• Geotechnical Engineering
• /
• v.14 no.5
• /
• pp.181-190
• /
• 1998

One-Dimensional Nonlinear Consolidation Model(NCM) ivas developed by using an Extended Power Function Model, which could represent the compressibility of soils. A nonlinear finite element program for NCM was developed to analyze the porewater pressure dissipation and the settlement of saturated soils. Parameters used in compressibility model could be easily obtained from conventional oedometer test data. This model has been applied to Yansan-Mulgum area for the comparison with the results of CONSOL program and that of Terzaghi theory. A Good The rates of consolidation predicted by this model and CONSOL were faster than that of conventional Tergaghi theory, for they consider the nonlinear characteristics of soils. Consolidation curves of this model were located between Terzaghi and CONSOL curves. Consolidation curves near drainage boundary, where effective stress valied rapidly, seemed to reflect the variations of compressibility of sails. Consolidation curves near drainage boundary obtained from this model were composed of two parabolic curves. Intersection of the parabolic curves occurred when effective stress reached the value of preconsolidation stress. Moreover, thin model could be used to represent the effect of magnitude of applied load. whereas CONSOL and Terazghi theory could not.

• Journal of the Korean GEO-environmental Society
• /
• v.9 no.5
• /
• pp.15-20
• /
• 2008

Compressibility of the marine clay was mainly studied velocity of consolidation and numerical analysis by this time but studies of reevaluated from the field measurement data was a little. For last three years, areal fills and extensive field instrumentations including settlement and pore water pressure were performed in the site of the Youngsan River estuary site, South Korea. From the settlement data, field consolidation curves for sub-layers were reconstructed. Effective surcharge loads during the staged loadings were calculated using the fill heights and the excess pore water pressures in the ground. In the numerical analysis (PLAXIS), prefabricated vertical drains were also simulated. Laboratory, field, and numerical analysis showed good agreements in compressibility. Due to different conditions and limitations of the clay was the same range of the oedometer tests.

• Journal of the Society of Disaster Information
• /
• v.15 no.1
• /
• pp.84-97
• /
• 2019

Purpose: The consolidation settlement of soft ground is dependent on the distribution of pore water pressure which is also affected by hydraulic conductivities (boundary condition) of layers, thickness of clayey soil layer and surcharge. Results: However, the current consolidation analyses are mostly based on Terzaghi's consolidation theory that assumes the initial pore water pressure ratio with depth to be constant. In this study, numerical analysis are carried out to investigate the variation of pore water pressure dissipation with depth and thickness of clayey soil layer, time, surcharge as well as drainage conditions. Conclusion: Comparative study with Terzaghi's consolidation theory is also conducted. The result shows that Terzaghi's consolidation theory should be used with caution unless it is ideally corresponded to the isochrone.

• Journal of the Korean GEO-environmental Society
• /
• v.9 no.3
• /
• pp.61-68
• /
• 2008

Side friction is often neglected in the analysis of the results of a consolidation test when the specimen has a high ratio of diameter to height. As the height of a specimen increases, however, side friction becomes important. This paper presents an investigation of the effect of side friction on consolidation test results for normally consolidated kaolinite slurry. Consolidation tests were performed to obtain settlement, pore pressure, compressibility, and hydraulic conductivity of kaolinite slurry. The compressibility relationship is corrected for side friction using a modified form of Taylor (1942) analytical solution. Numerical simulations using the CS2 piecewise-linear model are compared with settlement and excess pore pressure measurements. Experimental results show improved agreement with a modified CS2 model in which the effect of side friction is considered. The numerical and experimental results indicate that the side friction is an important factor affecting the rate of consolidation as well as the compressibility relationship for the specimen.

• Geotechnical Engineering
• /
• v.14 no.4
• /
• pp.141-150
• /
• 1998

Based on the authors' previous research, we have conducted more researches on finding out the coefficient of consolidation from Piezocone dissipation test results, especially measured behind the cone tip which is mostly used in Korea, by adopting the optimization technique. By analyzing numerical and real field examples, it can be found that the adopted optimum technique that minimizes the differences between the predicted dissipation curve and the measured one gives consistent and convergent results, irrespective of initial values. Such technique also provides horizontal coefficient of consolidation which is able to simulate real field consolidation behavior more effectively.

• Korean Journal of Agricultural Science
• /
• v.25 no.2
• /
• pp.225-234
• /
• 1998

This study was compared the degree of consolidation by Hyperbolic, Curve fitting, Asaoka's, Monden's methods using measured value with theoretical curve in consideration of smear effect and well resistance. The results of the study were summarized as follows ; 1. The degree of consolidation by Hyperbolic method was underestimated than the degree of consolidation by Curve fitting, Asaoka's, and Monden's methods. 2. Typical range of horizontal coefficient of consolidation was $C_h=(2{\sim}3)C_v$ in the case considering smear effect and well resistance, and $C_h=(0.5{\sim}2.5)C_v$ in the case disregarding smear effect and well resistance. 3. The degree of consolidation obtained by ground settlement monitoring was nearly same value when the coefficient of permeability of smear zone by back analysis was shown the half that of in-situ and the diameter of smear zone was shown double that of mendrel. 4. Increasing of diameter reduction ratio of drain, the time of consoildation was delayed. The affection of well resistance the case of small coefficient of permeability was much more than that in the case of large coefficient of permeability. It was recommended that design of diameter reduction of drain consider smear effect and well resistance.

• Journal of the Korean GEO-environmental Society
• /
• v.9 no.6
• /
• pp.53-60
• /
• 2008

In recent years, finite strain consolidation theories including a mechanical nonlinearity and a reasonable coordinate system have been proposed and used in educations and practical consolidation problems. However, despite their reasonable ability to predict the consolidation behavior, their failure in the field can be attributed to the complexity of estimating and selecting proper parameters for simulating the consolidation phenomenon. In this study, therefore, the application of a piecewise-linear method was proposed to solve such problems including the assumption of the uniqueness in compressibility. Especially, the concept of reference curve was introduced to define the effect of strain rate dependency of clay. The applicability of the methodology is verified by several tests. It was found that the proposed method is applicable in restrictive ranges of study carried out in the laboratory. Finally it is expected that the verification in field consolidation problem has to be carried out through future study.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.5
• /
• pp.145-154
• /
• 2003

In this study, the variation in excess pore pressure during dissipation is estimated by using successive cavity expansion theory and finite difference technique based on axisymmetric uncoupled linear consolidation theory with separate consideration of magnitude and initial distribution $\Delta{u}_{oct}$induced by changes of octahedral normal stress, and $\Delta{u}_{shear}$ induced by changes of octahedral shear stress. The coefficient of consolidation is also estimated by trial and error procedure until the predicted dissipation curve matches the measured curve at a typical degree of dissipation. The proposed method is applied to the results of miniature piezocone tests at Louisiana State University calibration chamber system. Based on the results of interpretation and the comparison with experimental measurements and those from other solutions, the prediction dissipation curves show a good match with those measured during dissipation tests and the values of coefficient of consolidation estimated by proposed method are more close to the range of laboratory measurements than those of other theories.

• Journal of the Korean Geotechnical Society
• /
• v.27 no.1
• /
• pp.41-52
• /
• 2011

The hypothesis on effective stress of unsaturated soil is validated by $K_0$ consolidation results of triaxial tests for the compacted residual soil. The stress characteristic curve (SSCC) can describe unsaturated soil behavior on water contents, which was defined from shear strength or from soil water characteristic curves. In this study, it was found that the stress path of $K_0$ consolidation can also define the SSCC. The effective stress was defined by SSCC. $K_0$ paths for various matric suctions could be described as a unique line by effective stress. The measured values of $K_0$ were interpreted by effective stress as a constant with respect to matric suction. Since the SSCC from $K_0$ consolidation agrees with that from the shear strength, the SSCC from soil water retention curve could describe effective stress behavior consistently on both $K_0$ consolidation path and stress at failure. The effective stress based on SSCC can describe the entire unsaturated behavior from consolidation to failure.

• 기술발표회
• /
• s.2006
• /
• pp.270-276
• /
• 2006

영산강 하구지역은 현재 신도시개발이 한창 진행되고 있으며, 연약한 해성퇴적층이 15~25cm로 존재하고 있다. 연약지반 개량설계는 불교란시료를 채취하고 각종 실내시험을 통하여 지반의 토질정수를 결정한다. 본 고찰은 압밀관련 지반정수인 선행압밀하중(Pc), 압축지수(Cc), 재압축지수(Cr)를 재해석하기 위해 침하계측 결과를 이용 실내시험의 압밀 곡선과 비교 분석하였다.