• Economic and Environmental Geology
• /
• v.50 no.1
• /
• pp.61-71
• /
• 2017

The effects of joint density and size distribution on the hydrogeologic characteristics of jointed rock masses are addressed through numerical experiments based on the 2-D DFN (discrete fracture network) fluid flow analysis. Using two joint sets, a total of 51 2-D joint network system were generated with various joint density and size distribution. Twelve fluid flow directions were chosen every $30^{\circ}$ starting at $0^{\circ}$, and total of 612 $20m{\times}20m$ DFN blocks were prepared to calculate the directional block conductivity. Also, the theoretical block conductivity, principal conductivity tensor and average block conductivity for each generated joint network system were determined. The directional block conductivity and chance for the equivalent continuum behavior of the 2-D DFN system were found to increase with the increase of joint density or size distribution. However, the anisotropy of block hydraulic conductivity increases with the increase of density discrepancy between the joint sets, and the chance for the equivalent continuum behavior were found to decrease. The smaller the intersection angle of the two joint sets, the more the equivalent continuum behavior were affected by the change of joint density and size distribution. Even though the intersection angle is small enough that it is difficult to have equivalent continuum behavior, the chance for anisotropic equivalent continuum behavior increases as joint density or size distribution increases.

• The Journal of Engineering Geology
• /
• v.10 no.1
• /
• pp.13-25
• /
• 2000

A three-dimensional discrete fracture network model based on probabilistic characteristics of fracture geometry and transmissivity was designed to calculate the conductivity tensor and to estimate theanisotropy of conductivity. The conductivities, $K_p$, obtained from the numerical simulation of single-holepacker test corresponded well to those from the field tests. From this, it can be concluded that thefracture network model designed in this study can represent hydraulic characteristics of in-situ fractured rock mass. Block-scale conductivities, $K_b$, estimated from the modelling of steady-state flow through the REV-scale block were ranged between the arithmetic mean and harmonic mean of theconductivity estimates from packer tests. The conductivity along north-south direction was 1.4 timesgreater than that along the east-west direction. It was concluded that the anisotropy of conductivitywas insignificant. It was also found that there was a little correlation between $K_b$ and $K_p$. This would be to that the conductivities from the packer test simulation was strongly dependent on thetransmissivity and the number of fractures within the packer test intervals.

• Proceedings of the KSEEG Conference
• /
• 2007.04a
• /
• pp.105-107
• /
• 2007

• The Journal of Engineering Geology
• /
• v.33 no.2
• /
• pp.307-322
• /
• 2023

Rock-mass grouting plays a crucial role in the construction of dams and deep caverns, effectively preventing seepage in the foundations, enhancing stability, and mitigating hazards. Most rock grouting is affected by hydrogeological and rock engineering indices such as rock quality designation (RQD), rock mass quality (Q-value), geological strength index (GSI), joint spacing (Js), joint aperture (Ap), lugeon value (Lu), secondary permeability index (SPI), and coefficient of permeability (K). Therefore, accurate geological analysis of basic rock properties and guidelines for grouting construction are essential for ensuring safe and effective grouting design and construction. Such analysis has been applied in dam construction sites, with a particular focus on the geological characteristics of bedrock and the development of prediction methods for grout take. In South Korea, many studies have focused on grout injection materials and construction management techniques. However, there is a notable lack of research on the analysis of hydrogeological and rock engineering information for rock masses, which are essential for the development of appropriate rock grouting plans. This paper reviews the current state of research into the correlation between the grout take with important hydrogeological and rock engineering indices. Based on these findings, future directions for the development of rock grouting research in South Korea are discussed.

• The Journal of Engineering Geology
• /
• v.4 no.1
• /
• pp.13-28
• /
• 1994

Hydrogeologic characteristics of crystalline rock including discontinuities is defined by the hydraulic data from the in situ test and by analytical method. Methodology and procedure of the in situ test are used in accordance with test purpose, site condition and characteristics of host rock Hydraulic conductivities in crystalline rock including discontinuifies such as fractured zone and joint, are defined by packer test and slug test. The results indicate Hvorslev' s theory of ground water flow in NX borehole, that the shorter of test interval is, the higher hydraulic conductivity is. This is an indicafion of the fact that the hydraulic rneasured were governed by scale effect of test interval, even at same borehole. According to the result of packer tests in two boreholes, it is understood that hydraulic conductivifies show variations according to the effect of as order of tests. In the comparison of hydraulic conductivifies from both of open borehole tests, the results are relatively well correrated in values. The hydraulic conductivity in the test intervals induding hydrogeologically significant discontinuity shows relatively higher value of hydraulic conductivity in vertical distribution of full depth.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2023.05a
• /
• pp.17-17
• /
• 2023

국내의 부지특성 및 감시 관련 규정은 원자력 안전위원회 고시 제2021-16호 제4조(세부지침)와 원자력 안전위원회 고시 제2021-17호 제16조에 의거하고, 국외는 국제원자력기구(IAEA: International Atomic Energy Agency)에서 안전기준을 제시하고 있다(IAEA, 2011). 따라서 국내 중·저준위 방사성폐기물 처분시설은 2006년부터 광역 지질을 포함한 부지 지질/지형, 기상, 수문, 수리지질, 인문사회 등을 망라한 조사를 시행하여 부지 현황에 대한 분석 및 안정성 평가를 수행한다. 부지감시의 수문·지구화학 분야에서는 현장 수질 측정 6항목과 실내 분석 26항목을 감시하고 있으나, 본 연구는 이 중 9개 항목(EC, Na, K, Ca, Mg, SiO₂, Cl, SO₄, HCO₃)을 선정하여 분석하였다. 연구 목적은 물시료 분석자료의 주성분-다중선형회귀-군집 분석과 Piper Diagram 분석결과로부터 해수와 담수(지하수)와의 특성분석 및 해수 영향을 분석하는 것이다. 현장 부지내 지하수 7개 관정(GM-1, 2, 4, 5, 6, 7, 8)과 해수 2개 지점(Sea-1, 2)을 대상으로 통계학적 주성분 분석결과, 대부분의 지하수는2개~4개의 요인으로 구분되고, 해수와의 유사성을 해석하기 위해 확인한 관정은 GM-5, GM-6, GM-1 지점으로 분류되었다. 상기와 같이 해수의 영향을 확인하기 위해 해수 2개 지점과 동일한 군집으로 분류되는 지하수는 GM-5 관정으로 확인되었고, 해안선에서 가까운 GM-5 관정과 같이 유사한 거리에 분포한 지하수 GM-1, 2, 4 관정은 2개 혹은 3개의 최적 군집으로 분류하였을 때도 GM-5와는 다른 특성을 보여주었다. 이는 해안과 인접하더라도 수질은 다른 지질학적 특성(지형, 기상, 단열대 등)에 따라 영향받았음을 지시한다.

• Economic and Environmental Geology
• /
• v.38 no.1
• /
• pp.79-89
• /
• 2005

Groundwater level changes in coastal aquifers occur due to oceanic tides, where the properties of oceanic tides can be applied to estimate hyadraulic parameters. Hydraulic parameters of coastal aquifers located in eastern part of Jeju island were estimated using the tidal response technique. Groundwater level data from a saltwater intrusion monitoring well system was used which showed tidal effects from 3 to 5 km. The hydraulic gradient was assessed by utilizing the filtering method from 71 consecutive hourly water-level observations. Calculated hydraulic diffusivity ranged from 2.94${\times}10^7m^2d^{-1}$ to 4.36${\times}10^7m^2d^{-1}$ . The hydraulic gradient of the coastal aquifer area was found to be ~$10^{-4}$, whereas the gradient of the area between wells Handong-1 and 2 was found to be ~$10^{-6}$, which is very low comparatively. Analysis of groundwater monitoring data showed that groundwater levels are periodically higher near coastal areas compared to that of inner land areas due to oceanic tide influences. When assessing groundwater flow direction in coastal aquifers it is important to consider tidal fluctuation.

• Journal of the Korean Society of Groundwater Environment
• /
• v.6 no.1
• /
• pp.33-41
• /
• 1999

Time-lag and amplitudes of the fluctuation of groundwater level are used to determine hydraulic parameters around Han River. The groundwater level at observation wells fluctuates between highest and lowest responding to the Han River level. The factors affecting the groundwater fluctuation are examined. The transmisivity of the Han River alluvium calculated from the measured water table fluctuations measured ranges from 9.39${\times}$10$^1$to 4.02${\times}$10$^3$㎡/day. Based on the hydrogeological data along the river sides, the flow characteristics of groundwater for water level fluctuations were simulated using a ground water flow model MODFLOW.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2002.09a
• /
• pp.261-264
• /
• 2002

창원시 대산면과 북면에서의 강변여과수의 지속적 사용과 확장 개발에 따른 수리지질학적 환경 변화에 대한 자료를 확보하기 위하여 연구가 진행 중에 있으며 일부 내용을 소개하고자한다. 취수정 주위에서 현장투수시험기를 이용하여 현장포화수리전도도를 측정하였으며 5.19$\times$$10^{-}$$_4$~ 9.39$\times$$10^{-4}$$^4$/cm/s 사이의 값을 얻었다. 창원시에서 실시한 통수시험 자료에 따르면 시험기간 동안의 대산면 취수정 자연수위는 0.48~3.86m로써 낙동강의 수위 1m 내외보다 높은 것으로 관측되었다. 정호 당 약 80~90㎥/hour 양수할 경우 -5.3~l.6m의 수위를 나타내었으며 3, 4, 5호정보다 6, 7호정의 수위변동 폭이 큼을 확인하였다.

• The Journal of Engineering Geology
• /
• v.25 no.2
• /
• pp.291-298
• /
• 2015

For hydrogeological studies, it is of importance to observe hydraulic head in order to interpret groundwater flow, characterize aquifers, and calibrate groundwater flow model. This study analyzed the zonal variation of hydraulic heads at the eight monitoring wells (GM-1~GM-8) installed with multi-packers in a coastal area and verified vertical and lateral trends of the hydraulic gradients. Hydraulic heads were expressed as the depth of water because the monitoring wells have different depths. The hydraulic gradient at the nearest well (GM-5) shows 0.0142 with increasing trend of hydraulic gradient along depth. This fact indicates typical phenomenon of the discharge area. On the other hand, GM-1 and GM-2 wells in coastal area demonstrate constant hydraulic gradient down to the depth of 100 meters while at the zone of deeper than 100 m the hydraulic gradients illustrate 0.0196 and 0.0735, respectively. This indicates that horizontal flow is dominant at shallower zone than 100 m whereas upward flow is dominant at the zone deeper than 100 m. GM-3 well located farther than the other wells from the coast shows a small hydraulic gradient of 0.0046 that evidences a prevalent horizontal flow between the recharge area and the discharge area.