• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.3
• /
• pp.69-76
• /
• 2008

This work proposes a 12b 1kS/s 65uA 0.35um CMOS algorithmic ADC for sensor interface applications such as accelerometers and gyro sensors requiring high resolution, ultra-low power, and small size simultaneously. The proposed ADC is based on an algorithmic architecture with recycling techniques to optimize sampling rate, resolution, chip area, and power consumption. Two versions of ADCs are fabricated with a conventional open-loop sampling scheme and a closed-loop sampling scheme to investigate the effects of offset and 1/f noise during dynamic operation. Switched bias power-reduction techniques and bias circuit sharing reduce the power consumption of amplifiers in the SHA and MDAC. The current and voltage references are implemented on chip with optional of-chip voltage references for low-power SoC applications. The prototype ADC in a 0.35um 2P4M CMOS technology demonstrates a measured DNL and INL within 0.78LSB and 2.24LSB, and shows a maximum SNDR and SFDR of 60dB and 70dB in versionl, and 63dB and 75dB in version2 at 1kS/s. The versionl and version2 ADCs with an active die area of $0.78mm^2$ and $0.81mm^2$ consume 0.163mW and 0.176mW at 1kS/s and 2.5V, respectively.

• Journal of Internet Computing and Services
• /
• v.10 no.6
• /
• pp.7-17
• /
• 2009

The development of wireless communication MAC layer is usually released as SoC which is a combination in hardware and software. In this system development environment, an environment for software development and verification is necessary because the hardware development takes a lot of time priori to completion. In integrated development of hardware and software, simulation environment of hardware and software provided by hardware modeling using HDL at RTL and ISS respectively. By increasing the development complexity of system, ESL design modeling systems at higher abstraction level than RTL has already prompted. The ESL design is divided untime model and time model. This paper present design and implementation of MCU for untime model simulation, not time model. Proposed MCU can optimize the system at early step of system development and move up the development completion time by verifying the system function easily and rapidly than part required exact time in untime model. In this paper, we present an MCU module based on SystemC and UC/OS-II Module providing real-time operate system.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.9
• /
• pp.58-67
• /
• 2009

This paper presents a fully digital gain control system with a new high bandwidth and wide dynamic range power detector for DVB-S2 application. Because the peak-to-average power ratio (PAPR) of DVB-S2 system is so high and the settling time requirement is so stringent, the conventional closed-loop analog gain control scheme cannot be used. The digital gain control is necessary for the robust gain control and the direct digital interface with the baseband modem. Also, it has several advantages over the analog gain control in terms of the settling time and insensitivity to the process, voltage and temperature variation. In order to have a wide gain range with fine step resolution, a new AGC system is proposed. The system is composed of high-bandwidth digital VGAs, wide dynamic range power detectors with RMS detector, low power SAR type ADC, and a digital gain controller. To reduce the power consumption and chip area, only one SAR type ADC is used, and its input is time-interleaved based on four power detectors. Simulation and measurement results show that the new AGC system converges with gain error less than 0.25 dB to the desired level within $10{\mu}s$. It is implemented in a $0.18{\mu}m$ CMOS process. The measurement results of the proposed IF AGC system exhibit 80-dB gain range with 0.25-dB resolution, 8 nV/$\sqrt{Hz}$ input referred noise, and 5-dBm $IIP_3$ at 60-mW power consumption. The power detector shows the 35dB dynamic range for 100 MHz input.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.1
• /
• pp.121-132
• /
• 2009

Default password protection used in operating systems have had many advances, but when the attacker has physical access to the server or gets root(administrator) privileges, the attacker can steal the password information(e.g. shadow file in Unix-like systems or SAM file in Windows), and using brute force and dictionary attacks can manage to obtain users' passwords. It is really difficult to obligate users to use complex passwords, so it is really common to find weak accounts to exploit. In this paper, we present a secure authentication scheme based on digital signatures and secure key storage that solves this problem, and explain the possible implementations using Trusted Platform Module(TPM). We also make a performance analysis of hardware and software TPMs inside implementations.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.1
• /
• pp.109-114
• /
• 2010

In this paper, the implementation of a human signal sensing module that has capabilities to check and restore the weak signals from the human body is presented. A module presented in this paper consists of processing and sensing elements related to human pulse and body temperature and a controller implemented with SoC design method. PPG data is detected by a noise filtering process toward the amplified signal which is from the operating frequency between 0.1Hz - 10Hz. A digital temperature sensor is used to check the body temperature. A sensor outputs the corresponding value of the electric voltage according to the body temperature. Moreover, this paper discusses the implementation of an enhanced microprocessor which is synthesized with VHDL as a part of the SoC development and used to control the entire module. The SoC processor is implemented on a Xilinx Spartan 3 XC3S1000 device and has the achieved operating frequency of 10MHz. The implemented SoC processor core is successfully tested with macro memories in FPGA and the experimental results are hereby shown.

• Journal of Advanced Marine Engineering and Technology
• /
• v.39 no.1
• /
• pp.63-67
• /
• 2015

White light-emitting diode (WLED) is growing interest in using both illumination and communications. This paper reports visible light communication (VLC) composed of a super bright white light-emitting diode, low cost commercial photo-diode and a Fresnel lens. LED driver is consisted of the power MOSFET and MOSFET driver that switches the LED on and off. The modulation bandwidth of the LED used was determined to be 8 MHz. However, it was possible to communicate up to 1 Mbps under illumination of 500 lx because of the weak signal power and a low spectral sensitivity of the SHF213 as a PIN photodiode. In order to enhance the system bandwidth, the LED light was focused on the PIN photodiode by use of the Fresnel lens. As a result of that, visible light link was operated up to modulation bandwidth of the LED. The signal to noise ratio can be improved by 40 dB using an optical concentration at the receiver.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2013.05a
• /
• pp.345-348
• /
• 2013

This paper provides a method for compression and transmission of on-chip bus data. As the data traffic on on-chip buses is rapidly increasing with enlarged video resolutions, many video processor chips suffer from a lack of bus bandwidth and their IP cores have to wait for a longer time to get a bus grant. In multimedia data such as images and video, the adjacent data signals very often have little or no difference between them. Taking advantage of this point, this paper develops a simple bus data compression method to improve the chip performance and presents its hardware implementation. The method is applied to a Video Codec - 1 (VC-1) decoder chip and reduces the processing time of one macro-block by 13.6% and 10.3% for SD and HD videos, respectively.

• Journal of IKEEE
• /
• v.23 no.2
• /
• pp.388-394
• /
• 2019

This paper describes a design of security system-on-chip (SoC) that integrates a Cortex-M0 CPU with an AAW (ARIA-AES- Whirlpool) crypto-core which implements two block cipher algorithms of ARIA and AES and a hash function Whirlpool into an unified hardware architecture. The AAW crypto-core was implemented in a small area through hardware sharing based on algorithmic characteristics of ARIA, AES and Whirlpool, and it supports key sizes of 128-bit and 256-bit. The designed security SoC was implemented on FPGA device and verified by hardware-software co-operation. The AAW crypto-core occupied 5,911 slices, and the AHB_Slave including the AAW crypto-core was implemented with 6,366 slices. The maximum clock frequency of the AHB_Slave was estimated at 36 MHz, the estimated throughputs of the ARIA-128 and the AES-128 was 83 Mbps and 78 Mbps respectively, and the throughput of the Whirlpool hash function of 512-bit block was 156 Mbps.

• Journal of IKEEE
• /
• v.26 no.4
• /
• pp.714-721
• /
• 2022

A phase-locked loop (PLL)-based frequency synthesizer is proposed for a system on a chip (SoC) using multi-frequency clock signals. The proposed PLL-based frequency synthesizer consists of a charge pump PLL which is implemented by a phase frequency detector (PFD), a charge pump (CP), a loop filter, a voltage controlled oscillator (VCO), and a frequency divider, and an edge combiner. The PLL outputs a 12-phase clock by a VCO using six differential delay cells. The edge combiner synthesizes the frequency of the output clock through edge combining and frequency division of the 12-phase output clock of the PLL. The proposed PLL-based frequency synthesizer is designed using a 55-nm CMOS process with a 1.2-V supply voltage. It outputs three clocks with frequencies of 166 MHz, 83 MHz and 124.5MHz for a reference clock with a frequency of 20.75 MHz.

• Journal of KIISE:Computer Systems and Theory
• /
• v.33 no.9
• /
• pp.592-607
• /
• 2006

This paper proposes a technique to select processors and hardware IPs and to map the tasks into the selected processing elements, aming to achieve high performance with minimal system cost when multitask applications with real-time constraints are run on a multicore SoC. Such technique is called to 'Hardware-Software Cosynthesis Technique'. A cosynthesis technique was already presented in our early work [1] where we divide the complex cosynthesis problem into three subproblems and conquer each subproblem separately: selection of appropriate processing components, mapping and scheduling of function blocks to the selected processing component, and schedulability analysis. Despite good features, our previous technique has a serious limitation that a task monopolizes the entire system resource to get the minimum schedule length. But in general we may obtain higher performance in multitask multicore system if independent multiple tasks are running concurrently on different processor cores. In this paper, we present two mapping techniques, task mapping avoidance technique(TMA) and task mapping pinning technique(TMP), which are applicable for general cases with diverse operating policies in a multicore environment. We could obtain significant performance improvement for a multimedia real-time application, multi-channel Digital Video Recorder system and for randomly generated multitask graphs obtained from the related works.