• Proceedings of the KIEE Conference
• /
• 2015.07a
• /
• pp.1265-1266
• /
• 2015

본 논문에서는 PMF와 FBG로 구성된 PDL 기반 사냑 간섭계를 이용하여 편광 간섭형 광섬유 압력 센서를 구현하였다. 여러 종류의 PMF들에서 압력 민감도를 비교하기 위해, 서로 다른 세 종류의 보우-타이형 PMF를 센서부로 사용하였다. 구현된 광섬유 압력 센서를 이용하여 0~0.3 MPa의 범위에서 압력 측정을 수행하였으며, 최대 압력 민감도는 근사적으로 -15.07 nm/MPa로 측정되었고, 센서의 선형성을 나타내는 $R^2$값은 ~0.992로 측정되었다. 제안된 센서는 FBG를 이용하여 외부 온도 변화의 보상이 가능하면서도, 이전의 편광유지 광자결정 광섬유 기반 압력 센서에 비해 압력 민감도를 4배까지 증가시킬 수 있었다.

• Korean journal of food and cookery science
• /
• v.7 no.2
• /
• pp.1-6
• /
• 1991

The sensory properties and the change of lipid content of cooked rice were investigated to evaluate the effects of cooker (electric and pressure cooker) and variety ($Japonica and Indica\timesJaponica variety$). Overall preference of cooked rices were higher in the pressure cooker than the electric cooker. In the case of electric cooker, Japonica variety was prefered than $I\timesJ$ variety. Free lipid contents were reduced and bound lipid contents were increased after cooking. The bound lipid contents had a correlation with shiness of cooked rice(r=-0.69).

• The Journal of the Acoustical Society of Korea
• /
• v.16 no.6
• /
• pp.68-75
• /
• 1997

In this study, to investigate vibration response of piping systems due to pulsation flow, a transfer matrix method is presented. Fluid-pipe interaction is formulated using wave equation for flow velocity and pressure, which depends on position and time. From the wave equation, transfer matrix is obtained. The dynamic responses of piping systems induced by pulsation flow appeared to depend upon fluctuation fluid velocity and pressure occurrnece from pulsation, and beating phenomena were observed near the resonance. Consequently, the dynamic behaviors of piping systems appeared to the same as response characteristics of the inside flow pattern of the pipe, and are determined by the inside fluid flow.

• Proceedings of the Korean Society for Food Science of Animal Resources Conference
• /
• 2004.10a
• /
• pp.227-230
• /
• 2004

본 연구에서는 신선육 및 원료육의 미생물 저감화 및 안전성 확보를 위해 식육에 초임계 이산화탄소 처리를 실시하였다. 이산화탄소의 초임계점인 78 atm, $38^{\circ}C$에서 10분 처리한 시료에서 병원성 미생물의 저감화가 나타나기 시작했으며, 압력을 100 atm 이상으로 증가시켰을 때 5 log 이상의 억제 효과가 나타나 신선육 및 원료육의 미생물학적 안전성이 검증되었다. 하지만 초임계 이산화탄소의 압력을 증가시킬수록 안정성은 확보되는 반면 시료의 구조${\cdot}$물성 변이가 심화되어 원료육의 가공적성도는 떨어지는 것으로 판단된다. 따라서 신선육 및 원료육의 품질을 고려한 미생물적 안전성을 확보하려면, 이산화탄소의 초임계점수준의 처리가 요구되며, 향후 초임계 이산화탄소 처리에 따른 육질변이 및 가공적성도에 대한 다각적이고 심도 있는 연구가 요구된다.

• Applied Chemistry for Engineering
• /
• v.9 no.3
• /
• pp.424-429
• /
• 1998

Cloud-point data at $230^{\circ}C$ and 1,800 bar are presented for two poly(ethylene-co-vinyl alcohol)(PEVA) copolymers[9.9mol% and 17.8mol% vinyl alcohol(VA)] in ethylene, propane, propylene, n-butane, 1-butene, dimethyl ether(DME), and chlorodifluromethane(CDFM). The static type experimental apparatus with a view cell has been used for the experiment at the high pressure and temperature. The pressure-temperature (P-T) loops of PEVA(9.9mol% VA) copolymer-DME mixtures are presented at copolymer concentrations of 1.4wt% to 20.0wt%. Also, we presented the phase behavior of PEVA(17.8mol% VA) copolymer-DME system at copolymer concentration of 1.9wt% to 6.8wt%. The cloud-point curves for the PEVA copolymers in dimethyl ether showed single phase above 480 bar as a result of the hydrogen bonding between the vinyl alcohol unit and dimethyl ether. The pressure-concentration(P-x) isotherm loops of PEVA(9.9mol% and 17.8mol% VA)-DME system are obtained. The cloud-point curves for PEVA(9.9mol% and 17.8 mol% VA) copolymers andthe ethylene, propane, propylene, n-butane, 1-butene, and CDFM all show negative slopes of phase behavior and are located at pressures below 1,800 bar. For PEVA copolymer-DME system(9.9mol% VA), cloud-point curves show positive slopes that decrease in pressures with decrease in temperature in the temperature range of $80^{\circ}C$ to $160^{\circ}C$.

• JOURNAL OF ELECTRICAL WORLD
• /
• no.1 s.3
• /
• pp.52-59
• /
• 1966

• Korean Chemical Engineering Research
• /
• v.47 no.3
• /
• pp.281-286
• /
• 2009

Bitumen extraction and sulfur removal from Athabasca oil sand were conducted using water in sub- and supercritical condition. Bitumen yield in micro reactor was investigated in the pressure range of 15~30 MPa, the temperature of 360 and $380^{\circ}C$ and water density $0.074{\sim}0.61g/cm^3$ for 0~120 min. Bitumen yield increased with reaction pressure irrespective of temperature and dramatically increased in especially supercritical region due to hydrogen formed from water gas shift reaction. Total amount of gas product decreased with reaction pressure but the portion of sulfur and hydrogen increased a little with increasing pressure to 25 and 30 MPa. It is seen that supercritical condition was favourable to the hydrogen formation and sulfur removal. Bitumen yield and sulfur removal from original oil sand reached a maximum 22% and 40% respectively in supercritical condition(the reaction time of 60 min at $380^{\circ}C$ and 25 or 30 MPa).

• Korean Chemical Engineering Research
• /
• v.43 no.1
• /
• pp.16-20
• /
• 2005

Porous polypropylene membranes were prepared by a thermally induced phase separation method in super-critical $CO_2$, where polypropylene and Camphene were used as raw materials. The porosity of polypropylene membranes with 10 wt% polypropylene concentration was 78, 80, 73% by using methanol, ethanol, and n-buthanol as an analytical solvent, respectively. The tensile strength increased with an increasing polypropylene concentration, where it was $0.17kg_f/mm^2$ at 10 wt% polypropylene concentration. The extraction rate for Camphene increased with time and Camphene was removed 94% in 5 min. It increased with an increasing temperature and was 99% at $45^{\circ}C$, however, decreased with an increasing temperature at higher than $45^{\circ}C$. The extraction rate increased with an increasing pressue up to 150 bar, however, decreased slightly with an increasing pressure over 150 bar. The extraction rate had a relation with the solubility of Camphene in supercritical $CO_2$.

• The Journal of the Petrological Society of Korea
• /
• v.8 no.2
• /
• pp.92-105
• /
• 1999

The Cretaceous Chaeyaksan basaltic rocks consist mainly of basaltic tuffs intercalating three layers of basalt. Stratigraphically, the rocks are located between the upper Songnaedong Formation and the lower Geoncheonri Formation and contain plagioclase, augite, hornblende, and a few olivine phenocrysts. Geochemically, they show calc-alkaline characteristics in some immobile element content, but show the alkaline suite feature in the mobile major element composition. The basalts are widely spilitized but some of them is altered to shoshonitic rocks with more calcic plagioclase, calcite, and chlorite, and adularia veinlets are common in the rocks. It is supposed that the post-eruption alteration of the rocks is done through alkali-replacement by hydrothermal solution or vapor rather than by low grade regional metamorphism. It is considered that A1 in hornblende will be available for estimating the pressure of the pre-eruption magma in the reservoir although the plagioclase of the rocks are highly albitized. The crystallization pressure was calculated as 5.7Kb by the equation of Johnson and Rutherford(l989) incorporating of the effect of overestimate of .41T in hornblende in the case of quartz-free rocks. Application of the estimated temperature, pressure and the constituent of phenocrysts of the rocks to the experimental P-T phase diagram for basalts established by Green(1982) indicates the crystallization course and succession of growth of the phenocrysts during of rising and cooling of the magma reservoir; augite + augite and olivine + augite, olivine, and hornblende -+ augite and hornblende+ augite, hornblende, and plagioclase. Such evolution course of the magma may include crystal fractionation by the phenocrysts crystallization and contamination by country rock in lower crust.

• Clean Technology
• /
• v.19 no.1
• /
• pp.8-12
• /
• 2013

Phase behavior of carbon dioxide + surfactant binary system and carbon dioxide + surfactant + water ternary system was investigated at the temperatures from 318 K to 348 K by using high pressure vapor liquid equilibrium apparatus containing variable-volume view cell. Sorbitan monopalmitate was used as the surfactant. The cloud point pressures for the binary mixture of carbon dioxide + sorbitan monopalmitate increased with an increasing of system temperatures and the maximum cloud point pressure was observed at the composition of 0.226 wt% of sorbitan monopalmitate. On the other hand, as the temperatures and compositions of water increased, the cloud point pressures for ternary system containing 0.1 wt% of sorbitan monopalmitate increased significantly. For the ternary system of constant 0.2 wt% of water, the cloud point pressure curves show relatively flat according to the change of compositions of surfactant. The cloud point pressures increased when the temperatures and compositions of water increased.