.95-102
• /
• 1995

작동유체로서 비등점이 서로 다른 2종류, 즉 2성분 혼합물을 사용한 2상 밀폐 열싸이폰은 단일성분의 열싸이폰 보다 공학적으로 우수한 성능을 갖는다. 따라서 상 분리 현상이 나타나지 않은 안정적인 혼합물인 물/에탄올의 혼합물을 작동유체로 사용한 열싸이폰의 작동특성이 실험적으로 수행되었다. 실험에서는 시동성, 정상상태 작동, 경사시 작동특성 및 열전달 한계(Dry-out) 등에 관한 2성분 열싸이폰의 작동특성에 관해서 고찰되었다.

• Tunnel and Underground Space
• /
• v.29 no.5
• /
• pp.332-345
• /
• 2019

Maximum dip vector of individual joint plane, which can be uniquely defined on the hemispherical projection plane, has been established by considering its dip and dip direction. A new stereographic projection method for the rock slope analysis which employs the maximum dip vector can intuitively predict the failure modes of rock slope. Since the maximum dip vector is uniquely projected on the maximum dip point of the great circle, the sliding direction of discontinuity plane can be recognized directly. By utilizing the maximum dip vector of discontinuity both the plane sliding and toppling directions of corresponding blocks can be discerned intuitively. Especially, by allocating the area of high dip maximum dip vector which can form the flanks of sliding block the potentiality for the formation of virtual sliding block has been estimated. Also, the potentiality of forming the triangular-sectioned sliding block has been determined by considering the dip angle of joint plane the dip direction of which is nearly opposite to that of the slope face. Safety factors of the different-shaped blocks of triangular section has been estimated and compared to the safety factor of the most hazardous block of rectangular section. For the wedge analysis the direction of crossline of two intersecting joint planes, which has same attribute of the maximum dip vector, is used so that wedge failures zone can be superimposed on the stereographic projection surface in which plane and toppling failure areas are already lineated. In addition the maximum dip vector zone of wedge top face has been delineated to extract the wedge top face-forming joint planes the orientation of which provides the vital information for the analysis of mechanical behavior of wedge block.

• Proceedings of the Korean Society of Coastal and Ocean Engineers Conference
• /
• 2003.08a
• /
• pp.270-275
• /
• 2003

일반적으로 완경사를 가지는 자연해빈은 항내 파랑 에너지를 감쇄시켜 항만의 정온도를 유지시키는 중요한 역할을 한다. 그러나 계속되는 항만개발로 자연해빈이 인공적인 호안이나 안벽 등으로 급속하게 대체되어 가고 있는 실정이다. (중략)

• The Journal of Engineering Geology
• /
• v.33 no.4
• /
• pp.573-586
• /
• 2023

Joints or weak planes can induce anisotropy in the strength and deformability of fractured rock masses. Comprehending this anisotropic behavior is crucial to engineering geology. This study used plaster as a friction material to mold specimens with a single joint. The strength and deformability of the specimens were measured in true triaxial compression tests. The measured results were compared with three-dimensional numerical analysis based on the distinct element method, conducted under identical conditions, to assess the reliability of the modeled values. The numerical results highlight that the principal stress conditions in the field, in conjunction with joint orientations, are crucial factors to the study of the strength and deformability of fractured rock masses. The strength of a transversely isotropic rock mass derived numerically considering changes in the dip angle of the joint notably increases as the intermediate principal stress increases. This increment varies depending on the dip of the joint. Moreover, the interplay between the dip direction of the joint and the two horizontal principal stress directions dictates the strength of the transversely isotropic rock mass. For a rock mass with two joint sets, the set with the steeper dip angle governs the overall strength. If a rock bridge effect occurs owing to the limited continuity of one of the joint sets, the orientation of the set with longer continuity dominates the strength of the entire rock mass. Although conventional three-dimensional failure criteria for fractured rock masses have limited applicability in the field, supplementing them with numerical analysis proves highly beneficial.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2006.05a
• /
• pp.603-607
• /
• 2006

최근 산불발생이 증가하고, 그에 따른 피해가 증가하고 있다. 또한 산불 발생지역의 토양침식으로 인한 2차적인 재해위험이 예상됨에 따라 산불 지역의 토양침식과 영향인자들에 대한 연구가 활발히 진행되고 있다. 본 연구에서는 낙산사 산불지역의 산지사면에 10개의 소규모 조사구를 설치하고 강우에 따른 토사유출량을 조사하였다. 토양침식 매개변수를 강우인자(강우량, 강우강도, 강우에너지), 지형인자(면적, 사면경사, 사면길이, 길이경사인자), 식생인자(전체피복도, 식생지수), 토양인자(투수계수, 유효입경, 유기물함량, 토심)로 구분하여 각각의 토양침식에 대한 관계를 분석하고, 시간경과에 따른 토양침식의 관계도 분석하였다. 강우강도와 강우량이 커짐에 따라 토양침식민감도에 대한 식생피복도의 영향이 더욱 가중되며, 식생 회복이 빠른 지역과 그렇지 않은 지역에서의 시간경과에 따른 누적 토양침식량의 변화는 크게 차이를 보였다. 낙산사 산불지역에서의 강우에 따른 토양침식은 강우에너지와 식생피복도의 관계가 가장 높았다.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.8 no.1
• /
• pp.23-30
• /
• 2005

A numerical scheme is proposed which is applicable to the evaluation of wave field containing floating structures, and the method is utilized to estimate the effect of the floating breakwaters to be installed in Wonjeon port near Masan. The model is based on the mild-slope equation which is widely accepted for the calculation of wave modulation near shores and an additional term is introduced to consider the wave scattering associated with the thin floating structures such as floating breakwaters. The tranquility in Wonjeon port with the floating breakwater in the east side is calculated and compared with the one with a bottom-fixed breakwater. The present method is believed to provide an efficient way of quantitative measurement of the performance of floating breakwaters.

• Journal of the Korean Solar Energy Society
• /
• v.24 no.2
• /
• pp.39-50
• /
• 2004

One of the challenge for successful daylighting design might be to capture sunlighting that varies in both intensity and position and to deliver the luminous flux into the inner space as deep as possible. Conventional glazing apertures allow daylight in the outer 3.5m of a perimeter spaces. More advanced daylighting technologies can extend this daylighting depth by reflecting sunlight further from the windows within a deep floor area. For this purpose, this study developed light shelves based on performance evaluation with a mock-up model that constructed recently and measured under real sky condition. All these daylighting devices have a customized geometry developed from the solar path at a given latitude and utilize unique reflecting finishing to maximize the amount of redirection and diffusion of the daylight. This paper tells that the best daylighting penetration typically can be expected from using light-colored sloped external shelves.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.3
• /
• pp.440-447
• /
• 2012

Numerical model experiments of wave transformation due to the reclamation and the construction of breakwater in case of 50 years design wave were performed using time dependent mild slope equation included shoaling, refraction, diffraction, reflection and wave breaking. As waves propagate to the shore, wave height gradually diminishes by the bottom friction and wave breaking etc.. After the reclamation and the construction of 75 m length breakwater, wave height distributions in the lee of breakwater have the range of 29~128 cm. To make better the harbor tranquility the length of breakwater needs to extend more than 100 m. After the construction of breakwater, wave height in the lee of the structure was deduced over 80%.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2011.05a
• /
• pp.49-49
• /
• 2011

최근 지구온난화에 따른 이상기후로 강우가 집중되는 돌발강우가 발생하여 지류의 수위를 급속도로 증가시켜 도심에서도 침수가 발생하는 경우가 발생하고 있다. 이에 대한 해결방법으로는 구조적인 대책과 비구조적인 대책으로 나눌 수 있으며 대표적인 구조적 대책으로 고지수로가 있다. 고지수로는 지류의 상류인 고지대에서 발생되는 유출량을 지류로 직접 흘려보내지 않고 지류의 하류나 본류로 직접 방류하여 지류가 부담하는 홍수량을 분담시켜 홍수의 피해를 경감시키는 역할을 한다. 따라서 고지수로의 유량을 모니터링 하는 것은 홍수방어 대책에 중요한 역할을 한다. 고지수로의 유량을 측정하는 다양한 방법 중 위어를 이용한 개수로에서 유량 측정은 경제적이지만 에너지 손실이 크고 위어의 직상류에 토사가 퇴적된다는 단점이 있다. 반면 파샬플륨은 퇴사에 관한 문제가 거의 발생하지 않는다. 따라서 파샬플륨은 토사유입이 많은 고지수로에서 위어에 비해 상대적으로 유리한 유량계측기라 할 수 있다. 또한 수로의 횡단을 막고 낙차를 두어 유량을 산정하는 위어에 비해 에너지의 손실이 작아 돌발강우와 같은 큰 규모의 유출량을 빠르게 배제시키는 데에도 적합한 유량계측기이다. 파샬플륨의 형상은 그림 1과 같으며 본 연구에서는 3차원 수치모의를 이용하여 ISO에서 제안한 파샬플륨의 유량산정공식을 검증하고 고지수로에 파샬플륨을 경사로 설치하였을 때를 고려하여 다양한 유량조건에 대해서 수치모의를 실시하였으며, 그 결과는 그림 2에 도시하였다. 수치모의 결과를 바탕으로 파샬플륨의 경사를 고려한 새로운 유량산정공식을 도출하였다. 이는 고지수로에 적용하는 파샬플륨의 설계 시에 실질적이고 유용한 참고자료로 활용이 가능할 것이라고 판단된다.

• Journal of Energy Engineering
• /
• v.10 no.3
• /
• pp.214-222
• /
• 2001

The purpose of this research it to develop gas-air rotary heat exchanger using heat pipe and the performances were examined by way of the theoretical analysis and the experiment. Centrifugal force to return the working fluid in heat pipe elements with different radius was evaluated as a function of the revolution speed and inclination angle, and a rotary heat exchanger with 60 heat pipes in 3 rows was designed and manufactured. The inclination angle of a heat pipe relative to the revolving axis was designed to be 2$^{\circ}$and water was used as a working fluid. Experimental result showed the heat exchange rate was enhanced by 16% with compared to the calculated value.