• The Journal of the Acoustical Society of Korea
• /
• v.23 no.7
• /
• pp.514-520
• /
• 2004

There are many techniques for underwater source localization. These are the methods based on TDOA (Time Difference Of Arrival) estimation. beamforming techniques and high resolution techniques, etc. In this Paper we estimate the underwater source position using MCPSP (Modified Cross Power Spectrum Phase) function that is calculated on frequency domain using sensors of small number. However, the performances of the localizing method based on MCPSP function drops greatly in the case of CW (Continuous Wave) signal . In this Paper we proposed the TDOA estimation method for pulsed CW signal. In the Proposed method we composed of new segment including a edge of ping. This segment was computed by short-time energy detection. With theoretical representation the performances of the proposed method were analyzed under various environment.

• Proceedings of the KIEE Conference
• /
• 2003.07d
• /
• pp.1999-2001
• /
• 2003

본 논문에서는 시간지연 관측기를 위치제어 시스템 적용하여 설계한 내용을 기술하였다. 시간지연제어기의 상태추정 기법을 이용한 시간지연 관측기는 플랜트 모델이 필요하지 않아 설계가 용이하고, 파라미터 변동 및 외란에 강건하다. 또한 계산이 간단하여 디지털 제어 시스템에 충분히 적용이 가능하다. 본 논문에서는 시간지연제어기가 위치제어기로 적용된 전기식 구동시스템에서 속도센서를 사용하지 않고 시간지연 관측기를 적용하여 제어기를 설계하였다. 시간지연 관측기를 적용한 구동시스템에 대해 비선형 시뮬레이션을 수행하였으며. 속도센서를 사용한 경우와 상태관측기를 적용한 경우 및 PID 제어기를 적용한 경우에 대해 비교하였다.

• The Journal of the Acoustical Society of Korea
• /
• v.36 no.5
• /
• pp.345-352
• /
• 2017

We propose a methods which is reducing direction estimation error of sound source in the reverberant and noisy environments. The proposed algorithm divides speech signal into voice and unvoice using VAD. We estimate the direction of source when current frame is voiced. TDOA (Time-Difference of Arrival) between microphone array using the GCC-PHAT (Generalized Cross Correlation with Phase Transform) method will be estimated in that frame. Then, we compare the peak value of cross-correlation of two signals applied to estimated time-delay with other time-delay in time-table in order to improve the accuracy of source location. If the angle of current frame is far different from before and after frame in successive voiced frame, the angle of current frame is replaced with mean value of the estimated angle in before and after frames.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.8C
• /
• pp.681-688
• /
• 2007

Applying an appropriate received signal processing algorithm based on the channel characteristics is important to improve the receiver performance. Wireless channels in general exhibit various time-delay characteristics depending on their power delay profile. When the estimated channel power summation is used to determine the amount of time delay, a channel adaptive receiver structure can be implemented. In this paper, we derive a closed-form expression for the error probability of the channel classification when the estimated channel power summation is used to classify channel groups having different time delay characteristics, and present the performance gain utilizing multiple estimation results.

• Journal of Internet Computing and Services
• /
• v.8 no.1
• /
• pp.25-31
• /
• 2007

The development of efficient Quality of Service (QoS) routing algorithms in high speed networks is very difficult since divergent services require various quality conditions, If the QoS parameter we concern is to measure the delay on that link, then the routing algorithm obtains the Least Delay (LD) path, Meanwhile, if the parameter is to measure of the link cast, then it calculates the Least Cost (LC) path. The Delay Constrained Least Cast (DCLC) path problem of the mixed issues on LD and LC has been shown to be NP-hard. The path cost of LD path is relatively mere expensive than that of LC path, and the path delay of LC path is relatively higher than that of LD path in DCLC problem. In this paper. we propose the algorithm based on estimated path for the DCLC problem and investigate its performance, It employs a new parameter which is probabilistic combination of cost and delay, We have performed empirical evaluation that compares our proposed algorithm with the DCUR in various network situations.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2010.11a
• /
• pp.125-126
• /
• 2010

채널의 다중경로를 통과한 신호들은 지연확산 영향으로 심하게 왜곡이 되거나 Inter-Symbol Interference(ISI)가 발생하므로 왜곡된 채널을 추정하여 보상해야 한다. 기존 iterative 채널 추정 방식에서는 채널 시간 지연 길이 밖으로 zero padding함으로 노이즈 성분을 제거하는 알고리즘이다. 반면에 본 논문은 채널 시간 지연 길이 안으로 있는 노이즈 성분까지 노이즈 제거 문턱 값 추정(noise elimination threshold estimation: NETE) 알고리즘을 사용하여 노이즈를 효과적으로 제거한다. 시뮬레이션 결과는 채널의 mean square error(MSE)를 통하여 제안된 기법을 적용할 경우 채널 추정 성능 개선이 나타남을 확인할 수 있었다.

• Journal of the Korea Society for Simulation
• /
• v.16 no.1
• /
• pp.1-9
• /
• 2007

The development of efficient Qualify of Service (QoS) routing algorithms in high speed networks is extremely difficult to achieve, because in order to operate, divergent services require various quality conditions. If the parameter of concern is to measure the delay on a specific link, the routing algorithm obtains the Least Delay (LD) path. Meanwhile, if the parameter is to measure the link cost, the Least Cost (LC) path is calculated. The Delay Constrained Least Cost (DCLC) path problem of the mixed issues on the LD and LC has been shown to be NP-hard. The path cost of LD path is relatively more expensive than that of the LC path, and the path delay of the LC path is relatively higher than that of the LD path in the DCLC problem. In this paper, we introduce the new factor for balancing cost and delay. The simulation result shows that our introduced factor is satisfied to solve the DCLC problem.

• Proceedings of the KAIS Fall Conference
• /
• 2001.05a
• /
• pp.119-123
• /
• 2001

본 논문에서는 자동화 사격장 Pop-Up시스템의 안정성 및 성능 향상을 위해 예측제어기를 설계하여 시간지연에 따른 문제를 보상하였다. 확률 모델에 기반한 예측제어기는 지연된 이전의 값들로부터 선형예측 기법과 확률함수를 이용하여 실제의 값을 추정하며, 이를 제어기에 적용하여 시간지연에 따른 문제점을 최소화하였다. 제안된 알고리즘의 타당성을 검정하기 위해 사격용 Pop-Up시스템에 본 알고리즘을 실현하였으며, 상이한 시간지연과 이득 변화에 따른 제어기의 성능을 관측하였다. 실험결과 제안된 예측제어기는 시간지연에 대해 PID 제어기보다 빠른 수렴 특성을 보이며, 제어기의 안정범위 내에서 허용할 수 있는 최대 시간지연 값도 증가시킬 수 있었다. 따라서 사격용 타겟의 Pop & Up동작이 제어시간 이내에 원활하게 작동되어 연속 사격의 실시간 제어를 효율적으로 수행하였다.

• The Journal of the Acoustical Society of Korea
• /
• v.38 no.6
• /
• pp.630-636
• /
• 2019

Passive Ranging Sonar (PRS) is a type of passive sonar consisting of three sub-array on the port and starboard, and has a characteristic of detecting a target and calculating a bearing and a distance. The bearing and distance calculation requires physical sub-array position information, and the bearing and distance accuracy performance are deteriorated when the position information of the sub-array is inaccurate. In particular, it has a greater impact on distance accuracy performance using plus value of two time-delay than a bearing using average value of two time-delay. In order to improve this, a study on sub-array position error estimation and error compensation is needed. In this paper, We estimate the sub-array position error based on enetic algorithm, an optimization search technique, and propose a method to improve the performance of distance accuracy by compensating the time delay error caused by the position error. In addition, we will verify the proposed algorithm and its performance using the sea-going data.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.9C
• /
• pp.778-785
• /
• 2010

This paper proposes a high-precision ranging scheme based on channel estimation technique and multipath delay analysis in IR-UWB systems. When the IR-UWB signal is transmitted and received, the high-precision ranging is estimated with the time-of-arrival information of the signal. In the proposed scheme, the channel estimation process with the minimum mean square error technique or zero forcing technique is performed and the overlapped multipath within the pulse is analyzed with matrix pencil (MP) algorithm to achieve the ranging accuracy of centimeters. The performance of proposed scheme is evaluated with various IEEE 802.15.4a channel models and the relationship between the ranging performance and the computational complexity is analyzed in terms of the MP parameter values.