• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2014.10a
• /
• pp.240-242
• /
• 2014

This paper presents the system which can be predicted 3-D underwater radiated noise pattern using submarine hull velocity and can be analyzed the counter detected performance for threats in real time. To verify the developed system the tests were done in a water tank for structure like a submarine. The far field radiated noise pattern predicted using the developed system is compared with the result calculated using the near field measurement system, these results have shown good agreement.

• The Journal of the Acoustical Society of Korea
• /
• v.38 no.2
• /
• pp.193-199
• /
• 2019

In this paper, the results of underwater vibration experiment are analyzed to verify platform vibration-induced noise isolation characteristics of a hull-mounted acoustic sensor. The experimental condition causing platform vibration-induced noise is generated using the mock-up hull, where the acoustic sensor is installed, with shaker in an acoustic water tank. The performance indices of ATF (Acceleration Transfer Function), AVS (Acceleration Voltage Sensitivity), and IL (Insertion Loss) for the acoustic sensor are calculated from the output of the standard accelerometers, which are installed on the mock-up hull and the acoustic sensor, and the output signal of the acoustic sensor. The frequency-dependent noise isolation characteristics of the acoustic sensor are analyzed based on the calculated performance indices and an effectiveness of the experiment is examined.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.24 no.10
• /
• pp.770-779
• /
• 2014

In this study, a numerical estimation method for 3D underwater radiated noise pattern using hull vibration and total acoustic power of the vibrating structure in the far-field is proposed. The underwater radiated noise pattern is known to be predicted using the vibration signals and radiation efficiency of each surface patch. But it is very difficult to know radiation efficiency of each surface patch which is one of important factors to calculate the 3D underwater radiated noise pattern. Instead of using radiation efficiency of each patch, the underwater radiated noise level is modified with the total acoustic power of the vibrating structure. The suggested estimation method for underwater radiated noise pattern is discussed with numerical model.

• The Journal of the Acoustical Society of Korea
• /
• v.43 no.2
• /
• pp.145-151
• /
• 2024

Recently, ship hull-mounted passive sonar system solution is needed in the perspective of improving target detection and elimination of vibration-induced noise. Our research team suggests acousticvibration matching method using front and rear signal of a sensor as the improvement of the problem above. Thus in this paper, theoretical background about matching method and its application on finite element method based multi-physics simulation are described. Furthermore, it is shown that target detection and hull vibration performance are improved by using matching method under the condition of our sensor system. Finally, practicality and future research are discussed.

• The Journal of the Acoustical Society of Korea
• /
• v.42 no.3
• /
• pp.243-249
• /
• 2023

The occurrence of cavitation on the propeller is directly linked to the naval ship's survivability, and it is necessary to design a propeller shape that delays the cavitation inception. However, the propeller cavitation can occur under various operating conditions, thus it is important to identify whether the propeller cavitation exists during operation as well as in the design phase. To this end, it is necessary to use noise or vibration signals on board to monitor the cavitation inception. In this study, a hydrophone and an accelerometer were installed on the ship hull right above the propeller to compare the performance of analyzing cavitation inception between acoustic and vibration signals. Also, a high speed camera was used to visually observe the occurrence of cavitation through an observation window. The measured results showed that the spectral shapes between acoustic and vibration signals were different, but the level increases at each frequency band and the overall level of the frequency band from 1 kHz to 10 kHz showed a similar tendency. The Detection of Envelope Modulation On Noise (DEMON) analysis also showed similar results for both acoustic and vibration signals, confirming that both hydrophones and accelerometers can be utilized in the analysis of cavitation inception.

• Journal of Advanced Marine Engineering and Technology
• /
• v.37 no.1
• /
• pp.91-98
• /
• 2013

The degradation of durability and increase of fatigue on the ship are mainly caused by vibration of the engine and rotating machineries. The damper to minimize the influence from vibration is usually attached between the machineries and its base. General damper applied on the vessel is passive damper which is designed to attenuate specified frequency signals, i.e, high frequency vibration signals. But it is hard to anticipate its performance for low frequency signals. In this research, active vibration isolator using VCM is developed to suppress wide band vibration signals. Routh-Huritz's stable condition, ultimate sensitivity method and parameter tuning are applied to derive PID parameters and 2 and 4 phase choppers are also adapted to drive VCM. Simulation and experiments are executed to confirm the effectiveness of the proposed control schemes.

• Proceedings of the Acoustical Society of Korea Conference
• /
• 1996.06a
• /
• pp.1-3
• /
• 1996

수중 트랜스듀서는 진동하는 물체위에 설치되어 다양한 외부 소음원이 유입되는 환경에 노출되어 있다. 외부 소음원으로는 선체 진동. 프로펠러 소음, 그리고 유동 유기 소음들을 들 수 있고, 트랜스듀서의 실제 작동시 이들의 레벨이 상당히 높아서 센서의 정확한 작동에 장애가 되고 있다. 본 논문에서는 외부 소음원에 무관한 고 정밀, 저 소음 특성을 지닌 음향센서를 개발하기 위하여 유한요소법 (FEN)을 사용하여 소음 전달 특성을 분석하고, air pocket과 음향 감쇠층의 다양한 조합으로 이루어진 구조를 개선한 음향센서의 설계 및 내소음성 평가를 하였다. 또한 사용한 음향 감쇠층의 최적 물성을 제시하고자 한다. 그 결과 센서 측면 하단부에 소음원이 위치할 경우 가장 큰 잡음 신호로 작용하며, 구조를 변경한 결과 기존 음향센서에 비해 55% 이상 내 소음성을 증진 시켰다. 그리고 음향 감쇠층의 최적 음향 임피던슨는 1 Mrayl 이하 혹은 4mrayl 이상으로 분석되었다.

• The Journal of the Acoustical Society of Korea
• /
• v.43 no.4
• /
• pp.400-405
• /
• 2024

When cavitation noise occurs in ship propellers, the level of underwater radiated noise abruptly increases, which can be a critical threat factor as it increases the probability of detection, particularly in the case of naval vessels. Therefore, accurately and promptly assessing cavitation signals is crucial for improving the survivability of submarines. Traditionally, techniques for determining cavitation occurrence have mainly relied on assessing acoustic/vibration levels measured by sensors above a certain threshold, or using the Detection of Envelop Modulation On Noise (DEMON) method. However, technologies related to this rely on a physical understanding of cavitation phenomena and subjective criteria based on user experience, involving multiple procedures, thus necessitating the development of techniques for early automatic recognition of cavitation signals. In this paper, we propose an algorithm that automatically detects cavitation occurrence based on simple statistical features reflecting cavitation characteristics extracted from acoustic signals measured by sensors attached to the hull. The performance of the proposed technique is evaluated depending on the number of sensors and model test conditions. It was confirmed that by sufficiently training the characteristics of cavitation reflected in signals measured by a single sensor, the occurrence of cavitation signals can be determined.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2009.10a
• /
• pp.1108-1111
• /
• 2009

Auto Pilot is the system which move automatically the vessel through locating operation mode to automatic after entering operating course using a electronic chart or plotter. And water jet is the a propulsion system that make a power to push the vessel through spouting the accelerated water which is absorbed by the hole in the bottom of vessel. The water jet receive the effect of the depth of water lowly, it's acceleration efficiency is higher under high speed and have an advantage on vibrating and floating sound, so it's demand is increasing as new propulsion system. However, the signal systems of auto pilot and water jet are different, we need the system to interface between each system. We designed the interface that efficiently digital feed back control embedded module between auto pilot and water jet system in this paper.