• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.2
• /
• pp.447-450
• /
• 2005

This paper describes an implementation of system based on ZIGBEE wireless communication technique to prevent for diseases of skin ailments and respiratory ailments as sensing the air pollutions that breaks out in the inside and purifying. ZIGBEE wireless communication technique has features - low battery consumption, low cost, acceptance of the maximum 256 node and simple protocol structure of below 32Kbyte. Hardware platform is implemented by using ATmega128L in ATmel corporation and 2.4GHz RF-IC CC2420 in Chipcon corporation and dust sensor(GP2Y1010AU) and gas sensor(GSBT11) that confirm degree of inside air pollution for ZIGBEE wireless communication technique.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.9 no.6
• /
• pp.1653-1658
• /
• 2008

In this paper, it is analyzed propagation distribution characteristics of radio wave, which is radiated on all sides from Access Point device for estimating scheme of wireless AP without GPS receiver environment. To tracking AP device is traced from wireless terminals and wireless terminal is traced from fixed AP devices, above all it is important to analysis the characteristics of receiving power in according to distance. Therefore in this paper, radio propagation characteristics of 2.4GHz wave is analyzed effect extent and quality in according to distance in doors and out doors, and utilized to location estimation.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.10 no.2
• /
• pp.1-6
• /
• 2010

Short-range wireless communication systems are expanding at rapid rate, finding application in offices and homes. Development of wireless local network is accompanied by steady increase in the demand for ever higher data rates. This in turn entails the necessity to develop communication systems which operate at higher frequencies. It can be expected that short-rage wireless communication networks will soon push towards the THz frequency range. We use a 3D ray-launching for analysis of propagation environments at the indoor fixtures. We extended the approach from the modeling of the reflectivity of optically thick, smooth building materials at THz frequencies to materials with a rough surface. The simulation result of propagation environment is similar to average received power of reference paper. The RMS delay spread was calculated to be 9.11 ns in a room size of $6m(L){\times}5m(W){\times}2.5m(H)$ for the concrete plaster.

• Journal of Advanced Marine Engineering and Technology
• /
• v.34 no.6
• /
• pp.852-857
• /
• 2010

In this paper, we proposed and demonstrated an indoor visible-light communication system using an array of light-emitting diodes (LEDs). The main idea is based on that the LEDs can be used not only for lighting but also for free-space optical communications. Because LEDs offer advantageous properties such as high brightness, reliability, lower power consumption and long lifetime, the indoor visible-light communication systems are going to provide high quality of service by the high radiation power of the LED lighting. Prototype of simplex channel for audio and the full-duplex channel for text message were developed. Results indicates the viability of creating inexpensive free-space optical communication transceivers that might be embedded in commercial light products to supports indoor wireless networking.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.5C
• /
• pp.472-478
• /
• 2010

In the environment of wireless communication system of IEEE 802.15.3a UWB standard, the angle of arrival(AOA) estimation technique for the indoor wireless positioning algorithms, based on the AOA parameter estimation which fits well for the wireless communication channel and shows high estimation accuracy, is proposed. After the UWB signal model, based on the IEEE 802.1.3a standard, is constructed, the average weighted MUSIC technique is proposed, which shows better estimation accuracy than those of conventional estimation technique. Through the simulation studies, the environment of the indoor wireless positioning system including the IEEE 802.15.3a channel is configured and we demonstrate better estimation results by the proposed AOA estimation technique than those from the conventional method.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.4
• /
• pp.847-856
• /
• 2013

This paper presents an AP placement technique considering indoor location-awareness and examines its performance. The proposed AP placement technique is addressed from three performance metrics: location-awareness and AP-based wireless network performance as well as its cost. The proposed AP placement technique consists of meta-heuristic algorithms that yield a near optimal AP configuration for given performance metrics, and deterministic algorithms that improve the fast convergence of the near optimal AP configuration. The performance of the AP placement technique presented in this paper is measured under the environments simulating indoor space, and numerical results obtained by experimental evaluation yield the fast convergence of a near-optimal solution to a given performance metric.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.2C
• /
• pp.91-99
• /
• 2003

In this paper, We analyze performance of ZFE MUD receiver in DSSS unidirectional wireless transceiver operating in 2.4㎓ ISM band and indoor environment. This system has the shortcomings that many burst error is occurred because of long term deep fade experienced by some user and impossibility of power control. Therefore, the solution to this problem is important because the performance of DS-CDMA system is guaranteed under, the perfect power control. MUD receive. which improves the performance of this system is not required to perform rigorous power control and is able to remove MAI using linear equalization. From the result of performance comparison, we show that ZFE MUD receiver is more adequate for this system than other receivers.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2006.05a
• /
• pp.1005-1008
• /
• 2006

In this paper, we provide data of wireless environment in indoor for Bluetooth and wireless LAN systems. To accurately measure transmission characteristic for influence of the indoor wall, we used radiation measurement system with antennas. And various structure and material of the indoor wall are measured. Results of the measurement show that the attenuation of power is about $1\sim3dB$ for cement wall(25cm). In the case of cement wall with steel frame, the attenuation of power was increased using horizontal polarization but was not affect using vertical polarization.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.10a
• /
• pp.461-462
• /
• 2016

IPS 측위는 GPS음영 지역인 실내의 특정 위치 정보를 판단하는 시스템으로 현재 위치에서 발생되는 신호 정보를 수집하는 시스템과 이 신호들로 구성된 실내 측위 지도, 측위 위치를 결정하기 위한 알고리즘 등에 따라 여러 종류로 나누어진다. 대표적인 IPS로 2.4Ghz, 5.0GHz 대역의 무선 신호(WiFi, BLE, Sensor Network, etc)를 활용하는 RF신호 기반 WPS 등이 있다. RF 신호를 기반으로 하는 실내 측위는 발생 기기의 고장, 장애물 발생, 채널 간섭 현상 등으로 인해 측위 시점 수집된 신호와 구축된 지도의 신호 정보가 달라 측위 정확도가 낮아지는 경우가 발생한다. 본 논문에서는 앞서 언급한 문제점을 해결하기 위해 기존 RF 환경을 사용하는 IPS 방안에 대하여 분석한다. 또한 RF 이외의 실내 측위 기술들에 대해서도 설명하고 측위 정확도를 위해 단일 측위 방식이 아닌 복합 측위 방식에 대한 설계를 제안한다.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2022.10a
• /
• pp.346-348
• /
• 2022

Many CCTVs are needed to monitor a physically large area. When installing CCTV indoors, the wiring environment is sufficient, so many CCTVs can be installed. However, wiring is relatively difficult outdoors. In addition, when monitoring a long distance, wiring costs to the monitoring site are incurred. Therefore, when installing CCTV at a physically long distance, it is necessary to apply wireless technology. In this study, the structure of the existing CCTV system was checked and the requirements for converting it to a wireless environment were derived. And according to the requirements, a wireless-based intelligent CCTV system was proposed. As a result, it was confirmed that the wireless-based intelligent CCTV proposed in this study operates normally in a wireless environment. This study was conducted based on the wifi environment, and additional research is needed to extend it to the mobile mobile telecommunication environment.