• Journal of the Korean earth science society
• /
• v.32 no.7
• /
• pp.719-731
• /
• 2011

Based on the ICE-3G and ICE-5G ice models, we predicted the velocities of crustal uplift caused by Glacial Isostatic Adjustment (GIA) at 39 tide gauge sites operated by Korea Hydrographic and Oceanographic Administration (KHOA). We also divided the Korean peninsula in the ranges of $32-38.5^{\circ}N$ and $124-132^{\circ}E$ in $0.5^{\circ}{\times}0.5^{\circ}$ grids, and computed the GIA velocities at each grid point. We found that the average uplift rates due to GIA in South Korea were 0.33 and 1.21 mm/yr for ICE-3G and ICE-5G, respectively. Because the GIA rates were relatively high at ~1 mm/yr when the updated ice model ICE-5G was used, we concluded that the GIA effect cannot be neglected when we compute the absolute sea level (ASL) rates around the Korean peninsula. In this study, we corrected the ICE-5G GIA velocities from the relative sea level rates provided by KHOA and we computed the ASL rates at 13 tide gauge stations. As a result, we found that the average ASL velocity around the Korean peninsula was 5.04 mm/yr. However, the ASL rates near Jeju island were abnormally higher than the other areas and the average was 8.84 mm/yr.

• Journal of Sericultural and Entomological Science
• /
• no.11
• /
• pp.69-72
• /
• 1970

The purpose of this study is to find out reasonable automatic silk reeling method of the domestic cocoons Jar the improvement of its reeling ability. The results obtained are as follows: 1. The silk yield and the reelability percentage decreased according to increase of the reeling velocity and decrease of the reeling temperature. 2. The reeling tension increased according to increase of the reeling velocity and decrease of the reeling temperature. 3. The reeling accidance increased according to i I1crease of the reeling velocity and temperature. 4. In case of the automatic silk reeling with fixed denier system, the reeling velocity (90∼120m/min) md temperature (35∼45$^{\circ}C$) had no influence on the raw silk qualities. 5. As a conclusion, the reasonable reeling velocity is 3bout 120m per minutes and the bath temperature is about 40$^{\circ}C$ in the automatic silk reeling of the domestic cocoons.

• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 1998.05a
• /
• pp.145-152
• /
• 1998

실내에서 가스폭발시 피해를 예측하기 위해서 폭발 화염면의 전파를 수치해석을 통해 해석했다. 확산방정식에 의해 가스누출에 의한 실내의 가스확산분포를 구했으며 문헌에서 선택한 누출의 초기조건을 사용했다. 화염온도를 계산하기 위해 각 가스 혼합비에 따른 엔탈피와 화학식에 대한 reduced mechanism을 사용했으며 문헌에서 찾은 각 가스의 농도별 층류 연소속도를 혼합가스의 층류연소속도에 적용시켰다. k-$\varepsilon$ 모델에서 turbulance energy를 층류연소속도와 결합시켜 난류화염 전파속도를 모델링 했다. 화염면의 전파를 분석하기 위해 실내의 위치에는 직각, 화염면의 전파에는 원통좌표계를 사용했다. 유리창의 파손에 의한 화염전파면의 변화에 따른 압력상승 요인을 해석하였으며 창문의 크기에 따라서 점화위치에 따른 실내 압력상승의 영향이 서로 다르게 나타나는 결과를 얻었다.

• The tire
• /
• s.28
• /
• pp.11-13
• /
• 1970

• Journal of Korea Society of Industrial Information Systems
• /
• v.29 no.1
• /
• pp.117-123
• /
• 2024

Bubbles generated in water receive an upward buoyant force due to the density and pressure difference of the surrounding fluid. Additionally, the behavior, shape, and heat exchange process of bubbles vary depending on the viscosity, surface tension, rising speed, and size difference with the surrounding fluid. In this study, we modeled speed, and heat transfer of a high-temperature single bubble rising in a cylindrical water tank. For this purpose, velocity, and temperature of the bubbles were calculated using theoretical equations, to be compared with numerical simulation results. The numerical analysis was performed using a commercial software, and the stability of the numerical analysis with mesh size was confirmed through calculation of the grid convergence index. The numerical analysis of the rising speed and temperature of a single bubble showed the values to converge when the minimum cell size was 1/160 of the bubble diameter, and the temperature decrease was confirmed to be the same as that of the surrounding fluid within 0.05 seconds.

• Journal of the Korean GEO-environmental Society
• /
• v.2 no.1
• /
• pp.57-65
• /
• 2001

In this study, the seepage behavior and the stability of the extension embankment were estimated for three cases the permeability coefficient of an extension part and the rising velocity due to the rainfall of flood period. In parallel flow condition, the unstability of the slope due to embankment erosion was examined by analyzing the variation of seepage line by the seepage modeling tests and FEM analysis, and the stability of the embankment slope accompanied by the sudden rise of the water level after the flood. The seepage behavior of extension embankment indicates that the larger permeability of the extension part the longer initial seepage distance, and the exit point from embankment slope is gradually increased, and then shows unstable seepage behavior that occurs a partial collapse as safety factor decreases with time. It is because of the increment of exit points due to variation of seepage line and rising velocities of water level. Also, the collapse aspect of embankment slope shows that the increment rising velocities of water level causes the increment collapse height and depth.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2009.05a
• /
• pp.315-316
• /
• 2009

In this study, latent heat material was used to reduce hydration heating velocity of high-strength mass concrete. And the properties of hydration heat and autogenous shrinkage, and the relationship between hydration heat and autogenous shrinkage of high-strength mass concrete were numerically investigated.

• The Korean Journal of Rheology
• /
• v.6 no.2
• /
• pp.139-146
• /
• 1994

미연신, 비결정 PET 필름의 띠연신조건(띠연신 응력, 띠연신 온도, 띠열판의 상승속 도)에 따른 필름의거동을 연구하였다. 띠열판의 상승속도가 10, 20, 30, 50 mm/min일 때 온 도(Td) 이하에서는 임계네킹응력이 띠연신 온도가 증가함에 따라 급격히 감소하고 그 온도 이상에서는 거의 변하지 않고 일정했으며 임계온도 이하에서는 임계온도와 띠연신 온도의 온도차(Tc-Td)가 임계네킹응력과 비례관계를 가져 다음과 같은 간단한 실험식을 얻었다. $\sigma$c=0.838 (Tc-Td)+$\sigma$0 임계네킹응력에서 띠연신한 필름의 치수는 연신 온도와 띠열판의 상 승속도에 거의 의존하지 않고 일정한 값을 나타내었다. 임계네킹응력 이상에서는 연신 조건 에 따라 필름의 폭, 두께, 그리고 연신비가 거의 변하지 않았다.

• Proceedings of the Korean Institute of Industrial Safety Conference
• /
• 2003.10a
• /
• pp.207-213
• /
• 2003

본 연구는 양수발전 등을 목적으로 축조한 소형 Dam 및 Sand Levee의 수위가 급상승할 경우 제체의 내측면에 미치는 영향을 Bishop's simplified method를 사용하여 Seepage Force(침투력)의 항을 중심으로 분석한 것이다. 특히 침투력의 항은 제체의 사면경사가 급할 경우 및 수위의 상승속도에 따라 제체의 안전성에 많은 영향을 미친다.(중략)

• The Journal of the Korea Contents Association
• /
• v.16 no.4
• /
• pp.604-613
• /
• 2016

The sea level of the Earth is rising approximately 2.0mm per year (global average value) due to thermal expansion of sea water, melting of glaciers and other causes by global warming. However, when it comes to design a river, the standard of design water level is decided by analyzing four largeness tide value and harmonic constant with observed tidal water level. Therefore, it seems the external water level needs to consider an increasing speed of the seawater level which corresponds to a design frequency. In the present study, the hourly observed tidal water level targeting 47 tidal stations operated by Korea Hydrographic and Oceanographic Administration (KHOA) from beginning of observation to 2015 per hour has been collected. The variation of monthly and yearly and increasing ratio have been performed divided 4 seas such as the Southern, East, Western, and Jeju Sea. Also, the external water level existing design for rivers nearby a coast was been reviewed. The current study could be used to figure out the cause of local seawater rise and reflect the external water level as basic data.