• Proceedings of the KOSOMBE Conference
• /
• v.1998 no.11
• /
• pp.237-238
• /
• 1998

The kinetics of sulfite oxidation must be fast and the concentration of sulfite must be low to emulate oxygen uptake by blood. The kinetics were studied yielding a first order rate constant in sulfile, zero order in oxygen. Limitations of the technique were evaluated using the experimental rate constant and an adaptation of Lightfoot's approximation, while the reaction of hemoglobin is reversible and essentially instantaneous, that for sulfite is irreversible and finite. Thus if the approach to saturations not monotonic or if the mass transfer resistance is significantly lowered, e. g. when blood film thicknesses are thinner than a few hundred microns, deviations may occur.

• Korean journal of applied entomology
• /
• v.38 no.2
• /
• pp.123-128
• /
• 1999

Recently, entomopathogenic nematodes have received a considerable attention as biologicalcontrol agents. For in vitro cultivation, storage and transportation of nematodes, oxygen supply isextremely impotant due to its limited solubility and mass transfer problem. The oxygen uptake rates(OURs) of four different Steinernema species were measured in a 5L bioreactor at varying temperatures.The OURs of the Steinernema spp. were below 0.5 x mmolO'||'&'||' . min in the range of 13-17$^{\circ}$C. TheOURs (mmo102/L - min) of S. glaseri Dongrae and S. carpocapsae Pocheon strains were 0.4 x lo-', 0.75x lo-\ulcorner at 21$^{\circ}$C, 1.5 x lo-\ulcorner, 3.2 x 10-2 at 25"C, and 2.8 x lo-', 5.8 x lo-\ulcorner at 29"C, respectively. However,the OURs were not significantly altered by the agitation speed of 50-150 rpm. The specific oxygenuptake rates (qol) of S. glaseri NC, S. glaseri Dongrae, S. glaseri Mungyeong and S. carpocapsaePocheon strains were 0.3 x 0.5 x 0.3 x and 0.2 x mmolO~/cell min at 25"C,respectively. As the nematode size and temperature were increased, the qo, was also increased.the qo, was also increased.

• Clean Technology
• /
• v.24 no.4
• /
• pp.307-314
• /
• 2018

In this study, NMO (Natural Manganese Ore), $MnO_2$, and $Mn_2O_3$ catalysts were used in the selective catalytic reduction process to remove nitrogen oxides (NOx) using $NH_3$ as a reducing agent at low temperatures in the presence of oxygen. In the case of the NMO (Natural Manganese Ore), it was confirmed that the conversion of nitrogen oxides in the stability test did not change even after 100 hours at 423 K. The Kinetics experiments were carried out within the range where heat and mass transfer were not factors. From a steady-state Kinetics study, it was found that the low-temperature SCR reaction was zero order with the respect to $NH_3$ and 0.41 ~ 0.57 order with the respect to NO and 0.13 ~ 0.26 order with the respect to $O_2$. As temperature increases, the reaction order decreases as a result of $NH_3$ and oxygen concentration. It was confirmed that the reaction between the $NH_3$ dissociated and adsorbedon the catalyst surface and the gaseous nitrogen monoxide (E-R model) and the reaction with the adsorbed nitrogen monoxide (L-H model) occur.

• 한국생물공학회:학술대회논문집
• /
• 2000.04a
• /
• pp.239-242
• /
• 2000

Experimental studies on the effects of impeller to provide the microbial transglutaminase derived from Streptoverticillium mobaraense have been conducted. The optimal production medium was determined by latin-square design, and the effects of aeration and agitation were observed by using different sizes and shapes of impellers for the poduction of transglutaminase. The effects of pH and temperature were also evaluated for the production of transglutaminase in flasks. As a result, pH is more effective than temperature for both enzyme production and growth of the microorganism. The peak enzyme activity for transglutaminase in fermenter was 0.7 U/mL, but this was still well below the avereage enzyme activity, 1,3 U/mL, obtained in flask runs.

• Journal of Hydrogen and New Energy
• /
• v.28 no.1
• /
• pp.85-91
• /
• 2017

To develop a pressurized chemical looping combustor, effect of pressure on minimum fluidization velocity and transition velocity to fast fluidization was investigated in a two-interconnected pressurized fluidized bed system using oxygen carrier particle. The minimum fluidization velocity was measured by bed pressure drop measurement with variation of gas velocity. The measured minimum fluidization velocity decreased as the pressure increased. The transition velocity to fast fluidization was measured by emptying time method and decreased as the pressure increased. Gas velocity in the fuel reactor should be greater than the minimum fluidization velocity and gas velocity in the air reactor should be greater than the transition velocity to fast fluidization to ensure proper operation of two interconnected fluidized bed system.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.17 no.1
• /
• pp.48-56
• /
• 2018

Due to the growing concerns of energy resource depletion and environmental destruction, the mass production of microalgae has been studied. The scale-up of a photobioreactor (PBR) is required for the mass production of biomass. In this paper, the geometric parameters and oxygen transfer rate (OTR) are considered, to scale up a flat panel photobioreactor (FP PBR). The PBR is designed using the goal-driven optimization (GDO) method to accomplish the scale-up. The local sensitivity of each output parameter with respect to the input parameter is analyzed through the design of experiment (DOE), and the design candidates are evaluated with the screening sampling method. The volumetric mass transfer coefficient is measured by the dynamic method.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.161-161
• /
• 2014

열플라즈마는 주로 아크 방전에 의해 발생시킨 전자, 이온, 중성입자(원자 및 분자)로 구성된 부분 이온화된 기체로, 국소열평형상태를 유지하여 구성입자가 모두 수천에서 수만도에 이르는 같은 온도를 갖는 고속의 제트 화염 형태를 이루고 있다. 이렇게 고온, 고열용량, 고속, 다량의 활성입자를 갖는 열플라즈마의 특성을 이용하여, 종래 기술에서는 얻을 수 없는 다양하고 효율적인 산업적 이용이 활발히 진행되고 있다. 용사코팅은 노즐 출구를 통해서 외부로 방출되는 열 플라즈마 화염을 이용하는 것으로 이 화염의 와류 특성으로 인하여 외기의 가스가 화염내부로 침투하는 특성을 가진다. 이러한 현상은 열원의 냉각효과 외에도 외기를 구성하는 기체 분자의 내부 유입을 의미하는 것으로 대기 상태에서 공정이 이루어진다면 열원 내로 유입되는 대기 내의 산소가 모재 표면과 반응하여 산화가 진행된다. 이러한 산화과정은 용사 코팅의 품질을 저하시키는 요인이 되므로, W, Ti 등과 같은 반응성이 높은 재료의 코팅은 산화과정을 방지하기 위하여 진공에서 코팅을 하여야만 한다. 진공 플라즈마용사코팅은 진공 또는 저압의 불활성 분위기 중에서 열플라즈마 화염에 용사재료를 투입하여 플라즈마 화염 내부에서 순간적으로 이를 용융시킨 후 고속으로 분출, 모재에 적층시키는 코팅공정이다. 이때 분말상의 용사재료를 고속으로 화염 중심에 투입하여 최대 에너지 전달이 이루어지도록 하는 것이 적층효율 및 코팅품질을 향상에 필수적이다. 하지만 플라즈마 화염 내부를 고속으로 이동하는 입자의 온도와 속도 및 궤적을 측정하여 제어하는 것은 매우 어렵기 때문에, 통상 형성된 코팅의 구조와 두께로부터 경험적으로 파라미터를 결정하는 것이 일반적이다. 본 연구에서는 초고속 레이저 카메라와 이미지 분석용 소프트웨어를 이용하여 플라즈마 화염내의 비행입자 궤적을 추적하고, 이를 통해 분말 이송가스의 유량이 코팅 효율 및 미세구조에 미치는 영향을 조사하였다. 플라즈마 화염은 중심부가 가장 높은 온도와 속도를 가지고 있기 때문에, 분말 이송가스의 유량이 적을 경우 투입된 분말은 단지 플라즈마 화염의 상부 경계면을 지나는 궤적을 갖게된다. 이로 인해 분말의 용융이 충분히 이루어지지 않아 적층 효율이 낮고 미용융 입자 및 기공이 많은 미세구조를 보였다. 이송가스 유량을 증가시키게 되면, 분말의 궤적은 플라즈마 화염의 중심부를 지나게 되어 적층 효율이 증가하고 미세구조 또한 개선되었다. 하지만 이송가스 유량이 지나치게 클 경우, 투입된 분말 입자는 플라즈마 화염을 조기에 관통하게 되어 비행궤적은 온도와 속도가 낮은 영역에 형성되었다.

• Journal of the Korean Chemical Society
• /
• v.40 no.7
• /
• pp.467-473
• /
• 1996

Although a polypyrrole shows better electrical conductivity, 100∼400 ${\Omega}^{-1}cm^{-1}$, than other organic conducting polymers, its electrical conductivity will be worsen in the presence of the oxygen due to its easy oxidation. On the other hand, polythiophene shows better stability in the air while its electrcal conductivity is poor compared to the polypyrrole. We succeed to develope the mixed polymer electrode that is stable in the air and shows a good redox characteristics. The mixed polymer electrode has been prepared by the electrical polymerization of polypyrrole on the Pt electrode as 1.70 C$cm^{-2}$ and then coating with polythiophene as 0.34 C$cm^{-2}$. The polymerization rate of polythiophene was $3.89{\times}10^{-8}$ at the bare Pt electrode and $6.07{\times}10^{-8}cms^{-1}$ at the mixed polymer electrode. And the standard rate constants of each electrode were $5.16{\times}10^{-6}\;and\;3.94{\times}10^{-4} cms^{-1}$ respectively. Also, the electrocatalytic rate of the polypyrrole polymer electrode was $3.45{\times}10^{-3}cm^3mol^{-1}s^{-1}.$ We found the immobilized layer at the modified electrode acted as an electrocatalyst. Finally, this polymerization process at the Pt electrode was the electron transfer controlled, but that the mixed polymer electrode was the diffusion and charge transfer controlled.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.36 no.3
• /
• pp.175-185
• /
• 2000

This paper described on a basic study to organize fishing vessel control system in order to control efficiently fishing vessel in Korean offshore. It was digitalized ARPA image on the fishing processing of a fleet of purse seiner in conducting fishing operation at Cheju offshore in Korea as a digital camera and then simulated by used VTMS. Futhermore, it was investigated on the application of FVTMS which can control efficiently fishing vessels in fishing ground. The results obtained were as follows ; (1) It was taken 16 minutes and 35 minutes to casting and hauling net in fishing processing respectively. The length of rope pulled by scout boat was 200m, tactical diameter in casting net was 340.8m, turning speed was 6kts as well. (2) The processing of casting and hauling net was moved to SW, NE as results of simulation when the current direction and speed set into NE, 2kts and SW, 2kts respectively. Such as these results suggest that can predict to control the fishing vessel previously with information of fishing ground, fishery and ship's maneuvering, etc. (3) The control range of VTMS radar used in simulation was about 16 miles. Although converting from a radar of the control vessel to another one, it was continuously acquired for the vector and the target data. The optimum control position could be determined by measuring and analyzing to distance and direction between the control vessel and the fleet of fishing vessel. (4) The FVTMS(fishing vessel traffic management services) model was suggested that fishing vessels received fishing conditions and safety navigation information can operate safely and efficiently.

• Applied Chemistry for Engineering
• /
• v.30 no.4
• /
• pp.493-498
• /
• 2019

In polymer exchange membrane fuel cells, it is crucial to fabricate a highly active and thin Pt catalyst layer for the smooth mass transport of dissolved oxygen and water. Although a highly loaded platinum (Pt) catalyst based on the hydrothermal synthesis has been reported in several studies, its growing behaviors and kinetics were yet to be understood. In this study, we investigated the growth of Pt crystal in suspension after the reduction step depending on a stirring time and evaluated the electrochemical activity. For only a couple of hours in the early stage, Pt colloids were adsorbed on the Pt-carbon catalyst and the Pt crystal was grown. After that, the small Pt colloid was formed by another nucleation step, which did not involve the growth of Pt crystal. We reveal that the Pt-Carbon catalyst with stirring for 6 h showed a high activity toward the oxygen reduction reaction.