• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.35S no.6
• /
• pp.1-8
• /
• 1998

This paper presents an asynchronous DS/CDMA multiuser detector, which is a two stage, symbol-by-symbol scheme consisting of conventional detectors followed by linear decorrelating detectors. The conventional detector first makes temporal decisions and the detected symbols are delayed by one symbol period to be used for the selection of decorrelating bases in the subsequent decorrelaing detection stage. It also employs a bank of early-late correlators in place of a bank of single correlators taking the small offset of chip timing asynchronism into account. The proposed detector requires only the coarse knowledge of relative time delays of interfering users and is suitable for digital implementation. To verify the detector performance, the analytical BER performance will be given and compared with the simulation results for BPSK DS/CDMA signals in AWGN channel. While the performance of the proposed detector will be analyzed for time-limited signal, the simulation is carried out for both the time-limited and band-limited signals. As can be seen in the simulation results, the proposed scheme shows good results.

• Proceedings of the Korea Inteligent Information System Society Conference
• /
• 2000.11a
• /
• pp.317-324
• /
• 2000

주기적인 연관규칙은 타겟데이터베이스를 일정 단위시간으로 나누었을 때 연관규칙이 만족하는 구간이 일정한 주기마다 발생하는 패턴을 탐색하는 방법이다. 하지만, 이 방법은 엄격한 주기를 가지도록 하여 실제 데이터에 그대로 적용하기가 어려웠다. 예를 들이 편의점 데이터에서 매일 오전 7시-8시 사이에 주기적으로 발생하는 연관규칙을 발견할 때, 이러한 연관규칙을 주기적인 연관규칙이라고 한다. 하지만, 실제 데이터에서는 날씨와 같이 사람의 행동에 영향을 미치는 다른 요인 때문에 항상 일정한 주기를 가지는 연관규칙을 찾기는 어렵다. 본 논문에서는 주기가 일정하지 않은 연관규칙을 찾기 위해서 연관규칙의 주기성을 허용 오차를 포함하며 재정의하고, 오차를 허용하기 위한 탐색 알고리즘을 보완하였다. 반면에, 오차를 허용함으로써 오차를 허용하지 않는 경우보다 더 많은 주기성을 찾을 수 있을 뿐만 아니라, 동일한 주기를 가지지만 오프셋이 다른 여러 개의 비슷한 주기가지 찾게 되어 사용자가 의미 있는 연관규칙을 찾는데 방해가 된다. 본 논문에서는 이를 해결하기 위해서 오차를 허용하는 주기적 연관규칙의 오차의 정도를 측정하기 위한 단위로 집중도(intensity)와 경향성(tendency)을 제안한다. 주기적 연관규칙이 매 주기마다 정확한 세그먼트에 나타나는 정도를 나타내는 집중도와, 최소 평균오차를 의미하는 경향성을 이용하여 유사한 주기들 중에서 대표주기만을 찾을 수 있도록 한다. 또한, 오차를 허용하는 주기적 연관규칙에서 오차가 주로 발생하는 패턴을 분석함으로써 고객들의 수요 경향성을 더 잘 파악할 수 있다. 예를 들어, 평소에는 매일 오진 7시∼8시에 나타나던 연관성이 지각하는 사람들이 같은 월요일에는 1시간 늦은 8시∼9시에 나타난다는 오타 정보까지 파악할 수 있다. 이러한 월요일마다 1시간 늦게 나타나는 오차의 경향성을 나타내는 오차 주기(error cyc1e)를 이용함으로써 고객들의 수요의 경향성을 좀 더 세밀한 부분까지 파악할 수 있게 해 준다.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.25 no.1
• /
• pp.1-6
• /
• 2015

In this paper, a fuzzy control method is used for balancing a single-wheel robot. A single-wheel robot controlled by the PD control method becomes easily unstable since the flywheel tends to lean against one direction. In the previous research, we have used the gain scheduling method. To remedy this problem, in this paper, a fuzzy compensation technique is proposed to compensate for the balancing angle. The fuzzy control method compensates offset values at the balancing angle to prevent the gimbal from falling against one direction. Experimental studies of the balancing control performance of a single-wheel mobile robot validate the proposed control method.

• KIPS Transactions on Software and Data Engineering
• /
• v.2 no.11
• /
• pp.809-814
• /
• 2013

Summed area table (SAT) is a data structure in which the sum of pixel values in an arbitrary rectangular area can be represented by the linear combination of four pixel values. Since SAT serially accumulates the pixel values from an image corner to the other corner, a high-resolution image can yield overflow in a floating-point representation. In this paper, we present a new SAT construction technique, which accumulates only the residuals from the linearly-regressed representation of an image and thereby significantly reduces the accumulation errors. Also, we propose a method to find the integral of the linear regression in constant time using double integral. We performed experiments on the image reconstruction, and the results showed that our approach more reduces the accumulation errors than the conventional fixed-offset SAT.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.10
• /
• pp.2129-2135
• /
• 2011

The WLAN and WPAN systems employed on 2.4GHz ISM band wireless networks provide complementary services within the same environments. Coexistence between the networks will be impaired, if the mutual packets are uncertainty associated the timing or gaussian distance. This paper analyzes the impact of the mutual interference on the services performance and in order to minimize the effect of WPAN system signals on the WLAN system, proposed a method of suppressing the interference on the WLAN system. The analysis is illustrated by examining the symbol error rate versus signal to noise interference ratio in terms of the carrier frequency offset.

• Journal of IKEEE
• /
• v.20 no.4
• /
• pp.373-377
• /
• 2016

This paper presents a low power boost converter using offset controlled Zero Current Sensor (ZCS) control for thermoelectric energy harvesting.[1] [5] Offset controlled ZCS uses adjustable pre-offset that is controled by 6bit code each connected gate of NMOS for switching. Offset controlled ZCS demonstrates an efficiency that is higher than using analog comparator ZCS and that is smaller area than using delay line ZCS. Experimentally, the offset controlled ZCS system consumes 10 times less power than analog comparator ZCS based system at similar performance.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.11
• /
• pp.1117-1124
• /
• 2011

In this paper, we implemented a Ka-band frequency synthesizer for millimeter wave seeker. We improved frequency synthesizer performance of phase noise, resolution and spurious using the DDS driven hybrid method The proposed frequency synthesizer has the bandwidth of 1 GHz, frequency switching time of below 9 ${\mu}s$, suppressed spurious level of below -68.9 dBc. phase noise of -113.58 dBc/Hz at offset 100 kHz and flatness of ${\pm}$0.7 dB.

• Journal of the Korea Society of Computer and Information
• /
• v.13 no.1
• /
• pp.175-183
• /
• 2008

QoS-support technology in networks is based on measuring QoS metrics which reflect a magnitude of stability and performance. The one-way delay measurement of the QoS metrics especially requires a guarantee of clock synchronization between end-to-end hosts. However, the hosts in networks have a relative or absolute difference in clock time by reason of clock offsets. flock skews and clock adjustments. In this paper, we present a theorem, methods and simulation results of one-way delay and clock offset estimations between end-to-end hosts. The proposed theorem is a relationship between one-way delay, one-way delay variation and round-trip time And we show that the estimation error is mathematically smaller than a quarter of round-trip time.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.6
• /
• pp.1068-1075
• /
• 2004

The WLAN(IEEE 802.l1b) and Bluetooth(IEEE 802.15.1) employed on 2.4㎓ ISM band wireless networks provide complementary services within the same environments. Coexistence between the networks will be impaired, if the mutual packets are uncertainty associated the timing or gaussian distance. This paper analyzes the impact of the mutual interference on the services performance in order to develope a method of coexistence between the WLAN and Bluetooth. The analysis is illustrated by examining the symbol error rate versus signal to noise interference ratio in terms of the carrier frequency of set.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.1A
• /
• pp.51-57
• /
• 2002

In this paper, a simple interpolation technique in a frequency domain is proposed for the discrete Fourier transform(DFT) algorithm. Frequency and phase resolution capabilities of the DFT algorithm can be significantly improved by the proposed interpolation technique without increase of a DFT size(the number of points for the DFT). The new technique uses a diving point in amplitude and phase spectrums. As an application, the technique can be used for joint estimation of fine frequency and phase offsets in burst mode digital transmission. Simulation results show that the joint estimator using the technique is robust to estimation errors.