• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.2
• /
• pp.467-470
• /
• 2006

본 논문에서는 GPS와 의사위성을 이용하는 무인항공기 착륙용 측위 정확도 예측 프로그램의 개발을 나타내었다. 무인항공기의 착륙 환경을 모사하기 위하여 착륙 장소의 GIS 데이터를 기반으로 광선추적(ray tracing) 기법을 이용하여 의사 위성신호의 전파과정을 상세히 모사하였으며, GPS 위성의 위치는 위성궤도 생성 프로그램과 오차 모델을 이용하여 생성하였다. 의사위성 신호와 GPS 신호를 동시에 사용하여 위치를 구할 수 있으며, 일반적인 GPS UERE 모델과 의사위성 설치 환경의 UERE 모델을 이용하여 DOP와 NSP를 계산하고 측위 정확도를 예측할 수 있다. 개발된 측위 정확도 예측 프로그램은 무인항공기의 착륙지의 선정 및 오차 예측뿐 아니라 의사위성과 GPS를 동시에 사용하는 모든 응용에 효과적으로 적용될 수 있다.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2008.05a
• /
• pp.793-795
• /
• 2008

최근 유비쿼터스 컴퓨팅과 유비쿼터스 네트워크를 활용하여 새로운 서비스들을 개발하려는 노력이 진행 중이며, 이에 관련된 기술의 중요성도 급증하고 있다. 특히 감시정찰 센서네트워크의 핵심 구성요소인 저가의 경량 센서노드에서 측정한 미가공 데이터(raw data)를 사용하여 침입 물체의 실시간 탐지, 식별, 추적 및 예측하기 위한 디지털 신호처리 기술은 주요 기술 중 하나이다. 본 논문에서는 감시정찰 센서네트워크의 핵심 구성요소인 자기 센서노드에서 측정한 자기 미가공 데이터를 사용하여 사람과 차량을 탐지할 수 있는 자기 센서 디지털 신호처리 알고리즘을 설계한다. 알고리즘의 주 목표는 감시정찰용 센서노드의 탐지 신뢰성을 높이기 위한 높은 침입물체 탐지 성공률(success rate)과 낮은 허위신고(false alarm) 횟수를 가지는 것이다.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.05a
• /
• pp.505-508
• /
• 2016

In city, tracing of power transmission lines is difficult due to compound installation of overhead and underground lines, transposition, bad view caused by trees or big buildings. It is hard problem for electrical technician on site to trace power transformers or power lines to serve customers in 3 phase -4 wires power distribution systems. It is necessary that the correct and fast tracing method is required for load balancing among distribution lines. Old technology use to trace lines with high power impulse injection. Our proposed method uses to trace lines with very small power high frequency signal injection. Simulation models for 3-phase power transformers, 3-phase wire lines, and customer loads are described to investigate the transmission characteristics of high frequency power line carrier. Distribution lines have only a limited ability to carry higher frequencies. Typically power transformers in the distribution system prevent propagating the higher frequency carrier signal. The proposed method uses the limited propagation ability to identify the power transformer to serve customers. The system consists of a transmitter and a receiver with power-line communication module. Some experiments are conducted to verify the theoretical concepts in a big commercial building. Also some simulations are done to help and understand the concepts by using MATLAB Simulink simulator.

• Proceedings of the Korean Society of Medical Physics Conference
• /
• 2005.04a
• /
• pp.59-63
• /
• 2005

Respiration motion causes movement of internal structures in the thorax and abdomen, making accurate delivery of radiation therapy to tumors in those areas a challenge. Accounting for such motion during treatment, therefore, has the potential to reduce margins drawn around the clinical target volume (CTV), resulting in a lower dose to normal tissues (e.g., lung and liver) and thus a lower risk of treatment induced complications. Among the techniques that explicitly account for intrafraction motion are breath-hold, respiration gating, and 4D or tumor-tracking techniques. Respiration gating methods periodically turn the beam on when the patient's respiration signal is in a certain part of the respiratory cycle (generally end-inhale or end-exhale). These techniques require acquisition of some form of respiration motion signal (infrared reflective markers, spirometry, strain gauge, thermistor, video tracking of chest outlines and fluoroscopic tracking of implanted markers are some of the techniques employed to date), which is assumed to be correlated with internal anatomy motion. In preliminary study for the respiratory gating radiation therapy, we performed to measurement of this respiration motion signal. In order to measure the respiratory motion signals of patient, respiration measurement system (RMS) was composed with three sensor (spirometer, thermistor, and belt transducer), 4 channel data acquisition system and mobile computer. For two patients, we performed to evaluation of respiratory cycle and shape with RMS. We observed under this system that respiratory cycle is generally periodic but asymmetric, with the majority of time spent. As expected, RMS traced patient's respiration each other well and be easily handled for application.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.20 no.2
• /
• pp.141-147
• /
• 2020

We studied for GPU based signal processor for naval multi-function radar. We implemented processing software both DSP and GPU, and compared computation performances and power consumption. As a result, computation performance was enhanced from 1.2 to 4.1 times compared with a DSP result. From the results, GPU can alternating DSP based signal processor for common radar processor even though Naval Multi Function Radar.

• Proceedings of the Acoustical Society of Korea Conference
• /
• autumn
• /
• pp.213-216
• /
• 2000

본 연구에서는 마이크로폰 어레이를 이용하여 화자의 음성신호로부터 화자의 위치를 추정하는 기존의 대표적인 알고리듬인 CPSP(Cross Power Spectrum Phase)로부터 보다 반향에 강인한 알고리듬인 저주파 위상 복원 알고리듬을 제안한다. CPSP 함수는 상호 상관관계(Cross Correlation)가 정규화 되어있는 형태를 갖는데, CPSP 함수의 최대 값 인덱스로부터 화자의 공간정보인 TDOA(Time Difference Of Arrival)를 추출한다. 그러나 CPSP 함수를 이용한 공간정보 추정 알고리듬은 실내환경에서 심각하게 일어나는 반향신호에 대해서 취약한 단점을 갖고 있다. 본 논문에서 제안하는 저주파 위상복원 알고리듬은 주파수 측면에서 반향신호가 CPSP 함수에 미치는 영향을 분석하여 반향으로 인하여 왜곡된 위상 성분을 복원함으로써 보다 신뢰도 있는 TDOA 추정을 가능하게 한다. 반향신호로 인한 CPSP의 위상은 저주파보다 고주파에서 심하게 왜곡되는데, 각각의 반향신호의 도달 시간을 기하학적 분포를 갖는 확률변수로 모델링하여 이를 수학적으로 증명하였다. 또한 실제 환경에서 채집한 음성신호를 이용한 모의 실험을 통해 개선된 알고리듬의 성능 개선을 확인하였다.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.13 no.5
• /
• pp.971-978
• /
• 2018

This paper deals with the design and implementation of a limiter, which is a key component of the Ku-band radar system. The limiter design with the multi-pin diode switch was complemented by wideband signal attenuation, and realized the physical implementation. In the test result of implemented limiter, when the pin diode switch is all off, it is possible to transmit the incoming signal without distortion. Also when the pin diode switch is turned on sequentially, the input signal is attenuated about 20dB or more step by step. Finally when all of them were turned on, attenuation about 50dB or more were measured for a wide bandwidth(1000MHz) in Ku-band.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.8
• /
• pp.1652-1658
• /
• 1997

We analyze the short-term fading characteristics of received signal in urban microcellular environment. In order to analyze the fading signal, we obtain the fading distributions by distance, the received power pattern by arrival angle and the spatial correlation coefficients of fading signal by spacing distance between two antennas. In addition, we compare the distributions of simulated fading signal with the Rician parameter K in various conditions. As the results, it can be seen that the occuring period of deep fade and fade range in microcell are different as the distance between two antennas;besides, the period of fade and fade range in OBS region occur shortly and deeply as compared with those in LOS region. The data used in analysis are obtained by the simulation program using ray tracing technique.

• Korean Journal of Optics and Photonics
• /
• v.13 no.5
• /
• pp.377-383
• /
• 2002

An all-digital closed-loop (ADCL) signal processor for an open-loop FOG was developed to replace the analog circuitry of a Digital Phase Tracking (DPT) signal processor with new digital circuitry. When the ADCL signal processor without a stabilizer for fiber phase modulator (FPM) was attached to the FOG, temperature drift of FOG was about 0.26$\mu$rad/$^{\circ}C$, which makes the FOG unusable in medium or higher-grade applications. This drift was due to variations of phase modulation amplitude and phase delay of the FPM. The stabilizer controls its phase modulation amplitude and phase delay by regulating the ratio of harmonics of the FOG output. Thus, the stabilizer reduces the drift of the FOG to negligible.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.39 no.8
• /
• pp.14-25
• /
• 2002

In this paper, we propose a modified AFC algorithm which is suitable for the implementation of WCDMA reverse link receiver modem. To reduce the complexity, the modified CP-FDD algorithm named 'Normalized CP-FDD' is applied to the AFC loop. The proposed FDD algorithm overcomes the conventional CP-FDD's sensitivity to the variance of input signal amplitude and increases the linear range of S -curve. Therefore, offset frequency estimation using the proposed scheme can be more stable than the conventional method. Unlike IS-95, since pilot symbol in WCDMA is not transmitted continuously, we introduce a moving average filter at the FDD input to increase the number of cross-product. So, tracking speed and stability are improved. For more rapid frequency acquisition and tracking, we adopt a multi-stage tracking mode. Using NCO having ROM table structure, the frequency offset is compensated. We applied the proposed algorithm in the implementation of WCDMA base station modem successfully.