• Journal of Korean Society of societal Security
• /
• v.1 no.2
• /
• pp.67-72
• /
• 2008

To confirm the stability of a cut slope in the road extension construction site, several investigations were carried out and countermeasures of slope was studied. This paper describes a study of design case of extra reinforcement on existing cut slope reinforced by preloading and piles in roads. To investigate the effect of stabilizing piles installed in a cut slope, an instrumentation system also designed, was. As a result that the stabilizing file and earth anchor are considered as the extra reinforcement, both stabilizing pile and earth anchor guarantee the stability of cut slope. However, stabilizing pile is selected in aspects of economy and continuity to the existing cut slop reinforcement including counterweight fill and stabilizing piles.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2002.10a
• /
• pp.15-15
• /
• 2002

사면은 인공적 또는 자연적인 현상에 의하여 발생된 경사진 지반을 말하며, 그 안정성은 작용외력과 지반상태 및 지하수 등에 의하여 영향을 받는다. 사면의 파괴는 여러 가지 형태로 일어날 수 있으나 대체로 강성 활동 파괴체가 소성화된 국부적인 지반을 따라서 발생되고, 사면의 파괴형상은 경계조건과 지반상태가 단순할 경우에만 쉽게 예측할 수 있으며, 복잡한 지반상태에서는 많은 노력과 비용을 들여서 정밀하게 조사해야만 어느 정도 실제와 근사하게 예측할 수 있다. 자연 또는 인공사면에서 지질 및 지반상태, 지하수 상태, 사면의 형상, 사면의 규모, 외력의 작용상태 등의 조건을 분석하여 사면파괴를 일으킬 수 있는 원인들을 찾아내어 적합한 안정화대책을 마련하는 방안을 모색한다. 특히 사면을 성토사면, 절토사면, 암절사면, 대절토사면으로 구분하여 사면파괴 원인과 안정화대책에 대해서 심도 있게 검토한다. 사면의 설계 및 안정검토를 위하여 일반적으로 적용하고 있는 사면안정 검토 방법들에 대해서 이론전개 과정에서 발생되는 문제점들과 이들이 결과에 미치는 영향에 대해서 언급한다. 그리고 사면을 안정시키기 위하여 일상적으로 적용하는 대책공법들의 적용성을 사면파괴 원인과 연계해서 판정하는 방안을 검토한다.

• The Journal of Engineering Geology
• /
• v.12 no.4
• /
• pp.367-378
• /
• 2002

Recently, the number of tunnels on national roads has been increased due to the trend that construction of the large-scaled cut slopes is limited because of the environmental issues. Therefore, the slope failures of tunnel portal have often occurred. The tunnel portal in use has limitations on selection of the countermeasure and construction against slope failure. In the cases of Suanbo hot springs 1 and 2 tunnel portals, seedding was chosen and constructed as the countermeasureof slope failure when the tunnel was first built but collapsed in April, 2002. In this study, the failure sites were examined accurately through the site investigation and an efficient countermeasure according to stability analysis is presented. It is shown that it is very efficient to use resloping for Suanbo hot springs 1 tunnel and concrete buttress, rock anchor to reinforcement countermeasure, and attached rockfall prevention net by dividing the site into 3 sections for Suanbo hot springs 2 tunnel.

• Proceedings of the Korean Geotechical Society Conference
• /
• 1997.09a
• /
• pp.137-146
• /
• 1997

• Spatial Information Research
• /
• v.16 no.3
• /
• pp.279-290
• /
• 2008

Landslide, one of the serious natural disasters, has Incurred a large loss of human and material resources. Recently, many forecasting or alarm systems based on various kinds of measuring equipment have been developed to reduce the damage of landslide. However, only a few of these equipments are guaranteed to evaluate the safety of whole side of land slope with their accessibility to the slope. In this study, we performed some experiments to evaluate the applicability of a terrestrial LiDAR as a surveying tool to measure the displacement of a land slope surface far a slope collapsing protection system. In the experiments, we had applied a slope stability method to a land slope and then forced to this slope with a load increasing step by step. In each step, we measured the slope surface with both a total station and a terrestrial LiDAR simultaneously. As the result of Slope Fracturing analysis using all targets, the LiDAR system showed that three was 1cm RMSE on X-axis, irregularity errors on Y-axis and few errors on Z-axis compare with Total Station. As the result of Slope Fracturing analysis using continuous targets, the pattern of Slope Fracturing was different according to the location of continuous targets and we could detect a continuous change which couldn't be found using Total station. The accuracy of the LiDAR data was evaluated to be comparable to that of the total station data. We found that a LiDAR system was appropriate to measuring the behaviour of land slope. The LiDAR data can cover the whole surface of the land slope, whereas the total station data are available on a small number of targets. Moreover, we extracted more detail information about the behavior of land slope such as the volume and profile changes using the LiDAR data.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2004.03b
• /
• pp.586-591
• /
• 2004

매년 발생되는 절토사면의 붕괴를 사전에 방지하기 위하여 절토사면에 상시 계측시스템을 설치하고 지반의 거동분석을 실시한다. 본 현장의 절토사면 붕괴 규모와 메카니즘을 분석하고 계측 결과와 상호 비교 분석한다. 본 현장은 상시계측시스템 운용 확대 실시에 따른 시험 설치 현장으로 2003년부터 운용 중에 있다. 계측결과에 의하면 강우량과 지반의 거동이 밀접한 관계가 있는 것으로 사료된다. 본 현장의 경우 크게 3번의 지반이동이 있었으며 현재는 안정화 단계에 있는 것으로 사료된다. 그러나, 향후 동절기의 외분 온도 변화와 동반하여 지반의 변동이 우려됨으로 인하여 지속적인 관찰과 자료 분석이 수행되어야 할 것으로 본다.

• 한국방재학회:학술대회논문집
• /
• 2011.02a
• /
• pp.201-201
• /
• 2011

산지유역의 지표 환경이 급격히 교란된 지역에서 집중 호우가 발생하면, 과대한 토사유출로 인해 하천유역 홍수 재해요인으로 작용할 수 있다. 본 연구에서는 산불발생지역, 벌목지역, 도로공사지역과 같이 산지환경이 급변한 지역을 토사유출 시험유역으로 운영하였다. 세 개의 시험유역 중에 지표교란이 심각한 도로공사시험유역에서 강우유출 및 토사유출이 가장 크게 발생하였다. 그림 1은 각 시험유역별 강우강도에 따른 첨두유량 관계를 나타낸 것이다. 또한 산불 후 10년이 경과된 급경사 산불시험유역이 벌목시험유역보다 유출 및 토사유출량이 많았다. 벌목시험유역은 벌목이후 잔류물과 빠른 식생회복으로 지표상태가 빠르게 안정화되어 유출 및 토사유출량이 적게 발생하였다. 도로공사 시험유역 나지사면에서 시행된 사면처리 공법 시공 전 후로 토사유출량의 변화가 현저히 크며(그림 2), 이는 공사를 진행하는 중에 적절한 사면관리 처리를 통한 토사유출량 저감이 필요하다는 것을 나타낸다.

• Tunnel and Underground Space
• /
• v.16 no.2 s.61
• /
• pp.146-155
• /
• 2006

The target slope of this study, formed during the construction of highway, is the very high infinite slope where sliding began along the discontinuity. Although an attempt was made to stabilize the upper part of the slope by installing the rock anchors, large scale failure was occurred at the lower part if the reinforced area. Afterwards, subsequent failures were observed two times. To investigate the cause of the failure, residual shear strength was measured by performing the direct shear test of rock specimen of the site. The anchor design was based on the pull-out test. Considering the slope surface where the undulation was severe and the variation of strength was very large, buttressing was used to obtain the required anchoring capacity.

• The Journal of Engineering Geology
• /
• v.19 no.3
• /
• pp.345-350
• /
• 2009

The endpoint of the Yangbuk tunnel constructed at the national road between Gyeongju and Gampo is composed of massive cutting because the road is driven through the sides of mountain. PAP(Prestressed Anchor and PC Pannel) retaining wall as a slope stability method was established over this section. Part of the anchor in PAP wall became broken after six months. We performed inverse analysis through its measurements obtained until that time. An geological investigation to confirm the condition of ground layering and the attraction force test to find as to whether some errors might be present in the anchor were made. According to the back analysis, it was turned out that the value with soil parameter 90% that was applied to the original design was pertinent. In the redesign, the permissible stress in the anchor body was changed from 306 kN to 591 kN and 784 kN and the fixation position was increased from 11.0 m to 23.0 m. Nevertheless, five months have passed since the exchange of the anchor, the measurement results validate that stable state has been maintained. This research is considered a case that the immediate maintenance helps prevent the slope accidents.

• Journal of the Korean GEO-environmental Society
• /
• v.7 no.5
• /
• pp.49-55
• /
• 2006

Quick lime made from limestone that are deposited abundantly in Korea has excellent potentials for stabilization of clayey soils. If Korea is able to take advantage of its abundant supply, economical efficiency could be achieved through mass production as well as being able to take advantage of utilization of natural resources. For stabilizing of clayey soil with lime, it is necessary to determine the required quantities of lime firstly and to evaluate the degree of stabilization with lime content. In this test, the quantity of lime required for 2 clayey soils which located in Seunggok and Bugok province respectively, and for 2 clay minerals-kaolinite and montmorillonite-were determined by ASTM C 977-92 and were evaluated for solidification of each samples with changing lime contents by Atterberg limit test and pH test. It was also evaluated for the improvement of each sample with lime content and curing time. The sample which added lime content determined by ASTM C 977-92 increased plastic limit, unconfined compression strength, and decreased pH in increasing trend.